Hamid Bashiri-Atrabi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hamid Bashiri-Atrabi has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Takashi Hosoda
Professor, Dept. of Urban Management, Graduate School of Engineering, Kyoto Univ., Kyoto 6158540, Japan
4 shared publications Akihide Tada
Professor, Graduate School of Engineering, Nagasaki Univ., Nagasaki 852-8521, Japan
1 shared publication- Bryan William Karney
Univ. of Toronto
1 shared publication - David E. Rheinheimer
Center for Watershed Sciences University of California Davis CA USA
1 shared publication Erfaneh Sharifi
Shahid Bahonar University of Kerman
1 shared publication- Erfaneh Sharifi
Dept. of Civil and Environmental Engineering, Univ. of Houston, Houston, TX 77004
1 shared publication
Latest Publications
- 7 October 2022
- Published by Morressier GmbH
The Influence of Initial Pressure Distribution on Pressure Transients in LNG Pipes
Liquid (or Water) hammer or hydraulic transient in Liquefied Natural Gas (LNG) pipelines refers to pressure spikes due to flow changes caused by |
- 7 October 2022
- Published by Morressier GmbH
The Influence of Initial Pressure Distribution on Pressure Transients in LNG Pipes
Liquid (or Water) hammer or hydraulic transient in Liquefied Natural Gas (LNG) pipelines refers to pressure spikes due to flow changes caused by |
- 8 January 2022
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 60 (3) , 376-388
Nonlinear mode analysis of periodic roll waves and wave splitting
This paper describes the characteristics of the formation of periodic roll waves and the splitting of waves based on nonlinear mode analysis. A novel system is developed to investigate the formation of roll waves through linear and nonlinear modal analyses. The nonlinear analysis shows the feasibility of the periodic roll waves and their splitting when the wavenumber is extremely small. It is observed that there are phase shifts in each term of the momentum equation for the periodic roll waves. The phase of the nonlinear convection term in the fundamental mode is shifted forward relative to the phase of the linear convective term, and it acts as the viscosity term. In contrast, the phase of the nonlinear convection term in the higher mode is delayed, and it acts as the friction term. At a smaller wavenumber, the phase shift in the nonlinear interaction between the fundamental and second modes leads to the suppression of the fundamental mode development, resulting in the wave splitting.
- 8 January 2022
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 60 (3) , 376-388
Nonlinear mode analysis of periodic roll waves and wave splitting
This paper describes the characteristics of the formation of periodic roll waves and the splitting of waves based on nonlinear mode analysis. A novel system is developed to investigate the formation of roll waves through linear and nonlinear modal analyses. The nonlinear analysis shows the feasibility of the periodic roll waves and their splitting when the wavenumber is extremely small. It is observed that there are phase shifts in each term of the momentum equation for the periodic roll waves. The phase of the nonlinear convection term in the fundamental mode is shifted forward relative to the phase of the linear convective term, and it acts as the viscosity term. In contrast, the phase of the nonlinear convection term in the higher mode is delayed, and it acts as the friction term. At a smaller wavenumber, the phase shift in the nonlinear interaction between the fundamental and second modes leads to the suppression of the fundamental mode development, resulting in the wave splitting.
- 4 November 2019
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 58 (4) , 638-652
Experimental and numerical simulation of bidirectional propagation of an air cavity
This study numerically and experimentally investigates the transient flow associated with a so-called Benjamin bubble, but, in contrast to previous studies, the approach permits bidirectional flow. Two experiments investigated the bidirectional propagation of an air cavity in a square tank; these two events were also simulated using a three-dimensional numerical model. An exactly conservative semi-Lagrangian scheme was employed to solve both the advection term in the momentum equation and the advection equation of the volume of fluid function. The model was compared with previous one-dimensional Benjamin bubble experimental data and a one-dimensional Boussinesq model. For the one-dimensional Benjamin bubble experiments, the three-dimensional model showed good agreement with both published data and a one-dimensional non-hydrostatic model. After modelling the advance of a one-dimensional cavity, a bidirectional Benjamin bubble was simulated using the three-dimensional model. The numerical results are in reasonable agreement with observations of the free surface and pressurized regions and reasonably predict the shape of the air–water interface.
