Leonardo Koerich
Research Subjects
Leonardo Koerich has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
André Weissheimer
University of Southern California, Los Angeles, Calif
3 shared publications- Daniel Paludo Brunetto
Federal University of Parana (UFPR) and private practice, Curitiba, Brazil
3 shared publications Lindsey Eidson
Private practice, Charlotte, NC
3 shared publicationsA. Weissheimer
Advanced Orthodontic Program, Herman Ostrow School of Dentistry, University of Southern California, Los Angeles, CA, USA
2 shared publicationsB. Paniagua
Departments of Psychiatry and Computer Science, University of North Carolina, Chapel Hill, NC, USA
2 shared publications- Jonathas Daniel Paggi Claus
Instituto Bucomaxilofacial, Florianópolis, SC, Brazil
2 shared publications
Latest Publications
- 1 September 2019
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 48 (9) , 1201-1208
Assessment of condylar changes after orthognathic surgery using computed tomography regional superimposition
- 1 September 2019
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 48 (9) , 1201-1208
Assessment of condylar changes after orthognathic surgery using computed tomography regional superimposition
- 1 October 2018
- Published by American Academy of Implant Dentistry in Journal of Oral Implantology
- Vol. 44 (5) , 365-369
A Technique of Cone-Beam Computerized Tomography Superimposition in Implant Dentistry
- 1 October 2018
- Published by American Academy of Implant Dentistry in Journal of Oral Implantology
- Vol. 44 (5) , 365-369
A Technique of Cone-Beam Computerized Tomography Superimposition in Implant Dentistry
- 1 August 2018
- Published by Elsevier in Journal of Cranio-Maxillofacial Surgery
- Vol. 46 (8) , 1348-1354
Three-dimensional stability analysis of maxillomandibular advancement surgery with and without articular disc repositioning
- 1 August 2018
- Published by Elsevier in Journal of Cranio-Maxillofacial Surgery
- Vol. 46 (8) , 1348-1354
Three-dimensional stability analysis of maxillomandibular advancement surgery with and without articular disc repositioning
- 25 May 2018
- Published by Elsevier in The Journal of Prosthetic Dentistry
- Vol. 120 (6) , 796-800
Computer-guided implant removal: A clinical report
- 25 May 2018
- Published by Elsevier in The Journal of Prosthetic Dentistry
- Vol. 120 (6) , 796-800
Computer-guided implant removal: A clinical report
- 1 November 2017
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 87 (6) , 926
Letters From Our Readers
Article Citation: Leonardo Koerich, Steven J. Lindauer, and André Weissheimer (2017) Letters From Our Readers. The Angle Orthodontist: November 2017, Vol. 87, No. 6, pp. 926-926. https://doi.org/10.2319/0003-3219-87.6.926
- 1 November 2017
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 87 (6) , 926
Letters From Our Readers
Article Citation: Leonardo Koerich, Steven J. Lindauer, and André Weissheimer (2017) Letters From Our Readers. The Angle Orthodontist: November 2017, Vol. 87, No. 6, pp. 926-926. https://doi.org/10.2319/0003-3219-87.6.926
- Open Access
- 1 October 2017
- Published by FapUNIFESP (SciELO) in Dental Press Journal of Orthodontics
- Vol. 22 (5) , 39-46
The effect of hard tissue surgical changes on soft tissue displacement: a pilot CBCT study
Keywords: Cone-Beam CT; Three-dimensional image; Orthognathic surgery
- 1 October 2017
- Published by FapUNIFESP (SciELO) in Dental Press Journal of Orthodontics
- Vol. 22 (5) , 39-46
Open AccessThe effect of hard tissue surgical changes on soft tissue displacement: a pilot CBCT study
Keywords: Cone-Beam CT; Three-dimensional image; Orthognathic surgery
- 1 May 2017
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 87 (3) , 473-479
Rapid 3D mandibular superimposition for growing patients
Objective: To evaluate the precision and reproducibility of a protocol to perform rapid voxel-based superimposition of the mandible in growing patients using CBCT. Materials and Methods: The sample comprised two cone-beam computed tomography scans taken at least 1 year apart from each of 24 growing patients. Voxel-based superimposition was performed by two examiners independently. The internal part of the symphysis extending to the first molar was used as the reference. The superimposition process took approximately 5 minutes. Once the mandibles were superimposed, surface models were created and root mean square (RMS) changes were obtained by means of iterative closest point. To evaluate precision, differences in three areas were measured between time point 1 (T1) and time point 2 (T2) superimposed. To evaluate reproducibility between different examiners, the distances between T2 superimposed by each operator were measured in five different areas. Descriptive statistics were used to evaluate the precision of the superimposition and the interexaminer reproducibility measurements for each case were reported individually. Results: The superimposition mean error between T1 and T2 for the right and left sides of the mandible and chin were 0.23 mm, 0.25 mm, and 0.33 mm, respectively. Interexaminer reproducibility error was ≤0.3 mm in 20 of 24 cases for measurements near the registration area. In the ramus area, two cases had errors >1 mm (1 mm–1.3 mm). Conclusion: The rapid superimposition was precise for assessing dentoalveolar changes and structures close to the registration area. However, evaluation of the condyles and ramus area had limitations and needs improvement.
