SHShirzad Hosseinverdi

Shirzad Hosseinverdi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shirzad Hosseinverdi has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Experimental and numerical investigations of transition in a pressure-gradient-induced laminar separation bubble

    by David Borgmann, Shirzad Hosseinverdi, Jesse Little, Hermann Fasel

    A pressure-gradient-induced laminar separation bubble (LSB) was examined using wind-tunnel experiments, direct numerical simulations (DNS) and linear local/global stability analysis. The LSB was experimentally generated on a flat plate using the favourable-to-adverse pressure gradient imposed by an inverted modified NACA $64_3-618$ airfoil. Direct numerical simulation was performed using boundary conditions extracted from a steady precursor simulation of the entire flow field. Despite good agreement in the upstream boundary layer with the experiment, DNS exhibited an approximately 25 % longer mean separation bubble, attributed to an earlier onset of transition due to the free-stream turbulence (FST) in the experiment. Introducing a very low level of isotropic FST in the DNS, similar to that measured in the experiment, caused earlier transition, decreased the mean bubble length and led to a remarkably good agreement between the DNS and experiments. Differences were observed for the dominant frequencies in the experiment and DNS, but both were within the band of most amplified frequencies predicted by LST. Proper orthogonal decomposition confirmed that dominant coherent structures from DNS and experiments are related to the inviscid Kelvin–Helmholtz instability and have similar characteristics despite slight differences in frequency. Local and global stability and dynamic mode decomposition analysis corroborated the convective nature of the dominant two-dimensional (2-D) instability and showed that the LSB is globally unstable to a range of 3-D wavenumbers, in agreement with 3-D structures observed in experiments. Results confirmed the strong impact of very low FST levels on the LSB and indicate a close agreement of the time-averaged and instability characteristics between the experiments and DNS.


  • High-Order-Accurate Incompressible Flow Solver for High-Fidelity Numerical Simulations and Linear Stability Analysis

    by Shirzad Hosseinverdi, Hermann F. Fasel

    The development of high-fidelity versatile incompressible Navier–Stokes solver that is applicable for both direct numerical simulations (DNSs) and linear global stability investigations is presented and discussed. The solver is based on a vorticity–velocity formulation of the Navier–Stokes equations for orthogonal curvilinear grids. A rigorous and efficient approach is proposed that guarantees the divergence-free condition for the velocity and vorticity fields. The code incorporates advanced numerical algorithms including compact finite differences in combination with a pseudo-spectral method, together with an efficient and high-order-accurate Poisson solver. Linear stability modules based on the linearized Navier–Stokes equations (LNSEs) tailored for primary and secondary instability analyses are developed and incorporated into the code, such that the solver can switch from DNS to LNSE in a consistent manner by turning off the nonlinear terms and vice versa. The linear framework includes all the nonparallel effects with respect to the steady/unsteady baseflow and the form of disturbances, and because it is formulated as an initial value problem, both convective and absolute/global instability mechanisms can be investigated. An additional significant advantage of the linear module is that, for the secondary stability analysis, time-periodic assumption is not required and/or the unsteady baseflow does not have to be computed a priori. In the present paper, results obtained with the new Navier–Stokes solver are compared with benchmark solutions for the flow past a static and oscillating circular cylinder. The new code then was employed for a three-dimensional DNS of the flow for a wing section with a modified NACA 6 series airfoil at a chord Reynolds number of [ ]. Furthermore, the capability of the linear stability modules was demonstrated by investigating the primary and secondary (convective and absolute) instability mechanisms for boundary layers and the flow past a circular cylinder.


  • Laminar-Turbulent Transition in a Swept Low-Speed Boundary Layer

    by Ladan Bahrainirad, Shirzad Hosseinverdi, Hermann F. Fasel

    View Video Presentation: https://doi.org/10.2514/6.2022-3633.vid Evolution of three-dimensional disturbances in an accelerating swept laminar boundary layer is investigated by direct numerical simulations and linear parabolized stability equations (PSE). First, so-called controlled transition simulations were carried out where a single un- steady secondary instability wave is added to the baseflow distorted by a stationary primary crossflow vortex, and the nature of secondary instability regimes was identified. Next, the development of a three-dimensional wave packet was investigated, where the wave packet is generated by a localized short-duration pulse disturbance. DNS data support the results obtained from a PSE analysis, namely that the underlying baseflow is unstable with respect to both stationary and traveling crossflow modes with a wide range of frequencies and spanwise wavenumbers, whereby traveling crossflow modes are reaching the largest maximum amplitudes. Nonlinear mechanisms eventually trigger the transition process, as the wave packet breakdown to turbulent patches.

