Tadesse Weldu Teklu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tadesse Weldu Teklu has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ali M. AlSumaiti
Abu Dhabi National Oil Company (ADNOC)
2 shared publications - Hossein Kazemi
LiFi Research and Development Center (LRDC), Electrical Engineering Division, Department of Engineering, University of Cambridge, Cambridge, U.K.
2 shared publications Ramona M. Graves
Colorado School of Mines
2 shared publications- Waleed Alameri
Research and Innovation Center on CO2 and Hydrogen (RICH), Department of Chemical and Petroleum Engineering, Khalifa University of Science & Technology
2 shared publications Hazim H. Abass
1 shared publicationJuan Carlos Carratu
1 shared publication
Latest Publications
- 1 September 2017
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 45, 706-725
Experimental investigation of acid imbibition on matrix and fractured carbonate rich shales
- 1 September 2017
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 45, 706-725
Experimental investigation of acid imbibition on matrix and fractured carbonate rich shales
- 27 April 2015
- Published by Society of Petroleum Engineers (SPE)
Experimental and Numerical Modeling of Low-Salinity Waterflood in a Low Permeability Carbonate Reservoir
Low-salinity waterflooding in carbonate reservoirs is of great interest because of the potential for increased recovery of oil. However, the exact mechanism of low-salinity oil recovery is not well understood. It has been suggested that the main mechanism is wettability alteration resulting from the interaction of Na+, Cl-, Ca2+, Mg2+, SO42-, and RCOO- in the electrical double layer (EDL) near the surface of carbonate pores. In this paper, we present laboratory experiments and numerical modeling in low-permeability carbonate cores to assess this assertion. Seawater followed by series of low-salinity waterflood experiments were performed on several facies of carbonate reservoir. The permeability of the cores is in the range of 0.5 to 1.5 mD and porosity is from 0.18 to 0.25. Cores were aged for eight weeks at reservoir pressure and temperature. The API gravity of the oil is 32°. The IFT and contact angle measurements were performed at several brine salinities. A two phase numerical model was used to simulate oil recovery and molecular transport of salt components to investigate the wettability alteration effect. The low-salinity waterflood experiments yielded incremental oil recovery of up to nine percent. Low-salinity waterflood was observed to be more significant in less-heterogeneous and less-vuggy cores. Moreover, low-salinity waterflood altered the wettability of several one-inch diameter, crude-aged, carbonate core discs from oil-wet to intermediate-wet. Hence, the main mechanism of incremental oil recovery during low-salinity waterflood in this carbonate reservoir is wettability alteration. The mathematical model matched the oil recovery when the relative permeability functions were adjusted to account for wettability alteration effects.
- 27 April 2015
- Published by Society of Petroleum Engineers (SPE)
Experimental and Numerical Modeling of Low-Salinity Waterflood in a Low Permeability Carbonate Reservoir
Low-salinity waterflooding in carbonate reservoirs is of great interest because of the potential for increased recovery of oil. However, the exact mechanism of low-salinity oil recovery is not well understood. It has been suggested that the main mechanism is wettability alteration resulting from the interaction of Na+, Cl-, Ca2+, Mg2+, SO42-, and RCOO- in the electrical double layer (EDL) near the surface of carbonate pores. In this paper, we present laboratory experiments and numerical modeling in low-permeability carbonate cores to assess this assertion. Seawater followed by series of low-salinity waterflood experiments were performed on several facies of carbonate reservoir. The permeability of the cores is in the range of 0.5 to 1.5 mD and porosity is from 0.18 to 0.25. Cores were aged for eight weeks at reservoir pressure and temperature. The API gravity of the oil is 32°. The IFT and contact angle measurements were performed at several brine salinities. A two phase numerical model was used to simulate oil recovery and molecular transport of salt components to investigate the wettability alteration effect. The low-salinity waterflood experiments yielded incremental oil recovery of up to nine percent. Low-salinity waterflood was observed to be more significant in less-heterogeneous and less-vuggy cores. Moreover, low-salinity waterflood altered the wettability of several one-inch diameter, crude-aged, carbonate core discs from oil-wet to intermediate-wet. Hence, the main mechanism of incremental oil recovery during low-salinity waterflood in this carbonate reservoir is wettability alteration. The mathematical model matched the oil recovery when the relative permeability functions were adjusted to account for wettability alteration effects.
