NSNabarun Saha

Nabarun Saha

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nabarun Saha has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A compact SOI based high-resolution broadband RF beamformer with phase change material aided programmability

    by Nabarun Saha, Giuseppe Brunetti, Caterina Ciminelli

    The future of wireless communication depends on broadband, high-frequency operation, where microwave photonic beamformers have shown remarkable potential to overcome the bandwidth and loss limitations of electronic systems. However, achieving a compact, squintfree, and energy-efficient broadband beamformer with high-resolution steering remains a key challenge. Here, we present a numerically validated 7-bit optical switchable delay-line (OSDL) beamformer on a standard silicon-on-insulator (SOI) platform that leverages lowloss phase change materials (PCMs) for compact, energy-efficient programmability. The localized and non-volatile tuning of PCM enables a compact footprint of 2.5×3.1 mm² and supports 128 squint-free beam directions over a 20 GHz bandwidth (up to 40 GHz). The nonvolatile nature of PCM halves the number of switching operations compared with conventional thermo-optic tuning, reducing energy consumption while maintaining performance. Additionally, carrier-suppressed dual sideband modulation removes the need for optical filtering as well as halves the modulation bandwidth. Statistical analysis confirms excellent robustness, showing negligible degradation under ±10 nm fabrication variations. These results highlight the potential of PCM-assisted photonic beamformers for scalable, energy-efficient 5/6G and satellite communication systems.


  • Open Access

    Efficiency boost of perovskite solar cell in homojunction configuration through tailored band alignment and p–n doping profile

    by Nabarun Saha, Giuseppe Brunetti, Aldo Di Carlo, Caterina Ciminelli

    The relentless quest for sustainable and eco-friendly energy sources can be addressed through solar cells which convert solar energy to electrical energy. In the family of solar cells, perovskite solar cells (PSCs) have seen an astonishing growth in power conversion efficiency (PCE) to which homojunction perovskite is the newest addition. Although numerous studies have examined PCE enhancement through energy band-offset optimization in the intrinsic PSCs, to date, such a study has never been reported in a homojunction configuration. Considering the enormous potential of homojunction PSCs and the importance of band offset, here we numerically identified the optimized range of conduction and valance band offset (CBO and VBO) in conjunction with donor and acceptor density inside the perovskite layer to boost their photovoltaic efficiency. The effect of the CBO and donor density is found to be superior to the VBO and acceptor density. Unlike intrinsic PSCs, the cliff in the energy band diagram drastically reduces the PCE for the CBO. The optimum CBO and donor density are around 0 to +0.1 eV and 2 × 1017 cm−3 respectively. The PCE is higher and nearly constant for a VBO > 0 eV and acceptor density > 7 × 1017 cm−3. With the optimum values of doping density and band offsets, the maximum PCE is calculated to be 25.43% in the presence of all possible losses and an optimum perovskite thickness of 600 nm with a 30:70% ratio of n and p-doped segments.


  • Open Access

    Highly Efficient Phase Change Material Assisted Reconfigurable Optical Delay Line Based on Cascaded Coupled-Resonator Optical Waveguides

    by Nabarun Saha, Giuseppe Brunetti, Caterina Ciminelli

    Microwave-phased array antenna system plays a pivotal role in wireless communication in which a compact, power-efficient, fast, continuously tunable delay line with flexible broadband operation driving each antenna is a crucial component. This article reports the design of a novel reconfigurable true-time delay line (TTDL) in the low-loss Si3N4 TriPleX waveguide platform with two cascaded coupled-resonator optical waveguides (CROW), each consisting of only two racetrack ring resonators operating at resonance. Unlike conventional thermo-optic tuning, low-loss phase change material (PCM) GeSe is used to realize reconfigurable TTDL for the first time, offering several advantages. First, the localized tuning effect of GeSe and its strategic orchestration breaks the delay-bandwidth constraint in conventional ring resonators, enabling simultaneous and independent tuning of delay and bandwidth. Second, PCM stimulated through electrical pulses enables fast response (1.4 μs) and two orders of lower power consumption than the conventional thermo-optic tuning in Si3N4 platform, thanks to larger refractive index modulation. Utilizing multilevel operation of PCM, the delay tuning range is found to be 114.8 ps with a low loss-to-delay ratio of 0.03 dB/ps and a flat-top response having ripples 2. Moreover, taking advantage of PCM's non-volatile nature, a compact optical beamforming network chip is designed through parallel arrangement of the proposed TTDL, enabling dynamic adjustment of bandwidth from 2 to 6.7 GHz with ripples o.


