OIOleksiy Iegorov

Oleksiy Iegorov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Oleksiy Iegorov has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Determining the power distribution of photovoltaic modules in multitracker photovoltaic systems

    by Ibrahim Farhan Alrefo, Oleksandr Shkurpela, Dmytro Kovalenko, Yana Forkun, Oleksiy Iegorov, Olga Iegorova, Oeksandr Miroshnyk, Oleg Synyuk, Valeriy Martynyuk

    The process that generates the output power of a photovoltaic system depending on the orientation of parallel strings has been considered in this work. The task addressed relates to the lack of simulation models for investigating multitracker photovoltaic stations that could make it possible to study their operation and compile recommendations to modernize photovoltaic stations and convert them into multitrackers for more efficient utilization of available area that is not facing south. This paper analyzes the influence of photovoltaic module characteristics when changing the level of illumination on the overall efficiency of the photovoltaic array in a solar multitracker station. The study was performed using the MATLAB software package (USA), which made it possible to quantitatively assess the level of mutual influence of the parameters of photovoltaic modules on the photovoltaic array power. By means of simulation modeling, it was established that multitracker photovoltaic systems have an advantage over monotracker ones during the morning and evening operation; specifically, the advantage is up to 32%. It is also shown that during the daytime, the multitracker system is on average 12–15% inferior to the monotracker system in terms of power. The results are attributed to the more efficient use of photovoltaic modules in the system, which are distributed at optimal angles. A feature of the photovoltaic system modeling in this study is the exclusion of the DC converter, so the findings give a more accurate idea about the position of the system’s operating point. The results make it possible to compile recommendations for multitracker photovoltaic stations for more efficient utilization of the available area that is not facing south and the use of the full power of station’s MPPT (Maximum Power Point Tracking) controllers

  • Open Access

    Improvement of dynamic characteristics of a synchronous reactive electric motor with an external rotor through design improvement

    by Oleksiy Iegorov, Mykola Kundenko, Olga Iegorova, Dong Yuming

    The article investigates the issue of improving the dynamic characteristics of a synchronous jet engine with an external rotor. The relevance of the problem is due to the increasing use of synchronous jet engines, which is one of the notable trends in modern electric power engineering and electric drives. This is due to both technological and economic factors associated with the global transition to energy-efficient and resource-saving solutions. Synchronous jet engines provide 10–15% higher efficiency compared to traditional asynchronous engines, unlike permanent magnet engines, they do not require rare-earth elements. In practice, fluctuations and deviations in the rotational speed occur due to a number of factors: during sudden changes in the load moment, due to instability of the supply frequency, during start-up and transient processes. The problem of stabilizing the speed of synchronous jet engines is one of the key ones when using them in electric drives, especially in systems with variable loads and requirements for high accuracy of the rotor angular velocity. The work analyses the processes of the dynamic transient process of a synchronous jet engine with an external rotor, proposes a technical solution that allows reducing the transition time from one rotor speed to another, performs electromagnetic calculations and compares their results with the results of tests of a prototype. The proposed structural improvement of the external rotor provides acceleration of the transition between operating modes and effective reduction of rotor oscillations characteristic of synchronous jet engines. It is established that for a synchronous jet engine with a power of 1000 W, the duration of the transient process is reduced by approximately 3 times compared to the basic design without an additional winding, while the amplitude of the oscillations of the rotational speed is reduced by 4.3 times.

  • Dependence of the characteristics of an induction motor with an external rotor on the rotor and stator misalignment

    by Lina Hussienat, Mohamed Qawaqzeh, Sultan AL Khateeb, Oleksiy Iegorov, Olga Iegorova, Mykola Kundenko, Marina Glebova, Oleksandr Miroshnyk, Taras Shchur, Paweł KIEŁBASA

    This paper addresses the issue of the influence of external rotor eccentricity on the electromechanical properties of an induction motor intended for applications in light electric vehicles, such as electric bicycles and electric scooters. Particular attention is devoted to the problem of maintaining a uniform air gap, the disturbance of which leads to deterioration of the motor’s performance parameters. To ensure quality control in the manufacturing process of induction motors with an external rotor, a method for evaluating eccentricity based on the analysis of the spectrogram of stator winding currents is proposed. The obtained results confirm the possibility of a qualitative assessment of the magnitude of eccentricity through the analysis of the phase currents of the stator winding. Additionally, a connection scheme for the induction motor with an external rotor to the control system is proposed, enabling rapid diagnostics of the geometric condition of the rotor relative to the stator, both at the production stage and during operation.

  • Open Access

    Development of the active part of an asynchronous generator for a low-power wind turbine

    by Oleksiy Iegorov, Oleksandr Shkurpela, Dmytro Kovalenko

    The article presents an analysis of the operating characteristics of developed asynchronous generators with a squirrel-cage rotor for low-power wind turbines. For comparison, three samples of 10-, 12-, and 14-pole asynchronous generators are proposed. The development was carried out in the Ansys Maxwell software package, and the operating characteristics were constructed in MATLAB. The use of an asynchronous generator in a low-power wind turbine is dictated by the lower cost of the asynchronous generator and the absence of imported rare materials, such as neodymium magnets. For comparison, operating characteristics were constructed for nominal and reduced frequencies, since the main operating range of the wind turbine is frequencies below the nominal frequency. Particular attention was paid to the characteristics of efficiency and power factor, since the control system of the asynchronous generator will have to be optimized to maximize these parameters in order to achieve maximum energy efficiency of the wind turbine. All developed generators demonstrated their ability to operate and have fairly similar operating characteristics. However, a detailed analysis allowed us to determine the optimal design of an asynchronous generator for use in a low-power wind turbine.

