RPRichard A. Perkins

Richard A. Perkins

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Richard A. Perkins has a total of 106 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Refrigerant properties development R&D :

    by Mark O McLinden, Katrina N Avery, Ala Bazyleva, Ian H Bell, Tara J Fortin, Marcia L Huber, Andrei F Kazakov, Eric W Lemmon, Stephanie L Outcalt, Richard A Perkins, et al.

    The HVAC&R industry is facing the challenge of phasing down the use of the HFC (hydrofluorocarbon) refrigerants. New energy-efficient refrigerants are required, and accurate property data for them are needed to design and operate new HVAC equipment using the new refrigerants. The present work has measured property data on key mixtures among the olefins R-1234yf, R-1234ze(E), R-1130(E), R-1132a, R-1132(E), and R-1336mzz(Z), together with the HFCs R-152a, R-32, and R-227ea. Measurements were also carried out on pure R-1130(E). Included were vapor-liquid equilibrium (VLE) measurements, pressure-density-temperature-composition (p, ρ, T, x) data, and speed of sound. This report summarizes the measurements carried out, describes the experimental techniques used, and gives examples of the results. These data were then used to develop models of the thermodynamic properties; these are expressed in terms of “equations of state” (EOS). In addition to the mixture models, EOS are presented for pure R-1130(E) and R-1132(E). The main output of the project takes the form of the numerical parameters for the pure-fluid and mixture models, which are reported here and in the form of data files for use with the NIST REFPROP database of refrigerant properties. Full details of both the experimental and modeling efforts are given in papers published in archival journals, which are linked in the report. The present work has added important new refrigerants and refrigerant blends to the existing data set. As a result, industry is able to evaluate a wider range of options.

  • Open Access

    Thermal Conductivity of Liquid trans-1,2-Dichloroethene (R-1130(E)): Measurement and Modeling

    by Karim S. Al-Barghouti, Aaron J. Rowane, Ian H. Bell, Marcia L. Huber, Richard A. Perkins

    The thermal conductivity of liquid trans-1,2-dichloroethene (R-1130(E)) was measured at temperatures ranging from 240 K to 340 K and pressures up to 25 MPa using a transient hot-wire instrument. A total of 447 thermal conductivity data points were measured along six isotherms. Each isotherm includes data at nine pressures, which were chosen to be at equal density increments starting at a pressure of 0.1 MPa (or slightly above the saturation pressure of R-1130(E) at temperatures above its normal boiling point) to a maximum pressure of 25 MPa. The combined expanded uncertainty of the presented experimental data is 1.4% at a 95% confidence level. The experimental data were used to evaluate the performance of an extended corresponding states (ECS) model and a residual entropy scaling (RES) model. Both models were applied in a totally predictive mode, and in a mode where the experimental data were used to tune the model parameters. A volume-translated Peng–Robinson equation of state was used to provide thermodynamic properties needed to apply both models. In a totally predictive mode, the ECS model had an average absolute relative deviation (ΔAARD) of 6.89% relative to the experimental data with the largest deviation being − 8.33%. The RES model in a totally predictive mode showed an ΔAARD of 2.55% with the largest deviation being − 5.81%. When model parameters were fitted to the experimental data, both the ECS and the RES model represented the experimental data to within its uncertainty of 1.4%.


  • Open Access

    A Dual-Path Pulse-Echo Instrument for Liquid-Phase Speed of Sound and Measurements on p-Xylene and Four Halogenated-Olefin Refrigerants [R1234yf, R1234ze(E), R1233zd(E), and R1336mzz(Z)]

    by Mark O. McLinden, Richard A. Perkins

    We describe an instrument to measure the speed of sound in liquids based on the dual-path, pulse-echo technique; it covers a temperature range of 228.15-423.15 K, with pressures of up to 93 MPa. It differs from similar instruments in the method of mounting the quartz-crystal transducer, a path-length ratio of 2.5:1, and automated data-collection protocols. The path-length difference was calibrated with measurements on high-purity propane. The performance of the instrument was verified by comparison with recent literature data on p-xylene. We present new liquid-phase measurements for the halogenated-olefin refrigerants 2,3,3,3-tetrafluoroprop-1-ene [R1234yf], trans-1,3,3,3-tetrafluoroprop-1-ene [R1234ze(E)], trans-1-chloro-3,3,3-trifluoroprop-1-ene [R1233zd(E)], and cis-1,1,1,4,4,4-hexafluorobut-2-ene [R1336mzz(Z)]. These measurements cover a combined temperature range of 230 to 420 K, with pressures of up to 50 MPa; these data are compared to literature data (where available) and multiproperty equations of state. The average relative expanded uncertainty in the speed of sound ranged from 0.035 to 0.088% for the different fluids.


  • Low-GWP non-flammable alternative refrigerant blends for HFC-134a :

    by Piotr A Domanski, Mark O McLinden, Valeri I Babushok, Ian H Bell, Tara J Fortin, Michael J Hegetschweiler, Marcia L Huber, Mark A Kedzierski, Dennis K Kim, Lingnan Lin, et al.

