Alexander I. Reshmin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexander I. Reshmin has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- V. G. Lushchik
Moscow State University, Institute of Mechanics, Moscow, Russia
15 shared publications V. G. Lushchik
Institute of Mechanics, Moscow State University, Moscow, Russia
6 shared publications- M. S. Makarova
Moscow State University, Institute of Mechanics, Moscow, Russia
4 shared publications S. Kh. Teplovodskii
State Moscow University
4 shared publicationsA. A. Pavelyev
3 shared publications- A. D. Chicherina
Moscow State University, Institute of Mechanics, Moscow, Russia
3 shared publications
Latest Publications
- 1 August 2026
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 61 (4) , 70
Delay of Separation of the Turbulent Boundary Layer on a Permeable Plate with Gas Suction in Flow with an Adverse Pressure Gradient
Turbulent flow with an adverse pressure gradient in the boundary layer on a permeable plate with gas suction is studied numerically using a differential three-parameter RANS turbulence model. The study is carried out at a pressure gradient that corresponds to pre-separation boundary layer flow. The calculations made it possible to establish a boundary layer separation criterion on a permeable plate in the range of deceleration and gas suction parameters.
- 1 August 2026
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 61 (4) , 70
Delay of Separation of the Turbulent Boundary Layer on a Permeable Plate with Gas Suction in Flow with an Adverse Pressure Gradient
Turbulent flow with an adverse pressure gradient in the boundary layer on a permeable plate with gas suction is studied numerically using a differential three-parameter RANS turbulence model. The study is carried out at a pressure gradient that corresponds to pre-separation boundary layer flow. The calculations made it possible to establish a boundary layer separation criterion on a permeable plate in the range of deceleration and gas suction parameters.
- 1 June 2026
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 61 (3) , 58
Reynolds Analogy Factor in the Compressible Turbulent Boundary Layer on a Cooled Wall
The compressible turbulent boundary layer in supersonic flow on a cooled wall is numerically studied using the three-parameter differential RANS turbulence model. The study is carried out for a number of the Mach numbers (from 2 to 8) and a number of the temperature factors (from 0.2 to 0.8). The dependences of the Reynolds analogy coefficient on the Mach number and the temperature factor are found using the results of calculations of the flow and heat transfer characteristics.
- 1 June 2026
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 61 (3) , 58
Reynolds Analogy Factor in the Compressible Turbulent Boundary Layer on a Cooled Wall
The compressible turbulent boundary layer in supersonic flow on a cooled wall is numerically studied using the three-parameter differential RANS turbulence model. The study is carried out for a number of the Mach numbers (from 2 to 8) and a number of the temperature factors (from 0.2 to 0.8). The dependences of the Reynolds analogy coefficient on the Mach number and the temperature factor are found using the results of calculations of the flow and heat transfer characteristics.
- 3 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (6) , 118
Promising Heat Exchangers with Diffuser Channels
The most significant results of numerical study of the processes in heat exchangers with diffuser channels, obtained by the authors between 2020 and 2024, are reviewed. The plate and double-pipe heat exchangers with various gaseous and liquid coolants are considered. The performed studies showed that the amount of heat transferred from the “hot” to “cold” coolant increases as compared to heat exchangers with smooth channels of constant cross-section, due to the enhancement of heat transfer in heat exchangers with diffuser channels. The results obtained can serve as a basis for the development of new advanced heat exchangers.
