BHB. Hafke

B. Hafke

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


B. Hafke has a total of 26 co-authors. Here are the top co-authors by number of shared publications:

  • T. Witte

    Faculty of Physics and Center for Nanointegration (CENIDE), University of Duisburg-Essen, 47057 Duisburg, Germany

    8 shared publications
  • Michael Horn-Von Hoegen

    Faculty of Physics, University of Duisburg-Essen 1 , 47057 Duisburg

    6 shared publications
  • M. Horn-Von Hoegen

    Department of Physics and Center for Nanointegration (CENIDE) University of Duisburg-Essen 47057 Duisburg Germany

    4 shared publications
  • B. Krenzer

    Department of Physics and Center for Nanointegration (CENIDE), University of Duisburg-Essen , Lotharstr. 1, 47057 Duisburg, Germany

    3 shared publications
  • T. Frigge

    Department of Physics and Center for Nanointegration (CENIDE), University of Duisburg-Essen , Lotharstr. 1, 47057 Duisburg, Germany

    3 shared publications
  • V. Tinnemann

    Department of Physics and Center for Nanointegration (CeNIDE), University of Duisburg-Essen, 47048 Duisburg, Germany

    3 shared publications

Latest Publications

  • Thermally Induced Crossover from 2D to 1D Behavior in an Array of Atomic Wires: Silicon Dangling-Bond Solitons in Si(553)-Au

    by B. Hafke, C. Brand, T. Witte, B. Sothmann, M. Horn-Von Hoegen, S. C. Erwin

    The self-assembly of submonolayer amounts of Au on the densely stepped Si(553) surface creates an array of closely spaced “atomic wires” separated by 1.5 nm. At low temperature, charge transfer between the terraces and the row of silicon dangling bonds at the step edges leads to a charge-ordered state within the row of dangling bonds with ×3 periodicity. Interactions between the dangling bonds lead to their ordering into a fully two-dimensional (2D) array with centered registry between adjacent steps. We show that as the temperature is raised, soliton defects are created within each step edge. The concentration of solitons rises with increasing temperature and eventually destroys the 2D order by decoupling the step edges, reducing the effective dimensionality of the system to 1D. This crossover from higher to lower dimensionality is unexpected and, indeed, opposite to the behavior in other systems.


  • Open Access

    Adsorbate induced manipulation of 1D atomic nanowires: Soliton mediated degradation of long-range order in the Si(553)-Au system

    by B. Hafke, T. Witte, M. Horn-Von Hoegen

    Deposition of Au on vicinal Si(553) surfaces results in the self-assembly of one-dimensional (1D) Au atomic wires. Charge transfer from the Au wire to the Si step edge leads to a chain of Si danglingbond orbitals with a long range ordered threefold periodicity along the steps and infinite interchain interaction perpendicular to the steps. Employing spot-profile analysis low-energy electron diraction (SPA-LEED) we observed a broadening of spot width with time, reflecting the degradation of Si dangling bond chain and Au wire length. Adsorbates were identified as primary source for spot broadening. They force the generation of solitons and anti-solitons which immediately destroy the long-range order along and perpendicular to the steps, respectively. From the temporal evolution of broadening, we conclude that the Au wires are less reactive to adsorption than the Si dangling bond chains.

  • Open Access

    Thermally-induced crossover from 2D to 1D behavior in an array of atomic wires: silicon dangling-bond solitons in Si(553)-Au

    by B. Hafke, C. Brand, T. Witte, B. Sothmann, M. Horn-Von Hoegen, S. C. Erwin

    The self-assembly of submonolayer amounts of Au on the densely stepped Si(553) surface creates an array of closely spaced \atomic wires" separated by 1.5 nm. At low temperature, charge transfer between the terraces and the row of silicon dangling bonds at the step edges leads to a charge-ordered state within the row of dangling bonds with x3 periodicity. Interactions between the dangling bonds lead to their ordering into a fully two-dimensional (2D) array with centered registry between adjacent steps. We show that as the temperature is raised, soliton defects are created within each step edge. The concentration of solitons rises with increasing temperature and eventually destroys the 2D order by decoupling the step edges, reducing the effective dimensionality of the system to 1D. This crossover from higher to lower dimensionality is unexpected and, indeed, opposite to the behavior in other systems.

