Man-Rong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Man-Rong Li has a total of 466 co-authors. Here are the top co-authors by number of shared publications:
- Martha Greenblatt
Rutgers University
32 shared publications Mark Croft
Department of Physics and Astronomy, Rutgers, The State University of New Jersey, Piscataway, New Jersey 08854, United States
27 shared publicationsDavid Walker
Lamont Doherty Earth Observatory, Columbia University 3 , Palisades, New York 10964
24 shared publications- Maria Retuerto
Department of Chemistry and Chemical Biology, Rutgers, The State University of New Jersey, 610 Taylor Road, Piscataway, New Jersey 08854, United States
21 shared publications Zheng Deng
Institute of Physics, Chinese Academy of Sciences
21 shared publications- Yifeng Han
School of Molecular Sciences, Center for Materials of the Universe, Arizona State University, Tempe, Arizona 85287, United States
19 shared publications
Latest Publications
- 3 August 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 263
ZIF-67 derived SrRuO3@Co3S4 core-shell heterostructure for efficient electrocatalytic hydrogen evolution
- 3 August 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 263
ZIF-67 derived SrRuO3@Co3S4 core-shell heterostructure for efficient electrocatalytic hydrogen evolution
- 24 July 2026
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 38 (15) , 7990-7999
Giant Magnetocrystalline Anisotropy and Coercivity in Honeycomb Iridate NiIrO3
The exploration of emergent quantum phases driven by the interplay of spin–orbit coupling (SOC) and electronic correlation remains a central theme in materials science and solid chemistry. Herein, we report the topotactic synthesis and physical properties of NiIrO3, the first honeycomb iridate to incorporate 3d magnetic ions into the interlayer lattice. Structural investigations reveal an ilmenite-type R-3 structure, featuring alternating edge-sharing NiO6 and IrO6 honeycomb layers connected via unusually short face-sharing Ni–Ir dimers. Unlike the low-temperature antiferromagnetic states typical of conventional honeycomb iridates, NiIrO3 exhibits robust long-range ferrimagnetic order below a remarkably high transition temperature of 213 K, accompanied by a spontaneous positive magnetoresistance. Most strikingly, the synergistic interplay among the strong SOC of 5d Ir4+ ions, severe structural distortions, and intense 3d-5d orbital hybridization breaks local symmetries, driving an exceptionally large uniaxial magnetocrystalline anisotropy energy of 32.2 meV/f.u. This extreme Ising-like anisotropy underpins a record-breaking giant coercive field exceeding 17.3 T at 4.2 K. This work not only establishes topotactic chemistry as a powerful tool for engineering 3d–5d orbital hybridizations but also positions NiIrO3 as a compelling material platform for developing high-density magnetic memory and low-power spintronic devices.
- 24 July 2026
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 38 (15) , 7990-7999
Giant Magnetocrystalline Anisotropy and Coercivity in Honeycomb Iridate NiIrO3
The exploration of emergent quantum phases driven by the interplay of spin–orbit coupling (SOC) and electronic correlation remains a central theme in materials science and solid chemistry. Herein, we report the topotactic synthesis and physical properties of NiIrO3, the first honeycomb iridate to incorporate 3d magnetic ions into the interlayer lattice. Structural investigations reveal an ilmenite-type R-3 structure, featuring alternating edge-sharing NiO6 and IrO6 honeycomb layers connected via unusually short face-sharing Ni–Ir dimers. Unlike the low-temperature antiferromagnetic states typical of conventional honeycomb iridates, NiIrO3 exhibits robust long-range ferrimagnetic order below a remarkably high transition temperature of 213 K, accompanied by a spontaneous positive magnetoresistance. Most strikingly, the synergistic interplay among the strong SOC of 5d Ir4+ ions, severe structural distortions, and intense 3d-5d orbital hybridization breaks local symmetries, driving an exceptionally large uniaxial magnetocrystalline anisotropy energy of 32.2 meV/f.u. This extreme Ising-like anisotropy underpins a record-breaking giant coercive field exceeding 17.3 T at 4.2 K. This work not only establishes topotactic chemistry as a powerful tool for engineering 3d–5d orbital hybridizations but also positions NiIrO3 as a compelling material platform for developing high-density magnetic memory and low-power spintronic devices.
