Marc Doleans
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Marc Doleans has a total of 600 co-authors. Here are the top co-authors by number of shared publications:
X. Wu
MSU National Superconducting Cyclotron Laboratory East Lansing, Michigan 48824, USA
10 shared publications- Sang-Ho Kim
Oak Ridge National Lab. (ORNL), Oak Ridge, TN (United States)
9 shared publications F. Marti
MSU National Superconducting Cyclotron Laboratory East Lansing, Michigan 48824, USA
8 shared publicationsD. Gorelov
NSCL/MSU, East Lansing, MI 48824, U.S.A.
6 shared publicationsR. Sundelin
6 shared publications- John D. Galambos
Oak Ridge National Lab. (ORNL), Oak Ridge, TN (United States)
5 shared publications
Latest Publications
- Open Access
- 12 October 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (10) , 102001
Plasma cleaning of the SLAC Linac Coherent Light Source II high energy verification cryomodule cavities
Plasma cleaning is a technique that can be applied in superconducting radio-frequency cavities in situ in cryomodules to decrease their level of field emission (FE). We developed the technique for Linac Coherent Light Source II (LCLS-II) cavities and we present in this paper the full development and application of plasma processing to the LCLS-II High Energy verification cryomodule (vCM). We validated our plasma processing procedure on the vCM, fully processing four out of eight cavities of this CM, demonstrating that cavity performance was preserved in terms of both accelerating field and quality factor. Applying plasma processing to this clean, record breaking cryomodule also showed that no contaminants were introduced in the string, maintaining the vCM FE-free up to the maximum field reached by each cavity. We also found that plasma processing eliminates multipacting (MP)-induced quenches that are frequently observed within the MP band field range. This suggests that plasma processing could be employed in situ in CMs to mitigate both FE and MP, significantly decreasing the testing time of cryomodules, the linac commissioning time and cost, and increasing the accelerator reliability.
- 12 October 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (10) , 102001
Open AccessPlasma cleaning of the SLAC Linac Coherent Light Source II high energy verification cryomodule cavities
Plasma cleaning is a technique that can be applied in superconducting radio-frequency cavities in situ in cryomodules to decrease their level of field emission (FE). We developed the technique for Linac Coherent Light Source II (LCLS-II) cavities and we present in this paper the full development and application of plasma processing to the LCLS-II High Energy verification cryomodule (vCM). We validated our plasma processing procedure on the vCM, fully processing four out of eight cavities of this CM, demonstrating that cavity performance was preserved in terms of both accelerating field and quality factor. Applying plasma processing to this clean, record breaking cryomodule also showed that no contaminants were introduced in the string, maintaining the vCM FE-free up to the maximum field reached by each cavity. We also found that plasma processing eliminates multipacting (MP)-induced quenches that are frequently observed within the MP band field range. This suggests that plasma processing could be employed in situ in CMs to mitigate both FE and MP, significantly decreasing the testing time of cryomodules, the linac commissioning time and cost, and increasing the accelerator reliability.
- 30 September 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (3) , 032229
Intrinsic spatial chirp of subcycle terahertz pulsed beams
We present an analysis of spatial chirp in subcycle pulsed beams corroborated by spatiotemporal electro-optic sampling measurements of terahertz radiation. Modeling the subcycle pulsed beam as a superposition of monochromatic Gaussian beams, free-space propagation is shown to directly lead to lateral spatial chirp with the spectrum on-axis substantially bluer than the overall energy spectrum. The two-transverse one-temporal dimensional profile of terahertz subcycle pulsed beams from organic crystals DSTMS and OH1 are measured and compared with observed spatiospectral correlations consistent with the model.- 30 September 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (3) , 032229
Intrinsic spatial chirp of subcycle terahertz pulsed beams
We present an analysis of spatial chirp in subcycle pulsed beams corroborated by spatiotemporal electro-optic sampling measurements of terahertz radiation. Modeling the subcycle pulsed beam as a superposition of monochromatic Gaussian beams, free-space propagation is shown to directly lead to lateral spatial chirp with the spectrum on-axis substantially bluer than the overall energy spectrum. The two-transverse one-temporal dimensional profile of terahertz subcycle pulsed beams from organic crystals DSTMS and OH1 are measured and compared with observed spatiospectral correlations consistent with the model.- Open Access
- 19 February 2021
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 24 (2) , 022002
Field emission mitigation studies in the SLAC Linac Coherent Light Source II superconducting rf cavities via in situ plasma processing
Field emission is one of the main factors that can limit the performance of superconducting radio frequency cavities. To reduce possible field emission in the Linac Coherent Light Source II (LCLS-II), we are developing plasma processing for 1.3 GHz nine-cell cavities. The ultimate goal of plasma processing will be to apply the technique in situ in the cryomodules in order to mitigate hydrocarbon-related field emission without disassembling them. Herein is presented the first systematic study of plasma processing applied to LCLS-II superconducting radio frequency cavities. Having developed a new method of plasma ignition for LCLS-II cavities, we applied plasma processing to 1.3 GHz cavities starting with a clean nitrogen doped cavity and proceeding with studying natural field emission and artificially contaminated cavities. All the cavities were cold tested before and after plasma cleaning in order to compare their performances. It was proved that this technique successfully removes carbon-based contamination from the cavity iris and that it is able to eliminate field emission in a naturally field emitting cavity. The effect of plasma processing on cavities exposed to vacuum failures was also investigated, showing positive results in some cases. This work shows how successful plasma processing is in removing hydrocarbon related contamination from the cavity surface without affecting the high Q-factors and quench fields characteristic of nitrogen doped cavities.
