Everton Fernando Zanoelo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Everton Fernando Zanoelo has a total of 76 co-authors. Here are the top co-authors by number of shared publications:
Cristina Benincá
Graduate Program in Technological and Environmental Chemistry
15 shared publications- Ronald Wbeimar Pacheco Ortiz
Universidade Federal do Rio de Janeiro Rua Hélio de Almeida, 40, Cidade Universitária
6 shared publications Fabio Ferreira Gonçalves
3 shared publicationsLúcio Cardozo-Filho
Universidade Estadual de Maringá
3 shared publicationsAnnelorie Mattar Knesebeck
Federal University of Paraná, Graduate Program of Chemical Engineering, Polytechnic Center, Jardim das Américas, 81531-980, Curitiba, PR, Brazil
2 shared publications- Cristina Benincá
Federal University of Paraná, Department of Chemical Engineering , 81531-990 , Curitiba , Paraná , Brazil
2 shared publications
Latest Publications
- 23 October 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (44) , 18818-18831
Role of Graphite Electrodes for Removal of Persistent Contaminants in Electrochemical Systems with Chloride Salts as an Electrolyte: A Case Study of Disappearance of an Azo Dye
- 23 October 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (44) , 18818-18831
Role of Graphite Electrodes for Removal of Persistent Contaminants in Electrochemical Systems with Chloride Salts as an Electrolyte: A Case Study of Disappearance of an Azo Dye
- 21 August 2021
- Published by Springer Nature in Adsorption
- Vol. 27 (8) , 1237-1250
CO2 capture by ethanolamines functionalized resins: amination and kinetics of adsorption in a fixed bed
- 21 August 2021
- Published by Springer Nature in Adsorption
- Vol. 27 (8) , 1237-1250
CO2 capture by ethanolamines functionalized resins: amination and kinetics of adsorption in a fixed bed
- Open Access
- 1 January 2020
- Published by FapUNIFESP (SciELO) in Brazilian Archives of Biology and Technology
- Vol. 63
Kinetics and Equilibrium of Mercury Sorption by Three Different Types of Live Algae
The kinetics and equilibrium of experimental data of mercury (II) sorption using three different macrophytes E. crassipes, E. azurea and S. ariculata were analyzed. From the kinetic models used, the model 1, which considers the surface area of constant sorption, presents the coefficient of determination, R2, closer to the unit (0.97). Already, in the liquid phase, the best fit of the experimental data was obtained for model 2 (R2=0.96), which considers the variable surface area. The calculated values for the determination coefficients indicate that the Redlich-Peterson isotherm best describes the equilibrium (R2=0.79). The results show that the macrophyte S. ariculata surface area, which presented the highest adsorption potential (15.77x10-4m2.g-1), was far below those found in the best adsorbents. However, considering the large volume of adsorbent material required in an industrial plant and the low cost of the analyzed adsorbents, it is considered that the macrophytes investigated have a considerable potential for the removal of mercury from wastewater.
- 1 January 2020
- Published by FapUNIFESP (SciELO) in Brazilian Archives of Biology and Technology
- Vol. 63
Open AccessKinetics and Equilibrium of Mercury Sorption by Three Different Types of Live Algae
The kinetics and equilibrium of experimental data of mercury (II) sorption using three different macrophytes E. crassipes, E. azurea and S. ariculata were analyzed. From the kinetic models used, the model 1, which considers the surface area of constant sorption, presents the coefficient of determination, R2, closer to the unit (0.97). Already, in the liquid phase, the best fit of the experimental data was obtained for model 2 (R2=0.96), which considers the variable surface area. The calculated values for the determination coefficients indicate that the Redlich-Peterson isotherm best describes the equilibrium (R2=0.79). The results show that the macrophyte S. ariculata surface area, which presented the highest adsorption potential (15.77x10-4m2.g-1), was far below those found in the best adsorbents. However, considering the large volume of adsorbent material required in an industrial plant and the low cost of the analyzed adsorbents, it is considered that the macrophytes investigated have a considerable potential for the removal of mercury from wastewater.
- 13 May 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (22) , 9257-9265
Synthesis of Malic Acid on Montmorillonite K10: A Langmuir–Hinshelwood Kinetic Study
- 13 May 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (22) , 9257-9265
Synthesis of Malic Acid on Montmorillonite K10: A Langmuir–Hinshelwood Kinetic Study
- 19 September 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 125 (2) , 521-534
Isomerization and hydration of fumaric acid under catalytic and noncatalytic conditions
- 19 September 2018
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 125 (2) , 521-534
Isomerization and hydration of fumaric acid under catalytic and noncatalytic conditions
- 29 May 2018
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 206 (1) , 1-11
Photo-fenton and UV photo degradation of naphthalene with zero- and two-valent iron in the presence of persulfate
An initial set of 12 kinetic experiments was carried out to remove naphthalene from an aqueous effluent by photo-Fenton involving Fe0 and Fe2+ at two different concentrations of H2O2 (150 and 300 mg L−1) and three different pHs (3, 5, and 7) (22×31 experiments). The rate constants (k) for the reaction of naphthalene degradation by involving Fe2+ as reactant were in general higher than those with Fe0, but the use of Fe2+ increased the concentration of naphthalene at equilibrium (Ce) when compared with the same response obtained with Fe0 at analogous conditions. A second set of twelve kinetic experiments of photo-Fenton degradation was also performed with persulfate as additive at the conditions already reported, but at a constant concentration of H2O2 of 150 mg L−1 (21×31 experiments with NaCl +21×31 experiments without NaCl). In almost all the runs in which only the source of iron was varied, k from the kinetic data involving Fe2+ was higher than that involving Fe0, but no difference was observed in terms of Ce that was always zero. The addition of persulfate to treat the effluent either containing or not containing salt enhanced the chemical kinetics, and shifted the equilibrium toward the full removal of naphthalene. A final set of nine experiments of UV photo degradation of naphthalene by involving persulfate without iron, with Fe0 and Fe2+ in the pH range from 3 to 7 (32 experiments) mainly showed that the use of H2O2 may be avoided to remove rapidly and completely naphthalene from wastewater.
