NKNeetesh Kumar

Neetesh Kumar

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Neetesh Kumar has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Aerodynamic characterisation of delta wing unmanned aerial vehicle using non-gradient-based estimator

    by N. Kumar, S. Saderla, Y. Kim

    Aerodynamic characterisation from flight testing is an integral subroutine for evaluating a new flight vehicle’s aerodynamic performance, stability and controllability. The estimation of aerodynamic parameters from flight test data has extensively been explored, in the past, using estimation methods such as the equation error method, output error method and filter error method. However, in the current era, non-gradient-based estimation techniques are gaining attention from researchers due to their inherent data-driven optimisation capability to find the global best solution. In this paper, a novel non-gradient-based estimation method is proposed for the aerodynamic characterisation of unmanned aerial vehicles from flight data, which relies on the maximum likelihood method augmented with particle swarm optimisation. Flight data sets of a wing-alone unmanned aerial vehicle are used to demonstrate the capabilities of the proposed method in estimating aerodynamic derivatives. Estimates from the proposed method are corroborated with the wind tunnel test and output error method results. It has been observed that simulated flight vehicle responses using estimated parameters are in good agreement with measured data in most of the manoeuvers considered. Confidence in the estimates of linear and nonlinear aerodynamic parameters is well established with the lower limit of Cramer-Rao bounds, which are minimal. The proposed method also demonstrates good predictability of the quasi-steady stall aerodynamic model by estimating stall characteristic parameters such as aerofoil static stall characteristics parameter, hysteresis time constant and breakpoint. The overall performance of the proposed estimation method is on par with the output error method and is validated with the proof-of-match exercise.


  • Open Access

    Parametric model identification of delta wing UAVs using filter error method augmented with particle swarm optimisation

    by J. P. Samuel J, N. Kumar, S. Saderla, Y. Kim

    From arsenal delivery to rescue missions, unmanned aerial vehicles (UAVs) are playing a crucial role in various fields, which brings the need for continuous evolution of system identification techniques to develop sophisticated mathematical models for effective flight control. In this paper, a novel parameter estimation technique based on filter error method (FEM) augmented with particle swarm optimisation (PSO) is developed and implemented to estimate the longitudinal and lateral-directional aerodynamic, stability and control derivatives of fixed-wing UAVs. The FEM used in the estimation technique is based on the steady-state extended Kalman filter, where the maximum likelihood cost function is minimised separately using a randomised solution search algorithm, PSO and the proposed method is termed FEM-PSO. A sufficient number of compatible flight data sets were generated using two cropped delta wing UAVs, namely CDFP and CDRW, which are used to analyse the applicability of the proposed estimation method. A comparison has been made between the parameter estimates obtained using the proposed method and the computationally intensive conventional FEM. It is observed that most of the FEM-PSO estimates are consistent with wind tunnel and conventional FEM estimates. It is also noticed that estimates of crucial aerodynamic derivatives obtained using FEM-PSO are having relative offsets of 2.5%, 1.5%, 6.5%, 3.4% and 7.6% w.r.t. wind tunnel values for CDFP, and 1.4%, 1.9%, 0.1%, 9.6% and 7.5% w.r.t. wind tunnel values for CDRW. Despite having slightly higher Cramer-Rao Lower Bounds of estimated aerodynamic derivatives using the FEM-PSO method, the simulated responses have a relative error of less than 0.10% w.r.t. measured flight data. A proof-of-match exercise is also conducted to ascertain the efficacy of the estimates obtained using the proposed method. The degree of effectiveness of the FEM-PSO method is comparable with conventional FEM.


  • Open Access

    System identification of cropped delta UAVs from flight test methods using particle Swarm-Optimisation-based estimation

    by N. Kumar, S. Saderla, Y. Kim

    In the era of Unmanned Aerial Systems (UAS), an onboard autopilot occupies a prominent place and is inevitable for many of their modern applications. The efficacy of autopilot heavily relies upon the accuracy of the sensors employed and the capability of the onboard flight controller. In general, aerodynamic behaviour and flight dynamic capabilities of Unmanned Aerial Vehicles (UAVs) govern the selection and the design of flight controllers. Precise modeling of linear aerodynamic characteristics from flight data can be achieved using many of the existing classical parameter estimation techniques such as Output Error Method (OEM), Equation Error Method (EEM), and Filter Error Method (FEM). However, all the classical methods may not be readily applicable for aerodynamic modeling in nonlinear flight envelopes. The current manuscript is an attempt to exploit the capabilities of the Artificial Intelligence (AI) technique, named Particle Swarm Optimisation (PSO), in combination with Least Squares (LS) cost function to perform linear as well as nonlinear aerodynamic parameter estimation. The aforementioned task is accomplished by considering flight data from manoeuvers pertaining to linear angles of attack, moderate and near stall flight envelopes of two different UAVs with cropped delta planform geometry. Parameters estimated using the proposed LS-PSO method are consistent with minimum standard deviation and are on a par with OEM estimates. The proposed LS-PSO method enhances the capabilities of LS-based EEM while estimating stall characteristic parameters, which was not possible with LS alone. The longitudinal and lateral-directional static parameters estimated from the full-scale wind tunnel testing of the two UAVs were also used to corroborate the results obtained from the flight data using the LS-PSO method.