Sung-Yong Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sung-Yong Kim has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Cheol-Ho Lee
2 shared publicationsChae-Hee Han
1 shared publication- Chae-Hee Han
Research Center, STEELKOREA, Seoul 06028, Republic of Korea
1 shared publication - Cheol-Ho Lee
Seoul National Univ
1 shared publication Dae-Kyung Kim
College of Smart City Convergence, University of Ulsan, Ulsan, Korea
1 shared publicationDae-Youl Park
1 shared publication
Latest Publications
- 27 February 2026
- Published by Korean Society of Steel Construction in Journal of Korean Society of Steel Construction
- Vol. 38 (1) , 19-27
Development of a Camber Method for T–H Section Steel Beam through Preflex Introduction
- 27 February 2026
- Published by Korean Society of Steel Construction in Journal of Korean Society of Steel Construction
- Vol. 38 (1) , 19-27
Development of a Camber Method for T–H Section Steel Beam through Preflex Introduction
- 16 September 2025
- Published by Elsevier in Engineering Structures
- Vol. 344
Neural network-based hysteresis modeling for structural steel components
- 16 September 2025
- Published by Elsevier in Engineering Structures
- Vol. 344
Neural network-based hysteresis modeling for structural steel components
- 5 July 2025
- Published by Springer Nature in International Journal of Steel Structures
- Vol. 25 (4) , 974-989
Probabilistic Serviceability Assessment for Pedestrian Walkways: A Case Study on a 52-m Span Footbridge
- 5 July 2025
- Published by Springer Nature in International Journal of Steel Structures
- Vol. 25 (4) , 974-989
Probabilistic Serviceability Assessment for Pedestrian Walkways: A Case Study on a 52-m Span Footbridge
- Open Access
- 31 December 2024
- Published by Korean Society of Hazard Mitigation in Journal of the Korean Society of Hazard Mitigation
- Vol. 24 (6) , 1-9
Comparative Analysis of Civil Defense Shelters within Buildings by Country
The Republic of Korea currently faces a significant lack of chemical, biological, radiological and nuclear (CBRN) protective shelters for civilians. Thus, further research is required to expand their availability. This study examines the current state and standards of civil defense shelters within buildings by countries with high shelter coverage rates and compares them with those in the Republic of Korea. Switzerland and Finland constructed underground shelters with high-level protection against CBRN attacks. Israel and Singapore are vulnerable to immediate artillery strikes because of their relatively small territories, and they have prioritized accessibility by constructing shelters on each floor of the buildings. During the Cold War, the United States focused on nuclear fallout protection by utilizing parts of existing buildings. The Republic of Korea has focused on securing a number of shelters by utilizing existing underground spaces while constructing few high-performance shelters in border areas. The Republic of Korea needs to develop CBRN shelter models that are suitable for domestic conditions by referencing foreign shelter cases and gradually expanding them.
- 31 December 2024
- Published by Korean Society of Hazard Mitigation in Journal of the Korean Society of Hazard Mitigation
- Vol. 24 (6) , 1-9
Open AccessComparative Analysis of Civil Defense Shelters within Buildings by Country
The Republic of Korea currently faces a significant lack of chemical, biological, radiological and nuclear (CBRN) protective shelters for civilians. Thus, further research is required to expand their availability. This study examines the current state and standards of civil defense shelters within buildings by countries with high shelter coverage rates and compares them with those in the Republic of Korea. Switzerland and Finland constructed underground shelters with high-level protection against CBRN attacks. Israel and Singapore are vulnerable to immediate artillery strikes because of their relatively small territories, and they have prioritized accessibility by constructing shelters on each floor of the buildings. During the Cold War, the United States focused on nuclear fallout protection by utilizing parts of existing buildings. The Republic of Korea has focused on securing a number of shelters by utilizing existing underground spaces while constructing few high-performance shelters in border areas. The Republic of Korea needs to develop CBRN shelter models that are suitable for domestic conditions by referencing foreign shelter cases and gradually expanding them.
