Muhammad Alshahed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Muhammad Alshahed has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Joachim N. Burghartz
Institut für Mikroelektronik Stuttgart, Allmandring 30a, 70569 Stuttgart, Germany
4 shared publicationsMohammed Alomari
Institut für Mikroelektronik Stuttgart, Allmandring 30a, 70569 Stuttgart, Germany
3 shared publicationsAlessandro Ottaviani
Institut für Mikroelektronik Stuttgart, Allmandring 30a, 70569 Stuttgart, Germany
2 shared publicationsChristine Harendt
IMS Chips, 70569 Stuttgart, Germany
2 shared publications- Lars Heuken
Institut für Mikroelektronik Suttgart (IMS CHIPS), 70569 Stuttgart, Germany
2 shared publications - Michael Heuken
Compound Semiconductor Technology (CST) RWTH Aachen University Aachen Germany
2 shared publications
Latest Publications
- Open Access
- 14 May 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (SC) , SCCD11
Temperature dependent lateral and vertical conduction mechanisms in AlGaN/GaN HEMT on thinned silicon substrate
This paper presents the influence of Si substrate thinning by grinding and dicing on the mechanical and electrical properties of AlGaN/GaN HEMT grown on 6-inch Si substrate. By experimentally removing 96% of the Si substrate, an increase in the lateral breakdown voltage by 13% is achieved for a wide temperature range. A decreasing vertical breakdown voltage with substrate thinning shows the necessity of substrate replacement to maintain the vertical isolation. Poole-Frenkel and space charge limited conduction mechanisms are identified for the vertical leakage in forward and reverse bias down to thicknesses of 200 μ m, respectively. The increase in chip bow and the resulting increase in tensile strain in the epitaxial layers resulting from the substrate removal are correlated to a 40% decrease in 2DEG charge carrier concentration along with a 27% increase in threshold voltage. These findings are explained by strain-induced gate barrier and polarization charge variations.
- 14 May 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (SC) , SCCD11
Open AccessTemperature dependent lateral and vertical conduction mechanisms in AlGaN/GaN HEMT on thinned silicon substrate
This paper presents the influence of Si substrate thinning by grinding and dicing on the mechanical and electrical properties of AlGaN/GaN HEMT grown on 6-inch Si substrate. By experimentally removing 96% of the Si substrate, an increase in the lateral breakdown voltage by 13% is achieved for a wide temperature range. A decreasing vertical breakdown voltage with substrate thinning shows the necessity of substrate replacement to maintain the vertical isolation. Poole-Frenkel and space charge limited conduction mechanisms are identified for the vertical leakage in forward and reverse bias down to thicknesses of 200 μ m, respectively. The increase in chip bow and the resulting increase in tensile strain in the epitaxial layers resulting from the substrate removal are correlated to a 40% decrease in 2DEG charge carrier concentration along with a 27% increase in threshold voltage. These findings are explained by strain-induced gate barrier and polarization charge variations.
- 6 September 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 216 (1)
Temperature Dependent Vertical Conduction of GaN HEMT Structures on Silicon and Bulk GaN Substrates
- 6 September 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 216 (1)
Temperature Dependent Vertical Conduction of GaN HEMT Structures on Silicon and Bulk GaN Substrates
- 16 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (7) , 2939-2947
Low-Dispersion, High-Voltage, Low-Leakage GaN HEMTs on Native GaN Substrates
In this paper, the advantages of GaN high electron mobility transistors (HEMTs) grown on native GaN over GaN/Si or GaN/sapphire substrates are investigated and correlated with epitaxial material quality. Transmission electron microscopy plan-view and cross-sectional analyses of GaN/GaN reveal dislocation densities below 1 x 10⁶ cm⁻², which is at least three orders of magnitude lower than that of GaN/Si or GaN/sapphire. In the case of GaN/Si, the dislocations not only originate from the substrate/nucleation layer interface, but also the strain relief and isolation buffer stacks are main contributors to the dislocation density. GaN/GaN HEMTs show superior electrical and thermal performance and feature three orders of magnitude lower OFF-state leakage. The current collapse (also referred to as current dispersion or RON-increase) after stress bias is less than 15% compared with 50% in the case of GaN/Si. A 2% drop of the ON-state current due to self-heating in dc operation when compared with 13% and 16% for GaN/Si and GaN/sapphire, respectively. The GaN/Si thermal performance becomes comparable to that of GaN/GaN only after substrate removal. Therefore, GaN/GaN provides high ON-state current, low OFF-state leakage current, minimal current collapse, and enhanced thermal power dissipation capability at the same time, which can directly be correlated with the absence of high dislocation density.
