Kristian Hengster-Movric
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kristian Hengster-Movric has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Michael Sebek
Czech Technical University in Prague
9 shared publications - Xueji Zhang
Atlas Copco Airpower NV, Boomsesteenweg, Antwerp, Belgium
4 shared publications - Cassio T. Faria
Siemens Industry Software NV, Interleuvenlaan 68, 3000 Leuven, Belgium
2 shared publications - Frank L. Lewis
UTA Research Institute, The University of Texas at Arlington, Arlington, TX, USA
2 shared publications - Stefan Knotek
Department of Control Engineering, Faculty of Electrical Engineering, Czech Technical University in Prague, 12135 Prague, Czechia
2 shared publications - Abhijit Das
Vijaygarh Jyotish Ray College
1 shared publication
Latest Publications
- 26 May 2023
- Published by Elsevier in Aerospace Science and Technology
- Vol. 139
Decentralized active damping control for aeroelastic morphing wing
- 26 May 2023
- Published by Elsevier in Aerospace Science and Technology
- Vol. 139
Decentralized active damping control for aeroelastic morphing wing
- 27 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 68 (10) , 6323-6329
Decentralized Design of Distributed Observers for LTI Systems
This note proposes a novel decentralized/decomposed design of distributed observers for general continuous-time linear time invariant (LTI) systems. Each observer can only observe a portion of the system. By transforming the system to a real Jordan canonical form, an observability decomposition is performed based on Popov-Belevitch-Hautus (PBH) test. Each observer reconstructs observable states from its local measurements. The unobservable states are reconstructed relying on a communication network, by virtue of synchronizing region design in pinning control theory. The required graph connectivity is milder than strongly connected graphs. The proposed design is decentralized in the sense that its computational complexity is decomposed via solving lower-dimensionality algebraic Riccati equations (AREs). The computational complexity is thus independent of the total number of agents in the graph, exhibiting a high level of scalability on large networks. Another key feature of the proposed design is that the convergence rate of estimation errors can be tuned to be arbitrarily fast. Numerical simulations demonstrate the design procedure and the corresponding performance.
- 27 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 68 (10) , 6323-6329
Decentralized Design of Distributed Observers for LTI Systems
This note proposes a novel decentralized/decomposed design of distributed observers for general continuous-time linear time invariant (LTI) systems. Each observer can only observe a portion of the system. By transforming the system to a real Jordan canonical form, an observability decomposition is performed based on Popov-Belevitch-Hautus (PBH) test. Each observer reconstructs observable states from its local measurements. The unobservable states are reconstructed relying on a communication network, by virtue of synchronizing region design in pinning control theory. The required graph connectivity is milder than strongly connected graphs. The proposed design is decentralized in the sense that its computational complexity is decomposed via solving lower-dimensionality algebraic Riccati equations (AREs). The computational complexity is thus independent of the total number of agents in the graph, exhibiting a high level of scalability on large networks. Another key feature of the proposed design is that the convergence rate of estimation errors can be tuned to be arbitrarily fast. Numerical simulations demonstrate the design procedure and the corresponding performance.
- 8 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 29 (5) , 1997-2011
Distributed Estimation on Sensor Networks With Measurement Uncertainties
This article brings distributed estimation for large-scale systems. The plant is considered affected by process disturbance, and measurements are corrupted by measurement noise. The proposed approach fuses measurements of differing reliability so that all nodes reach consensus on the plant's state estimate. This architecture is flexible to the addition of new nodes and, to a certain extent, robust to node or communication link failures. In spite of limited observability by each of the nodes, data fusion over the network allows each node to obtain the full estimate of the plant's state. Structured Lyapunov functions are used to prove the convergence of the estimator. Estimation error covariances are analyzed in detail. The proposed distributed observer design is validated by numerical simulations.
- 8 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 29 (5) , 1997-2011
Distributed Estimation on Sensor Networks With Measurement Uncertainties
This article brings distributed estimation for large-scale systems. The plant is considered affected by process disturbance, and measurements are corrupted by measurement noise. The proposed approach fuses measurements of differing reliability so that all nodes reach consensus on the plant's state estimate. This architecture is flexible to the addition of new nodes and, to a certain extent, robust to node or communication link failures. In spite of limited observability by each of the nodes, data fusion over the network allows each node to obtain the full estimate of the plant's state. Structured Lyapunov functions are used to prove the convergence of the estimator. Estimation error covariances are analyzed in detail. The proposed distributed observer design is validated by numerical simulations.
