Sofia K. Mylona
Research Subjects
Sofia K. Mylona has a total of 64 co-authors. Here are the top co-authors by number of shared publications:
- Marc J. Assael
Laboratory of Thermophysical Properties and Environmental Processes, Chemical Engineering Department, Aristotle University, Thessaloniki, Greece
14 shared publications - Richard A. Perkins
Thermophysical Properties of Fluids Group, National Institute of Standards and Technology, Boulder, USA
5 shared publications - Josefa Fernández
Laboratory of Thermophysical and Tribological Properties, Nafomat Group, Department of Applied Physics, Faculty of Physics and Institute of Materials (iMATUS), Universidade de Santiago de Compostela, 15782 Santiago de Compostela, Spain
4 shared publications M. L. Huber
National Institute of Standards and Technology Applied Chemicals and Materials Division 325 Broadway, Boulder, Colorado 80305, USA
4 shared publications- Maria J Perez Comuñas
Laboratory of Thermophysical and Tribological Properties, Nafomat Group, Department of Applied Physics, Faculty of Physics and Institute of Materials (iMATUS), University of Santiago de Compostela, 15782 Santiago de Compostela, Spain
4 shared publications - Eric F. May
Department of Chemical Engineering, The University of Western Australia, Crawley, WA 6009, Australia
3 shared publications
Latest Publications
- 1 January 2022
- Published by Begell House Inc. Publishers
THERMAL CONDUCTIVITY OF LIQUIDS MEASURED WITH THE TRANSIENT HOT-WIRE TECHNIQUE
The accurate knowledge of the thermophysical properties of fluids is crucial for the design and operation of heat transfer equipment. Discrepancies in thermophysical measurements from different laboratories and measurement techniques led the industrial research and development laboratories to search for commercial thermophysical properties instruments that would provide accurate and consistent measurements. One such instrument is the Transient Hot Wire. The Transient Hot-Wire Technique has a well-developed theory that is used to accurately measure the thermal conductivity of liquids, pastes and powders over a wide temperature and pressure range. In this work three commercial devices, laboratory and portable, are presented. All devices follow the ASTM D7896-19 standard for the thermal conductivity measurements by the Transient Hot-Wire technique. Depending on the model, they differ in the allowable temperature and pressure ranges. The accuracy and repeatability of each instrument were determined by measuring the properties of water, ethylene glycol, heptane, and glycerol at different temperatures. Data taken on all four fluids across all the sensors used had accuracies better than ± 5 % and repeatability better than ± 1 %, which makes the Transient Hot-Wire a reliable instrument that would provide consistent and accurate results.
- 1 January 2022
- Published by Begell House Inc. Publishers
THERMAL CONDUCTIVITY OF LIQUIDS MEASURED WITH THE TRANSIENT HOT-WIRE TECHNIQUE
The accurate knowledge of the thermophysical properties of fluids is crucial for the design and operation of heat transfer equipment. Discrepancies in thermophysical measurements from different laboratories and measurement techniques led the industrial research and development laboratories to search for commercial thermophysical properties instruments that would provide accurate and consistent measurements. One such instrument is the Transient Hot Wire. The Transient Hot-Wire Technique has a well-developed theory that is used to accurately measure the thermal conductivity of liquids, pastes and powders over a wide temperature and pressure range. In this work three commercial devices, laboratory and portable, are presented. All devices follow the ASTM D7896-19 standard for the thermal conductivity measurements by the Transient Hot-Wire technique. Depending on the model, they differ in the allowable temperature and pressure ranges. The accuracy and repeatability of each instrument were determined by measuring the properties of water, ethylene glycol, heptane, and glycerol at different temperatures. Data taken on all four fluids across all the sensors used had accuracies better than ± 5 % and repeatability better than ± 1 %, which makes the Transient Hot-Wire a reliable instrument that would provide consistent and accurate results.
- 3 September 2021
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 42 (12) , 1-17
High Pressure Thermal Conductivity Measurements of Ternary (Methane + Propane + Heptane) Mixtures with a Transient Hot-Wire Apparatus
- 3 September 2021
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 42 (12) , 1-17
High Pressure Thermal Conductivity Measurements of Ternary (Methane + Propane + Heptane) Mixtures with a Transient Hot-Wire Apparatus
- 30 January 2020
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 65 (2) , 906-915
High-Pressure Thermal Conductivity Measurements of a (Methane + Propane) Mixture with a Transient Hot-Wire Apparatus
- 30 January 2020
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 65 (2) , 906-915
High-Pressure Thermal Conductivity Measurements of a (Methane + Propane) Mixture with a Transient Hot-Wire Apparatus
- 1 June 2019
- Published by Elsevier in The Journal of Chemical Thermodynamics
- Vol. 133, 135-142
Thermal conductivity data for refrigerant mixtures containing R1234yf and R1234ze(E)
- 1 June 2019
- Published by Elsevier in The Journal of Chemical Thermodynamics
- Vol. 133, 135-142
Thermal conductivity data for refrigerant mixtures containing R1234yf and R1234ze(E)
- 1 March 2019
- Published by AIP Publishing in Journal of Physical and Chemical Reference Data
- Vol. 48 (1) , 013101
Reference Correlations for the Viscosity of 13 Inorganic Molten Salts
In 1988, reference correlations for the viscosity of a selection of molten inorganic salts were proposed by Janz and have been used extensively. During the last 31 years, many additional measurements have been published. In a very recent paper, new reference correlations for the thermal conductivity of 13 inorganic molten salts were proposed. In this paper, reference correlations for the viscosity of those same salts are proposed. All available experimental data for the viscosity of 13 inorganic molten salts have been critically examined with the intention of establishing improved or new reference viscosity correlations. All experimental data have been categorized into primary and secondary data according to the quality of measurement specified by a series of criteria. Standard reference correlations are proposed for the following molten salts (with estimated uncertainties at the 95% confidence level given in parentheses): LiNO3 (6.7%), NaNO3 (3.0%), KNO3 (3.0%), NaBr (1.6%), KBr (2.0%), RbBr (2.2%), LiCl (3.7%), NaCl (2.4%), KCl (1.6%), RbCl (3.6%), CsCl (1.1%), NaI (1.5%), and RbI (1.5%).
