Andrius Slavickas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Andrius Slavickas has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
Aurimas Tonkūnas
Lithuanian Energy Institute, Breslaujos g. 3, LT-44403 Kaunas, Lithuania
6 shared publicationsRaimondas Pabarčius
Lithuanian Energy Institute, Breslaujos g. 3, LT-44403 Kaunas, Lithuania
6 shared publicationsAndrius Tidikas
Lithuanian Energy Institute
3 shared publicationsHando Tohver
3 shared publicationsTadas Kaliatka
Lithuanian Energy Institute
3 shared publications- Eugenijus Ušpuras
Laboratory of Nuclear Installation Safety
2 shared publications
Latest Publications
- Open Access
- 16 April 2026
- Published by Elsevier in SSRN Electronic Journal
Basalt fibers modified with neutron absorbers for nuclear shielding concrete: fiber manufacture, characterization and dose-rate impact
Modified basalt fibers doped with neutron-absorbing and gamma-attenuating oxides were developed as a multifunctional concrete admixture for nuclear shielding applications. Within the ECOSCREEN project, basalt microfiber compositions were modified by introducing boron-, gadolinium-, hafnium-, and yttrium-bearing oxides, aiming to achieve a uniform, mix-independent distribution of absorbers in concrete while retaining the durability benefits of fiber reinforcement. The fibers were produced under laboratory conditions and characterized by tensile testing, chemical resistance in aggressive media, and SEM/EDS-based microstructural assessment, confirming stable morphology and the presence of absorber elements. Shielding performance was quantified using continuous-energy Monte Carlo transport simulations with three independent codes (Serpent, MCNP6, OpenMC) employing harmonized geometry, sources, detectors, and ENDF/B-VII.1-based nuclear data. A dedicated cross-verification stage demonstrated consistent predictions of neutron, primary-photon, and activation-photon transport, enabling code-averaged spectra to be used for dose rate assessment. A simplified slab model was evaluated for three representative sources: VVER-1000 spent fuel, RBMK-1500 spent fuel, and a DEMO/EuroFusion activated-water source. For 21 concrete mixes (five modified basalt fiber types at 25-100 kg/m3 plus plain concrete), modified basalt fiber addition produced a monotonic reduction of neutron flux (most pronounced in the thermal range) and a measurable improvement in photon shielding for fibers modified with heavy-element oxides. The largest total dose rate reductions behind the shield were obtained for the hafnium-modified basalt fiber concrete at 100 kg/m3 (13.44% for VVER-1000 spent fuel, 14.24% for RBMK-1500 spent fuel, and 4.97% for the DEMO/EuroFusion source relative to plain concrete).
- 16 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessBasalt fibers modified with neutron absorbers for nuclear shielding concrete: fiber manufacture, characterization and dose-rate impact
Modified basalt fibers doped with neutron-absorbing and gamma-attenuating oxides were developed as a multifunctional concrete admixture for nuclear shielding applications. Within the ECOSCREEN project, basalt microfiber compositions were modified by introducing boron-, gadolinium-, hafnium-, and yttrium-bearing oxides, aiming to achieve a uniform, mix-independent distribution of absorbers in concrete while retaining the durability benefits of fiber reinforcement. The fibers were produced under laboratory conditions and characterized by tensile testing, chemical resistance in aggressive media, and SEM/EDS-based microstructural assessment, confirming stable morphology and the presence of absorber elements. Shielding performance was quantified using continuous-energy Monte Carlo transport simulations with three independent codes (Serpent, MCNP6, OpenMC) employing harmonized geometry, sources, detectors, and ENDF/B-VII.1-based nuclear data. A dedicated cross-verification stage demonstrated consistent predictions of neutron, primary-photon, and activation-photon transport, enabling code-averaged spectra to be used for dose rate assessment. A simplified slab model was evaluated for three representative sources: VVER-1000 spent fuel, RBMK-1500 spent fuel, and a DEMO/EuroFusion activated-water source. For 21 concrete mixes (five modified basalt fiber types at 25-100 kg/m3 plus plain concrete), modified basalt fiber addition produced a monotonic reduction of neutron flux (most pronounced in the thermal range) and a measurable improvement in photon shielding for fibers modified with heavy-element oxides. The largest total dose rate reductions behind the shield were obtained for the hafnium-modified basalt fiber concrete at 100 kg/m3 (13.44% for VVER-1000 spent fuel, 14.24% for RBMK-1500 spent fuel, and 4.97% for the DEMO/EuroFusion source relative to plain concrete).
- 16 September 2025
- Published by Taylor & Francis in Nuclear Technology
- Vol. 212 (8) , 2133-2146
Evaluation of Decay Heat Calculation Uncertainties for Spent Fuel from RBMK-1500 Reactor
- 16 September 2025
- Published by Taylor & Francis in Nuclear Technology
- Vol. 212 (8) , 2133-2146
Evaluation of Decay Heat Calculation Uncertainties for Spent Fuel from RBMK-1500 Reactor
- 26 May 2024
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 206
Numerical simulation of axial and radial decay heat distribution in spent RBMK-1500 fuel assembly
- 26 May 2024
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 206
Numerical simulation of axial and radial decay heat distribution in spent RBMK-1500 fuel assembly
- Open Access
- 12 December 2023
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 417, 112811
Assessing shielding material Performance: Benchmarking of Monte Carlo codes for oil shale and Basalt-Boron fiber concretes
- 12 December 2023
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 417, 112811
Open AccessAssessing shielding material Performance: Benchmarking of Monte Carlo codes for oil shale and Basalt-Boron fiber concretes
- Open Access
- 22 November 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (23) , 11884
Nuclear Analysis of High-Power LIEBE Molten Target at CERN for the Production of Radioisotopes
To enhance the production of short-lived isotopes, higher beam powers are sought, which require targets able to accommodate them. One such target prototype is a liquid metal target LIEBE, developed at CERN. In this paper, a simulation of the proton beam interaction with the LIEBE target is presented. Simulations were performed by a series of proton transport calculations using the MCNP Monte Carlo code. The latest LIEBE target MCNP input was created in high-fidelity geometry, and the FENDL-3.1 cross-section data library was used. Flux and dose rate maps in the LIEBE target obtained from the simulations are presented in the paper. The maximum obtained dose around the target is roughly 361 Sv/h for gamma rays and 214 Sv/h for neutrons. The 70 MeV–100 µA proton beam penetrates roughly 7 mm deep into the liquid eutectic lead–bismuth. Based on this, further required changes to the LIEBE target can be evaluated.
