Clovis Pouant
Research Subjects
Research Interests
Clovis Pouant has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Patrick Hoffmann
CEA-Gramat
2 shared publications - Alain Reineix
XLIM, Centre National de la Recherche Scientifique, Limoges, France
1 shared publication - Francois Torres
XLIM Research Institute, UMR 7252, CNRS, University of Limoges, Limoges, France
1 shared publication - Gerjan J. M. Hagelaar
LAPLACE, Université de Toulouse, CNRS, INPT, UPS , Toulouse
1 shared publication - Jeremy Raoult
J. Raoult and L. Chusseau are with the University of Montpellier, Centre National de la Recherche Scientifique, Institut d'Électronique et des Systèmes, UMR5214, F-34097 Montpellier, France;
1 shared publication - Laurent Chusseau
IES, Université de Montpellier, CNRS, Montpellier, France
1 shared publication
Latest Publications
- 1 September 2026
- Published by IOP Publishing in Plasma Sources Science and Technology
- Vol. 35 (9) , 095003
Plasma-based microwave power limiter in a printed transmission line: an overview of the physics of leakage power
The physics underlying the leakage power of a plasma-based microwave power limiter in a printed transmission line is theoretically and numerically explored. An analytical expression for the leakage power is proposed, based on a local energy balance between the microwave power dissipated in the plasma discharge and losses due to collisions and diffusion towards the walls. This model is validated through comparison with self-consistent microwave–plasma interaction simulations and provides a physical explanation for the experimental constancy of leakage power with respect to moderate incident powers. A detailed analysis of leakage behaviour under varying operational conditions is presented. The study shows that the leakage power reaches a minimum at an optimal gas pressure between 5 and 10 Torr, following a dependence analogous to Paschen’s law. The effect of cavity length on the leakage power is also explored. When the plasma column extends to the boundary at the end of the cavity, the microwave power that is not dissipated in the discharge leaks out of the limiter, resulting in increased output power as the incident power increases. An analytical expression for the plasma column length is derived, demonstrating a logarithmic dependence on the incident power, consistent with numerical observations. This trend supports the feasibility of limiters handling high-power microwave threats using compact cavity designs. Finally, the influence of the dielectric substrate thickness is addressed. Increasing this thickness leads to higher leakage power and longer plasma columns. Conversely, reducing the dielectric thickness is an effective way to decrease the leakage power and minimize the overall size of the limiter. Overall, good agreement is observed between the theoretical frameworks, simulation results and experimental measurements.
- 1 September 2026
- Published by IOP Publishing in Plasma Sources Science and Technology
- Vol. 35 (9) , 095003
Plasma-based microwave power limiter in a printed transmission line: an overview of the physics of leakage power
The physics underlying the leakage power of a plasma-based microwave power limiter in a printed transmission line is theoretically and numerically explored. An analytical expression for the leakage power is proposed, based on a local energy balance between the microwave power dissipated in the plasma discharge and losses due to collisions and diffusion towards the walls. This model is validated through comparison with self-consistent microwave–plasma interaction simulations and provides a physical explanation for the experimental constancy of leakage power with respect to moderate incident powers. A detailed analysis of leakage behaviour under varying operational conditions is presented. The study shows that the leakage power reaches a minimum at an optimal gas pressure between 5 and 10 Torr, following a dependence analogous to Paschen’s law. The effect of cavity length on the leakage power is also explored. When the plasma column extends to the boundary at the end of the cavity, the microwave power that is not dissipated in the discharge leaks out of the limiter, resulting in increased output power as the incident power increases. An analytical expression for the plasma column length is derived, demonstrating a logarithmic dependence on the incident power, consistent with numerical observations. This trend supports the feasibility of limiters handling high-power microwave threats using compact cavity designs. Finally, the influence of the dielectric substrate thickness is addressed. Increasing this thickness leads to higher leakage power and longer plasma columns. Conversely, reducing the dielectric thickness is an effective way to decrease the leakage power and minimize the overall size of the limiter. Overall, good agreement is observed between the theoretical frameworks, simulation results and experimental measurements.
- 15 January 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 61 (1) , 111-120
Modeling and Analysis of Large-Signal RFI Effects in MOS Transistors
The ability of radio-frequency (RF) interference signals to upset or disrupt electronic equipment is a matter of concern, and identification of the physical mechanisms leading to device malfunction is of prime importance. This paper presents experimental and theoretical results and analyzes the effects of a large-signal microwave excitation up to 2 GHz on several commercial small-signal MOS transistors. For frequencies beyond the maximum operating frequency, experimental results show RF signal rectification in the devices, and these results are confirmed by SPICE simulations using extracted models for the transistors, including package and test circuit parasitics, with excellent agreement with experiments. Analysis of internal transistors currents and voltages finally leads to the conclusion that the observed rectification effect is not due to active nonlinearities of the devices, but rather due to the nonlinear overlap and parasitic drain–bulk diode capacitances of the MOS transistors. In particular, the role of the nonlinear voltage dependence of the junction capacitance is highlighted. Finally, a simplified model is proposed to reproduce this behavior.
- 15 January 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 61 (1) , 111-120
Modeling and Analysis of Large-Signal RFI Effects in MOS Transistors
The ability of radio-frequency (RF) interference signals to upset or disrupt electronic equipment is a matter of concern, and identification of the physical mechanisms leading to device malfunction is of prime importance. This paper presents experimental and theoretical results and analyzes the effects of a large-signal microwave excitation up to 2 GHz on several commercial small-signal MOS transistors. For frequencies beyond the maximum operating frequency, experimental results show RF signal rectification in the devices, and these results are confirmed by SPICE simulations using extracted models for the transistors, including package and test circuit parasitics, with excellent agreement with experiments. Analysis of internal transistors currents and voltages finally leads to the conclusion that the observed rectification effect is not due to active nonlinearities of the devices, but rather due to the nonlinear overlap and parasitic drain–bulk diode capacitances of the MOS transistors. In particular, the role of the nonlinear voltage dependence of the junction capacitance is highlighted. Finally, a simplified model is proposed to reproduce this behavior.