- 1 March 2019
- Published by AIP Publishing in Journal of Physical and Chemical Reference Data
- Vol. 48 (1) , 013101
Reference Correlations for the Viscosity of 13 Inorganic Molten Salts
In 1988, reference correlations for the viscosity of a selection of molten inorganic salts were proposed by Janz and have been used extensively. During the last 31 years, many additional measurements have been published. In a very recent paper, new reference correlations for the thermal conductivity of 13 inorganic molten salts were proposed. In this paper, reference correlations for the viscosity of those same salts are proposed. All available experimental data for the viscosity of 13 inorganic molten salts have been critically examined with the intention of establishing improved or new reference viscosity correlations. All experimental data have been categorized into primary and secondary data according to the quality of measurement specified by a series of criteria. Standard reference correlations are proposed for the following molten salts (with estimated uncertainties at the 95% confidence level given in parentheses): LiNO3 (6.7%), NaNO3 (3.0%), KNO3 (3.0%), NaBr (1.6%), KBr (2.0%), RbBr (2.2%), LiCl (3.7%), NaCl (2.4%), KCl (1.6%), RbCl (3.6%), CsCl (1.1%), NaI (1.5%), and RbI (1.5%).
- 4 April 2016
- Published by Walter de Gruyter GmbH
Reference Correlations for the Viscosity and Thermal Conductivity of Fluids Over an Extended Range of Conditions: Hexane in the Vapor, Liquid, and Supercritical Regions (IUPAC Technical Report)
This article summarizes the correlation procedures developed for IUPAC Project 2012-040-1-100 [Reference correlations for the thermal conductivity and viscosity of fluids over extended range of conditions (vapor, liquid and supercritical regions)]. This project is focused on the development of wide-range reference correlations for the thermal conductivity and viscosity of fluids that incorporate as much theoretical knowledge of these properties as possible. The thermal conductivity and viscosity correlations developed here for pure fluids are functions of temperature and density. The best available equations of state for a given fluid are used to calculate the thermodynamic properties required for these correlations, often from measured temperatures and pressures. The correlation methodology developed during this project has been applied to hexane in this report but can be applied to any pure fluid with a reliable equation of state and reliable data for the thermal conductivity and viscosity over a significant range of temperatures and densities.
- 4 April 2016
- Published by Walter de Gruyter GmbH
Reference Correlations for the Viscosity and Thermal Conductivity of Fluids Over an Extended Range of Conditions: Hexane in the Vapor, Liquid, and Supercritical Regions (IUPAC Technical Report)
This article summarizes the correlation procedures developed for IUPAC Project 2012-040-1-100 [Reference correlations for the thermal conductivity and viscosity of fluids over extended range of conditions (vapor, liquid and supercritical regions)]. This project is focused on the development of wide-range reference correlations for the thermal conductivity and viscosity of fluids that incorporate as much theoretical knowledge of these properties as possible. The thermal conductivity and viscosity correlations developed here for pure fluids are functions of temperature and density. The best available equations of state for a given fluid are used to calculate the thermodynamic properties required for these correlations, often from measured temperatures and pressures. The correlation methodology developed during this project has been applied to hexane in this report but can be applied to any pure fluid with a reliable equation of state and reliable data for the thermal conductivity and viscosity over a significant range of temperatures and densities.
- 18 August 2015
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 36 (10-11) , 3083-3105
A Novel Portable Absolute Transient Hot-Wire Instrument for the Measurement of the Thermal Conductivity of Solids
- 18 August 2015
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 36 (10-11) , 3083-3105
A Novel Portable Absolute Transient Hot-Wire Instrument for the Measurement of the Thermal Conductivity of Solids
- 14 July 2015
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 60 (12) , 3539-3544
Measurements of the Viscosity of Krytox GPL102 Oil in the Temperature Range (282 to 364) K and up to 20 MPa
- 14 July 2015
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 60 (12) , 3539-3544
Measurements of the Viscosity of Krytox GPL102 Oil in the Temperature Range (282 to 364) K and up to 20 MPa