  • Open Access

    Decelerated lattice excitation and absence of bulk phonon modes at surfaces: Ultra-fast electron diffraction from Bi(111) surface upon fs-laser excitation

    by V. Tinnemann, C. Streubühr, B. Hafke, T. Witte, A. Kalus, A. Hanisch-Blicharski, M. Ligges, P. Zhou, D. von der Linde, U. Bovensiepen, et al.

    Ultrafast reflection high-energy electron diffraction is employed to follow the lattice excitation of a Bi(111) surface upon irradiation with a femtosecond laser pulse. The thermal motion of the atoms is analyzed through the Debye–Waller effect. While the Bi bulk is heated on time scales of 2 to 4 ps, we observe that the excitation of vibrational motion of the surface atoms occurs much slower with a time constant of 12 ps. This transient nonequilibrium situation is attributed to the weak coupling between bulk and surface phonon modes which hampers the energy flow between the two subsystems. From the absence of a fast component in the transient diffraction intensity, it is in addition concluded that truncated bulk phonon modes are absent at the surface.


  • Open Access

    Condensation of ground state from a supercooled phase in the Si(111)-(4 × 1) → (8 × 2)-indium atomic wire system

    by B. Hafke, T. Witte, D. Janoschka, P. Dreher, F.-J. Meyer zu Heringdorf, M. Horn-Von Hoegen

    Strong optical irradiation of indium atomic wires on a Si(111) surface causes the nonthermal structural transition from the (8 × 2) reconstructed ground state to an excited (4 × 1) state. The immediate recovery of the system to the ground state is hindered by an energy barrier for the collective motion of the indium atoms along the reaction coordinate from the (4 × 1) to the (8 × 2) state. This metastable, supercooled state can only recover through nucleation of the ground state at defects like adsorbates or step edges. Subsequently, a recovery front propagates with constant velocity across the surface and the (8 × 2) ground state is reinstated. In a combined femtosecond electron diffraction and photoelectron emission microscopy study, we determined—based on the step morphology—a velocity of this recovery front of ∼100 m/s.


  • Open Access

    Ultrafast electron diffraction from a Bi(111) surface: Impulsive lattice excitation and Debye–Waller analysis at large momentum transfer

    by V. Tinnemann, C. Streubühr, B. Hafke, A. Kalus, A. Hanisch-Blicharski, M. Ligges, P. Zhou, D. von der Linde, U. Bovensiepen, M. Horn-Von Hoegen

    The lattice response of a Bi(111) surface upon impulsive femtosecond laser excitation is studied with time-resolved reflection high-energy electron diffraction. We employ a Debye–Waller analysis at large momentum transfer of 9.3 Å−1 ≤ Δ k ≤ 21.8 Å−1 in order to study the lattice excitation dynamics of the Bi surface under conditions of weak optical excitation up to 2 mJ/cm2 incident pump fluence. The observed time constants τint of decay of diffraction spot intensity depend on the momentum transfer Δk and range from 5 to 12 ps. This large variation of τint is caused by the nonlinearity of the exponential function in the Debye–Waller factor and has to be taken into account for an intensity drop ΔI > 0.2. An analysis of more than 20 diffraction spots with a large variation in Δk gave a consistent value for the time constant τT of vibrational excitation of the surface lattice of 12 ± 1 ps independent on the excitation density. We found no evidence for a deviation from an isotropic Debye–Waller effect and conclude that the primary laser excitation leads to thermal lattice excitation, i.e., heating of the Bi surface.