  • Investigation of low-speed boundary-layer instability and transition using experiments, theory and DNS

    by David Borgmann, Shirzad Hosseinverdi, Jesse C. Little, Hermann F. Fasel

    A collaborative study of boundary layer instability and transition has been conducted using wind tunnel experiments, direct numerical simulations (DNS) and linear stability theory (LST). Experiments are performed in the Arizona Low Speed Wind Tunnel (ALSWT) at approximately 7m/s (unit Reynolds number of 4.2 x 10^5 m^-1). The ALSWT test section velocity is adjustable through variation of the fan RPM and blade angle. A parametric study yielded minimum turbulence intensities of approximately 0.022% (1 Hz-10 kHz) over a range of RPM and blade angles. This low turbulence intensity was accompanied by benign spectral content primarily associated with blade passage frequency which could be moved outside of the range of interest for boundary layer stability studies. Installation of a flat plate and corresponding support structure increased turbulence intensity to 0.028% (1 Hz-10 kHz) but had no negative influence on stability experiments. Precursor calculations of the test section flow field were performed with ANSYS Fluent to provide boundary conditions for subsequent high resolution DNS in the region of interest on the flat plate downstream of the leading edge. A detailed comparison between experiments and DNS shows good agreement between boundary layer velocity profiles. Subtle discrepancies between experiments and DNS are attributed to the existence of favorable pressure gradient (beta_H = 0.015) in the experiment which results in slightly fuller velocity profiles and a more stable boundary layer. Disturbance growth experiments (linear problem) are performed using alternating current dielectric barrier discharge (ac- DBD) plasma actuators. A linearized Navier-Stokes solver was employed to map out the linear stability diagram which then guided the actuator location (Re_x = 10^5) and forcing frequency (50 Hz) to allow observation of both growth and decay of the disturbance amplitudes over the extent of the domain. Disturbance growth measurements are in good agreement between experiments and DNS for both first and second maxima and any discrepancies are explained by consideration of pressure gradient and nonzero free-stream turbulence in the experiment which is not captured in DNS. Finally, branch one and branch two neutral curves for a range of ac-DBD plasma forcing frequencies (30 Hz-100 Hz) are identified from experimental data and compare well with LST. Overall, these results show the utility of the ALSWT as a test bed for boundary layer stability and transition research.


  • Open Access

    A fourth-order accurate compact difference scheme for solving the three-dimensional Poisson equation with arbitrary boundaries

    by Shirzad Hosseinverdi, Hermann F. Fasel

    This paper presents an efficient high-order sharp-interface method for solving the three-dimensional (3D) Poisson equation with Dirichlet boundary conditions on a nonuniform Cartesian grid with irregular domain boundaries. The new approach is based on the combination of the fourth-order compact finite difference scheme and the preconditioned stabilized biconjugate-gradient (BiCGSTAB) method. Contrary to the original immersed interface method by LeVeque and Li [1], the new method does not require jump corrections, instead, the (regular) compact finite difference stencil is adjusted at the irregular grid points (in the vicinity of the interfaces of the immersed bodies) to obtain a solution that is sharp across the interface while keeping the fourth-order global accuracy. The contribution of the present work is the design of a fourth-order-accurate 3D Poisson solver whose accuracy and efficiency does not deteriorate in the presence of an immersed boundary. This is attributed to (i) the modification of the discrete operators near immersed boundaries does not lead to a wide grid stencil due to the compact nature of the discretization and (ii) a preconditioning technique whose efficiency and cost are independent of the complexity of the geometry and the presence or not of an immersed boundary. The accuracy and computational efficiency of the proposed algorithm is demonstrated and validated over a range of problems including smooth and irregular boundaries. The test cases show that the new method is fourth-order accurate in the maximum norm whether an immersed boundary is present or not, on uniform or nonuniform grids. Furthermore, the efficiency of the preconditioned BiCGSTAB is demonstrated with regard to convergence rate and `extra' floating-point operation ($FLOP_{extra}$) which is due to the presence of immersed boundaries.