  • Critical Wavelength Referencing Free Biosensor Using Silicon-on-Insulator-Based Directional Coupler

    by Garima Bawa, Nabarun Saha, Yogesh Kumar Verma, Saurabh Mani Tripathi

    In this paper, we propose and theoretically analyze a novel sensor structure for bulk refractive index and bio-layer sensing applications. The sensor employs a directional coupler consisting of two silicon-on-insulator waveguides and utilizes the existence of the critical wavelength in the transmission spectra of the directional coupler to enhance the sensitivity. Optimizing various opto-geometrical parameters, viz. the width of individual waveguides, the separation between them, and the slot width of the upper cladding, we have achieved an extremely high Refractive Index sensitivity (RI) ∼ 30 μm/RIU for aqueous solutions having RI close to ∼ 1.333, and a surface adlayer sensitivity ∼ 25.5 nm/nm for adsorbed bio-layers of RI 1.45 and thickness 6 nm. The analysis has been performed for the TE-like mode. We also show that the phase measurement-based sensitivity calculations, despite being relatively complex, offer critical wavelength free sensing, and thus are better suited to avoid false alarms. Owing to the high bulk and surface sensitivities, our results can find application in designing high-precision biosensors.

  • Design of a Photonic Strain Sensor Based on a Suspended Bragg Grating Reflector

    by Morteza Maleki, Nabarun Saha, Giuseppe Brunetti, Caterina Ciminelli

    The proliferation of space debris in Low Earth Orbit (LEO) poses significant risks to operational satellites and spacecraft. Effective management and mitigation of these risks require precise characterization of debris impact dynamics. This paper proposes a strain sensor with a Si 3 N 4 Bragg grating suspended on a membrane. Designed at the communication wavelength of 1.55 µm, with a small footprint (~ 100 µm 2 ) this sensor can be integrated into the satellite structure, to measure real-time impact of pressures and associated structural deformations. The structure may be used in reflection and transmission modes, simplifying the readout and processing stages. Two-dimensional finite element method (FEM) simulation results revealed a reflection variation of 0.8 a.u. when applying a strain of 10,000 $\mu\varepsilon$ . The proposed method allows for collecting detailed data on debris size, velocity, and impact energy, which are critical for understanding the potential damage to satellites. This approach offers a promising solution for improving debris monitoring and impact prediction, contributing to developing more robust space debris mitigation strategies.

  • Open Access

    Fully Reconfigurable Photonic Filter for Flexible Payloads

    by Annarita di Toma, Giuseppe Brunetti, Nabarun Saha, Caterina Ciminelli

    Reconfigurable photonic filters represent cutting-edge technology that enhances the capabilities of space payloads. These advanced devices harness the unique properties of light to deliver superior performance in signal processing, filtering, and frequency selection. They offer broad filtering capabilities, allowing for the selection of specific frequency ranges while significantly reducing Size, Weight, and Power (SWaP). In scenarios where satellite communication channels are crowded with various signals sharing the same bandwidth, reconfigurable photonic filters enable efficient spectrum management and interference mitigation, ensuring reliable signal transmission. Furthermore, reconfigurable photonic filters demonstrate their ability to adapt to the dynamic space environment, withstanding extreme temperatures, radiation exposure, and mechanical stress while maintaining stable and reliable performance. Leveraging the inherent speed of light, these filters enable high-speed signal processing operations, paving the way to various space payload applications, such as agile frequency channelization. This capability allows for the simultaneous processing and analysis of different frequency bands. In this theoretical study, we introduce a fully reconfigurable filter comprising two decoupled ring resonators, each with the same radius. Each resonator can be independently thermally tuned to achieve reconfigurability in both central frequency and bandwidth. The precise reconfiguration of both central frequency and bandwidth is achieved by using the thermo-optic effect along the whole ring resonator path. A stopband rejection of 45 dB, with a reconfigurable bandwidth and central frequency of 20 MHz and 180 MHz, respectively, has been numerically achieved, with a maximum electrical power of 11.50 mW and a reconfiguration time of 9.20 µs, by using the scattering matrix approach, where the elements have been calculated through Finite Element Method-based and Beam Propagation Method-based simulations. This performance makes the proposed device suitable as key building block of RF optical filters, useful in the next-generation telecommunication payload domain.


  • Open Access

    Modeling Highly Efficient Homojunction Perovskite Solar Cells With Graphene-TiO2 Nanocomposite as the Electron Transport Layer

    by Nabarun Saha, Giuseppe Brunetti, Mario N. Armenise, Aldo Di Carlo, Caterina Ciminelli

    Perovskite-based solar cells have observed tremendous growth in the last decade aiming at developing renewable energy sources. The enhancement of the power conversion efficiency (PCE), sustainability, and easing of the fabrication are the main driving forces of the ongoing research activity. In this context, graphene is particularly promising since it not only provides better charge collection but also helps to improve the sustainability and low-temperature fabrication of the perovskite cell. Here, a homojunction MaPbI 3 perovskite solar cell with graphene-TiO 2 nano-composite as the electron transport layer (ETL) has been numerically investigated. The effect of doping concentration on the p and n-doped section in the homojunction-MaPbI 3 has been studied, showing that 10 17 and 10 16 cm −3 doping on the p and n section of MaPbI 3 , respectively, provide the best band alignment with the ETL layer. The optimum thickness ratio of two doped sections (p:n) is found to be 60:40 in %. Moreover, the presence of graphene in the TiO 2 layer improves PCE thanks to enhanced fill factor and saturated current density. A combined effect of all these results in a PCE of 22.71% with a 100 nm thick ETL layer having an optimum graphene concentration of around 1%.


