Edoardo Moreci
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Edoardo Moreci has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Valerio Lo Brano
Department of Engineering, University of Palermo, 90133 Palermo, Italy
3 shared publications - Giuseppina Ciulla
Engineering Department, University of Palermo, Viale delle Scienze, Building 9, 90128 Palermo, Italy
2 shared publications Giuseppina Ciulla
1 shared publication- Marco Beccali
Università degli Studi di Palermo
1 shared publication - Vincenzo La Rocca
Dipartimento di Energia, Ingegneria dell'Informazione e Modelli Matematici - DEIM, University of Palermo, Palermo, Italy
1 shared publication
Latest Publications
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Energy and economic assessment of a small domestic wind turbine in Palermo
The cost effectiveness of micro-wind technology is closely linked to the annual energy production plants, which strongly depends on the wind characteristics and on the morphological properties of the installation site. The power curve of a wind turbine, supplied by manufacturers, characterizes the theoretical energy performance that it should have at a particular site. The behavior of a wind turbine in the field is affected by the speed but also by wind direction variations. At each change of direction and speed, the turbine will try to adapt to new conditions and the phase transition negatively influences the energy production. In order to experimentally confirm what above mentioned, the authors have built up a test facility and started a monitoring campaign in the urban area of Palermo. In particular, a micro wind turbine and a weather station were installed at the solar laboratory of DEIM. Thanks to data monitoring was possible a climate characterization of the site, and the evaluation of the experimental power curve of the turbine. The experimental data were discussed and compared to the manufactured data.
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Energy and economic assessment of a small domestic wind turbine in Palermo
The cost effectiveness of micro-wind technology is closely linked to the annual energy production plants, which strongly depends on the wind characteristics and on the morphological properties of the installation site. The power curve of a wind turbine, supplied by manufacturers, characterizes the theoretical energy performance that it should have at a particular site. The behavior of a wind turbine in the field is affected by the speed but also by wind direction variations. At each change of direction and speed, the turbine will try to adapt to new conditions and the phase transition negatively influences the energy production. In order to experimentally confirm what above mentioned, the authors have built up a test facility and started a monitoring campaign in the urban area of Palermo. In particular, a micro wind turbine and a weather station were installed at the solar laboratory of DEIM. Thanks to data monitoring was possible a climate characterization of the site, and the evaluation of the experimental power curve of the turbine. The experimental data were discussed and compared to the manufactured data.
- 1 January 2016
- Published by Elsevier in Sustainable Cities and Society
- Vol. 20, 81-95
Annual heating energy requirements of office buildings in a European climate
- 1 January 2016
- Published by Elsevier in Sustainable Cities and Society
- Vol. 20, 81-95
Annual heating energy requirements of office buildings in a European climate
- Open Access
- 9 September 2013
- Published by Wiley in International Journal of Photoenergy
- Vol. 2013, 1-10
Forecasting the Cell Temperature of PV Modules with an Adaptive System
The need to reduce energy consumptions and to optimize the processes of energy production has pushed the technology towards the implementation of hybrid systems for combined production of electric and thermal energies. In particular, recent researches look with interest at the installation of hybrid system PV/T. To improve the energy performance of these systems, it is necessary to know the operating temperature of the photovoltaic modules. The determination of the operating temperature is a key parameter for the assessment of the actual performance of photovoltaic panels. In the literature, it is possible to find different correlations that evaluate the referring to standard test conditions and/or applying some theoretical simplifications/assumptions. Nevertheless, the application of these different correlations, for the same conditions, does not lead to unequivocal results. In this work an alternative method, based on the employment of artificial neural networks (ANNs), was proposed to predict the operating temperature of a PV module. This methodology does not require any simplification or physical assumptions. In the paper is described the ANN that obtained the best performance: a multilayer perception network. The results have been compared with experimental monitored data and with some of the most cited empirical correlations proposed by different authors.
- 9 September 2013
- Published by Wiley in International Journal of Photoenergy
- Vol. 2013, 1-10
Open AccessForecasting the Cell Temperature of PV Modules with an Adaptive System
The need to reduce energy consumptions and to optimize the processes of energy production has pushed the technology towards the implementation of hybrid systems for combined production of electric and thermal energies. In particular, recent researches look with interest at the installation of hybrid system PV/T. To improve the energy performance of these systems, it is necessary to know the operating temperature of the photovoltaic modules. The determination of the operating temperature is a key parameter for the assessment of the actual performance of photovoltaic panels. In the literature, it is possible to find different correlations that evaluate the referring to standard test conditions and/or applying some theoretical simplifications/assumptions. Nevertheless, the application of these different correlations, for the same conditions, does not lead to unequivocal results. In this work an alternative method, based on the employment of artificial neural networks (ANNs), was proposed to predict the operating temperature of a PV module. This methodology does not require any simplification or physical assumptions. In the paper is described the ANN that obtained the best performance: a multilayer perception network. The results have been compared with experimental monitored data and with some of the most cited empirical correlations proposed by different authors.