- 19 February 2021
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 24 (2) , 022002
Open AccessField emission mitigation studies in the SLAC Linac Coherent Light Source II superconducting rf cavities via in situ plasma processing
Field emission is one of the main factors that can limit the performance of superconducting radio frequency cavities. To reduce possible field emission in the Linac Coherent Light Source II (LCLS-II), we are developing plasma processing for 1.3 GHz nine-cell cavities. The ultimate goal of plasma processing will be to apply the technique in situ in the cryomodules in order to mitigate hydrocarbon-related field emission without disassembling them. Herein is presented the first systematic study of plasma processing applied to LCLS-II superconducting radio frequency cavities. Having developed a new method of plasma ignition for LCLS-II cavities, we applied plasma processing to 1.3 GHz cavities starting with a clean nitrogen doped cavity and proceeding with studying natural field emission and artificially contaminated cavities. All the cavities were cold tested before and after plasma cleaning in order to compare their performances. It was proved that this technique successfully removes carbon-based contamination from the cavity iris and that it is able to eliminate field emission in a naturally field emitting cavity. The effect of plasma processing on cavities exposed to vacuum failures was also investigated, showing positive results in some cases. This work shows how successful plasma processing is in removing hydrocarbon related contamination from the cavity surface without affecting the high Q-factors and quench fields characteristic of nitrogen doped cavities.
- Open Access
- 10 July 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 126 (2) , 023302
Plasma ignition and detection for in-situ cleaning of 1.3 GHz 9-cell cavities
Superconducting radio frequency cavities performance preservation is crucial, from vertical test to accelerator operation. Field emission is still one of the performance limiting factors to overcome, and plasma cleaning has been proven successful by the Spallation Neutron Source (SNS), in cleaning field emitters (hydrocarbon contaminants) and increasing the work function of Nb. The cleaning for Linac Coherent Light Source-II will follow the same plasma composition adopted at SNS, which allows in situ processing of cavities installed in cryomodules. A novel method for plasma ignition has been developed at the Fermi National Accelerator Laboratory: a plasma glow discharge is ignited using high order modes to overcome limitations imposed by the fundamental power coupler. The plasma can be easily ignited and tuned in each of the cavity cells using low radio frequency (RF) power, from 100 W to as low as 2 W depending on the gas and pressure. A method for RF plasma detection has been developed: the plasma location is identified within the cavity without the need of cameras. The presented method can be applied to other multicell cavity designs, even for accelerators where the coupling for the fundamental modes at room temperature is very weak.
- 10 July 2019
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 126 (2) , 023302
Open AccessPlasma ignition and detection for in-situ cleaning of 1.3 GHz 9-cell cavities
Superconducting radio frequency cavities performance preservation is crucial, from vertical test to accelerator operation. Field emission is still one of the performance limiting factors to overcome, and plasma cleaning has been proven successful by the Spallation Neutron Source (SNS), in cleaning field emitters (hydrocarbon contaminants) and increasing the work function of Nb. The cleaning for Linac Coherent Light Source-II will follow the same plasma composition adopted at SNS, which allows in situ processing of cavities installed in cryomodules. A novel method for plasma ignition has been developed at the Fermi National Accelerator Laboratory: a plasma glow discharge is ignited using high order modes to overcome limitations imposed by the fundamental power coupler. The plasma can be easily ignited and tuned in each of the cavity cells using low radio frequency (RF) power, from 100 W to as low as 2 W depending on the gas and pressure. A method for RF plasma detection has been developed: the plasma location is identified within the cavity without the need of cameras. The presented method can be applied to other multicell cavity designs, even for accelerators where the coupling for the fundamental modes at room temperature is very weak.