- 10 November 2014
- Published by Society of Petroleum Engineers (SPE)
Low-salinity Water-alternating-CO2 Flooding Enhanced Oil Recovery: Theory and Experiments
Carbon dioxide flooding is currently the most technically and economically viable enhanced oil recovery (EOR) process in carbonate and sandstone reservoirs. Low-salinity waterflood is a relatively new EOR process; and our experiments in carbonate cores show significant oil recovery improvements. We propose a new EOR process to improve economics, which involves low-salinity water-alternating-CO2 (LS-WAG) injection. To evaluate the proposed idea, three core floods and several contact angle and IFT measurements were performed. The core floods include: seawater flood, followed by low-salinity waterflood, followed by CO2 injection, which yielded fourteen, twenty-five, and thirty-eight percent additional oil recovery by CO2 from two carbonate and one sandstone experiments. We performed contact angle measurements on several low-permeability carbonate, medium-permeability Berea sandstone, and ultra-low permeability Three Forks mudstone core discs using different salinities. The contact angle measurements confirmed that favorable wettability alteration is achievable with the proposed EOR process. In addition, visual observations suggested that the proposed EOR process could be effective for cleaning the matrix-fracture interface in conventional and unconventional reservoirs. IFT measurments and modeling relevant to the EOR process is also included in this study. Low-salinity waterflood EOR Waterflooding is by far the most widely used method to increase oil recovery. Recent studies show that, by modifying the ionic content of water, wettability of reservoirs can be altered. When using seawater to alter wettability, there are different chemical mechanisms in effect between sandstone and carbonate formations. The polar components in the crude oil reacts with the positively charged carbonate rock surface differently from the negatively charged quartz/clay in sandstone formations, indicating different chemical bonding reaction mechanisms. In general, wettability alteration can be improved by modifying the ionic composition of the injected sea water (RezaeiDoust et al., 2009; Austad et al., 2010; Zekri et al., 2012; Al-Harrasi et al., 2012; Nasralla et al., 2013; Alameri et al., 2014a; Awolayo et al., 2014). Alameri et al. (2014a) through contact angle measurements and core flood experiments on carbonate cores showed improved oil recovery attributed to wettability alteration. Similar contact angle measurement and core flood experiments by Nasralla et al. (2011) showed oil-recovery improvement on sandstone cores. Study by Zekri et al. (2012) reported contact angle change with low-salinity brine, both on limestone and sandstone cores. Several brine injection concentrations were used in the experiment to examine the effect of salinity in oil recovery by varying sulfate concentrations. The study concluded that wettability alteration is the main mechanism to increase recovery by low-salinity water flooding. CO2 Flooding EOR Hydrocarbon and non-hydrocarbon gas injection in general, and CO2 floods in particular, is the leading EOR flooding process in light-oil and medium-oil, both in sandstone and carbonate reservoirs (Stalkup, 1978; Holm, 1987; Manrique et al., 2007; Ghedan 2009; Alvarado and Manrique 2010; OGJ 2014). Mostly from Permian basin, by the start of 2014, 300 M bbl/day of oil is produced by CO2-EOR in USA and is forecasted to grow to 638 M bbl/day by 2020 (Kuuskraa and Wallace 2014; OGJ 2014). Current utilization factor in mature USA CO2-EOR projects range from 5 to 15 Mcf of CO2 injected/bbl of oil produced (DOE/NETL 2014).
- 10 November 2014
- Published by Society of Petroleum Engineers (SPE)
Low-salinity Water-alternating-CO2 Flooding Enhanced Oil Recovery: Theory and Experiments
Carbon dioxide flooding is currently the most technically and economically viable enhanced oil recovery (EOR) process in carbonate and sandstone reservoirs. Low-salinity waterflood is a relatively new EOR process; and our experiments in carbonate cores show significant oil recovery improvements. We propose a new EOR process to improve economics, which involves low-salinity water-alternating-CO2 (LS-WAG) injection. To evaluate the proposed idea, three core floods and several contact angle and IFT measurements were performed. The core floods include: seawater flood, followed by low-salinity waterflood, followed by CO2 injection, which yielded fourteen, twenty-five, and thirty-eight percent additional oil recovery by CO2 from two carbonate and one sandstone experiments. We performed contact angle measurements on several low-permeability carbonate, medium-permeability Berea sandstone, and ultra-low permeability Three Forks mudstone core discs using different salinities. The contact angle measurements confirmed that favorable wettability alteration is achievable with the proposed EOR process. In addition, visual observations suggested that the proposed EOR process could be effective for cleaning the matrix-fracture interface in conventional and unconventional reservoirs. IFT measurments and modeling relevant to the EOR process is also included in this study. Low-salinity waterflood EOR Waterflooding is by far the most widely used method to increase oil recovery. Recent studies show that, by modifying the ionic content of water, wettability of reservoirs can be altered. When using seawater to alter wettability, there are different chemical mechanisms in effect between sandstone and carbonate formations. The polar components in the crude oil reacts with the positively charged carbonate rock surface differently from the negatively charged quartz/clay in sandstone formations, indicating different chemical bonding reaction mechanisms. In general, wettability alteration can be improved by modifying the ionic composition of the injected sea water (RezaeiDoust et al., 2009; Austad et al., 2010; Zekri et al., 2012; Al-Harrasi et al., 2012; Nasralla et al., 2013; Alameri et al., 2014a; Awolayo et al., 2014). Alameri et al. (2014a) through contact angle measurements and core flood experiments on carbonate cores showed improved oil recovery attributed to wettability alteration. Similar contact angle measurement and core flood experiments by Nasralla et al. (2011) showed oil-recovery improvement on sandstone cores. Study by Zekri et al. (2012) reported contact angle change with low-salinity brine, both on limestone and sandstone cores. Several brine injection concentrations were used in the experiment to examine the effect of salinity in oil recovery by varying sulfate concentrations. The study concluded that wettability alteration is the main mechanism to increase recovery by low-salinity water flooding. CO2 Flooding EOR Hydrocarbon and non-hydrocarbon gas injection in general, and CO2 floods in particular, is the leading EOR flooding process in light-oil and medium-oil, both in sandstone and carbonate reservoirs (Stalkup, 1978; Holm, 1987; Manrique et al., 2007; Ghedan 2009; Alvarado and Manrique 2010; OGJ 2014). Mostly from Permian basin, by the start of 2014, 300 M bbl/day of oil is produced by CO2-EOR in USA and is forecasted to grow to 638 M bbl/day by 2020 (Kuuskraa and Wallace 2014; OGJ 2014). Current utilization factor in mature USA CO2-EOR projects range from 5 to 15 Mcf of CO2 injected/bbl of oil produced (DOE/NETL 2014).