Xinran Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xinran Lu has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- David K. Wood
Department of Biomedical Engineering, University of Minnesota, Minneapolis, MN
2 shared publications Anwesha Chaudhury
Center for Systems Biology and Department of Pathology, Massachusetts General Hospital, Boston, Massachusetts
1 shared publication- Changhai Zhao
Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun, China
1 shared publication Eric J. Olson
M Corporate Research Analytical Laboratory, 3M Center 201-BS-03, St. Paul, MN 55144-1000, United States
1 shared publication- Hai Yu
Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, People’s Republic of China
1 shared publication Jacob D. Calhoun
M Separation and Purification Sciences Division, 3M Center 236-1C-14, St. Paul, MN 55144-1000, United States
1 shared publication
Latest Publications
- 28 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-10
Investigation and Calibration of Error Compensation Methods for Linear Image-Type Angular Displacement Measurement
Angular displacement measurement based on image recognition methods is an increasingly popular approach to absolute displacement measurement. Employing multiple, collaborative image sensors can significantly reduce measurement errors when determining angular displacement. However, limited installation space restricts the number of sensors that can be utilized, and residual errors persist even when numerous sensors are employed. We propose an error correction method based on nonlinear fitting of multiple harmonic components to enhance measurement accuracy. This paper begins by elucidating the principles of image-type displacement measurement, then analyzing the harmonic errors inherent to such measurement results. Subsequently, we introduce a method for correcting angular displacement measurement errors based on nonlinear fitting of multiple harmonic components. We validate this method through experimentation. The results indicate that our error correction method can improve measurement accuracy from 510.97" to 0.82" with a code disk diameter of 87 mm when using only one reading head, suggesting that our method is effective. This work may offer a sound technical basis for the advancement of miniaturized and high-precision angular displacement measurement technology.
- 28 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-10
Investigation and Calibration of Error Compensation Methods for Linear Image-Type Angular Displacement Measurement
Angular displacement measurement based on image recognition methods is an increasingly popular approach to absolute displacement measurement. Employing multiple, collaborative image sensors can significantly reduce measurement errors when determining angular displacement. However, limited installation space restricts the number of sensors that can be utilized, and residual errors persist even when numerous sensors are employed. We propose an error correction method based on nonlinear fitting of multiple harmonic components to enhance measurement accuracy. This paper begins by elucidating the principles of image-type displacement measurement, then analyzing the harmonic errors inherent to such measurement results. Subsequently, we introduce a method for correcting angular displacement measurement errors based on nonlinear fitting of multiple harmonic components. We validate this method through experimentation. The results indicate that our error correction method can improve measurement accuracy from 510.97" to 0.82" with a code disk diameter of 87 mm when using only one reading head, suggesting that our method is effective. This work may offer a sound technical basis for the advancement of miniaturized and high-precision angular displacement measurement technology.
- Open Access
- 1 September 2021
- Published by Elsevier in Journal of Chromatography A
- Vol. 1654, 462445
Orthogonal pre-use and post-use efficiency testing for single-use anion exchange chromatography
- 1 September 2021
- Published by Elsevier in Journal of Chromatography A
- Vol. 1654, 462445
Open AccessOrthogonal pre-use and post-use efficiency testing for single-use anion exchange chromatography
- 21 August 2018
- Published by Wiley in American Journal of Hematology
- Vol. 93 (10) , 1227-1235
Oxygen‐dependent flow of sickle trait blood as an in vitro therapeutic benchmark for sickle cell disease treatments
Although homozygous sickle cell disease is often clinically severe, the corresponding heterozygous state, sickle cell trait, is almost completely benign despite the fact that there is only a modest difference in sickle hemoglobin levels between the two conditions. In both conditions, hypoxia can lead to polymerization of sickle hemoglobin, changes in red cell mechanical properties, and impaired blood flow. Here, we test the hypothesis that differences in the oxygen‐dependent rheological properties in the two conditions might help explain the difference in clinical phenotypes. We use a microfluidic platform that permits quantification of blood rheology under defined oxygen conditions in physiologically sized microchannels and under physiologic shear rates. We find that, even with its lower sickle hemoglobin concentration, sickle trait blood apparent viscosity increases with decreasing oxygen tension and may stop flowing under completely anoxic conditions, though far less readily than the homozygous condition. Sickle cell trait blood flow becomes impaired at significantly lower oxygen tension than sickle cell disease. We also demonstrate how sickle cell trait can serve as a benchmark for sickle cell disease therapies. We characterize the rheological effects of exchange transfusion therapy by mixing sickle blood with nonsickle blood and quantifying the transfusion targets for sickle hemoglobin composition below which the rheological response resembles sickle trait. These studies quantify the differences in blood flow phenotypes of sickle cell disease and sickle cell trait, and they provide a potentially powerful new benchmark for evaluating putative therapies in vitro.
