Desireddy Harikishore Kumar Reddy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Desireddy Harikishore Kumar Reddy has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
K. Seshaiah
6 shared publications- Yeoung-Sang Yun
Division of Semiconductor and Chemical Engineering, Jeonbuk National University, Jeonju, Jeonbuk 561-756, Republic of Korea; School of Chemical Engineering, Jeonbuk National University, Jeonju, Jeonbuk 561-756, Republic of Korea
6 shared publications Seung-Mok Lee
4 shared publications- Seung-Mok Lee
Department of Environmental Engineering, Catholic Kwandong University, Gangneung, Korea
4 shared publications A.V.R. Reddy
3 shared publicationsB. Naresh Kumar
Analytical & Environmental Chemistry Division, Department of Chemistry , Sri Venkateswara University , Tirupati , India
3 shared publications
Latest Publications
- Open Access
- 12 May 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (20) , 13057-13065
Pd(II)-Imprinted Chitosan Adsorbent for Selective Adsorption of Pd(II): Optimizing the Imprinting Process through Box–Behnken Experimental Design
- 12 May 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (20) , 13057-13065
Open AccessPd(II)-Imprinted Chitosan Adsorbent for Selective Adsorption of Pd(II): Optimizing the Imprinting Process through Box–Behnken Experimental Design
- 30 May 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (22) , 18650-18659
Fabrication of Stable and Regenerable Amine Functionalized Magnetic Nanoparticles as a Potential Material for Pt(IV) Recovery from Acidic Solutions
MnFe2O4@SiO2–NH2 magnetic nanocomposite (AFMNC) adsorbent with a particle size of ∼50 nm was successfully synthesized using a facile approach. The as-prepared composite particles showed a fast binding of Pt(IV) with easy magnetic solid–liquid separation. The kinetic data were fitted to both pseudo-first and second-order rate models, indicating that AFMNC exhibited a much higher rate of Pt(IV) binding (0.125 g mg–1 min–1) compared to that of commercial ion-exchange resin Amberjet 4200 (0.0002 g mg–1 min–1). The equilibrium adsorption data were fitted to the Langmuir isotherm model with a relatively high sorption capacity of 380 mg/g. Scanning transmission electron microscopy analysis demonstrated the presence of platinum chloride after sorption on AFMNC, suggesting an adsorbate–adsorbent anion-exchange interaction. In addition, due to its magnetic characteristics, AFMNC can be easily separated from the aqueous medium after the sorption process. The novel nanocomposite may facilitate recovery of Pt(IV) from waste solutions.
- 30 May 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (22) , 18650-18659
Fabrication of Stable and Regenerable Amine Functionalized Magnetic Nanoparticles as a Potential Material for Pt(IV) Recovery from Acidic Solutions
MnFe2O4@SiO2–NH2 magnetic nanocomposite (AFMNC) adsorbent with a particle size of ∼50 nm was successfully synthesized using a facile approach. The as-prepared composite particles showed a fast binding of Pt(IV) with easy magnetic solid–liquid separation. The kinetic data were fitted to both pseudo-first and second-order rate models, indicating that AFMNC exhibited a much higher rate of Pt(IV) binding (0.125 g mg–1 min–1) compared to that of commercial ion-exchange resin Amberjet 4200 (0.0002 g mg–1 min–1). The equilibrium adsorption data were fitted to the Langmuir isotherm model with a relatively high sorption capacity of 380 mg/g. Scanning transmission electron microscopy analysis demonstrated the presence of platinum chloride after sorption on AFMNC, suggesting an adsorbate–adsorbent anion-exchange interaction. In addition, due to its magnetic characteristics, AFMNC can be easily separated from the aqueous medium after the sorption process. The novel nanocomposite may facilitate recovery of Pt(IV) from waste solutions.
