BRBogdan I. Rachiy

Bogdan I. Rachiy

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bogdan I. Rachiy has a total of 156 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Thermal and electrical conductivity of nanocarbon/ferrite/epoxy hybrid composites

    by Olena Yakovenko, Ludmila Matzui, Ludmila Vovchenko, Yulia Perets, Dmytro Zaiats, Pavlo Lishchuk, Kateryna Dubyk, Larysa Kaykan, Julia Mazurenko, Bohdan Rachiy

    1. The intensive development of electronics, telecommunications and technologies is accompanied by a constant increase in power density in the latest devices, which places new demands on efficient ...

  • Open Access

    Effect of Thermal Activation on the Structure and Electrochemical Properties of Carbon Material Obtained from Walnut Shells

    by Nataliia Ivanichok, Pavlo Kolkovskyi, Oleh Ivanichok, Volodymyr Kotsyubynsky, Volodymyra Boychuk, Bogdan Rachiy, Michał Bembenek, Łukasz Warguła, Rashad Abaszade, Liubomyr Ropyak

    A simple activation method has been used to obtain porous carbon material from walnut shells. The effect of the activation duration at 400 °C in an atmosphere with limited air access on the structural, morphological, and electrochemical properties of the porous carbon material obtained from walnut shells has been studied. Moreover, the structure and morphology of the original and activated carbon samples have been characterized by SAXS, low-temperature adsorption porosimetry, SEM, and Raman spectroscopy. Therefore, the results indicate that increasing the duration of activation at a constant temperature results in a reduction in the thickness values of interplanar spacing (d002) in a range of 0.38–0.36 nm and lateral dimensions of the graphite crystallite from 3.79 to 2.52 nm. It has been demonstrated that thermal activation allows for an approximate doubling of the specific SBET surface area of the original carbon material and contributes to the development of its mesoporous structure, with a relative mesopore content of approximately 75–78% and an average pore diameter of about 5 nm. The fractal dimension of the obtained carbon materials was calculated using the Frenkel–Halsey–Hill method; it shows that its values for thermally activated samples (2.52, 2.69) are significantly higher than for the original sample (2.17). Thus, the porous carbon materials obtained were used to fabricate electrodes for electrochemical capacitors. Electrochemical investigations of these cells in a 6 M KOH aqueous electrolyte were conducted by cyclic voltammetry, galvanostatic charge/discharge, and impedance spectroscopy. Consequently, it was established that the carbon material activated at 400 °C for 2 h exhibits a specific capacity of approximately 110–130 F/g at a discharge current density ranging from 4 to 100 mA/g.


  • Open Access

    Porous Structure and Fractal Dimensions of Activated Carbon Prepared from Waste Coffee Grounds

    by Sofiia Victoriia Sklepova, Nataliia Ivanichok, Pavlo Kolkovskyi, Volodymyr Kotsyubynsky, Volodymyra Boychuk, Bogdan Rachiy, Andrzej Uhryński, Michał Bembenek, Liubomyr Ropyak

    The present work reports the results of a systematic study on the evolution of the morphological properties of porous carbons derived from coffee waste using a one-pot potassium-hydroxide-assisted process at temperatures in the range of 400–900 °C. Raw materials and obtained carbons were studied by TG, DTG, SEM and nitrogen adsorption porosimetry. The decomposition temperature ranges for hemicellulose, cellulose and lignin as the main component of the feedstock have been established. It is shown that the proposed method for the thermochemical treatment of coffee waste makes it possible to obtain activated carbon with a controllable pore size distribution and a high specific surface area (up to 1050 m2/g). A comparative study of the evolution of the distribution of pore size, pore area and pore volume has been carried out based on the BJH and NL-DFT (slit-like pores approximation) methods. The fractal dimension of the obtained carbons has been calculated by Frenkel–Halsey–Hill method for single-layer and multilayer adsorptions.


  • Open Access

    Structure and magnetic properties of hydrothermally synthesized CuFe2O4 and CuFe2O4/rGO composites

    by Ruslan Zapukhlyak, Mykola Hodlevsky, Volodymyra Boychuk, Julia Mazurenko, Volodymyr Kotsyubynsky, Liliia Turovska, Bogdan Rachiy, Sofia Fedorchenko


  • Open Access

    Structural and sorption properties of nanoporous carbon materials obtained from walnut shells

    by S.A. Lisovska, R.V. Ilnytskyy, R.P. Lisovskyy, N.Ya. Ivanichok, Kh.V. Bandura, B.I. Rachiy

    Using the method of low-temperature nitrogen adsorption/desorption, the porous structure of nanoporous carbon materials obtained by alkaline activation of light industry waste (walnut shells) with subsequent thermal modification was investigated. The optimal relationship between temperature and modification time has been established. It is shown that an increase in the modification temperature reduces the transition time of micropores into mesopores and leads to a decrease in the specific surface area and total pore volume. Thus, the material obtained at a modification temperature of 400 ºC and a holding time of 120 min is characterized by the maximum specific surface area of 940 m2/g. It has been investigated that an increase in the time of temperature modification leads to an increase in specific electrical conductivity.


