Amir Naeiji
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Amir Naeiji has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Farzaneh Raji
Florida Int Univ, Miami, FL 33199 USA
2 shared publications - Ioannis Zisis
Florida International Univ
2 shared publications I. Zisis
PhD Student, Department of Civil and Environmental Engineering, Florida International University, 10555 W. Flagler Street, EC 3680, Miami, FL 33174
1 shared publication- Manuel Matus
DDA Forensics
1 shared publication - Mohammadtaghi Moravej
Dept. of Civil and Environmental Engineering, Florida International Univ., 10555 W. Flagler St., Miami, FL 33174
1 shared publication
Latest Publications
- 6 June 2022
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 227
Codification study of wind-induced loads on canopies attached to mid-rise buildings
- 6 June 2022
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 227
Codification study of wind-induced loads on canopies attached to mid-rise buildings
- Open Access
- 17 May 2019
- Published by Florida International University
Wind Loads on Residential Rooftop Solar Photovoltaic Panels
Solar energy harvesting using photovoltaic (PV) systems has gained popularity in recent years due to its relative ease of use and its cost efficiency compared to the rest of the clean energy sources. However, to further expand the application of PV systems requires making them more desirable than the other competitive energy sources. The improvement of safety and cost efficiency are requisites for further popularization of PV system application. To satisfy these requisites it is necessary to optimally design the system against the environmental conditions. Wind action is one of the main ambient loads affecting the performance of PV systems. This dissertation aims to investigate the effects of wind load on residential scale roof mounted PV panels and their supporting structures as well as evaluating the structural response of the system to the wind-induced vibration. To achieve these goals, several full- and large-scale experimental tests were performed at the Wall of Wind Experimental Facility at Florida International University (FIU). The wind effects on different PV system and roof configurations were investigated in these tests. The results shed light on the most influential parameters affecting the wind pressures acting on the PV panel surface. In addition, the findings are presented in the form of design pressure coefficients for adoption to future building codes and wind standards. The second phase of the physical testing included the investigation of the actual response of the PV system to the wind action. Because of the dynamic properties of the PV panel, it was expected that the wind induced vibration can affect the dynamic response of the system including the acceleration at the panel surface and support reactions at the racking system to roof interface. To test this theory, two different models of the system were developed, one with the real PV panels and the other one with wooden rigid panels. Comparing the results, it was concluded that the dynamic response of the system was not considerably affected by wind-induced fluctuations. Finally, and to better understand the dynamic response of the system, an analytical model was developed using ANSYS and dynamic analysis was carried out using as input the wind induced pressure data acquired from the physical testing. At the first step, the analytical model was verified by comparing the analytical modal frequencies to the experimental natural frequencies obtained from the hammer test. It was shown that the analytical model can well represent the dynamic properties
- 17 May 2019
- Published by Florida International University
Open AccessWind Loads on Residential Rooftop Solar Photovoltaic Panels
Solar energy harvesting using photovoltaic (PV) systems has gained popularity in recent years due to its relative ease of use and its cost efficiency compared to the rest of the clean energy sources. However, to further expand the application of PV systems requires making them more desirable than the other competitive energy sources. The improvement of safety and cost efficiency are requisites for further popularization of PV system application. To satisfy these requisites it is necessary to optimally design the system against the environmental conditions. Wind action is one of the main ambient loads affecting the performance of PV systems. This dissertation aims to investigate the effects of wind load on residential scale roof mounted PV panels and their supporting structures as well as evaluating the structural response of the system to the wind-induced vibration. To achieve these goals, several full- and large-scale experimental tests were performed at the Wall of Wind Experimental Facility at Florida International University (FIU). The wind effects on different PV system and roof configurations were investigated in these tests. The results shed light on the most influential parameters affecting the wind pressures acting on the PV panel surface. In addition, the findings are presented in the form of design pressure coefficients for adoption to future building codes and wind standards. The second phase of the physical testing included the investigation of the actual response of the PV system to the wind action. Because of the dynamic properties of the PV panel, it was expected that the wind induced vibration can affect the dynamic response of the system including the acceleration at the panel surface and support reactions at the racking system to roof interface. To test this theory, two different models of the system were developed, one with the real PV panels and the other one with wooden rigid panels. Comparing the results, it was concluded that the dynamic response of the system was not considerably affected by wind-induced fluctuations. Finally, and to better understand the dynamic response of the system, an analytical model was developed using ANSYS and dynamic analysis was carried out using as input the wind induced pressure data acquired from the physical testing. At the first step, the analytical model was verified by comparing the analytical modal frequencies to the experimental natural frequencies obtained from the hammer test. It was shown that the analytical model can well represent the dynamic properties
- 1 September 2017
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 168, 228-246
Wind loads on residential scale rooftop photovoltaic panels
- 1 September 2017
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 168, 228-246
Wind loads on residential scale rooftop photovoltaic panels
- 17 April 2015
- Published by American Society of Civil Engineers (ASCE)
- p. 1868-1878
Large-Scale Wind Testing of Photovoltaic Panels Mounted on Residential Roofs
- 17 April 2015
- Published by American Society of Civil Engineers (ASCE)
- p. 1868-1878
Large-Scale Wind Testing of Photovoltaic Panels Mounted on Residential Roofs