- 22 November 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (23) , 11884
Open AccessNuclear Analysis of High-Power LIEBE Molten Target at CERN for the Production of Radioisotopes
To enhance the production of short-lived isotopes, higher beam powers are sought, which require targets able to accommodate them. One such target prototype is a liquid metal target LIEBE, developed at CERN. In this paper, a simulation of the proton beam interaction with the LIEBE target is presented. Simulations were performed by a series of proton transport calculations using the MCNP Monte Carlo code. The latest LIEBE target MCNP input was created in high-fidelity geometry, and the FENDL-3.1 cross-section data library was used. Flux and dose rate maps in the LIEBE target obtained from the simulations are presented in the paper. The maximum obtained dose around the target is roughly 361 Sv/h for gamma rays and 214 Sv/h for neutrons. The 70 MeV–100 µA proton beam penetrates roughly 7 mm deep into the liquid eutectic lead–bismuth. Based on this, further required changes to the LIEBE target can be evaluated.
- Open Access
- 8 August 2022
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 54 (12) , 4731-4742
The impact of fuel depletion scheme within SCALE code on the criticality of spent fuel pool with RBMK fuel assemblies
- 8 August 2022
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 54 (12) , 4731-4742
Open AccessThe impact of fuel depletion scheme within SCALE code on the criticality of spent fuel pool with RBMK fuel assemblies
- 1 December 2021
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 178, 109980
Dose rates and specific activities of Li2CO3 pellets and diamond detectors irradiated during TT and DTE2 campaigns at JET
- 1 December 2021
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 178, 109980
Dose rates and specific activities of Li2CO3 pellets and diamond detectors irradiated during TT and DTE2 campaigns at JET
- Open Access
- 10 March 2021
- Published by Hindawi Limited in Science and Technology of Nuclear Installations
- Vol. 2021, 1-11
Neutron Transport Simulations of RBMK Fuel Assembly Using Multigroup and Continuous Energy Data Libraries within the SCALE Code
The neutron transport simulations of RBMK-1500 fuel assembly were performed using both multigroup and continuous energy data libraries available within the SCALE code system in order to validate its suitability for the estimation of RBMK neutronic characteristics. The resonance processing of cross section, involved in the preparation of the multigroup data library, has a significant impact on neutron transport calculations. Standard Dancoff factors (DFs) used for the heterogeneous geometry of RBMK fuel assembly are insufficient for the accurate estimation of resonance self-shielding. Thus, the SCALE module MCDancoff was used in this study to determine location-specific DFs. The results of RBMK-1500 fuel assembly simulations using standard and user-defined DFs were compared. In addition, the continuous energy (CE) cross-section data library was applied for the benchmark calculations. The impact of different nuclear data libraries on neutron transport simulations was tested as well. It was found out that the usage of the multigroup data libraries generates some deviation from the reference simulations obtained with CE libraries. The CE library based on the estimated ENDF/B-VII.1 data proved to be the best alternative for neutron transport simulations of RBMK fuel assembly.
- 10 March 2021
- Published by Hindawi Limited in Science and Technology of Nuclear Installations
- Vol. 2021, 1-11
Open AccessNeutron Transport Simulations of RBMK Fuel Assembly Using Multigroup and Continuous Energy Data Libraries within the SCALE Code
The neutron transport simulations of RBMK-1500 fuel assembly were performed using both multigroup and continuous energy data libraries available within the SCALE code system in order to validate its suitability for the estimation of RBMK neutronic characteristics. The resonance processing of cross section, involved in the preparation of the multigroup data library, has a significant impact on neutron transport calculations. Standard Dancoff factors (DFs) used for the heterogeneous geometry of RBMK fuel assembly are insufficient for the accurate estimation of resonance self-shielding. Thus, the SCALE module MCDancoff was used in this study to determine location-specific DFs. The results of RBMK-1500 fuel assembly simulations using standard and user-defined DFs were compared. In addition, the continuous energy (CE) cross-section data library was applied for the benchmark calculations. The impact of different nuclear data libraries on neutron transport simulations was tested as well. It was found out that the usage of the multigroup data libraries generates some deviation from the reference simulations obtained with CE libraries. The CE library based on the estimated ENDF/B-VII.1 data proved to be the best alternative for neutron transport simulations of RBMK fuel assembly.
- Open Access
- 1 January 2020
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 22, 100723
Dose rates and specific activities of copper based materials irradiated during the TT plasma operation at JET
- 1 January 2020
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 22, 100723
Open AccessDose rates and specific activities of copper based materials irradiated during the TT plasma operation at JET