- Open Access
- 29 February 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (5) , 2012
Experimental and Numerical Analysis of a Temporary Bridge Connector Consisting of an Upper Bearing Block–Lower Pin Configuration
In this study, the structural details of a hinge connection for steel girder segments were developed to improve the process of rapid and easy construction. In the connector developed in this study (referred to as the “speedBridge” hereafter), the compression load exerted on the upper flange is resisted by two bearing blocks in contact with each other, and the tensile force on the bottom flange is resisted by the hinge structure installed at the lower part of the steel girder. The structural behavior of the developed connection was investigated experimentally. It was shown that the developed connection details could develop an excellent connection plastic rotation of 5% rad without fracture. The test specimen developed initial stiffness in accordance with elementary beam theory for a supported beam. The maximum load reached 110% of the plastic moment of the beam. Finite element analysis was conducted to comprehend the load transfer path, and the results demonstrated that the hinge connection exhibited sufficient stiffness and strength, exceeding the bending capacity of the beam under tension without any signs of the failure modes considered in the design procedure.
- 29 February 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (5) , 2012
Open AccessExperimental and Numerical Analysis of a Temporary Bridge Connector Consisting of an Upper Bearing Block–Lower Pin Configuration
In this study, the structural details of a hinge connection for steel girder segments were developed to improve the process of rapid and easy construction. In the connector developed in this study (referred to as the “speedBridge” hereafter), the compression load exerted on the upper flange is resisted by two bearing blocks in contact with each other, and the tensile force on the bottom flange is resisted by the hinge structure installed at the lower part of the steel girder. The structural behavior of the developed connection was investigated experimentally. It was shown that the developed connection details could develop an excellent connection plastic rotation of 5% rad without fracture. The test specimen developed initial stiffness in accordance with elementary beam theory for a supported beam. The maximum load reached 110% of the plastic moment of the beam. Finite element analysis was conducted to comprehend the load transfer path, and the results demonstrated that the hinge connection exhibited sufficient stiffness and strength, exceeding the bending capacity of the beam under tension without any signs of the failure modes considered in the design procedure.
- Open Access
- 22 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (21) , 10696
Vacant House Characteristics by Use Area and Their Application to Sustainable Community
The problem of vacant houses is important to identify its causes and then solve it. This study aims to determine the factors affecting the occurrence of vacant houses and examines their influence. The results highlight that the residential environment, population, social, physical environment, and geographic factors are statistically significant for the residential areas’ vacant house occurrence, but physical environmental was not significant for the commercial area vacant house occurrence; however, the individual building factor was significant. In residential areas, if the housing itself becomes obsolete or the area is outdated, people often depart from the area, leaving behind empty houses. In the commercial area, it is possible to decrease the number of vacant houses by converting old houses into shops in line with revitalizing a commercial district; a decrease in the number of businesses can be interpreted as a decline in commercial districts and an increase in vacant houses.
- 22 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (21) , 10696
Open AccessVacant House Characteristics by Use Area and Their Application to Sustainable Community
The problem of vacant houses is important to identify its causes and then solve it. This study aims to determine the factors affecting the occurrence of vacant houses and examines their influence. The results highlight that the residential environment, population, social, physical environment, and geographic factors are statistically significant for the residential areas’ vacant house occurrence, but physical environmental was not significant for the commercial area vacant house occurrence; however, the individual building factor was significant. In residential areas, if the housing itself becomes obsolete or the area is outdated, people often depart from the area, leaving behind empty houses. In the commercial area, it is possible to decrease the number of vacant houses by converting old houses into shops in line with revitalizing a commercial district; a decrease in the number of businesses can be interpreted as a decline in commercial districts and an increase in vacant houses.
- 1 December 2017
- Published by Elsevier in Journal of Constructional Steel Research
- Vol. 139, 62-68
Seismic retrofit of welded steel moment connections with highly composite floor slabs
- 1 December 2017
- Published by Elsevier in Journal of Constructional Steel Research
- Vol. 139, 62-68
Seismic retrofit of welded steel moment connections with highly composite floor slabs
- Open Access
- 27 February 2012
- Published by Korean Society of Steel Construction in Journal of Korean Society of Steel Construction
- Vol. 24 (1) , 1-11
Development of Time Lag Considered (TLC) Crowd Load Model Based on Probabilistic Approach
- 27 February 2012
- Published by Korean Society of Steel Construction in Journal of Korean Society of Steel Construction
- Vol. 24 (1) , 1-11
Open AccessDevelopment of Time Lag Considered (TLC) Crowd Load Model Based on Probabilistic Approach