Madeleine Schilliger Kildal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Madeleine Schilliger Kildal has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Jan Carlsson
Provinn AB, Gothenburg, Sweden
5 shared publications - Andres Alayon Glazunov
Linköping University Norrköping Campus Sweden
3 shared publications Amir Majidzadeh
2 shared publications- Jian Yang
Department of Electrical Engineering, Chalmers University of Technology, Gothenburg, Sweden
2 shared publications - Sadegh Mansouri Moghaddam
Department of Electrical Engineering, Chalmers University of Technology, Gothenburg, Sweden
2 shared publications - Aidin Razavi
Ericsson AB
1 shared publication
Latest Publications
- 4 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (8) , 5008-5020
Evaluation of a Random Line-of-Sight Over-the-Air Measurement Setup at 28 GHz
Over-the-air (OTA) measurement techniques have, and will continue to have, a key role in evaluating the performance of modern antennas and wireless devices. The new random line-of-sight (random-LOS) measurement setup offers the evaluation of the OTA performance of different types of devices, for example, car antennas and small wireless devices in the random-LOS environment. A plane wave is synthesized in the test zone of the OTA setup, where the far-field of a radio base station can be emulated. We present measurements and simulations of the random-LOS OTA measurement setup, employing a reflector antenna, with a dual-polarized linear array feed, operating at the 28 GHz band. An analysis of the power and phase-field distributions in a cylinder and a circular test zone is presented. The computed standard deviation (STD) of the power distribution is approximately 1dB within a circular test zone, with a diameter of 0.3m. The STD of the phase, within the same test zone, is less than 15°. The radiation patterns of a horn antenna have been measured in the random-LOS measurement setup and shown a good agreement with the theoretical values.
- 4 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (8) , 5008-5020
Evaluation of a Random Line-of-Sight Over-the-Air Measurement Setup at 28 GHz
Over-the-air (OTA) measurement techniques have, and will continue to have, a key role in evaluating the performance of modern antennas and wireless devices. The new random line-of-sight (random-LOS) measurement setup offers the evaluation of the OTA performance of different types of devices, for example, car antennas and small wireless devices in the random-LOS environment. A plane wave is synthesized in the test zone of the OTA setup, where the far-field of a radio base station can be emulated. We present measurements and simulations of the random-LOS OTA measurement setup, employing a reflector antenna, with a dual-polarized linear array feed, operating at the 28 GHz band. An analysis of the power and phase-field distributions in a cylinder and a circular test zone is presented. The computed standard deviation (STD) of the power distribution is approximately 1dB within a circular test zone, with a diameter of 0.3m. The STD of the phase, within the same test zone, is less than 15°. The radiation patterns of a horn antenna have been measured in the random-LOS measurement setup and shown a good agreement with the theoretical values.
- 2 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 69 (11) , 13165-13179
Verification of the Random Line-of-Sight Measurement Setup at 1.5-3 GHz Including MIMO Throughput Measurements of a Complete Vehicle
The performance evaluation of wireless systems is crucial for the development of future systems with more connected devices. It is essential to have an easy and relevant method for ensuring the wireless communication performance of the devices. We have recently developed a new random line-of-sight (random-LOS) measurement system for evaluating the communication performance of wireless devices, e.g., transceivers and antennas installed on a vehicle. In the measurement system, a plane wave is generated in the test zone emulating the far-field wave transmitted from a radio base station. In this paper we present both numerical simulations and actual experimental results of the random-LOS over-the-air (OTA) measurement setup operating in the 1.5-3 GHz band. The measurement accuracy is determined by the field variations within the test zone, where a smaller variation gives better measurement accuracy. In this paper the achieved accuracy expressed in terms of standard deviation (STD) was evaluated to be approximately 1 dB of the power within a cylindrical test zone of height 0.4 m and diameter 2 m. The active multiple-input multiple-output (MIMO) performance of antenna systems installed on an actual vehicle was measured and evaluated using the presented setup. A comparison to a theoretical zero forcing (ZF) receiver is also presented.