- 20 July 2020
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 30 (15) , 6166-6188
Distributed adaptive consensus protocol with decaying gains
- 20 July 2020
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 30 (15) , 6166-6188
Distributed adaptive consensus protocol with decaying gains
- 22 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 27 (1) , 1-13
Distributed Observer and Controller Design for Spatially Interconnected Systems
This paper tackles networked distributed observer and controller design problem over directed graph topology for spatially interconnected systems. Traditional centralized design methods suffer from a lack of adaptability to graph variations incurred by network reconfiguration, communication failures, and redundant sensors integration. In this paper, to handle the foregoing limitations imposed by centralized design, state observers are designed in a distributed manner facilitated by pinning control precepts. On the one hand, this novel approach adds fault tolerance with respect to communication link failures. On the other hand, the proposed approach brings flexibility of integrating additional sensors into the network. In addition, this approach affords a reduction of computational cost. A sufficient condition to guarantee stability of the closed-loop system is derived. The controllers, though in the end implemented in a distributed way, are designed in a centralized framework, where linear-quadratic-regulator theory is adopted to handle the fact that separation principle fails to hold in the networked observer and controller design. Numerical simulation results of a piezoelectric actuated smart flexible system are presented, and the effectiveness of the proposed design is thereby verified.
- 22 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 27 (1) , 1-13
Distributed Observer and Controller Design for Spatially Interconnected Systems
This paper tackles networked distributed observer and controller design problem over directed graph topology for spatially interconnected systems. Traditional centralized design methods suffer from a lack of adaptability to graph variations incurred by network reconfiguration, communication failures, and redundant sensors integration. In this paper, to handle the foregoing limitations imposed by centralized design, state observers are designed in a distributed manner facilitated by pinning control precepts. On the one hand, this novel approach adds fault tolerance with respect to communication link failures. On the other hand, the proposed approach brings flexibility of integrating additional sensors into the network. In addition, this approach affords a reduction of computational cost. A sufficient condition to guarantee stability of the closed-loop system is derived. The controllers, though in the end implemented in a distributed way, are designed in a centralized framework, where linear-quadratic-regulator theory is adopted to handle the fact that separation principle fails to hold in the networked observer and controller design. Numerical simulation results of a piezoelectric actuated smart flexible system are presented, and the effectiveness of the proposed design is thereby verified.
- 1 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 674-679
Consensus-based distributed sensor fusion over a network
This paper studies the distributed filtering of noisy measurements of one scalar quantity. The considered network is composed of two sets of nodes: sensing nodes which perform the measuring task and non-sensing nodes which mediate between the sensing nodes. Inspired by Bayesian sensor fusion, three consensus-based algorithms are proposed. In the algorithms, graph edge weights in effect are determined based on variances of measurements of all the sensors. Evolution dynamics of the expected values and covariances of the state estimates throughout the network is analyzed. Numerical simulations are given to examine the fusion performance of the proposed scheme. The results are fairly consistent with the analytical solution regarding the statistical properties of the steady-state state estimates in the network.
- 1 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 674-679
Consensus-based distributed sensor fusion over a network
This paper studies the distributed filtering of noisy measurements of one scalar quantity. The considered network is composed of two sets of nodes: sensing nodes which perform the measuring task and non-sensing nodes which mediate between the sensing nodes. Inspired by Bayesian sensor fusion, three consensus-based algorithms are proposed. In the algorithms, graph edge weights in effect are determined based on variances of measurements of all the sensors. Evolution dynamics of the expected values and covariances of the state estimates throughout the network is analyzed. Numerical simulations are given to examine the fusion performance of the proposed scheme. The results are fairly consistent with the analytical solution regarding the statistical properties of the steady-state state estimates in the network.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 269-273
Distributed adaptive consensus protocol with Laplacian eigenvalues estimation
This paper addresses distributed consensus problem for multi-agent systems with general linear time-invariant dynamics and undirected connected communication graphs. A distributed adaptive consensus protocol is found to solve problems of existing adaptive consensus protocols related to different, generally large and possibly unbounded coupling gains. This protocol guarantees ultimate boundedness under all conditions, however for an asymptotic stability, a proper estimation of reference values for coupling gains is required. Here, we propose an algorithm for the estimation of the coupling gain reference. The algorithm is based on a distributed estimation of the Laplacian eigenvalues. In comparison to the previously proposed algorithm based on the interval halving method, this algorithm offers robustness to change of the network topology. In addition, it decouples the estimation from the consensus protocol, hence it does not influence stability properties of the adaptive consensus protocol.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 269-273