    This project addresses the objectives of the Statement of Need number WPSON-17-02 for “No/Low Global Warming Potential Alternatives to Ozone Depleting Refrigerants” issued by the Strategic Environmental Research and Development Program (SERDP), the U.S. Department of Defense (DoD) environmental science and technology program, planned and executed in full partnership with the U.S. Department of Energy and the U.S. Environmental Protection Agency. The goal of this Statement of Need was to identify low global-warming-potential (GWP), non-flammable refrigerants to replace HFC-134a (GWP = 1300) in military equipment.

  • Low-GWP non-flammable alternative refrigerant blends for HFC-134a :

    by Piotr A Domanski, Mark O McLinden, Valeri I Babushok, Ian H Bell, Tara J Fortin, Michael J Hegetschweiler, Marcia L Huber, Mark A Kedzierski, Dennis K Kim, Lingnan Lin, et al.

  • Thermal Conductivity of Binary Mixtures of 1,1,1,2-Tetrafluoroethane(R-134a), 2,3,3,3-Tetrafluoropropene (R-1234yf), and trans-1,3,3,3-Tetrafluoropropene (R-1234ze(E)) Refrigerants

    by Aaron J. Rowane, Ian H. Bell, Marcia L. Huber, Richard A. Perkins

    A total of 2160 thermal conductivity data points, measured using a transient hot-wire instrument, are reported for binary mixtures of R 134a, R-1234yf, and R-1234ze(E) refrigerants from 200 to 340 K to pressures of 12 MPa for mixtures containing R-1234yf and to 50 MPa for R-134a/ 1234ze(E) mixtures. Data are reported at compositions of approximately (0.33/0.67) mole fraction and (0.67/0.33) mole fraction for each binary mixture investigated. The estimated relative expanded uncertainty of the thermal conductivity measurements is less than 2%. The data are used to refit binary interaction parameters for the Extended Corresponding States (ECS) model implemented in REFPROP (version 10.0). Additionally, the data in this study are used to assess the performance of a generalized entropy scaling model for refrigerants. Finally, the strengths and weaknesses of the ECS and entropy scaling models are compared.


  • Speed of Sound Measurements of Binary Mixtures of 1,1,1,2-Tetrafluoroethane (R-134a), 2,3,3,3-Tetrafluoropropene (R-1234yf), and trans-1,3,3,3-Tetrafluoropropene (R-1234ze(E)) Refrigerants

    by Aaron J. Rowane, Richard A. Perkins

    Speed of sound data measured using a dual-path pulse-echo instrument are reported for binary mixtures of 1,1,1,2-tetrafluoroethane (R-134a), 2,3,3,3-tetrafluoropropene (R-1234yf), and trans-1,3,3,3-tetrafluoropropene (R-1234ze(E)). For each binary mixture, the speed of sound is studied at two compositions of approximately (0.33/0.67) and (0.67/0.33) mole fraction. The conditions covered in this study range in temperature from 230 to 345 K and from pressures slightly above the bubble curve up to a maximum pressure of 51 MPa. However, to avoid potential polymerization reactions, data for mixtures containing R-1234yf are limited to a maximum pressure of 12 MPa at temperatures below 295 K and 8 MPa at temperatures above 295 K. The mean uncertainty of the measured speed of sound is less than 0.1%, where relative combined expanded uncertainties at individual state points range from 0.04 to 0.4% of the measured speed of sound value. The greatest combined expanded uncertainties are encountered as the state point approaches the mixture critical region where weakened echo signals and lower speed of sound values are observed. The reported data are compared to available REFPROP mixture models, which are not adjusted using the data reported here, with average absolute deviations ranging from 0.27 to 0.75% with maximum deviations as high as 1.1%. The comparisons to the REFPROP correlations show that further adjustments to the mixture models are needed to provide a representation of the data within its experimental uncertainty.


  • New International Formulation for the Thermal Conductivity of Heavy Water

    by M. L. Huber, R. A. Perkins, M. J. Assael, S. A. Monogenidou, R. Hellmann, J. V. Sengers

    The International Association for the Properties of Water and Steam has adopted new formulations for the thermodynamic and transport properties of heavy water. This manuscript describes the development of a formulation for the thermal conductivity of heavy water that was adopted as an international standard in 2021. It is consistent with the equation of state adopted in 2017, revised slightly in 2018, and is valid for fluid states up to 825 K and 250 MPa with uncertainties ranging from 1.5% to 6% depending on the state point. Comparisons with experimental data and with an earlier thermal-conductivity formulation are presented. The 2021 formulation accounts for the critical enhancement of the thermal conductivity, which was not incorporated in the previous formulation. Furthermore, in the zero-density limit, the 2021 formulation is based on thermal conductivity values at temperatures from 250 to 2500 K obtained from the kinetic theory of polyatomic gases. In addition, the 2021 formulation is applicable in a larger range of pressures than the previous formulation.