- Top Cited Papers
- 25 May 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 5 (26) , 13557-13564
Effective adsorption of Pd( ii ), Pt( iv ) and Au( iii ) by Zr( iv )-based metal–organic frameworks from strongly acidic solutions
Separation of precious metal ions from acidic solutions is of great importance due to their cumulative supply risk and environmental concern. However, their separation is still challenging as they are often present in extremely low pH solutions. Metal–organic frameworks (MOFs) have attracted extensive curiosity for adsorption owing to their fascinating physicochemical features including tunable pore sizes, active functional sites, and porosity. Here, two Zr-based MOFs of UiO-66 and UiO-66-NH2 with an 8-ligand-connected Zr6 node were fabricated and tested for adsorption of Pd(II), Pt(IV) and Au(III) anions (PdCl4 2−, PtCl6 2− and AuCl4 −) in strongly acidic solutions. Both MOFs were tested for uptake time and adsorption capacities and showed rapid and high precious metal adsorption performances. Inner-sphere complexation between the precious metal anions and the incompletely coordinated Zr atoms in the MOFs was the key mechanism involved in the precious metal adsorption. In the case of UiO-66-NH2, additional electrostatic attraction was found between the protonated amine group (–NH3 +) and the precious metal anions, as well as partial reduction of the bound precious metal ions. Moreover, the pathway of adsorption–reduction–crystallization–precipitation for the interaction of UiO-66-NH2 and AuCl4 − resulted in extremely high recovery efficiency for gold.
- 25 May 2017
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 5 (26) , 13557-13564
Top Cited PapersEffective adsorption of Pd( ii ), Pt( iv ) and Au( iii ) by Zr( iv )-based metal–organic frameworks from strongly acidic solutions
Separation of precious metal ions from acidic solutions is of great importance due to their cumulative supply risk and environmental concern. However, their separation is still challenging as they are often present in extremely low pH solutions. Metal–organic frameworks (MOFs) have attracted extensive curiosity for adsorption owing to their fascinating physicochemical features including tunable pore sizes, active functional sites, and porosity. Here, two Zr-based MOFs of UiO-66 and UiO-66-NH2 with an 8-ligand-connected Zr6 node were fabricated and tested for adsorption of Pd(II), Pt(IV) and Au(III) anions (PdCl4 2−, PtCl6 2− and AuCl4 −) in strongly acidic solutions. Both MOFs were tested for uptake time and adsorption capacities and showed rapid and high precious metal adsorption performances. Inner-sphere complexation between the precious metal anions and the incompletely coordinated Zr atoms in the MOFs was the key mechanism involved in the precious metal adsorption. In the case of UiO-66-NH2, additional electrostatic attraction was found between the protonated amine group (–NH3 +) and the precious metal anions, as well as partial reduction of the bound precious metal ions. Moreover, the pathway of adsorption–reduction–crystallization–precipitation for the interaction of UiO-66-NH2 and AuCl4 − resulted in extremely high recovery efficiency for gold.
- 1 January 2017
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 170, 48-55
Facile room temperature deposition of gold nanoparticle-ionic liquid hybrid film on silica substrate
- 1 January 2017
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 170, 48-55
Facile room temperature deposition of gold nanoparticle-ionic liquid hybrid film on silica substrate
- 12 September 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (92) , 89089-89097
Fabrication of high performance amine-rich magnetic composite fibers for the recovery of precious Pt( iv ) from acidic solutions
Magnetic nanoparticles (MNPs) possessing a high surface to volume ratio, copious chemically active sites, and ease of separation from aqueous solutions are emerging materials for water treatment. Further encapsulation of these nanoparticles (NPs) with polymeric materials may protect these NPs from direct contact with the aqueous environment and also enhance their sorption efficiency. In the case of polymer fibers, breakage will occur depending on environmental conditions, and the addition of MNPs in fibers will provide an opportunity for the complete recovery of fibers after the sorption process. In the present study, a mixed solution of amine-rich chitosan (CS) and polyethyleneimine (PEI) containing magnetic MnFe2O4 nanoparticles was utilized for fabricating versatile and robust magnetic polymer composite fibers (MPCFs) in a facile methodology. The effective fabrication of MPCFs was confirmed by using analytical techniques such as FTIR, XRD, VSM, FE-SEM, and TEM. Morphological characterization demonstrated that MnFe2O4 nanoparticles were well distributed in the composite fibers. Detailed batch sorption experiments revealed that MPCFs exhibited significant improvement in adsorption efficiency compared with bare MnFe2O4 nanoparticles. The MPCFs exhibited high adsorption capacity (371.35 ± 16.79 mg g−1) and fast equilibrium (within 30 min). The Pt-loaded MPCFs were easily separated from aqueous solution under an external magnetic field. It can be concluded that MPCFs with amine-rich functional groups and magnetic properties are promising for Pt adsorption from aqueous solutions.