- 3 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (6) , 118
Promising Heat Exchangers with Diffuser Channels
The most significant results of numerical study of the processes in heat exchangers with diffuser channels, obtained by the authors between 2020 and 2024, are reviewed. The plate and double-pipe heat exchangers with various gaseous and liquid coolants are considered. The performed studies showed that the amount of heat transferred from the “hot” to “cold” coolant increases as compared to heat exchangers with smooth channels of constant cross-section, due to the enhancement of heat transfer in heat exchangers with diffuser channels. The results obtained can serve as a basis for the development of new advanced heat exchangers.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 148
Comparative Analysis of Heat-Transfer Efficiency in Round and Flat Continuous Diffusers
Numerical simulation of flow and heat transfer in round and flat continuous diffusers with a smooth surface is performed using a three-parameter differential RANS turbulence model supplemented by a transfer equation for the turbulent heat flux. A comparative analysis of local and integral characteristics of the flow and heat transfer shows that, at the same opening angle, the Nusselt number in a round diffuser is higher than in a flat diffuser, and this excess increases with increasing opening angle. However, the Reynolds analogy factor for a round diffuser is slightly higher than for a flat diffuser due to the higher value of the friction coefficient in a round diffuser. It is shown that, with an increasing Reynolds number, the Reynolds analogy factor, both current and averaged over the diffuser length, slightly decreases. The Nusselt number averaged over the length also decreases, while the averaged friction coefficient remains practically constant.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 148
Comparative Analysis of Heat-Transfer Efficiency in Round and Flat Continuous Diffusers
Numerical simulation of flow and heat transfer in round and flat continuous diffusers with a smooth surface is performed using a three-parameter differential RANS turbulence model supplemented by a transfer equation for the turbulent heat flux. A comparative analysis of local and integral characteristics of the flow and heat transfer shows that, at the same opening angle, the Nusselt number in a round diffuser is higher than in a flat diffuser, and this excess increases with increasing opening angle. However, the Reynolds analogy factor for a round diffuser is slightly higher than for a flat diffuser due to the higher value of the friction coefficient in a round diffuser. It is shown that, with an increasing Reynolds number, the Reynolds analogy factor, both current and averaged over the diffuser length, slightly decreases. The Nusselt number averaged over the length also decreases, while the averaged friction coefficient remains practically constant.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (8) , 159
Reynolds Analogy Coefficient in a Compressible Turbulent Boundary Layer with a Pressure Gradient
Numerical study of a compressible turbulent boundary layer in supersonic flow with adverse and favorable pressure gradients is carried out using the three-parameter differential RANS turbulence model. The pressure gradients are implemented by changing the Mach number of the free-stream flow along the plate. The study is carried out for a number of the free-stream Mach numbers (from 1 to 3) and two values of the temperature factor (0.5 and 1.5). Using the results of calculations of the flow and heat transfer characteristics, the dependences of the Reynolds analogy coefficient on two pressure gradient parameters are obtained.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (8) , 159
Reynolds Analogy Coefficient in a Compressible Turbulent Boundary Layer with a Pressure Gradient
Numerical study of a compressible turbulent boundary layer in supersonic flow with adverse and favorable pressure gradients is carried out using the three-parameter differential RANS turbulence model. The pressure gradients are implemented by changing the Mach number of the free-stream flow along the plate. The study is carried out for a number of the free-stream Mach numbers (from 1 to 3) and two values of the temperature factor (0.5 and 1.5). Using the results of calculations of the flow and heat transfer characteristics, the dependences of the Reynolds analogy coefficient on two pressure gradient parameters are obtained.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 149
Study of Turbulent Flow Characteristics in Plate Heat Exchangers with Diffuser Channels
Numerical simulation of the flow and heat transfer in a unit of a counter-flow heat exchanger is carried out using a three-parameter differential RANS turbulence model supplemented by a transfer equation for a turbulent heat flow. The adjacent channels of the unit are flat, continuous diffusers with a smooth surface. The physical properties and thickness of the wall between the channels are taken into account. The analysis of the influence of the opening angle of the diffusers on the local and integral characteristics of the flow of hot and cold fluids, as well as heat exchange, shows that the intensity of turbulence and shear stress increase with an increase in the angle of inclination of the heat-transfer wall of the diffuser channel.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 149
Study of Turbulent Flow Characteristics in Plate Heat Exchangers with Diffuser Channels
Numerical simulation of the flow and heat transfer in a unit of a counter-flow heat exchanger is carried out using a three-parameter differential RANS turbulence model supplemented by a transfer equation for a turbulent heat flow. The adjacent channels of the unit are flat, continuous diffusers with a smooth surface. The physical properties and thickness of the wall between the channels are taken into account. The analysis of the influence of the opening angle of the diffusers on the local and integral characteristics of the flow of hot and cold fluids, as well as heat exchange, shows that the intensity of turbulence and shear stress increase with an increase in the angle of inclination of the heat-transfer wall of the diffuser channel.