- 4 November 2019
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 58 (4) , 638-652
Experimental and numerical simulation of bidirectional propagation of an air cavity
This study numerically and experimentally investigates the transient flow associated with a so-called Benjamin bubble, but, in contrast to previous studies, the approach permits bidirectional flow. Two experiments investigated the bidirectional propagation of an air cavity in a square tank; these two events were also simulated using a three-dimensional numerical model. An exactly conservative semi-Lagrangian scheme was employed to solve both the advection term in the momentum equation and the advection equation of the volume of fluid function. The model was compared with previous one-dimensional Benjamin bubble experimental data and a one-dimensional Boussinesq model. For the one-dimensional Benjamin bubble experiments, the three-dimensional model showed good agreement with both published data and a one-dimensional non-hydrostatic model. After modelling the advance of a one-dimensional cavity, a bidirectional Benjamin bubble was simulated using the three-dimensional model. The numerical results are in reasonable agreement with observations of the free surface and pressurized regions and reasonably predict the shape of the air–water interface.
- 28 June 2018
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 57 (1) , 122-130
Assessment of two-equation model for simulation of air pocket advancing into a rectangular duct
This research aims to evaluate the influence of air on the water surface and pressure profiles in two-phase (air–water) flow. In previous studies, the authors used the continuity and momentum equations for water in a one-dimensional finite volume model. In the present study, the authors additionally incorporate both the mass conservation and momentum equations for incompressible fluids as basic equations for the air portion. Momentum equations were integrated for the free surface and pressurized flow regions after interface observations made at each time step. To correct velocity and pressure in the pressurized portion, the authors used the highly simplified mark-and-cell method. A pressure drop equation is used at the interface of pressurized and free surface flows to deduce the pressure. The Harten total variation diminishing scheme was used to avoid numerical oscillations. The results were compared with experimental data and numerical simulations without considering the air effect.
- 28 June 2018
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 57 (1) , 122-130
Assessment of two-equation model for simulation of air pocket advancing into a rectangular duct
This research aims to evaluate the influence of air on the water surface and pressure profiles in two-phase (air–water) flow. In previous studies, the authors used the continuity and momentum equations for water in a one-dimensional finite volume model. In the present study, the authors additionally incorporate both the mass conservation and momentum equations for incompressible fluids as basic equations for the air portion. Momentum equations were integrated for the free surface and pressurized flow regions after interface observations made at each time step. To correct velocity and pressure in the pressurized portion, the authors used the highly simplified mark-and-cell method. A pressure drop equation is used at the interface of pressurized and free surface flows to deduce the pressure. The Harten total variation diminishing scheme was used to avoid numerical oscillations. The results were compared with experimental data and numerical simulations without considering the air effect.
- 1 May 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Irrigation and Drainage Engineering
- Vol. 144 (5)
Prediction of Local Scour Depth Downstream of Sluice Gates Using Harmony Search Algorithm and Artificial Neural Networks
Using two coupled models, this study predicts the maximum local scour depth downstream of sluice gates. The models are an artificial neural network (ANN) coupled with the harmony search (HS) algorithm, and an ANN coupled with a generalized reduced gradient (GRG) method. The models are trained and tested using extensive observations obtained from the literature. The main parameters used to predict the scour are apron length, densimetric Froude number, tailwater depth, and median sediment size. In addition, multiple linear regression (MLR) is applied to express the relationship between independent and dependent variables. Results of the ANN model coupled with HS and with GRG and of the MLR are compared. The performance of ANN is more effective when coupled with the HS algorithm. To increase the ability of the HS algorithm, a parameter varying method is applied. Results lead to the conclusion that ANN coupled with the HS algorithm is an accurate and simple method for predicting the maximum scour depth downstream of sluice gates.
- 1 May 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Irrigation and Drainage Engineering
- Vol. 144 (5)
Prediction of Local Scour Depth Downstream of Sluice Gates Using Harmony Search Algorithm and Artificial Neural Networks
Using two coupled models, this study predicts the maximum local scour depth downstream of sluice gates. The models are an artificial neural network (ANN) coupled with the harmony search (HS) algorithm, and an ANN coupled with a generalized reduced gradient (GRG) method. The models are trained and tested using extensive observations obtained from the literature. The main parameters used to predict the scour are apron length, densimetric Froude number, tailwater depth, and median sediment size. In addition, multiple linear regression (MLR) is applied to express the relationship between independent and dependent variables. Results of the ANN model coupled with HS and with GRG and of the MLR are compared. The performance of ANN is more effective when coupled with the HS algorithm. To increase the ability of the HS algorithm, a parameter varying method is applied. Results lead to the conclusion that ANN coupled with the HS algorithm is an accurate and simple method for predicting the maximum scour depth downstream of sluice gates.