- 29 May 2018
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 206 (1) , 1-11
Photo-fenton and UV photo degradation of naphthalene with zero- and two-valent iron in the presence of persulfate
An initial set of 12 kinetic experiments was carried out to remove naphthalene from an aqueous effluent by photo-Fenton involving Fe0 and Fe2+ at two different concentrations of H2O2 (150 and 300 mg L−1) and three different pHs (3, 5, and 7) (22×31 experiments). The rate constants (k) for the reaction of naphthalene degradation by involving Fe2+ as reactant were in general higher than those with Fe0, but the use of Fe2+ increased the concentration of naphthalene at equilibrium (Ce) when compared with the same response obtained with Fe0 at analogous conditions. A second set of twelve kinetic experiments of photo-Fenton degradation was also performed with persulfate as additive at the conditions already reported, but at a constant concentration of H2O2 of 150 mg L−1 (21×31 experiments with NaCl +21×31 experiments without NaCl). In almost all the runs in which only the source of iron was varied, k from the kinetic data involving Fe2+ was higher than that involving Fe0, but no difference was observed in terms of Ce that was always zero. The addition of persulfate to treat the effluent either containing or not containing salt enhanced the chemical kinetics, and shifted the equilibrium toward the full removal of naphthalene. A final set of nine experiments of UV photo degradation of naphthalene by involving persulfate without iron, with Fe0 and Fe2+ in the pH range from 3 to 7 (32 experiments) mainly showed that the use of H2O2 may be avoided to remove rapidly and completely naphthalene from wastewater.
- 26 March 2018
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 205 (8) , 1050-1059
Soft-sensor models to estimate the efficiency of H2S removal from an oil refinery stream of nonphenolic sour water
A large set of results of concentration of hydrogen sulfide in the feed and bottom product streams of a sour water stripper found in a typical oil refinery was experimentally obtained. The readings of H2S concentrations were at several different operating conditions in terms of the main process variables that classically have significant effects on the efficiency of H2S removal (E). In particular, the considered factors were the mass flow rate, and temperature of sour water fed into the stripper, the mass flow rate of external steam injected into the reboiler, the difference between the temperature of the product stream leaving and entering the reboiler, and the difference of pressure at the two ends of the tower. Three different soft-sensor models were suggested to describe the observed variation in E from 63 to 97%, namely, an equilibrium, statistical and an artificial neural network model. The best of them was the neural network one with three input variables, four neurons in the one-hidden layer, and a hyperbolic tangent function for both the output and one-hidden layers. The mean absolute relative deviation between measured and calculated E by involving this model was only approximately 2.5% with negligible tendency for the residuals. It confirms the reliability of this approach as a tool to inferential estimation of the efficiency of removal of H2S from the sour water by stripping.
- 26 March 2018
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 205 (8) , 1050-1059
Soft-sensor models to estimate the efficiency of H2S removal from an oil refinery stream of nonphenolic sour water
A large set of results of concentration of hydrogen sulfide in the feed and bottom product streams of a sour water stripper found in a typical oil refinery was experimentally obtained. The readings of H2S concentrations were at several different operating conditions in terms of the main process variables that classically have significant effects on the efficiency of H2S removal (E). In particular, the considered factors were the mass flow rate, and temperature of sour water fed into the stripper, the mass flow rate of external steam injected into the reboiler, the difference between the temperature of the product stream leaving and entering the reboiler, and the difference of pressure at the two ends of the tower. Three different soft-sensor models were suggested to describe the observed variation in E from 63 to 97%, namely, an equilibrium, statistical and an artificial neural network model. The best of them was the neural network one with three input variables, four neurons in the one-hidden layer, and a hyperbolic tangent function for both the output and one-hidden layers. The mean absolute relative deviation between measured and calculated E by involving this model was only approximately 2.5% with negligible tendency for the residuals. It confirms the reliability of this approach as a tool to inferential estimation of the efficiency of removal of H2S from the sour water by stripping.
- Open Access
- 1 January 2018
- Published by Open Access Text Pvt, Ltd. in Integrative Food, Nutrition and Metabolism
- Vol. 5 (2)
Sodium content of salty biscuits marketed in Brazil: a benchmark study on the content of salt in processed foods and on consumer perceptions
- 1 January 2018
- Published by Open Access Text Pvt, Ltd. in Integrative Food, Nutrition and Metabolism
- Vol. 5 (2)
Open AccessSodium content of salty biscuits marketed in Brazil: a benchmark study on the content of salt in processed foods and on consumer perceptions