Frank Bagusat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Frank Bagusat has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Hans-Jörg Mögel
Institute of Physical Chemistry
3 shared publications- Michael May
Fraunhofer Institute for High-Speed Dynamics, Ernst-Mach-Institut, EMI, Freiburg, Germany
3 shared publications - Torsten Lässig
Fraunhofer Institute for High Speed Dynamics, Ernst-Mach-Institut, Germany
3 shared publications - Andreas Heine
Ernst-Mach-Institut, EMI
2 shared publications - Christoph Sauer
Ernst-Mach-Institut, EMI
2 shared publications H. -J. Mögel
Freiberg University of Mining and Technology
2 shared publications
Latest Publications
- Open Access
- 20 July 2021
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 8 (1) , 2-19
Hugoniot Data and Equation of State Parameters for an Ultra-High Performance Concrete
This work aims at the characterization of a modern concrete material. For this purpose, we perform two experimental series of inverse planar plate impact (PPI) tests with the ultra-high performance concrete B4Q, using two different witness plate materials. Hugoniot data in the range of particle velocities from 180 to 840 m/s and stresses from 1.1 to 7.5 GPa is derived from both series. Within the experimental accuracy, they can be seen as one consistent data set. Moreover, we conduct corresponding numerical simulations and find a reasonably good agreement between simulated and experimentally obtained curves. From the simulated curves, we derive numerical Hugoniot results that serve as a homogenized, mean shock response of B4Q and add further consistency to the data set. Additionally, the comparison of simulated and experimentally determined results allows us to identify experimental outliers. Furthermore, we perform a parameter study which shows that a significant influence of the applied pressure dependent strength model on the derived equation of state (EOS) parameters is unlikely. In order to compare the current results to our own partially reevaluated previous work and selected recent results from literature, we use simulations to numerically extrapolate the Hugoniot results. Considering their inhomogeneous nature, a consistent picture emerges for the shock response of the discussed concrete and high-strength mortar materials. Hugoniot results from this and earlier work are presented for further comparisons. In addition, a full parameter set for B4Q, including validated EOS parameters, is provided for the application in simulations of impact and blast scenarios.
- 20 July 2021
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 8 (1) , 2-19
Open AccessHugoniot Data and Equation of State Parameters for an Ultra-High Performance Concrete
This work aims at the characterization of a modern concrete material. For this purpose, we perform two experimental series of inverse planar plate impact (PPI) tests with the ultra-high performance concrete B4Q, using two different witness plate materials. Hugoniot data in the range of particle velocities from 180 to 840 m/s and stresses from 1.1 to 7.5 GPa is derived from both series. Within the experimental accuracy, they can be seen as one consistent data set. Moreover, we conduct corresponding numerical simulations and find a reasonably good agreement between simulated and experimentally obtained curves. From the simulated curves, we derive numerical Hugoniot results that serve as a homogenized, mean shock response of B4Q and add further consistency to the data set. Additionally, the comparison of simulated and experimentally determined results allows us to identify experimental outliers. Furthermore, we perform a parameter study which shows that a significant influence of the applied pressure dependent strength model on the derived equation of state (EOS) parameters is unlikely. In order to compare the current results to our own partially reevaluated previous work and selected recent results from literature, we use simulations to numerically extrapolate the Hugoniot results. Considering their inhomogeneous nature, a consistent picture emerges for the shock response of the discussed concrete and high-strength mortar materials. Hugoniot results from this and earlier work are presented for further comparisons. In addition, a full parameter set for B4Q, including validated EOS parameters, is provided for the application in simulations of impact and blast scenarios.
- 1 August 2018
- Published by Elsevier in Composites Part B: Engineering
- Vol. 147, 47-55
Effect of consolidation pressure on the impact behavior of UHMWPE composites
- 1 August 2018
- Published by Elsevier in Composites Part B: Engineering
- Vol. 147, 47-55
Effect of consolidation pressure on the impact behavior of UHMWPE composites
- 24 April 2018
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 4 (2) , 231-243
Shock Response of Lightweight Adobe Masonry
- 24 April 2018
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 4 (2) , 231-243
Shock Response of Lightweight Adobe Masonry
- 1 December 2017
- Published by Elsevier in Composite Structures
- Vol. 182, 590-597
Investigations on the spall and delamination behavior of UHMWPE composites
- 1 December 2017
- Published by Elsevier in Composite Structures
- Vol. 182, 590-597
Investigations on the spall and delamination behavior of UHMWPE composites
- 1 January 2017
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 99, 122-130
Hugoniot data of Seeberger sandstone up to 7 GPa
- 1 January 2017
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 99, 122-130
Hugoniot data of Seeberger sandstone up to 7 GPa
- 1 December 2015
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 86, 240-248
Analysis of the shock response of UHMWPE composites using the inverse planar plate impact test and the shock reverberation technique
- 1 December 2015
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 86, 240-248
Analysis of the shock response of UHMWPE composites using the inverse planar plate impact test and the shock reverberation technique
- Open Access
- 7 September 2015
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 94, 01026
The role of the modified taylor impact test in dynamic material research
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 7 September 2015
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 94, 01026
Open AccessThe role of the modified taylor impact test in dynamic material research
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- Open Access
- 31 August 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 26, 01007
Modified Taylor-tests with miniaturized samples
- 31 August 2012
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 26, 01007
Open AccessModified Taylor-tests with miniaturized samples
- 29 February 2008
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 130 (12) , 4182-4186
Investigation of Structural Transition of Regenerated Silk Fibroin Aqueous Solution by Rheo-NMR Spectroscopy
In this study we applied Rheo-NMR to investigate the structural change of Bombyx mori silk fibroin in aqueous solution under shear. Monitoring the time dependence of 1H solution NMR spectra of silk fibroin subjected to constant shear strain, signal intensities of random coil decreased suddenly during shear while peaks from β-sheet structure did not arise in the solution spectra. After these experiments, an aggregate of silk was found in the Couette flow cell and its secondary structure was determined as β-sheet by 13C solid-state NMR. In conclusion the moderate shear applied here triggered the change in the secondary structure.
- 29 February 2008
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 130 (12) , 4182-4186
Investigation of Structural Transition of Regenerated Silk Fibroin Aqueous Solution by Rheo-NMR Spectroscopy
In this study we applied Rheo-NMR to investigate the structural change of Bombyx mori silk fibroin in aqueous solution under shear. Monitoring the time dependence of 1H solution NMR spectra of silk fibroin subjected to constant shear strain, signal intensities of random coil decreased suddenly during shear while peaks from β-sheet structure did not arise in the solution spectra. After these experiments, an aggregate of silk was found in the Couette flow cell and its secondary structure was determined as β-sheet by 13C solid-state NMR. In conclusion the moderate shear applied here triggered the change in the secondary structure.
- 14 January 2008
- Published by Springer Nature
- p. 82-84
Time periodic changes of viscosity in kaolin suspensions as an example for modelling concentrated suspensions
- 14 January 2008
- Published by Springer Nature
- p. 82-84
Time periodic changes of viscosity in kaolin suspensions as an example for modelling concentrated suspensions