  • Open Access

    КОНСПЕКТ – ВАЖЛИВИЙ ІНСТРУМЕНТ ПІДВИЩЕННЯ ЯКОСТІ ОСВІТИ

    by Анна Гамарник, Михайло Яцура, Богдан Рачій

    Виходячи з того, що вміння і техніка конспектування – це одні з основних робочих компетенцій, якими студент повинен оволодіти з початку навчання, у статті проведено аналіз видів (форматів) конспектів і переконливо показано, що жоден з відомих форматів конспектів не може задовольнити потреби студента-фізика. На основі досвіду авторів запропоновано інноваційну методику ведення конспекту лекцій і практичних занять з фізики студентам

  • Electrochemical behavior of NiWO4 modified by ultrasonic and laser irradiation

    by Yurii Starchuk, Ivan Budzulyak, Olha Popovych, Bogdan Rachiy, Lyubov Yablon

    In this work, NiWO4 was prepared by co-precipitation and modified by ultrasonic and laser irradiation. Its electrochemical properties were investigated by potentiodynamic, galvanostatic and impedance spectroscopy methods. The results show that NiWO4 ultrasonic-modified and exposed to laser irradiation for 420 s has the highest capacitance of 520 F/g at a discharge current of 1 mA. This capacitance value is 2.5 times higher than for NiWO4 ultrasonic-modified and 3.4 times higher than for NiWO4 obtained by co-deposition. The capacitance enhancement of NiWO4 modified by ultrasonic and laser irradiation is the result of stimulation of fast redox reactions, which is confirmed by impedance studies.


  • Open Access

    Effect of Synthesis Conditions on Capacitive Properties of Porous Carbon Derived from Hemp Bast Fiber

    by Michał Bembenek, Volodymyr Kotsyubynsky, Volodymyra Boychuk, Bogdan Rachiy, Ivan Budzulyak, Łukasz Kowalski, Liubomyr Ropyak

    A systematic study of the influence of synthesis conditions on the structural, morphological, and electrical properties, as well as the electrochemical performance of hemp fiber-derived carbon materials was performed. An analysis of the capacitive response of carbons obtained under various activation conditions with additional treatment with HNO3 and annealing was completed. The contribution of the formation of an electrical double layer at the outer electrode–electrolyte interface, as well as on surfaces inside micropores, has been studied and analyzed in terms of the effect of the turbostratic carbon properties (average lateral size of graphite crystallites, pore size distribution, BET surface area).


  • Open Access

    НОВА ФОРМА САМОСТІЙНОЇ РОБОТИ СТУДЕНТІВ ФІЗИЧНИХ СПЕЦІАЛЬНОСТЕЙ ЗАКЛАДІВ ВИЩОЇ ОСВІТИ

    by Anna Gamarnyk, Mykhailo Yatsura, Bohdan Rachiy

    У статті обґрунтовано й запропоновано як одну з форм самостійної роботи студентів фізичних спеціальностей закладів вищої освіти ведення словника фізичних понять (термінів), який може стати, як показує досвід, важливою складовою навчального процесу. Доведено, що ведення подібного словника може бути корисним і для студентів, які вивчають будь-яку дисципліну з певними застереженнями в методичних порадах щодо ведення словника.

  • Structure and Electrochemical Properties of Laser-Modified NiWO4

    by Yurii Starchuk, Olha Popovych, Bogdan Rachiy, Ivan Budzulyak

    In recent years, nickel tungstate has attracted considerable research interest as an electrode material for supercapacitors. In this work, NiWO4 was synthesized by co-precipitation and exposed to laser irradiation. The structure of nickel tungstate was investigated by X-ray diffraction and its electrochemical properties by potentiodynamics, galvanostatic and impedance spectroscopy methods. The results show that NiWO4 subjected to laser irradiation for 180 s showed higher specific characteristics than the initial material. Namely, at a discharge current of 1 mA, NiWO4 achieves a specific capacitance of 153 F/g, and this value is 48% higher than that of the initial material. The higher specific characteristics of laser-modified NiWO4 result from the ability of the material to interact better with electrolyte ions due to the passage of fast redox reactions and the capacitance of the electrical double layer, which is confirmed by impedance studies.