Olesia Kostyrka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Olesia Kostyrka has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Tetiana Kostenko
National University of Civil Protection of Ukraine
5 shared publications - Viktor Kostenko
Donetsk National Technical University
4 shared publications Cherkasy Institute of Fire Safety named after Chornobyl Heroes of National University of Civil Defense of Ukraine
2 shared publications- Maryna Tavrel
Technical University “Metinvest Polytechnic” LLC
2 shared publications - Olena Borsuk
National University of Civil Defense of Ukraine
2 shared publications - Olena Zavialova2 shared publications
Latest Publications
- 13 April 2026
- Published by National University of Civil Protection of Ukraine in Problems of Emergency Situations
- p. 214
Study of fire hazards in electrical connections of various types
Studies have been conducted to determine the temperature of electric lamps of various types in emergency modes of operation of power grids, namely overvoltage. Graphs of the dependence of the temperature of the bulb of incandescent lamps, arc mercury lamps and LED lamps on the voltage applied to them. Mathematical models of the value of the heating temperature of the bulb of the electric incandescent lamp, the arc mercury lamp and the LED lamp are obtained depending on the time. It is determined that the temperature of the bulb of the incandescent electric lamp increases exponentially and stabilizes after about 300 seconds. The temperature of an arc mercury lamp also varies exponentially, but, compared to an incandescent lamp, it is not so fast, but stabilizes after about 600 seconds. It is determined that in emergency modes of operation, the temperature of incandescent lamps and arc mercury lamps may exceed the normative values of temperature groups, as a result of which, when used in environments where explosive gases or vapors are present, they can become a source of ignition and lead to explosion or ignition of these substances. It is determined that the temperature of the LED lamp changes according to the linear law and after 300 seconds stops growing. Temperature dependencies of different elements of the LED lamp are built depending on the electric voltage applied to it. It was found that the driver, namely the power control chip, heats up most when the LED electric lamp is operating. It is determined that when the electric voltage decreases, the power control chip heats up more, but not significantly. It was found that the LED lamp is the best from the point of view of fire safety, since it has the lowest temperature, and also the change in the voltage of the electrical network reacts the least, which is explained by its design and principle of operation.
- 13 April 2026
- Published by National University of Civil Protection of Ukraine in Problems of Emergency Situations
- p. 214
Study of fire hazards in electrical connections of various types
Studies have been conducted to determine the temperature of electric lamps of various types in emergency modes of operation of power grids, namely overvoltage. Graphs of the dependence of the temperature of the bulb of incandescent lamps, arc mercury lamps and LED lamps on the voltage applied to them. Mathematical models of the value of the heating temperature of the bulb of the electric incandescent lamp, the arc mercury lamp and the LED lamp are obtained depending on the time. It is determined that the temperature of the bulb of the incandescent electric lamp increases exponentially and stabilizes after about 300 seconds. The temperature of an arc mercury lamp also varies exponentially, but, compared to an incandescent lamp, it is not so fast, but stabilizes after about 600 seconds. It is determined that in emergency modes of operation, the temperature of incandescent lamps and arc mercury lamps may exceed the normative values of temperature groups, as a result of which, when used in environments where explosive gases or vapors are present, they can become a source of ignition and lead to explosion or ignition of these substances. It is determined that the temperature of the LED lamp changes according to the linear law and after 300 seconds stops growing. Temperature dependencies of different elements of the LED lamp are built depending on the electric voltage applied to it. It was found that the driver, namely the power control chip, heats up most when the LED electric lamp is operating. It is determined that when the electric voltage decreases, the power control chip heats up more, but not significantly. It was found that the LED lamp is the best from the point of view of fire safety, since it has the lowest temperature, and also the change in the voltage of the electrical network reacts the least, which is explained by its design and principle of operation.
- 27 May 2025
- Published by National University of Civil Protection of Ukraine in Problems of Emergency Situations
- No. 41,p. 74-87
Determination of various types electric lamps parameters in emergency modes of operation
Studies have been conducted to determine the temperature of electric lamps of various types in emergency modes of operation of power grids, namely overvoltage. Graphs of the dependence of the temperature of the bulb of incandescent lamps, arc mercury lamps and LED lamps on the voltage applied to them. Mathematical models of the value of the heating temperature of the bulb of the electric incandescent lamp, the arc mercury lamp and the LED lamp are obtained depending on the time. It is determined that the temperature of the bulb of the incandescent electric lamp increases exponentially and stabilizes after about 300 seconds. The temperature of an arc mercury lamp also varies exponentially, but, compared to an incandescent lamp, it is not so fast, but stabilizes after about 600 seconds. It is determined that in emergency modes of operation, the temperature of incandescent lamps and arc mercury lamps may exceed the normative values of temperature groups, as a result of which, when used in environments where explosive gases or vapors are present, they can become a source of ignition and lead to explosion or ignition of these substances. It is determined that the temperature of the LED lamp changes according to the linear law and after 300 seconds stops growing. Temperature dependencies of different elements of the LED lamp are built depending on the electric voltage applied to it. It was found that the driver, namely the power control chip, heats up most when the LED electric lamp is operating. It is determined that when the electric voltage decreases, the power control chip heats up more, but not significantly. It was found that the LED lamp is the best from the point of view of fire safety, since it has the lowest temperature, and also the change in the voltage of the electrical network reacts the least, which is explained by its design and principle of operation.
