Yoonsoo Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yoonsoo Kim has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- Jun Moon
Division of Endocrinology and Metabolism, Department of Internal Medicine Yeungnam University College of Medicine Daegu Korea
6 shared publications Vladimir Shin
Graduate School of Mechanical and Aerospace Engineering, Gyeongsang National University, Jinju, Republic of Korea
5 shared publications- Hyondong Oh
Korea Advanced Institute of Science and Technology (KAIST)
4 shared publications - Alain Vande Wouwer
Systems, Estimation, Control and Optimization (SECO), University of Mons, 7000 Mons, Belgium
3 shared publications - Neetesh Kumar
Department of Aerospace Engineering, Indian Institute of Technology Kanpur, Kanpur, India
3 shared publications - Ngo Phong Nguyen
Vietnamese–German University
3 shared publications
Latest Publications
- 29 October 2026
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- p. 1-29
Robust-powered yaw control of aircraft with distributed electric propulsors
This paper presents two robust-powered yaw control methods for distributed electric propulsion (DEP) aircraft. These two methods are based on a robust servo linear-quadratic regulator (RS-LQR), employing (1) a hybrid yaw control utilising both aerodynamic and electric forces and (2) a fault-tolerant control (FTC) working for the event of electric propulsor failure. The hybrid yaw controller optimally combines aerodynamic forces and electric propulsion by adjusting control weightings to improve tracking performance and robustness. Its performance is measured via settling time, maximum overshoot and a robustness measure quantified through the minimum singular value of the return difference matrix. In parallel, the FTC is initiated by a real-time fault detection algorithm that identifies faulty propulsors through the monitoring of yawing moment deviations, followed by the control being reconfigured to redistribute control effort among the remaining propulsors. As part of the FTC algorithm, a logic of equalising the yawing moment is introduced to minimise the impact of propulsor failures. The proposed methods are validated through a hardware-in-the-loop (HILS) simulation that involves Raspberry Pi and the FlightGear flight simulator. Results show significantly improved yaw tracking performance and system robustness.
- 29 October 2026
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- p. 1-29
Robust-powered yaw control of aircraft with distributed electric propulsors
This paper presents two robust-powered yaw control methods for distributed electric propulsion (DEP) aircraft. These two methods are based on a robust servo linear-quadratic regulator (RS-LQR), employing (1) a hybrid yaw control utilising both aerodynamic and electric forces and (2) a fault-tolerant control (FTC) working for the event of electric propulsor failure. The hybrid yaw controller optimally combines aerodynamic forces and electric propulsion by adjusting control weightings to improve tracking performance and robustness. Its performance is measured via settling time, maximum overshoot and a robustness measure quantified through the minimum singular value of the return difference matrix. In parallel, the FTC is initiated by a real-time fault detection algorithm that identifies faulty propulsors through the monitoring of yawing moment deviations, followed by the control being reconfigured to redistribute control effort among the remaining propulsors. As part of the FTC algorithm, a logic of equalising the yawing moment is introduced to minimise the impact of propulsor failures. The proposed methods are validated through a hardware-in-the-loop (HILS) simulation that involves Raspberry Pi and the FlightGear flight simulator. Results show significantly improved yaw tracking performance and system robustness.
- 25 March 2026
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 114 (6) , 459
Distributed Control of Cycloidal Rotors Using Command Filtered Adaptive Backstepping with Event-Triggered Synchronization
- 25 March 2026
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 114 (6) , 459
Distributed Control of Cycloidal Rotors Using Command Filtered Adaptive Backstepping with Event-Triggered Synchronization
- 18 March 2026
- Published by Elsevier in European Journal of Control
- Vol. 89
Stability margin of a cyclic platoon with a single distinct vehicle
- 18 March 2026
- Published by Elsevier in European Journal of Control
- Vol. 89
Stability margin of a cyclic platoon with a single distinct vehicle
- 6 February 2026
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 24 (2) , 175-189
Rank Minimization in Networked Control Systems: A Brief Survey
- 6 February 2026
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 24 (2) , 175-189
Rank Minimization in Networked Control Systems: A Brief Survey
- 4 January 2026
- Published by Springer Nature in International Journal of Aeronautical and Space Sciences
- Vol. 27 (4) , 3238-3258
Formation Optimization of Heterogeneous Multi-drone Systems for Load Transport
- 4 January 2026
- Published by Springer Nature in International Journal of Aeronautical and Space Sciences
- Vol. 27 (4) , 3238-3258
Formation Optimization of Heterogeneous Multi-drone Systems for Load Transport
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 55564-55578
Observer-Based Output Feedback Nonsingular Terminal Sliding Mode Control for Systems With Mismatched Disturbances: Theory and Applications
This paper proposes an observer-based output feedback nonsingular terminal sliding mode control (OBOF-NTSMC) for systems with mismatched disturbances. Compared with available sliding mode controllers with mismatched disturbances, the merits of the proposed OBOF-NTSMC comprise: fast and accurate finite-time estimation is achieved; the assumption of the (global) constant bound induced for the observer design is relaxed; regardless of the system order, only one observer is required for the control design; the strict assumption of all states to be measurable is removed; and fast and precise finite-time regulation of the system output is ensured. The proposed OBOF-NTSMC has three main components: a variable gain finite-time sliding mode observer (VGFT-SMO), a nonsingular terminal sliding surface (NTSS), and a modified super-twisting reaching law (MST-RL). By designing the VGFT-SMO, we first reconstruct the unmeasurable output derivatives and the accumulated disturbance. Then, the NTSS is proposed such that in the sliding phase, the system output is driven to zero. Finally, the MST-RL is designed to drive the sliding variable to zero during the reaching phase. A rigorous investigation is carried out to establish finite-time convergence of the system output. Extensive applications are given to illustrate the superiority of the proposed OBOF-NTSMC.