- 17 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-7
Turbulent Boundary Layer on a Plate in Compressible Gas Flow
For the compressible turbulent boundary layer, the results of the numerical study using the three-parameter RANS turbulence model are compared with the results of direct numerical simulation (DNS). It is shown that the calculation results using the RANS model are in satisfactory agreement with the DNS results at the Mach numbers from 6 to 14. This makes it possible to recommend the use of the RANS model in engineering calculations of the hypersonic boundary layer when there is no need for powerful computing systems.
- 17 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-7
Turbulent Boundary Layer on a Plate in Compressible Gas Flow
For the compressible turbulent boundary layer, the results of the numerical study using the three-parameter RANS turbulence model are compared with the results of direct numerical simulation (DNS). It is shown that the calculation results using the RANS model are in satisfactory agreement with the DNS results at the Mach numbers from 6 to 14. This makes it possible to recommend the use of the RANS model in engineering calculations of the hypersonic boundary layer when there is no need for powerful computing systems.
- 1 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-16
Double-Pipe Heat Exchanger with Diffuser Channels with Gas and Liquid Coolants
Heat transfer in double-pipe heat exchangers with diffuser channels with small opening angles with gas and liquid coolants is numerically simulated. In the calculations, a three-parameter differential RANS turbulence model supplemented with a transfer equation for a turbulent heat flow is used. It is shown that due to the intensification of heat transfer in heat exchangers with diffuser channels, the amount of heat transferred from the hot coolant to the cold one increases compared to heat exchangers with channels with a constant cross section.
- 1 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-16
Double-Pipe Heat Exchanger with Diffuser Channels with Gas and Liquid Coolants
Heat transfer in double-pipe heat exchangers with diffuser channels with small opening angles with gas and liquid coolants is numerically simulated. In the calculations, a three-parameter differential RANS turbulence model supplemented with a transfer equation for a turbulent heat flow is used. It is shown that due to the intensification of heat transfer in heat exchangers with diffuser channels, the amount of heat transferred from the hot coolant to the cold one increases compared to heat exchangers with channels with a constant cross section.
- 1 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-15
Numerical Modeling of Flow Laminarization in Channels with a Negative Pressure Gradient
The flow and heat transfer in channels with a negative pressure gradient are numerically simulated using a three-parameter differential RANS turbulence model supplemented with a transfer equation for a turbulent heat flux. The flow in a planar converging channel with a small wall inclination angle is considered in a wide range of Reynolds numbers. Heat transfer in the flow of a helium-xenon gas mixture in a heated pipe is studied in a wide range of heat fluxes into the pipe wall. The flow acceleration parameter that ensures laminarization of the turbulent flow in the channel is estimated.
- 1 June 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (3) , 1-15
Numerical Modeling of Flow Laminarization in Channels with a Negative Pressure Gradient
The flow and heat transfer in channels with a negative pressure gradient are numerically simulated using a three-parameter differential RANS turbulence model supplemented with a transfer equation for a turbulent heat flux. The flow in a planar converging channel with a small wall inclination angle is considered in a wide range of Reynolds numbers. Heat transfer in the flow of a helium-xenon gas mixture in a heated pipe is studied in a wide range of heat fluxes into the pipe wall. The flow acceleration parameter that ensures laminarization of the turbulent flow in the channel is estimated.
- 1 October 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (5) , 1634-1645
Numerical Modeling of Flow and Heat Transfer in a Flat Confuser
Flow and heat transfer in a flat confuser is numerically modeled using a three-parameter differential RANS turbulence model supplemented with a transport equation for turbulent heat flow. The influence of the angle of inclination of the confuser wall and the Reynolds number on the characteristics of flow and heat transfer in the boundary layer is considered. The calculation results are compared with the experimental data.
- 1 October 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (5) , 1634-1645
Numerical Modeling of Flow and Heat Transfer in a Flat Confuser
Flow and heat transfer in a flat confuser is numerically modeled using a three-parameter differential RANS turbulence model supplemented with a transport equation for turbulent heat flow. The influence of the angle of inclination of the confuser wall and the Reynolds number on the characteristics of flow and heat transfer in the boundary layer is considered. The calculation results are compared with the experimental data.