  • Open Access

    The influence of the design of the stator winding of a synchronous-reactive generator on increasing its energy efficiency

    by O. B. Iegorov, M. P. Kundenko, O. Yu. Iegorova, V. A. Mardziavko, A. Yu. Rudenko

    Introduction. Increasing the energy efficiency of electric generators is a pressing task for various areas of energy, in particular for autonomous systems and transport. Synchronous-reactive generators (SRGs) are becoming increasingly widespread due to their simple design, absence of magnets and mechanical contacts, and high reliability. The task of the proposed work is to study the influence of the design of the double winding of the stator of a SRG on its energy characteristics, determine the optimal parameters of the mutual arrangement of the windings, and develop recommendations for increasing the generator efficiency. Goal. Analysis of the influence of the design of the double winding of the stator of a SRG on the output energy characteristics and determine recommendations when designing this type of electrical machines. Methodology. The analysis was carried out using numerical modeling by the finite element method in the ANSYS Maxwell environment. Various options for the mutual arrangement of the main and excitation windings in the generator stator were considered. Results. The influence of the single-layer and double-layer winding design on the output characteristics of the generator was studied. It was found that a two-layer arrangement with a phase shift of 2 slots provides minimal torque ripple, improves the stability of the generator operation and helps to increase the efficiency to 92.5 %. Scientific novelty. For the first time, the effect of the phase shift of the windings on electromagnetic processes in the SRG has been studied in detail, which allows optimizing its design and improving operational performance. Practical value. The results can be used in the design of new generators with improved characteristics for use in wind power, diesel generator sets and autonomous electrical systems. References 19, table 1, figures 12.


  • Open Access

    STUDY OF STARTING MODES OF SINGLE-PHASE INDUCTION MOTORS WHEN CHANGING THE PARAMETERS OF THE STATOR WINDINGS, PHASE-SHIFTING CAPACITOR AND SUPPLY VOLTAGE

    by Suad Omar Aldaikh, Mohannad O. Rawashdeh, Lina H. Hussienat, Mohamed Qawaqzeh, Oleksiy Iegorov, Olga Iegorova, Mykola Kundenko, Dmytro Danylchenko, Oleksandr Miroshnyk, Taras Shchur

    Single-phase induction motors (SPIM) are widely used in household appliances, agriculture, trade, medicine and other areas where a cheap unregulated electric drive powered by a single-phase AC network is required. They are produced in millions of pieces per year. Therefore, significant attention has always been paid to research aimed at reducing resource consumption in the production and operation of these engines, improving the initial characteristics and increasing their competitiveness. The article conducted a study of the starting torque when starting single-phase induction motors depending on the initial phase of the voltage of the single-phase network supplying the stator winding, on the phase angles of the network voltage at fixed phase angles of the starting winding. It is also analysed how the active resistance and inductive leakage resistance of the stator winding and the equivalent rotor winding, and the resistance of the capacitor capacitance affect the starting characteristics of the engine.


  • Open Access

    INDUCTION WIND GENERATOR USING EXCITATION CAPACITORS

    by Oleksiy Iegorov, Olga Iegorova, Marina Glebova, Jana Forkun

    The development of autonomous energy is characterized by a growing need for autonomous sources of electricity of various capacities, increased requirements for the quality of electrical energy, reliability and efficiency. In this regard, the design and cr

  • Open Access

    DETERMINATION OF THE MAXIMUM TIME OF DISCONNECTION OF AN INDUCTION MOTOR FROM THE MAINS IN THE EVENT OF VOLTAGE FAILURE

    by Oleksiy Iegorov, Olga Iegorova, Marina Glebova

    The work investigated the behavior of an induction motor when the supply voltage disappears and its value changes. Analysis of the results shows that the permissible time of voltage dip depends on the total moment of inertia of the moving parts, and to a

  • Open Access

    FEATURES CALCULATIONS OF DYNAMIC MODES OF THE ELECTRICAL SYSTEM

    by Oleksiy Iegorov, Olga Iegorova, Marina Glebova, Jana Forkun

    The purpose of the study is to consider modeling the modes of local objects on a single information model within the framework of an automated system for controlling the modes of electrical systems. A mathematical model of the electrical system is propose

  • Open Access

    DETERMINATION OF DEVIATIONS OF THE PARAMETERS OF THE MAGNET WIRES OF ELECTRIC MACHINES

    by Oleksiy Iegorov, Olga Iegorova, Marina Glebova, Jana Forkun

    The paper considers the principles and conditions of modeling the cores of electric machines with damage. The feasibility of using the finite element method in the analysis of electromagnetic processes and fields of electric machines is justified and the