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 55564-55578
Open AccessObserver-Based Output Feedback Nonsingular Terminal Sliding Mode Control for Systems With Mismatched Disturbances: Theory and Applications
This paper proposes an observer-based output feedback nonsingular terminal sliding mode control (OBOF-NTSMC) for systems with mismatched disturbances. Compared with available sliding mode controllers with mismatched disturbances, the merits of the proposed OBOF-NTSMC comprise: fast and accurate finite-time estimation is achieved; the assumption of the (global) constant bound induced for the observer design is relaxed; regardless of the system order, only one observer is required for the control design; the strict assumption of all states to be measurable is removed; and fast and precise finite-time regulation of the system output is ensured. The proposed OBOF-NTSMC has three main components: a variable gain finite-time sliding mode observer (VGFT-SMO), a nonsingular terminal sliding surface (NTSS), and a modified super-twisting reaching law (MST-RL). By designing the VGFT-SMO, we first reconstruct the unmeasurable output derivatives and the accumulated disturbance. Then, the NTSS is proposed such that in the sliding phase, the system output is driven to zero. Finally, the MST-RL is designed to drive the sliding variable to zero during the reaching phase. A rigorous investigation is carried out to establish finite-time convergence of the system output. Extensive applications are given to illustrate the superiority of the proposed OBOF-NTSMC.
- 4 November 2025
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 23 (11) , 3225-3237
Adaptive Integral Backstepping Control for Blade Pitch Angle Tracking in a Distributed Electric Propulsion Based Cycloidal Rotor
- 4 November 2025
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 23 (11) , 3225-3237
Adaptive Integral Backstepping Control for Blade Pitch Angle Tracking in a Distributed Electric Propulsion Based Cycloidal Rotor
- 13 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 61 (4) , 8836-8852
Singular Perturbation Margin of INDI-Based Flight Control Systems With Delays
A linear singularly perturbed system (SPS) based on a linear approximation of Incremental Nonlinear Dynamic Inversion (INDI) is formulated for a general INDI-based flight control system. This system includes first-order actuator dynamics where its time constant is taken as the singular perturbation parameter. The stability of the singularly perturbed system (SPS) is studied, which gives an understanding of the sensitivity of INDI to delays. Two sources of delay are considered, one coming from the state derivative measurement and the other coming from the delayed input signal. It is shown in this paper that the upper bound of the singular perturbation parameter serves as a robustness metric of the SPS to the two types of delays. Consequently a relative singular perturbation margin (SPMR) is proposed as a delay margin. The results are confirmed with two aircraft simulation cases for MIMO and SISO systems. In the latter, the relationship between the relative singular perturbation margin (SPMR) and the phase margin (PM) is analyzed.
- 13 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 61 (4) , 8836-8852
Singular Perturbation Margin of INDI-Based Flight Control Systems With Delays
A linear singularly perturbed system (SPS) based on a linear approximation of Incremental Nonlinear Dynamic Inversion (INDI) is formulated for a general INDI-based flight control system. This system includes first-order actuator dynamics where its time constant is taken as the singular perturbation parameter. The stability of the singularly perturbed system (SPS) is studied, which gives an understanding of the sensitivity of INDI to delays. Two sources of delay are considered, one coming from the state derivative measurement and the other coming from the delayed input signal. It is shown in this paper that the upper bound of the singular perturbation parameter serves as a robustness metric of the SPS to the two types of delays. Consequently a relative singular perturbation margin (SPMR) is proposed as a delay margin. The results are confirmed with two aircraft simulation cases for MIMO and SISO systems. In the latter, the relationship between the relative singular perturbation margin (SPMR) and the phase margin (PM) is analyzed.
- 5 February 2025
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 23 (2) , 360-369
A Simple Demonstrator for Multi-agent Circular Formation Control With Collision Avoidance Using Distributed Model Predictive Control
- 5 February 2025
- Published by Springer Nature in International Journal of Control, Automation, and Systems
- Vol. 23 (2) , 360-369
A Simple Demonstrator for Multi-agent Circular Formation Control With Collision Avoidance Using Distributed Model Predictive Control