- 16 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (7) , 2939-2947
Low-Dispersion, High-Voltage, Low-Leakage GaN HEMTs on Native GaN Substrates
In this paper, the advantages of GaN high electron mobility transistors (HEMTs) grown on native GaN over GaN/Si or GaN/sapphire substrates are investigated and correlated with epitaxial material quality. Transmission electron microscopy plan-view and cross-sectional analyses of GaN/GaN reveal dislocation densities below 1 x 10⁶ cm⁻², which is at least three orders of magnitude lower than that of GaN/Si or GaN/sapphire. In the case of GaN/Si, the dislocations not only originate from the substrate/nucleation layer interface, but also the strain relief and isolation buffer stacks are main contributors to the dislocation density. GaN/GaN HEMTs show superior electrical and thermal performance and feature three orders of magnitude lower OFF-state leakage. The current collapse (also referred to as current dispersion or RON-increase) after stress bias is less than 15% compared with 50% in the case of GaN/Si. A 2% drop of the ON-state current due to self-heating in dc operation when compared with 13% and 16% for GaN/Si and GaN/sapphire, respectively. The GaN/Si thermal performance becomes comparable to that of GaN/GaN only after substrate removal. Therefore, GaN/GaN provides high ON-state current, low OFF-state leakage current, minimal current collapse, and enhanced thermal power dissipation capability at the same time, which can directly be correlated with the absence of high dislocation density.
- 31 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 7 (11) , 1786-1794
Measurement-Based Compact Thermal Model Extraction Methodology for Packaged ICs
In this paper, a rigorous methodology for extracting the thermal compact model parameters of packaged chips is presented. The methodology is based on using a custom-designed test chip with multiple heating and temperature sensing elements in order to predict the temperature distribution in packaged chips after packaging. The technique involves measurement of various chips with different thicknesses, different packages, and for different power dissipation scenarios through which the thermal model parameters can be extracted. The results show that ultrathin chips with a total thickness below 20 μm experience a dramatically increased temperature for localized heat dissipation. In addition to this, the measurements conducted in time domain and frequency domain show that at high enough frequencies of heat pulsing, the temperature variations become independent of the thermal boundary conditions of the chip. The measurement results are compared to the finite-element method simulation data. The simulations together with the measurement methodology serve as a technique to extract the thermal compact model parameters of packaged chips after being fabricated and packaged in an accurate and efficient way.
- 31 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 7 (11) , 1786-1794
Measurement-Based Compact Thermal Model Extraction Methodology for Packaged ICs
In this paper, a rigorous methodology for extracting the thermal compact model parameters of packaged chips is presented. The methodology is based on using a custom-designed test chip with multiple heating and temperature sensing elements in order to predict the temperature distribution in packaged chips after packaging. The technique involves measurement of various chips with different thicknesses, different packages, and for different power dissipation scenarios through which the thermal model parameters can be extracted. The results show that ultrathin chips with a total thickness below 20 μm experience a dramatically increased temperature for localized heat dissipation. In addition to this, the measurements conducted in time domain and frequency domain show that at high enough frequencies of heat pulsing, the temperature variations become independent of the thermal boundary conditions of the chip. The measurement results are compared to the finite-element method simulation data. The simulations together with the measurement methodology serve as a technique to extract the thermal compact model parameters of packaged chips after being fabricated and packaged in an accurate and efficient way.
- 1 November 2015
- Published by Elsevier in Solid-State Electronics
- Vol. 113, 121-126
Thermal characterization and modeling of ultra-thin silicon chips
- 1 November 2015
- Published by Elsevier in Solid-State Electronics
- Vol. 113, 121-126
Thermal characterization and modeling of ultra-thin silicon chips