YIYury Z. Ionikh

Yury Z. Ionikh

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yury Z. Ionikh has a total of 77 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Ionization Waves in the Context of the Low-Pressure Discharge Ignition

    by Yuriy Ionikh, Aleksandr Meshchanov

    The ignition of a discharge (breakdown) in a low-pressure gas, of the order of 0.1–10 Torr, in the so-called long tubes, in which the length significantly exceeds their transverse size, is considered. The breakdown mechanism in them differs significantly from that which occurs in the gaps between large flat electrodes creating the initially uniform electric field. That mechanism is described in all monographs and textbooks on gas electronics, the key factor in it is being electron avalanches (Townsend mechanism). In long tubes, the ignition of a discharge is preceded by the traversing the gap by an ionization wave, a region of an electric field of abnormally high strength. Due to this, the nature of the breakdown acquires a number of features that are not typical of an avalanche breakdown. One of them is that the most important discharge ignition characteristic, the breakdown voltage, is susceptible to relatively weak influences, such as room lighting, with constant or pulsed voltage of mild amplitude. They can either reduce or increase the breakdown voltage by up to hundreds of percent. This chapter describes the results of the relevant experiments and provides a qualitative explanation of the observed effects.

  • Mutual Effect of the Ionization Wave and the Surface Charge of the Wall During the Breakdown in the Discharge Tube

    by A. V. Meshchanov, Yu. Z. Ionikh, A. Z. Devdariani

    The propagation of the ionization wave along the discharge tube with a precharged wall was studied. Pure inert gases, from neon to xenon, were used, as well as the Ne–Ar mixture, at pressures ~1 Torr. The discharge tubes had a length of 80 cm and a diameter of about 1.5 cm. The ionization wave was excited by a positive- or negative-polarity voltage pulse. The wall charge appeared as a result of the passage of the previous ionization wave initiated in the single-electrode mode. In this mode, the ionization wave is not accompanied by the ignition of the glow discharge. It was established that the time dependence of the longitudinal coordinate of the wave and its instantaneous velocity at each point were determined not by the exciting pulse amplitude but by its excess over the potential of the charged wall. This excess also determines the breakdown voltage in the tube with a precharged wall. This fact confirms the concept of the primary breakdown between the high-voltage electrode and the wall (Nedospasov and Novik, 1960) as the mechanism of the appearance of the ionization wave during the ignition of the glow discharge. Estimates of the characteristic lifetime of the wall charge were obtained.


  • On the Processes of Charging the Wall of a Discharge Tube under External Illumination

    by A. V. Meshchanov, Yu. Z. Ionikh

    The breakdown and discharge ignition in discharge tubes with a diameter of about 1 cm and a length of 80 cm in inert gases (neon, argon, krypton, and xenon) at a pressure of about 1 Torr are studied experimentally. The tube is illuminated by radiation from continuous or pulsed light sources in the visible spectrum range. A ramp voltage with a small slope steepness (of about 50 V/s) is applied to the anode of the tube. Previously, the authors established that under these conditions external illumination can increase the breakdown voltage in several times. This effect was explained by the appearance of a charge on the tube wall as a result of photodesorption of electrons from its inner surface. In this work, it is found that charging the wall begins only when the anode potential approaches the breakdown potential measured without illumination. In addition, it is found that during the increase in the voltage on the anode and charging the wall, the anode potential differs from the breakdown potential by a constant and small value (less than 200 V).


  • Open Access

    Decay of metastable atoms in the afterglow of single-electrode breakdown

    by Vladislav V. Zaletov, Aleksander I. Shishpanov, Yury Z. Ionikh

    This paper deals with experimental studies of ionization waves igniting the breakdown in long discharge tubes in neon at low pressures. Ionization waves were produced by rectangular voltage pulses applied to the high-voltage electrode of the discharge tube. Our research focused on concentration measurements of neon excited atoms at the metastable 1s5(3P2) level after the ionization wave passage and the breakdown termination. We also found the characteristic decay times of these states and the most significant elementary processes responsible for metastable atom deactivation. Проведены экспериментальные исследования волн ионизации, которые предваряют пробой в длинных разрядных трубках в неоне при низком давлении. Волны ионизации возникали при подаче прямоугольных импульсов напряжения на высоковольтный электрод разрядной трубки. Измерены концентрации атомов неона на метастабильном уровне 1s5(3P2), возникших после прохождения волны ионизации и окончания пробоя. Определены характерные времена распада этих состояний и элементарные процессы, ответственные за гибель метастабильных атомов в наиболее значительной степени.