- Open Access
- 29 April 2026
- Published by Springer Nature in npj Computational Materials
- Vol. 12 (1)
Rational synthesis of a new Haldane chain compound by predicted pressure-induced phase modification
- 29 April 2026
- Published by Springer Nature in npj Computational Materials
- Vol. 12 (1)
Open AccessRational synthesis of a new Haldane chain compound by predicted pressure-induced phase modification
- 25 April 2026
- Published by Elsevier in Chinese Journal of Structural Chemistry
- Vol. 45 (9)
Modification of structure and electrical properties of antiperovskite Ni3FeN under high pressure
- 25 April 2026
- Published by Elsevier in Chinese Journal of Structural Chemistry
- Vol. 45 (9)
Modification of structure and electrical properties of antiperovskite Ni3FeN under high pressure
- 18 March 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (12) , 13309-13316
3D Unconventional Superconductivity in Bulk LaO
Lanthanum-based compounds are cornerstones of superconductivity research, yet the La 5d orbitals typically remain empty spectator states far above the Fermi level (EF). While superconductivity has been induced in LaO up to 5.37 K in tensile epitaxy films, the intrinsic ground state of the bulk phase has remained controversial mostly due to synthetic challenges, with early reports suggesting a metallic nature. Here we report the high-pressure and high-temperature synthesis of pure bulk rock-salt LaO and unveil its intrinsic type-II superconductivity with a transition temperature (TC) of ∼6 K at ambient pressure. The bulk TC is further enhanced to 6.9 K in La1-xYxO at x = 0.10, where Y doping leads to lattice contraction (chemical pressing) and a remarkable increase in electron carrier concentration. Strikingly, applying physical pressure further enhances the TC to a maximum of 12.7 K at 20 GPa, the highest TC in lanthanum monochalcogenides LaX (X = S, Se, Te, and O) to date. This pressure dependence is diametrically opposed to the behavior observed in films, and occurs despite a pressure-induced reduction in the density of states at EF─a trend that sharply contradicts the conventional phonon-mediated BCS mechanism. Our first-principles calculations reveal that compressive strain modifies the crystal field splitting to enhance La 5d/O 2p hybridization, fostering a three-dimensional multipocket Fermi surface favorable for spin/orbital fluctuation-mediated pairing. This work clarifies the intrinsic superconductivity of bulk LaO and provides a foundation for designing new rare-earth-based superconductors with higher TC.
- 18 March 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (12) , 13309-13316
3D Unconventional Superconductivity in Bulk LaO
Lanthanum-based compounds are cornerstones of superconductivity research, yet the La 5d orbitals typically remain empty spectator states far above the Fermi level (EF). While superconductivity has been induced in LaO up to 5.37 K in tensile epitaxy films, the intrinsic ground state of the bulk phase has remained controversial mostly due to synthetic challenges, with early reports suggesting a metallic nature. Here we report the high-pressure and high-temperature synthesis of pure bulk rock-salt LaO and unveil its intrinsic type-II superconductivity with a transition temperature (TC) of ∼6 K at ambient pressure. The bulk TC is further enhanced to 6.9 K in La1-xYxO at x = 0.10, where Y doping leads to lattice contraction (chemical pressing) and a remarkable increase in electron carrier concentration. Strikingly, applying physical pressure further enhances the TC to a maximum of 12.7 K at 20 GPa, the highest TC in lanthanum monochalcogenides LaX (X = S, Se, Te, and O) to date. This pressure dependence is diametrically opposed to the behavior observed in films, and occurs despite a pressure-induced reduction in the density of states at EF─a trend that sharply contradicts the conventional phonon-mediated BCS mechanism. Our first-principles calculations reveal that compressive strain modifies the crystal field splitting to enhance La 5d/O 2p hybridization, fostering a three-dimensional multipocket Fermi surface favorable for spin/orbital fluctuation-mediated pairing. This work clarifies the intrinsic superconductivity of bulk LaO and provides a foundation for designing new rare-earth-based superconductors with higher TC.