- 27 May 2025
- Published by National University of Civil Protection of Ukraine in Problems of Emergency Situations
- No. 41,p. 74-87
Determination of various types electric lamps parameters in emergency modes of operation
Studies have been conducted to determine the temperature of electric lamps of various types in emergency modes of operation of power grids, namely overvoltage. Graphs of the dependence of the temperature of the bulb of incandescent lamps, arc mercury lamps and LED lamps on the voltage applied to them. Mathematical models of the value of the heating temperature of the bulb of the electric incandescent lamp, the arc mercury lamp and the LED lamp are obtained depending on the time. It is determined that the temperature of the bulb of the incandescent electric lamp increases exponentially and stabilizes after about 300 seconds. The temperature of an arc mercury lamp also varies exponentially, but, compared to an incandescent lamp, it is not so fast, but stabilizes after about 600 seconds. It is determined that in emergency modes of operation, the temperature of incandescent lamps and arc mercury lamps may exceed the normative values of temperature groups, as a result of which, when used in environments where explosive gases or vapors are present, they can become a source of ignition and lead to explosion or ignition of these substances. It is determined that the temperature of the LED lamp changes according to the linear law and after 300 seconds stops growing. Temperature dependencies of different elements of the LED lamp are built depending on the electric voltage applied to it. It was found that the driver, namely the power control chip, heats up most when the LED electric lamp is operating. It is determined that when the electric voltage decreases, the power control chip heats up more, but not significantly. It was found that the LED lamp is the best from the point of view of fire safety, since it has the lowest temperature, and also the change in the voltage of the electrical network reacts the least, which is explained by its design and principle of operation.
- Open Access
- 1 June 2023
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 24 (4) , 79-87
Studying the Effect of Mineral Fertilizers on the Development of the Eutrophication Process in the Water Bodies
The article is devoted to the disclosure of the effect on the vital activity of cyanobacteria by changes in the nutrients in the chemical composition of artificial aquatic biotopes. The research results allowed us to establish that the dissolution of complex mineral fertilizer (nitrogen,...
- 1 June 2023
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 24 (4) , 79-87
Open AccessStudying the Effect of Mineral Fertilizers on the Development of the Eutrophication Process in the Water Bodies
The article is devoted to the disclosure of the effect on the vital activity of cyanobacteria by changes in the nutrients in the chemical composition of artificial aquatic biotopes. The research results allowed us to establish that the dissolution of complex mineral fertilizer (nitrogen,...
- Open Access
- 1 May 2022
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 23 (3) , 184-192
Experimental Testing of Water Body Aeration Airlift Technology
The article is devoted to substantiation of parameters of water body aeration technology at high, as well as low, air temperatures. As a result of studies, the design of the water aerator based on a two-stage airlift has been improved. A study of its physical model has been conducted. The cost...
- 1 May 2022
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 23 (3) , 184-192
Open AccessExperimental Testing of Water Body Aeration Airlift Technology
The article is devoted to substantiation of parameters of water body aeration technology at high, as well as low, air temperatures. As a result of studies, the design of the water aerator based on a two-stage airlift has been improved. A study of its physical model has been conducted. The cost...
- Open Access
- 1 November 2021
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 22 (6) , 122-130
Pilot Tests of a Hybrid Solar Installation
The article is devoted to the study of the efficiency of the structural elements of the solar collector in cloudy conditions with the stabilization of heat transfer due to the use of terrestrial radiation. The study involves experimental verification of theoretically obtained assumptions about...
- 1 November 2021
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 22 (6) , 122-130
Open AccessPilot Tests of a Hybrid Solar Installation
The article is devoted to the study of the efficiency of the structural elements of the solar collector in cloudy conditions with the stabilization of heat transfer due to the use of terrestrial radiation. The study involves experimental verification of theoretically obtained assumptions about...
- Open Access
- 30 March 2019
- Published by Dnipro University of Technology in Mining of Mineral Deposits
- Vol. 13 (1) , 86-94
Applying European approach to predict coal self-heating in Ukrainian mines
- 30 March 2019
- Published by Dnipro University of Technology in Mining of Mineral Deposits
- Vol. 13 (1) , 86-94
Open AccessApplying European approach to predict coal self-heating in Ukrainian mines
- 1 January 2018
- Published by Donetsk National Technical University in JOURNAL of Donetsk mining institute
- No. 1
SUGGESTIONS TO IMPROVING THE THERMAL CONDITION IN THE UNDER CLOTHES SPACE OF RESCUER
Sorry, this entry is only available in Ukrainian. For the sake of viewer convenience, the content is shown below in the alternative language. You may click the
- 1 January 2018
- Published by Donetsk National Technical University in JOURNAL of Donetsk mining institute
- No. 1
SUGGESTIONS TO IMPROVING THE THERMAL CONDITION IN THE UNDER CLOTHES SPACE OF RESCUER
Sorry, this entry is only available in Ukrainian. For the sake of viewer convenience, the content is shown below in the alternative language. You may click the