  • Hindering breakdown in a long discharge tube by visible spectrum light illumination

    by A V Meshchanov, A I Shishpanov, Y Z Ionikh

    The effect of irradiation with visible spectrum light on breakdown in discharge tubes 75–80 cm long and 1.5 cm in inner diameter in rare gases at a pressure of ∼1 Torr was studied. A ramp voltage of variable slope in the range of ∼10–1–105 kV s−1 was applied to the tube anode. The tube was illuminated by radiation from fluorescent lamps operating in a continuous mode, as well as by LEDs or a laser diode operating in a pulsed mode. The breakdown voltage and the pre-breakdown ionization wave (IW) velocity were measured. Illumination led to a change in the breakdown potential. The sign of this change depended on the anode voltage rise rate dU/dt. At dU/dt > 102–103 kV s−1, the breakdown voltage decreased. A similar effect was observed earlier and was explained by the appearance of electrons in the discharge gap under the light action, as a result of which the breakdown delay time decreased. This, in turn, caused a decrease in the breakdown voltage. At dU/dt < 101–102 kV s−1, on the contrary, the breakdown potential increased; at dU/dt ∼ 0.1 kV s−1, this increase could reach 5–6 times. The dependence of the observed effect on the radiation intensity, its wavelength, and the illuminated area position on the tube surface is studied. The pre-breakdown IW behaved in an unusual way under these conditions: its velocity and the signal amplitude recorded by the capacitive probe increased when moving from the high-voltage anode to the cathode. It is assumed that the observed features are caused by the desorption of weakly bound electrons from the tube wall surface under the action of irradiation. These electrons create a current that charges the wall near the anode. Since the first stage of discharge ignition is the initial breakdown between the anode and the tube wall, the anode potential for such a breakdown should increase, which means an increase in the breakdown voltage. Additional experiments with the initiation of a preliminary IW by a pulse applied to the cathode, confirmed the existence of a charge on the wall near the anode.


  • An “Anomalous” Effect of Illumination on the Breakdown in a Long Discharge Tube in Xenon

    by A. V. Meshchanov, S. A. D’YAchkov, Yu. Z. Ionikh

    We studied an electric breakdown in an 80-cm-long discharge tube with the inner diameter of 1.5 cm (the so-called “long discharge tube”) in xenon at 1 Torr. The discharge was initiated by positive pulses of ramp voltage with a rise rate dU/dt on the order of 10–1–105 kV/s. The breakdown voltage was measured in darkness and upon tube illumination by fluorescent lamps, LEDs, or a diode laser. The effect of illumination depends on the slope of the pulse leading edge. The voltage drops at dU/dt > 100 kV/s, while growing at dU/dt < 100 kV/s. The voltage increases by a factor of six for the voltage slope of 0.1–1 kV/s. The dependence of the observed effect on radiation intensity, wavelength, and position of the illuminated area on the tube surface is studied. The pre-breakdown ionization wave behaves unusually under the described conditions: its speed and intensity of emission at its front grow in the course of wave propagation. Photodesorption of electrons from the tube surface as a result of which the wall near the anode becomes positively charged is assumed to represent the mechanism of the observed phenomena. This causes an increase in the breakdown voltage and accelerated propagation of the ionization wave. Additional experiments confirm the presence of the wall charge in the near-anode region under the discussed conditions.


  • Breakdown voltage in long tubes: the effect of surface charge

    by A V Meshchanov, A I Shishpanov, P S Bazhin, Y Z Ionikh

    The study focuses on ignition processes in long discharge tubes (the length of which is large compared to the diameter) in rare gases Ne, Ar, and their mixture at a low pressure (∼1 Torr). Gas breakdown was caused by ramp voltage pulses of positive or negative polarity applied to the active electrode. The breakdown voltage was determined by the voltage drop at breakdown. The emission of the ionization wave (IW) preceding the breakdown was explored. The discharge tubes were exposed to two types of external influences. The first was illumination of the tube cathode with visible spectrum light, while the second was the constant or pulsed bias of the cathode potential by a value lower than that of maintaining discharge. In both cases the breakdown voltage increased up to doubling under some conditions. The observation of the IW revealed the presence of extra waves preceding the regular pre-breakdown IW. The extra wave velocity and emission intensity differed from those of the regular waves. Their main feature is that they do not overcome the entire inter-electrode gap, but weaken and disappear in between. It is assumed that the extra waves deposit the wall surface charge, which in turn affects the breakdown voltage. The increased breakdown voltage value remains for tens of minutes, which could indicate the surface charge lifetime of the same order. This was confirmed by direct wall-potential measurements using an electrostatic voltmeter.