- 12 September 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (92) , 89089-89097
Fabrication of high performance amine-rich magnetic composite fibers for the recovery of precious Pt( iv ) from acidic solutions
Magnetic nanoparticles (MNPs) possessing a high surface to volume ratio, copious chemically active sites, and ease of separation from aqueous solutions are emerging materials for water treatment. Further encapsulation of these nanoparticles (NPs) with polymeric materials may protect these NPs from direct contact with the aqueous environment and also enhance their sorption efficiency. In the case of polymer fibers, breakage will occur depending on environmental conditions, and the addition of MNPs in fibers will provide an opportunity for the complete recovery of fibers after the sorption process. In the present study, a mixed solution of amine-rich chitosan (CS) and polyethyleneimine (PEI) containing magnetic MnFe2O4 nanoparticles was utilized for fabricating versatile and robust magnetic polymer composite fibers (MPCFs) in a facile methodology. The effective fabrication of MPCFs was confirmed by using analytical techniques such as FTIR, XRD, VSM, FE-SEM, and TEM. Morphological characterization demonstrated that MnFe2O4 nanoparticles were well distributed in the composite fibers. Detailed batch sorption experiments revealed that MPCFs exhibited significant improvement in adsorption efficiency compared with bare MnFe2O4 nanoparticles. The MPCFs exhibited high adsorption capacity (371.35 ± 16.79 mg g−1) and fast equilibrium (within 30 min). The Pt-loaded MPCFs were easily separated from aqueous solution under an external magnetic field. It can be concluded that MPCFs with amine-rich functional groups and magnetic properties are promising for Pt adsorption from aqueous solutions.
- Top Cited Papers
- 1 May 2016
- Published by Elsevier in Coordination Chemistry Reviews
- Vol. 315, 90-111
Spinel ferrite magnetic adsorbents: Alternative future materials for water purification?
- 1 May 2016
- Published by Elsevier in Coordination Chemistry Reviews
- Vol. 315, 90-111
Top Cited PapersSpinel ferrite magnetic adsorbents: Alternative future materials for water purification?
- 1 April 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 289, 413-422
Aliquat-336-impregnated alginate capsule as a green sorbent for selective recovery of gold from metal mixtures
- 1 April 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 289, 413-422
Aliquat-336-impregnated alginate capsule as a green sorbent for selective recovery of gold from metal mixtures
- 1 September 2014
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 20 (5) , 3658-3662
Characterization of binary oxide photoactive material and its application for inorganic arsenic removal
- 1 September 2014
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 20 (5) , 3658-3662
Characterization of binary oxide photoactive material and its application for inorganic arsenic removal
- 1 July 2014
- Published by Elsevier in Ecological Engineering
- Vol. 68, 200-208
Biosorption properties of pretreated sporopollenin biomass for lead(II) and copper(II): Application of response surface methodology
- 1 July 2014
- Published by Elsevier in Ecological Engineering
- Vol. 68, 200-208
Biosorption properties of pretreated sporopollenin biomass for lead(II) and copper(II): Application of response surface methodology
- 1 July 2014
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 454, 96-103
Magnetic biochar composite: Facile synthesis, characterization, and application for heavy metal removal
- 1 July 2014
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 454, 96-103
Magnetic biochar composite: Facile synthesis, characterization, and application for heavy metal removal