  • Pulsed electron gun for electron diffraction at surfaces with femtosecond temporal resolution and high coherence length

    by B. Hafke, T. Witte, C. Brand, Th. Duden, M. Horn-Von Hoegen

    We present a newly designed 30 kV pulsed electron gun for ultrafast electron diffraction suited for pump-probe setups driven by femtosecond laser pulses. The electron gun can be operated both in transmission and reflection geometry. A robust design with a back illuminated Au photocathode, extraction fields of 7.5 kV/mm, and a magnetic focus lens ensures reliable daily use. Magnetic deflectors allow for beam alignment and characterization. Focusing of the UV pulse on the photocathode results in a small source size of photoemitted electrons and thus a high transverse coherence length of more than 50 nm in diffraction. A low difference of ΔE = 0.1 eV between the work function of the 10 nm Au photocathode and photon energy of the frequency tripled UV laser pulses results in an instrumental temporal resolution of 330 fs full width at half maximum. This resolution is discussed with respect to the number of electrons per pulse.


  • Nanoscale interfacial heat transport of ultrathin epitaxial hetero films: Few monolayer Pb(111) on Si(111)

    by T. Witte, T. Frigge, B. Hafke, B. Krenzer, M. Horn-Von Hoegen

    We studied the phononic heat transport from ultrathin epitaxial Pb(111) films across the heterointerface into a Si(111) substrate by means of ultrafast electron diffraction. The thickness of the Pb films was varied from 15 to 4 monolayers. It was found that the thermal boundary conductance σTBC of the heterointerface is independent of the film thickness. We have no evidence for finite size effects: the continuum description of heat transport is still valid, even for the thinnest films of only 4 monolayer thickness.


  • Open Access

    Two-dimensional interaction of spin chains in the Si(553)-Au nanowire system

    by B. Hafke, T. Frigge, T. Witte, B. Krenzer, J. Aulbach, J. Schäfer, R. Claessen, S. C. Erwin, M. Horn-Von Hoegen

    Adsorption of Au on Si(553) results in the self-assembly of highly ordered step arrays of one-dimensional (1D) Au atomic wires along the step direction. Charge transfer from the terrace to the step edge causes every third Si atom at the step edge to exhibit a partially filled dangling bond hosting a single fully spin-polarized electron which forms in an ordered 1D spin chain along the step. The interstep correlation of this threefold periodicity in neighboring Si step edges and the geometry of the unit cell has been determined by means of high-resolution spot profile analysis low-energy electron diffraction, scanning tunneling microscopy, and density functional theory. While the twofold periodicity of the Au wires exhibits a weak interwire interaction, leading to streaks in the diffraction pattern, the correlation of the Si step edge atoms is by far a stronger interaction, resulting in clear spots. The corresponding unit cell spanned by threefold ordered step edge atoms can be described as a centered structure which is magnetically frustrated and may stabilize a (two-dimensional) quantum spin liquid.


  • Nanoscale heat transport from Ge hut, dome, and relaxed clusters on Si(001) measured by ultrafast electron diffraction

    by T. Frigge, B. Hafke, V. Tinnemann, B. Krenzer, M. Horn-Von Hoegen

    The thermal transport properties of crystalline nanostructures on Si were studied by ultra-fast surface sensitive time-resolved electron diffraction. Self-organized growth of epitaxial Ge hut, dome, and relaxed clusters was achieved by in-situ deposition of 8 monolayers of Ge on Si(001) at 550 °C under UHV conditions. The thermal response of the three different cluster types subsequent to impulsive heating by fs laser pulses was determined through the Debye-Waller effect. Time resolved spot profile analysis and life-time mapping was employed to distinguish between the thermal response of the different cluster types. While dome clusters are cooling with a time constant of τ = 150 ps, which agrees well with numerical simulations, the smaller hut clusters with a height of 2.3 nm exhibit a cooling time constant of τ = 50 ps, which is a factor of 1.4 slower than expected.