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 142 (12)
Propagation of an Air-Water Interface from Pressurized to Free-Surface Flow in a Circular Pipe
Hydraulic transients with the movement of an interface between pressurized flow and free surface flow can be observed in rapid water emptying in the pipes. This study focuses on air cavity intrusion into horizontal and inclined circular pipes. Laboratory experiments were carried out to observe the negative surge during depressurization in a circular pipe. In order to generate the undular bore in a circular pipe, in some cases a sharp-crested weir at the open end of the horizontal pipe was used. Various behaviors of air cavity were observed for a series of weir heights. A numerical model is proposed and applied to the cavity flow in a circular pipe. To reproduce the undular bore in circular pipes (when water depth is greater than pipe radius), this study derived the depth-averaged shallow water equations with the effects of vertical acceleration using the Boussinesq equation. In this study, the continuity and the momentum equations of free surface and pressurized flows with the hydrostatic and the ...
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 142 (12)
Propagation of an Air-Water Interface from Pressurized to Free-Surface Flow in a Circular Pipe
Hydraulic transients with the movement of an interface between pressurized flow and free surface flow can be observed in rapid water emptying in the pipes. This study focuses on air cavity intrusion into horizontal and inclined circular pipes. Laboratory experiments were carried out to observe the negative surge during depressurization in a circular pipe. In order to generate the undular bore in a circular pipe, in some cases a sharp-crested weir at the open end of the horizontal pipe was used. Various behaviors of air cavity were observed for a series of weir heights. A numerical model is proposed and applied to the cavity flow in a circular pipe. To reproduce the undular bore in circular pipes (when water depth is greater than pipe radius), this study derived the depth-averaged shallow water equations with the effects of vertical acceleration using the Boussinesq equation. In this study, the continuity and the momentum equations of free surface and pressurized flows with the hydrostatic and the ...
- 30 September 2015
- Published by Springer Nature in Water Resources Management
- Vol. 29 (15) , 5729-5748
Application of Harmony Search Algorithm to Reservoir Operation Optimization
- 30 September 2015
- Published by Springer Nature in Water Resources Management
- Vol. 29 (15) , 5729-5748
Application of Harmony Search Algorithm to Reservoir Operation Optimization
- 25 August 2015
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 53 (6) , 814-819
The motion of entrapped air cavities in inclined ducts
The paper reports a study of the water surface profile of an entrapped air cavity while emptying water in an initially filled inclined duct. A one-dimensional (1D) model, which consists of the continuity and momentum equations applicable for open channel flow, pipe flow and air–water interface flow, is developed based on the finite volume method. A pressure drop model is proposed to reproduce a better profile around the cavity front, with a particular focus on air pressure changes inside the confined cavity to simulate a kind of transient flow with an entrapped air cavity. In contrast to the previous studies, the application of the model shows that when the pressure drop is not considered and the air pressure is not changed, the confined cavity soon vanishes. A comparison between the simulated and experimental results shows that the model is able to accurately reproduce the water surface profile of an entrapped air cavity while emptying inclined ducts.
- 25 August 2015
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 53 (6) , 814-819
The motion of entrapped air cavities in inclined ducts
The paper reports a study of the water surface profile of an entrapped air cavity while emptying water in an initially filled inclined duct. A one-dimensional (1D) model, which consists of the continuity and momentum equations applicable for open channel flow, pipe flow and air–water interface flow, is developed based on the finite volume method. A pressure drop model is proposed to reproduce a better profile around the cavity front, with a particular focus on air pressure changes inside the confined cavity to simulate a kind of transient flow with an entrapped air cavity. In contrast to the previous studies, the application of the model shows that when the pressure drop is not considered and the air pressure is not changed, the confined cavity soon vanishes. A comparison between the simulated and experimental results shows that the model is able to accurately reproduce the water surface profile of an entrapped air cavity while emptying inclined ducts.
- 1 January 2015
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 141 (1)
Simulation of Air Cavity Advancing into a Straight Duct
- 1 January 2015
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 141 (1)
Simulation of Air Cavity Advancing into a Straight Duct