- 1 August 2017
- Published by Office of Scientific and Technical Information (OSTI)
Proton PowerUpgrade Conceptual Design Report
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 August 2017
- Published by Office of Scientific and Technical Information (OSTI)
Proton PowerUpgrade Conceptual Design Report
The U.S. Department of Energy's Office of Scientific and Technical Information
- 27 December 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (24) , 243301
Ignition and monitoring technique for plasma processing of multicell superconducting radio-frequency cavities
An in-situ plasma processing technique has been developed at the Spallation Neutron Source (SNS) to improve the performance of the superconducting radio-frequency (SRF) cavities in operation. The technique uses a low-density reactive neon-oxygen plasma at room-temperature to improve the surface work function, to help remove adsorbed gases on the RF surface, and to reduce its secondary emission yield. SNS SRF cavities have six accelerating cells and the plasma typically ignites in the cell where the electric field is the highest. This article details the technique to ignite and monitor the plasma in each cell of the SNS cavities.
- 27 December 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 120 (24) , 243301
Ignition and monitoring technique for plasma processing of multicell superconducting radio-frequency cavities
An in-situ plasma processing technique has been developed at the Spallation Neutron Source (SNS) to improve the performance of the superconducting radio-frequency (SRF) cavities in operation. The technique uses a low-density reactive neon-oxygen plasma at room-temperature to improve the surface work function, to help remove adsorbed gases on the RF surface, and to reduce its secondary emission yield. SNS SRF cavities have six accelerating cells and the plasma typically ignites in the cell where the electric field is the highest. This article details the technique to ignite and monitor the plasma in each cell of the SNS cavities.
- 1 April 2016
- Published by Elsevier in Applied Surface Science
- Vol. 369, 29-35
Improving the work function of the niobium surface of SRF cavities by plasma processing
- 1 April 2016
- Published by Elsevier in Applied Surface Science
- Vol. 369, 29-35
Improving the work function of the niobium surface of SRF cavities by plasma processing
- Open Access
- 18 December 2015
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 101 (1) , 012021
Commissioning and operation of the horizontal test apparatus at SNS
The Spallation Neutron Source (SNS) at Oak Ridge National Lab (ORNL) has built, commissioned and operated a Horizontal Test Apparatus (HTA) vessel in the Radiofrequency Test Facility (RFTF) test cave. It can be operated at 4.5 K using the independent Cryogenic Test Facility (CTF). The HTA is designed to be a single cavity version of an SNS cryomodule with the ability to demount and replace the cavity. It provides the functionality for testing a single dressed SNS medium or high beta Superconducting Radiofrequency (SRF) cavity. The HTA is currently being used in support of R&D for in-situ plasma processing of the cavity's inner niobium surface. The design and commissioning of the HTA at 4.5 K will be presented as well as results from operating the HTA including cool-down, warm-up and steady state operations. Results from plasma processing a warm SCRF cavity in-between cold HTA tests will also be reported.
- 18 December 2015
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 101 (1) , 012021
Open AccessCommissioning and operation of the horizontal test apparatus at SNS
The Spallation Neutron Source (SNS) at Oak Ridge National Lab (ORNL) has built, commissioned and operated a Horizontal Test Apparatus (HTA) vessel in the Radiofrequency Test Facility (RFTF) test cave. It can be operated at 4.5 K using the independent Cryogenic Test Facility (CTF). The HTA is designed to be a single cavity version of an SNS cryomodule with the ability to demount and replace the cavity. It provides the functionality for testing a single dressed SNS medium or high beta Superconducting Radiofrequency (SRF) cavity. The HTA is currently being used in support of R&D for in-situ plasma processing of the cavity's inner niobium surface. The design and commissioning of the HTA at 4.5 K will be presented as well as results from operating the HTA including cool-down, warm-up and steady state operations. Results from plasma processing a warm SCRF cavity in-between cold HTA tests will also be reported.