- 21 August 2018
- Published by Wiley in American Journal of Hematology
- Vol. 93 (10) , 1227-1235
Oxygen‐dependent flow of sickle trait blood as an in vitro therapeutic benchmark for sickle cell disease treatments
Although homozygous sickle cell disease is often clinically severe, the corresponding heterozygous state, sickle cell trait, is almost completely benign despite the fact that there is only a modest difference in sickle hemoglobin levels between the two conditions. In both conditions, hypoxia can lead to polymerization of sickle hemoglobin, changes in red cell mechanical properties, and impaired blood flow. Here, we test the hypothesis that differences in the oxygen‐dependent rheological properties in the two conditions might help explain the difference in clinical phenotypes. We use a microfluidic platform that permits quantification of blood rheology under defined oxygen conditions in physiologically sized microchannels and under physiologic shear rates. We find that, even with its lower sickle hemoglobin concentration, sickle trait blood apparent viscosity increases with decreasing oxygen tension and may stop flowing under completely anoxic conditions, though far less readily than the homozygous condition. Sickle cell trait blood flow becomes impaired at significantly lower oxygen tension than sickle cell disease. We also demonstrate how sickle cell trait can serve as a benchmark for sickle cell disease therapies. We characterize the rheological effects of exchange transfusion therapy by mixing sickle blood with nonsickle blood and quantifying the transfusion targets for sickle hemoglobin composition below which the rheological response resembles sickle trait. These studies quantify the differences in blood flow phenotypes of sickle cell disease and sickle cell trait, and they provide a potentially powerful new benchmark for evaluating putative therapies in vitro.
- 27 January 2017
- Published by Wiley in Microcirculation
- Vol. 24 (5)
A microfluidic platform to study the effects of vascular architecture and oxygen gradients on sickle blood flow
Our goal was to develop a model of the microvasculature that would allow us to quantify changes in the rheology of sickle blood as it traverses the varying vessel sizes and oxygen tensions in the microcirculation. We designed and implemented a microfluidic model of the microcirculation that comprises a branching microvascular network and physiologic oxygen gradients. We used computational modeling to determine the parameters necessary to generate stable, linear gradients in our devices. Sickle blood from six unique patients was perfused through the microvascular network and subjected to varying oxygen gradients while we observed and quantified blood flow. We found that all sickle blood samples fully occluded the microvascular network when deoxygenated, and we observed that sickle blood could cause vaso‐occlusions under physiologic oxygen gradients during the microvascular transit time. The number of occlusions observed under five unique oxygen gradients varied among the patient samples, but we generally observed that the number of occlusions decreased with increasing inlet oxygen tension. The model system we have developed is a valuable tool to address fundamental questions about where in the circulation sickle‐cell vaso‐occlusions are most likely to occur and to test new therapies.
- 27 January 2017
- Published by Wiley in Microcirculation
- Vol. 24 (5)
A microfluidic platform to study the effects of vascular architecture and oxygen gradients on sickle blood flow
Our goal was to develop a model of the microvasculature that would allow us to quantify changes in the rheology of sickle blood as it traverses the varying vessel sizes and oxygen tensions in the microcirculation. We designed and implemented a microfluidic model of the microcirculation that comprises a branching microvascular network and physiologic oxygen gradients. We used computational modeling to determine the parameters necessary to generate stable, linear gradients in our devices. Sickle blood from six unique patients was perfused through the microvascular network and subjected to varying oxygen gradients while we observed and quantified blood flow. We found that all sickle blood samples fully occluded the microvascular network when deoxygenated, and we observed that sickle blood could cause vaso‐occlusions under physiologic oxygen gradients during the microvascular transit time. The number of occlusions observed under five unique oxygen gradients varied among the patient samples, but we generally observed that the number of occlusions decreased with increasing inlet oxygen tension. The model system we have developed is a valuable tool to address fundamental questions about where in the circulation sickle‐cell vaso‐occlusions are most likely to occur and to test new therapies.