- 1 May 2017
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 87 (3) , 473-479
Rapid 3D mandibular superimposition for growing patients
Objective: To evaluate the precision and reproducibility of a protocol to perform rapid voxel-based superimposition of the mandible in growing patients using CBCT. Materials and Methods: The sample comprised two cone-beam computed tomography scans taken at least 1 year apart from each of 24 growing patients. Voxel-based superimposition was performed by two examiners independently. The internal part of the symphysis extending to the first molar was used as the reference. The superimposition process took approximately 5 minutes. Once the mandibles were superimposed, surface models were created and root mean square (RMS) changes were obtained by means of iterative closest point. To evaluate precision, differences in three areas were measured between time point 1 (T1) and time point 2 (T2) superimposed. To evaluate reproducibility between different examiners, the distances between T2 superimposed by each operator were measured in five different areas. Descriptive statistics were used to evaluate the precision of the superimposition and the interexaminer reproducibility measurements for each case were reported individually. Results: The superimposition mean error between T1 and T2 for the right and left sides of the mandible and chin were 0.23 mm, 0.25 mm, and 0.33 mm, respectively. Interexaminer reproducibility error was ≤0.3 mm in 20 of 24 cases for measurements near the registration area. In the ramus area, two cases had errors >1 mm (1 mm–1.3 mm). Conclusion: The rapid superimposition was precise for assessing dentoalveolar changes and structures close to the registration area. However, evaluation of the condyles and ramus area had limitations and needs improvement.
- 1 May 2016
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 45 (5) , 662-669
Three-dimensional maxillary and mandibular regional superimposition using cone beam computed tomography: a validation study
- 1 May 2016
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 45 (5) , 662-669
Three-dimensional maxillary and mandibular regional superimposition using cone beam computed tomography: a validation study
- 1 November 2015
- Published by Wiley in Orthodontics & Craniofacial Research
- Vol. 19 (2) , 65-73
Three‐dimensional regional displacement after surgical–orthodontic correction of Class III malocclusion
Structured Objectives: To investigate how displacements of maxillo‐mandibular structures are associated with each other at splint removal and 1 year post‐surgery following 1‐jaw and 2‐jaw surgeries for correction of Class III malocclusion.Setting and Sample Population: Fifty patients who underwent surgical correction with maxillary advancement only (n = 25) or combined with mandibular setback (n = 25) were prospectively enrolled in this study.Methods: Cone‐beam computed tomographies were taken pre‐surgery, at splint removal and at 1 year post‐surgery. Three‐dimensional cranial base superimpositions and shape correspondence were used to measure the outcomes from pre‐surgery to splint removal (surgical changes) and splint removal to 1 year post‐surgery (post‐surgical adaptations). Pearson's correlation coefficients were used to evaluate the association between the regional displacements.Results: Both surgery groups presented mandibular clockwise rotation with surgery and post‐surgical adaptive counterclockwise rotation. In patients treated with maxillary advancement only, the surgical changes of the maxilla were significantly correlated with chin changes. The amount and direction of chin autorotation were significantly correlated with right and left ramus autorotation. Right and left condylar displacements were significantly correlated. One year post‐surgery, adaptive displacements and bone remodeling of both rami were correlated with the chin and condylar changes. For the 2‐jaw group, the few correlations between the positional and remodeling changes in the anatomic regions of interest observed due to the surgery were different than those observed after post‐surgical adaptations, suggesting that these changes occurred independently.Conclusion: Our results indicate that surgical displacements and post‐surgical adaptations are often correlated in one‐jaw surgery and are, in general, independent in two‐jaw surgery.
- 1 November 2015
- Published by Wiley in Orthodontics & Craniofacial Research
- Vol. 19 (2) , 65-73
Three‐dimensional regional displacement after surgical–orthodontic correction of Class III malocclusion
Structured Objectives: To investigate how displacements of maxillo‐mandibular structures are associated with each other at splint removal and 1 year post‐surgery following 1‐jaw and 2‐jaw surgeries for correction of Class III malocclusion.Setting and Sample Population: Fifty patients who underwent surgical correction with maxillary advancement only (n = 25) or combined with mandibular setback (n = 25) were prospectively enrolled in this study.Methods: Cone‐beam computed tomographies were taken pre‐surgery, at splint removal and at 1 year post‐surgery. Three‐dimensional cranial base superimpositions and shape correspondence were used to measure the outcomes from pre‐surgery to splint removal (surgical changes) and splint removal to 1 year post‐surgery (post‐surgical adaptations). Pearson's correlation coefficients were used to evaluate the association between the regional displacements.Results: Both surgery groups presented mandibular clockwise rotation with surgery and post‐surgical adaptive counterclockwise rotation. In patients treated with maxillary advancement only, the surgical changes of the maxilla were significantly correlated with chin changes. The amount and direction of chin autorotation were significantly correlated with right and left ramus autorotation. Right and left condylar displacements were significantly correlated. One year post‐surgery, adaptive displacements and bone remodeling of both rami were correlated with the chin and condylar changes. For the 2‐jaw group, the few correlations between the positional and remodeling changes in the anatomic regions of interest observed due to the surgery were different than those observed after post‐surgical adaptations, suggesting that these changes occurred independently.Conclusion: Our results indicate that surgical displacements and post‐surgical adaptations are often correlated in one‐jaw surgery and are, in general, independent in two‐jaw surgery.
- 1 September 2015
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 44 (9) , 1188-1196
Fast three-dimensional superimposition of cone beam computed tomography for orthopaedics and orthognathic surgery evaluation
- 1 September 2015
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 44 (9) , 1188-1196
Fast three-dimensional superimposition of cone beam computed tomography for orthopaedics and orthognathic surgery evaluation