- 2 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 69 (11) , 13165-13179
Verification of the Random Line-of-Sight Measurement Setup at 1.5-3 GHz Including MIMO Throughput Measurements of a Complete Vehicle
The performance evaluation of wireless systems is crucial for the development of future systems with more connected devices. It is essential to have an easy and relevant method for ensuring the wireless communication performance of the devices. We have recently developed a new random line-of-sight (random-LOS) measurement system for evaluating the communication performance of wireless devices, e.g., transceivers and antennas installed on a vehicle. In the measurement system, a plane wave is generated in the test zone emulating the far-field wave transmitted from a radio base station. In this paper we present both numerical simulations and actual experimental results of the random-LOS over-the-air (OTA) measurement setup operating in the 1.5-3 GHz band. The measurement accuracy is determined by the field variations within the test zone, where a smaller variation gives better measurement accuracy. In this paper the achieved accuracy expressed in terms of standard deviation (STD) was evaluated to be approximately 1 dB of the power within a cylindrical test zone of height 0.4 m and diameter 2 m. The active multiple-input multiple-output (MIMO) performance of antenna systems installed on an actual vehicle was measured and evaluated using the presented setup. A comparison to a theoretical zero forcing (ZF) receiver is also presented.
- 10 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (11) , 6291-6299
Measurements and Simulations for Validation of the Random-LOS Measurement Accuracy for Vehicular OTA Applications
Over-the-air (OTA) measurement techniques are essential to verify the performance of antennas and wireless devices. The random line-of-sight (random-LOS) measurement setup offers the advantage to test the OTA performance of antennas mounted on cars in existing, or new, semianechoic chamber and full-anechoic chamber. Hence, reusing currently available infrastructures together with a cost-efficient measurement setup will reduce OTA costs for the automotive industry. In random-LOS, a plane wave is synthesized in the test zone, where the far field of a radio base station is emulated. We present measurements and simulations of a random-LOS OTA setup operating at the 2.7 GHz band. We compare the cases when the emulated base station signals are generated by a single dual-polarized bowtie antenna, a uniform linear array of bowties and a uniform planar array of bowties. The evaluation of the standard deviation of the reference received signal in the test zone shows good agreement between measurements and simulations. We show with measurements that for a test zone with a radius of 0.5 m, the standard deviation can be less than 0.8 dB for the analyzed random-LOS OTA setup.
- 10 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (11) , 6291-6299
Measurements and Simulations for Validation of the Random-LOS Measurement Accuracy for Vehicular OTA Applications
Over-the-air (OTA) measurement techniques are essential to verify the performance of antennas and wireless devices. The random line-of-sight (random-LOS) measurement setup offers the advantage to test the OTA performance of antennas mounted on cars in existing, or new, semianechoic chamber and full-anechoic chamber. Hence, reusing currently available infrastructures together with a cost-efficient measurement setup will reduce OTA costs for the automotive industry. In random-LOS, a plane wave is synthesized in the test zone, where the far field of a radio base station is emulated. We present measurements and simulations of a random-LOS OTA setup operating at the 2.7 GHz band. We compare the cases when the emulated base station signals are generated by a single dual-polarized bowtie antenna, a uniform linear array of bowties and a uniform planar array of bowties. The evaluation of the standard deviation of the reference received signal in the test zone shows good agreement between measurements and simulations. We show with measurements that for a test zone with a radius of 0.5 m, the standard deviation can be less than 0.8 dB for the analyzed random-LOS OTA setup.
- 1 April 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Measured probabilities of detection for 1- and 2 bitstreams of 2-port car-roof antenna in RIMP and Random-LOS
Autonomous cars will in a near future drive around in cities and on highways. Antennas will then be needed to secure the wireless connection to these cars. To be able to test the antennas we have defined two edge environments: the Random Line-of-Sight (LOS) and the Rich Isotropic Multipath (RIMP). This paper shows a throughput performance comparison between measurements and simulations of a car-roof (shark-fin) antenna mounted on a ground plane in both of these environments. The comparison is done for both one and two bitstreams in a 2×2 MIMO system. The analysis is based on probability of detection (PoD) curves representing the throughput performance with digital threshold receivers.
- 1 April 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Measured probabilities of detection for 1- and 2 bitstreams of 2-port car-roof antenna in RIMP and Random-LOS
Autonomous cars will in a near future drive around in cities and on highways. Antennas will then be needed to secure the wireless connection to these cars. To be able to test the antennas we have defined two edge environments: the Random Line-of-Sight (LOS) and the Rich Isotropic Multipath (RIMP). This paper shows a throughput performance comparison between measurements and simulations of a car-roof (shark-fin) antenna mounted on a ground plane in both of these environments. The comparison is done for both one and two bitstreams in a 2×2 MIMO system. The analysis is based on probability of detection (PoD) curves representing the throughput performance with digital threshold receivers.