  • Open Access

    A Compact, Highly Sensitive pH Sensor Based on Polymer Waveguide Bragg Grating

    by Nabarun Saha, Giuseppe Brunetti, Mario Nicola Armenise, Caterina Ciminelli

    Accurate probing, monitoring, and controlling the pH level is critical in different fields. In the last two decades, optical fiber/waveguide-based pH sensors have been widely investigated with the aim of further enhancement of sensitivity and miniaturization. Here, we propose a novel and cost-effective pH sensor based on polymer waveguide Bragg grating, addressing main aspects like sensitivity enhancement, miniaturization, narrow band response, and stable performance. The large evanescent field due to metal under cladding and high index coating combined with excellent penetration depth match with pH-sensitive polymer coating of poly-acrylic acid/poly-allylamine hydrochloride (PAA/PAH) in an aqueous medium, ensures a sensitivity of 10.4 nm/pH for a pH range of 4 to 7, two orders higher than all reported Bragg grating pH sensors to our knowledge. A narrow band (∼1 nm) response has been ensured by low propagation loss of the TE mode. Further, the variations in sensitivity and peak reflectivity are within 3% for a ±10% inaccuracy in various structural parameters, reflecting excellent fabrication tolerances. The proposed sensor is an important development, especially for the perishable food industry in which a high sensitivity in a pH range of 4 to 7 is highly desirable to accurately determine the freshness of foods.


  • A Long-Period Waveguide Grating Sensor for Accurate Simultaneous Detection of Dual Analytes

    by Krishnendu Dandapat, Nabarun Saha, Ranjeet Dwivedi, Saurabh Mani Tripathi, Arun Kumar

    To the best of our knowledge, we are the first to report the existence of two dispersion turning points (DTP) in an optimized planar waveguide long-period grating (LPG) sensor for the lowest order cladding mode. Using numerical simulation, we investigate the potential of the sensor structure for bulk refractive index (RI) and surface sensing, with the goal of predicting its possible application as an integrated photonic biosensor. The proposed sensor exhibits an exceptionally high RI sensitivity ~7500 nm/refractive index unit (RIU) (~10000 nm/RIU) near lower (higher) DTP. The surface sensitivity, which is incredibly high in this form of structure, is found to be 6.5 nm/nm (7 nm/nm) near lower (higher) DTP for the RI relevant for biosensing. Utilizing the sensing characteristics of both the DTP, we propose a dual-slot biosensor by cascading two LPGs having different grating periods. The proposed biosensor shows two independent dual-resonance phenomena and is, therefore, capable of simultaneous detection of dual analytes. Utilizing the proposed dual-slot biosensor, we present simulation results for specific detection of Hepatitis B antigen and DNA hybridization simultaneously. The proposed biosensor will reduce the sensor cost as well as detection time since a single source and detector are required to sense two different analytes at once.


  • Open Access

    Highly Sensitive Refractive Index Sensor Based on Polymer Bragg Grating: A Case Study on Extracellular Vesicles Detection

    by Nabarun Saha, Giuseppe Brunetti, Arun Kumar, Mario Nicola Armenise, Caterina Ciminelli

    The measurement of small changes in the refractive index (RI) leads to a comprehensive analysis of different biochemical substances, paving the way to non-invasive and cost-effective medical diagnosis. In recent times, the liquid biopsy for cancer detection via extracellular vesicles (EV) in the bodily fluid is becoming very popular thanks to less invasiveness and stability. In this context, here we propose a highly sensitive RI sensor based on a compact high-index-coated polymer waveguide Bragg grating with a metal under cladding. Owing to the combined effect of a metal under cladding and a high-index coating, a significant enhancement in the RI sensitivity as well as the dynamic range has been observed. The proposed sensor has been analyzed by combining finite element method (FEM) and coupled-mode theory (CMT) approaches, demonstrating a sensitivity of 408–861 nm/RIU over a broad dynamic range of 1.32–1.44, and a strong evanescent field within a 150 nm proximity to the waveguide surface compliant with EV size. The aforementioned performance makes the proposed device suitable for performing real-time and on-chip diagnoses of cancer in the early stage.