- Open Access
- 18 September 2025
- Published by AIP Publishing in Matter and Radiation at Extremes
- Vol. 10 (6)
Screening of TiB2-based ternary composites for X-ray transparent heaters in high-pressure and high-temperature experiments
High-pressure and high-temperature (HPHT) experiments in large-volume presses (LVPs) benefit from reliable, available, and affordable heaters to achieve stable and homogeneous heating and, in some circumstances, X-ray transparency for monitoring of properties of an in situ experiment using X-ray diffraction and contrast imaging techniques. We have developed heaters meeting the above requirements, and we screen the ternary system TiB2–SiC–hexagonal (h)BN (denoted as TSB) to enable manufacture of X-ray transparent heaters for HPHT runs. Heaters fabricated using optimized TSB-631 (60%TiB2–30%SiC–10%hBN by weight) have been tested in modified truncated assemblies, showing excellent performance up to 22 GPa and 2395 K in HPHT runs. TSB-631 has good ceramic machinability, outstanding reproducibility, high stability, and negligible temperature gradient for runs at 3–7 GPa with cell assemblies with truncated edge lengths of 8–12 mm. The fabricated heaters not only show excellent performance in HPHT runs, but also demonstrate high X-ray transparency over a wide X-ray wavelength region, indicating potential applications for in situ X-ray diffraction/imaging under HPHT conditions in LVPs and other high-pressure apparatus.
- 18 September 2025
- Published by AIP Publishing in Matter and Radiation at Extremes
- Vol. 10 (6)
Open AccessScreening of TiB2-based ternary composites for X-ray transparent heaters in high-pressure and high-temperature experiments
High-pressure and high-temperature (HPHT) experiments in large-volume presses (LVPs) benefit from reliable, available, and affordable heaters to achieve stable and homogeneous heating and, in some circumstances, X-ray transparency for monitoring of properties of an in situ experiment using X-ray diffraction and contrast imaging techniques. We have developed heaters meeting the above requirements, and we screen the ternary system TiB2–SiC–hexagonal (h)BN (denoted as TSB) to enable manufacture of X-ray transparent heaters for HPHT runs. Heaters fabricated using optimized TSB-631 (60%TiB2–30%SiC–10%hBN by weight) have been tested in modified truncated assemblies, showing excellent performance up to 22 GPa and 2395 K in HPHT runs. TSB-631 has good ceramic machinability, outstanding reproducibility, high stability, and negligible temperature gradient for runs at 3–7 GPa with cell assemblies with truncated edge lengths of 8–12 mm. The fabricated heaters not only show excellent performance in HPHT runs, but also demonstrate high X-ray transparency over a wide X-ray wavelength region, indicating potential applications for in situ X-ray diffraction/imaging under HPHT conditions in LVPs and other high-pressure apparatus.
- 2 September 2025
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 37 (18) , 7277-7286
Heuristic Engineering of Magnetic Mn4Ta2O9 Phases from High-Pressure and High-Temperature Synthesis
- 2 September 2025
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 37 (18) , 7277-7286
Heuristic Engineering of Magnetic Mn4Ta2O9 Phases from High-Pressure and High-Temperature Synthesis
- 11 July 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (35) , 18298-18304
A computational and Raman spectroscopic study of successive phase transitions in Co3TeO6 under high pressure and high temperature
A R3 to P21/n transition is predicted for Co3TeO6 under 16 GPa (FM) or 19 GPa (AFM), while ex situ XRD data show phase coexistence of R3 (72%) and P21/n (28%), which indicates a high energy barrier in the kinetic process of the phase transition.
- 11 July 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (35) , 18298-18304
A computational and Raman spectroscopic study of successive phase transitions in Co3TeO6 under high pressure and high temperature
A R3 to P21/n transition is predicted for Co3TeO6 under 16 GPa (FM) or 19 GPa (AFM), while ex situ XRD data show phase coexistence of R3 (72%) and P21/n (28%), which indicates a high energy barrier in the kinetic process of the phase transition.
- 6 March 2025
- Published by Elsevier in Chinese Chemical Letters
- Vol. 37 (6)
Designing oxide-ion conductor in superstructural barium tellurate
- 6 March 2025
- Published by Elsevier in Chinese Chemical Letters
- Vol. 37 (6)
Designing oxide-ion conductor in superstructural barium tellurate
- 13 September 2024
- Published by Elsevier in Chinese Journal of Structural Chemistry
- Vol. 44 (2)
Structural determination and exotic resistive behaviour of α-RuI3 under high-pressure
- 13 September 2024
- Published by Elsevier in Chinese Journal of Structural Chemistry
- Vol. 44 (2)
Structural determination and exotic resistive behaviour of α-RuI3 under high-pressure