  • Numerical investigation of laminar–turbulent transition in laminar separation bubbles: the effect of free-stream turbulence

    by Shirzad Hosseinverdi, Hermann F. Fasel

    The role of free-stream turbulence (FST) in the hydrodynamic instability mechanisms and transition to turbulence in laminar separation bubbles (LSBs) was investigated using direct numerical simulations (DNS). Towards this end, a set of highly resolved DNS have been carried out, where isotropic FST fluctuations with intensities from 0.1 % to 3 % are introduced to investigate the relevant physical mechanisms governing the interaction of separation and transition in LSBs. For disturbance-free simulations, i.e. without FST, laminar–turbulent transition involves a Kelvin–Helmholtz (KH) instability of the separated shear layer. For LSBs subjected to FST, vortical FST fluctuations penetrate the approaching attached laminar boundary layer upstream of the separation location and induce slowly growing low-frequency disturbances, so-called Klebanoff (K) modes, which cause a spanwise modulation with a distinct spanwise wavelength. Simultaneously, the FST enhances the initial levels of instability waves with frequencies in the frequency range of the KH instability, but at much smaller amplitude levels compared to the K-modes. Results from the calculations based on the linearized Navier–Stokes equations and comparison with DNS results reveal that the K-mode exhibits exponential growth in the separated shear layer until it reaches a peak amplitude. At the same time, two-dimensional (2D) disturbance waves are also exponentially amplified, in fact at larger growth rate compared to the K-mode, due to the primary (convective) shear-layer instability mechanism until they saturate downstream of the peak amplitude associated with the K-mode. Therefore, based on detailed spectral analysis and modal decompositions for the separation bubbles investigated, the transition process is the result of two different mechanisms: (i) strong amplification of high-frequency (order of the shedding frequency), essentially 2D or weakly oblique fluctuating disturbances and (ii) low-frequency, three-dimensional K-modes caused by FST. Depending on the intensity of the FST, one of these mechanisms would dominate the transition process, or both mechanisms act together and contribute simultaneously. The net effect of these two events is an acceleration of transition for an increased level of FST intensity, which in turn leads to a reduction of the extent of the separation bubble in streamwise and wall-normal directions. The ‘roll-up’ into spanwise large-scale vortical structures resulting from the shear-layer instability, and the eventual breakdown of these structures, strongly contribute to the reattachment process. The spanwise coherence of these ‘rollers’ deteriorates due to the presence of large-amplitude K-modes, thus effectively weakening their strength for high levels of FST intensities ( $Tu>1\,\%$ ).


  • Role of Klebanoff modes in active flow control of separation: direct numerical simulations

    by Shirzad Hosseinverdi, Hermann F. Fasel

    Our previous research has shown that an active flow control strategy using two-dimensional (2-D) harmonic blowing and suction with properly chosen frequency and amplitude can significantly reduce the separation region, delay transition to turbulence and can even relaminarize the flow. How such effective flow control for transition delay and relaminarization is affected by free-stream turbulence (FST) remains an open question. In order to answer this question, highly resolved direct numerical simulations (DNS) are carried out where very low-amplitude isotropic FST fluctuations are introduced at the inflow boundary of the computational domain. With FST the effectiveness of the flow control is not diminished, and the extent of the separated flow region is reduced by the same amount as for the zero FST case. However, a striking difference observed in the DNS is the fact that in the presence of even very low levels of FST, the flow transitions shortly downstream of the reattachment location of the bubble, contrary to the case without FST. It appears that this different behaviour for even very small levels of FST is caused by an interaction between the high-amplitude 2-D disturbances introduced by the flow control forcing and 3-D Klebanoff modes (K-modes) that are generated by the FST. The streamwise elongated streaks due to the K-modes cause a spanwise-periodic modulation of the basic flow and subsequently of the primary 2-D wave. The disturbances associated with this modulation exhibit strong growth and initiate the breakdown process to turbulence. Linear secondary instability investigations with respect to low-frequency 3-D disturbances are carried out based on the linearized Navier–Stokes equations. The response of the forced flow to the low-frequency 3-D disturbances reveals that the time-periodic base flow is unstable with respect to a wide range of 3-D modes. In particular, the wavelength associated with the spanwise spacing of the K-mode falls into the range of, and is in fact very close to, the most unstable 3-D disturbances. Results from the secondary instability analysis and the comparison with DNS results, support the conjecture that the forcing amplitude has a major impact on the onset and amplification rate of the K-modes: lowering the forcing amplitude postpones the onset of the growth of the K-modes and reduces the growth rate of the K-modes for a given FST intensity. The net effect of these two events is a delay of the transition onset. Nevertheless, the instability mechanism that governs the transition process is the same as previously identified, i.e. interaction of the K-mode and 2-D primary wave. Furthermore, for low levels of FST, the amplitude of the low-frequency K-modes scales linearly with the FST intensity in the approach boundary layer up to the secondary instability regime.