  • Estimation of plasma parameters in a pre-breakdown ionization wave at the glow discharge ignition in argon

    by Nikolay A Dyatko, Yury Z Ionikh, Aleksandr V Meshchanov

    The results of an experimental study of a pre-breakdown ( slow ) ionization wave (IW) in argon-filled discharge tubes of 15 mm i.d. and 80 and 100 cm length at a pressure of 1 and 4 Torr are presented. The breakdown and the IW were initiated by a positive voltage pulse with an amplitude of 2 and 4 kV. The IW was detected by the light emitted from its front. The IW emission spectrum consisted of the argon atomic and ion lines. The Ar(763.5 nm) and Ar + (488.0 nm) lines were used to retrieve the electric field strength value in the IW front. For this, the intensity ratio of these lines was measured. The upper levels for these lines are excited by electron impact, and, due to a large difference between their excitation energies, this ratio strongly depends on the reduced electric field strength E/N ( E is the electric field strength, N is the atom number density). Theoretical modeling makes it possible to find a relation between the line intensity ratio and the E/N value. In the model, the axial profile of the IW electric field is approximated by a rectangle with a width determined from the measured emission intensity waveform and the wave velocity. As a result, the E/N magnitude in the IW front was found for various positions along the tube. Emission intensity of the DC discharge was also measured, which allowed us to estimate the emitting level population and electron number density in the IW front. The density of seed electrons ahead of the wave is also evaluated and processes responsible for the appearance of these electrons are discussed.


  • Effect of High-Voltage Electrode Potential Bias on the Breakdown Induced by Ionization Wave in Discharge Tube

    by A. V. Meshchanov, Yu. Z. Ionikh, Yu. S. Akishev

    An experimental study has been done of the bias effect of the active (high-voltage) electrode potential on the breakdown characteristics in a discharge tube 15 mm in diameter, filled with neon, argon, or their mixture (3 : 1) at a pressure of ~1 Torr. The bias of the potential is carried out by parallel connection to the electrode with an additional constant voltage or additional pulses with an amplitude less than the voltage for maintaining self-sustained discharge. In this case, a change in the breakdown voltage, the velocity of the pre-breakdown ionization wave, and the brightness of radiation from its front is observed. In particular, the breakdown voltage can increase up to 1.5–2 times, and this state of the discharge gap can be maintained for tens of minutes. The observed effects are assumed to be caused by the appearance of a charge on the tube wall and a change in its potential near the electrode, which affect the characteristics of the primary breakdown between the electrode and the wall and, in turn, the processes of discharge ignition. The mechanisms of appearance of the surface charge on the wall when feeding a bias voltage to electrode are investigated.


  • Open Access

    Electric Breakdown in Long Discharge Tubes at Low Pressure (Review)

    by Yu. Z. Ionikh

    The review is devoted to studies of the processes and mechanisms of ignition of a glow discharge in tubes whose length significantly exceeds their diameter (long discharge tubes) at low pressures (~10 Torr and lower) and moderate voltage rise rates (~1 kV/μs and lower). The electric field in such tubes before a breakdown is substantially nonuniform. Therefore, a breakdown occurs after an ionization wave (or waves) passes through the discharge gap at a speed of ~10 5 –10 7 cm/s. This makes the characteristics of the breakdown in long tubes significantly different from the breakdown between large and closely spaced electrodes, where the electric field is uniform before the breakdown and where the Townsend or, under strong overvoltage, streamer mechanism is realized. On the other hand, the nature of these processes is very different from those occurring in nanosecond discharges, which arise at voltages with a steepness of ~1 kV/ns and higher and are associated with high-speed (~10 9 cm/s) ionization waves. The review is based on the materials of experimental and computational works published from 1938 to 2020. Breakdown processes, optical and electrical characteristics of the discharge gap during breakdown, and the influence of the external circuit parameters and external actions (shielding and illumination by external sources of visible radiation) are analyzed.