Distributed adaptive consensus protocol with Laplacian eigenvalues estimation
This paper addresses distributed consensus problem for multi-agent systems with general linear time-invariant dynamics and undirected connected communication graphs. A distributed adaptive consensus protocol is found to solve problems of existing adaptive consensus protocols related to different, generally large and possibly unbounded coupling gains. This protocol guarantees ultimate boundedness under all conditions, however for an asymptotic stability, a proper estimation of reference values for coupling gains is required. Here, we propose an algorithm for the estimation of the coupling gain reference. The algorithm is based on a distributed estimation of the Laplacian eigenvalues. In comparison to the previously proposed algorithm based on the interval halving method, this algorithm offers robustness to change of the network topology. In addition, it decouples the estimation from the consensus protocol, hence it does not influence stability properties of the adaptive consensus protocol.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Generalized output synchronization of heterogeneous linear multi-agent systems
This paper investigates output synchronization of heterogeneous linear time-invariant systems. Agents distributively communicate measured outputs and synchronize on regulated outputs. Necessary structure of single-agents' drift dynamics is used. Relations between single-agent dynamics, measured outputs and regulated outputs are investigated. Cooperative stability conditions reduce to requirements depending separately on single-agents' structure and interconnecting graph topology, allowing for a distributed control design. Sufficient condition is given based on coordinate transformations which reveal the effects of distributed control on single-agents. It is shown that identical subsystem state synchronization and robustness to interconnections guarantee regulated output synchronization.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Generalized output synchronization of heterogeneous linear multi-agent systems
This paper investigates output synchronization of heterogeneous linear time-invariant systems. Agents distributively communicate measured outputs and synchronize on regulated outputs. Necessary structure of single-agents' drift dynamics is used. Relations between single-agent dynamics, measured outputs and regulated outputs are investigated. Cooperative stability conditions reduce to requirements depending separately on single-agents' structure and interconnecting graph topology, allowing for a distributed control design. Sufficient condition is given based on coordinate transformations which reveal the effects of distributed control on single-agents. It is shown that identical subsystem state synchronization and robustness to interconnections guarantee regulated output synchronization.
- 1 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2677-2682
Output H∞ synchronization of heterogeneous linear multi-agent systems via a distributed output-feedback
This paper investigates output H ∞ synchronization of a group of linear heterogeneous agents. Agents are subject to external unmodeled disturbances and distributively communicate one set of outputs. The aim is to design a distributed controller to achieve synchronization on another set of outputs with an H ∞ bound. We obtain an H ∞ -criterion for each agent that guarantees output synchronization in the absence of the external unmodeled disturbances and output H ∞ synchronization in their presence. We derive the overall L 2 -gain of the output synchronization error with respect to the external unmodeled disturbances. We demonstrate our developments by a simulation example.
- 1 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2677-2682
Output H∞ synchronization of heterogeneous linear multi-agent systems via a distributed output-feedback
This paper investigates output H ∞ synchronization of a group of linear heterogeneous agents. Agents are subject to external unmodeled disturbances and distributively communicate one set of outputs. The aim is to design a distributed controller to achieve synchronization on another set of outputs with an H ∞ bound. We obtain an H ∞ -criterion for each agent that guarantees output synchronization in the absence of the external unmodeled disturbances and output H ∞ synchronization in their presence. We derive the overall L 2 -gain of the output synchronization error with respect to the external unmodeled disturbances. We demonstrate our developments by a simulation example.
- 13 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 450-455
Distributed observer and controller design for state-output decomposed systems
This paper tackles the networked distributed observer and controller design problem. The observers are designed in a distributed fashion. The computation effort due to high dimension of the whole system is then mitigated. The controllers are designed using linear quadratic regulation theory. A sufficient condition to guarantee the stability of the closed-loop system is derived. A conservative matrix norm bound condition for the controller is provided as well. Numerical simulation is given to verify the design procedure.
- 13 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 450-455
Distributed observer and controller design for state-output decomposed systems
This paper tackles the networked distributed observer and controller design problem. The observers are designed in a distributed fashion. The computation effort due to high dimension of the whole system is then mitigated. The controllers are designed using linear quadratic regulation theory. A sufficient condition to guarantee the stability of the closed-loop system is derived. A conservative matrix norm bound condition for the controller is provided as well. Numerical simulation is given to verify the design procedure.