Zakari Eckert
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Zakari Eckert has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Anne M. Grillet
2 shared publicationsJeremiah J. Boerner
2 shared publications- Michael A. Gallis
Sandia National Laboratories (SNL-NM), Albuquerque, NM (United States)
2 shared publications Advanced Simulation And Computing
1 shared publicationAlbuquerque Sandia National Laboratories (Snl-Nm)
1 shared publication- Ales Necas
TAE Technologies
1 shared publication
Latest Publications
- 1 July 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 165 (1)
Coupled internal energy modes in DSMC
The Landau–Teller model for vibrational energy relaxation of gases toward equilibrium is a first-order kinetic model where the rate of relaxation is proportional to the current defect between the energy in that mode and the equilibrium amount of energy in the mode. In Direct Simulation Monte Carlo (DSMC), collisions are first resolved using a total collision cross section; then, if a collision occurs, the internal energy modes of the colliding particles are tested for relaxation. To reproduce the Landau–Teller model in gases with multiple internal modes, the relaxation of multiple internal modes in a single DSMC collision must be prohibited. This work provides analytical comparison of model-form differences between four models: (1) Landau–Teller theory, (2) the vibrational master equation for a mixture of harmonic oscillators, and DSMC when (3) allowing or (4) prohibiting multiple relaxation in a single collision. This is followed by a rigorous examination of the quantitative effect of the algorithmic choice of allowing or prohibiting multiple relaxation in DSMC. The deviation from the Landau–Teller model caused by allowing multiple relaxations in DSMC is minimal compared to the statistical noise in most cases. However, DSMC practitioners are advised to carefully consider the importance of direct coupling between internal modes, as neglecting these can lead to significant errors.
- 1 July 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 165 (1)
Coupled internal energy modes in DSMC
The Landau–Teller model for vibrational energy relaxation of gases toward equilibrium is a first-order kinetic model where the rate of relaxation is proportional to the current defect between the energy in that mode and the equilibrium amount of energy in the mode. In Direct Simulation Monte Carlo (DSMC), collisions are first resolved using a total collision cross section; then, if a collision occurs, the internal energy modes of the colliding particles are tested for relaxation. To reproduce the Landau–Teller model in gases with multiple internal modes, the relaxation of multiple internal modes in a single DSMC collision must be prohibited. This work provides analytical comparison of model-form differences between four models: (1) Landau–Teller theory, (2) the vibrational master equation for a mixture of harmonic oscillators, and DSMC when (3) allowing or (4) prohibiting multiple relaxation in a single collision. This is followed by a rigorous examination of the quantitative effect of the algorithmic choice of allowing or prohibiting multiple relaxation in DSMC. The deviation from the Landau–Teller model caused by allowing multiple relaxations in DSMC is minimal compared to the statistical noise in most cases. However, DSMC practitioners are advised to carefully consider the importance of direct coupling between internal modes, as neglecting these can lead to significant errors.
- Open Access
- 1 May 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (5)
Verification of an energy-conserving semi-implicit electrostatic particle-in-cell scheme for modeling high-density plasma at scale
A verification study of a semi-implicit energy-conserving electrostatic particle-in-cell algorithm is presented. The algorithm relaxes the time-step and mesh-size constraints that require resolution of the plasma period and Debye length associated with traditional explicit momentum-conserving particle-in-cell algorithms. Physical implications and applicability of using the semi-implicit scheme for modeling high-density plasmas are discussed. Where possible, numerical results are compared against analytical solutions. The simulation results indicate that the algorithm is stable at time steps larger than twice the inverse plasma frequency and cell sizes larger than the Debye length. It is found that the algorithm gives adequate results, provided that the distribution function and the spatiotemporal scales dictating the physics of the problem are resolved. As such, the algorithm may provide a robust method for kinetic modeling of high-density plasmas at scale.
- 1 May 2026
- Published by AIP Publishing in Physics of Plasmas
- Vol. 33 (5)
Open AccessVerification of an energy-conserving semi-implicit electrostatic particle-in-cell scheme for modeling high-density plasma at scale
A verification study of a semi-implicit energy-conserving electrostatic particle-in-cell algorithm is presented. The algorithm relaxes the time-step and mesh-size constraints that require resolution of the plasma period and Debye length associated with traditional explicit momentum-conserving particle-in-cell algorithms. Physical implications and applicability of using the semi-implicit scheme for modeling high-density plasmas are discussed. Where possible, numerical results are compared against analytical solutions. The simulation results indicate that the algorithm is stable at time steps larger than twice the inverse plasma frequency and cell sizes larger than the Debye length. It is found that the algorithm gives adequate results, provided that the distribution function and the spatiotemporal scales dictating the physics of the problem are resolved. As such, the algorithm may provide a robust method for kinetic modeling of high-density plasmas at scale.
- 30 October 2024
- Published by Elsevier in Journal of Computational Physics
- Vol. 521
Benchmark verification of PIC-DSMC programs
- 30 October 2024
- Published by Elsevier in Journal of Computational Physics
- Vol. 521
Benchmark verification of PIC-DSMC programs
- Open Access
- 1 July 2024
- Published by Office of Scientific and Technical Information (OSTI)
Recent Enhancements to the SPARTA DSMC Code
- 1 July 2024
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessRecent Enhancements to the SPARTA DSMC Code
- 1 June 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (6)
Enforcing detailed balance in the Borgnakke–Larsen redistribution method with temperature dependent relaxation models
For decades, it has been observed that the commonly used Borgnakke–Larsen method for energy redistribution in Direct Simulation Monte Carlo codes fails to satisfy the principle of detailed balance when coupled to a wide variety of temperature dependent relaxation models, while seemingly satisfying detailed balance when coupled to others. Many attempts have been made to remedy the issue, yet much ambiguity remains, and no consensus appears in the literature regarding the root cause of the intermittent compatibility of the Borgnakke–Larsen method with temperature dependent relaxation models. This paper alleviates that ambiguity by presenting a rigorous theoretical derivation of the Borgnakke–Larsen method's requirement for satisfying detailed balance. Specifically, it is shown that the Borgnakke–Larsen method maintains detailed balance if and only if the probability of internal-energy exchange during a collision depends only on collision invariants (e.g., total energy). The consequences of this result are explored in the context of several published definitions of relaxation temperature, including translational, total, and cell-averaged temperatures. Of particular note, it is shown that cell-averaged temperatures, which have been widely discussed in the literature as a way to ensure equilibrium is reached, also fail in a similar, although less dramatic, fashion when the aforementioned relationship is not enforced. The developed theory can be used when implementing existing or new relaxation models and will ensure that detailed balance is satisfied.
- 1 June 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (6)
Enforcing detailed balance in the Borgnakke–Larsen redistribution method with temperature dependent relaxation models
For decades, it has been observed that the commonly used Borgnakke–Larsen method for energy redistribution in Direct Simulation Monte Carlo codes fails to satisfy the principle of detailed balance when coupled to a wide variety of temperature dependent relaxation models, while seemingly satisfying detailed balance when coupled to others. Many attempts have been made to remedy the issue, yet much ambiguity remains, and no consensus appears in the literature regarding the root cause of the intermittent compatibility of the Borgnakke–Larsen method with temperature dependent relaxation models. This paper alleviates that ambiguity by presenting a rigorous theoretical derivation of the Borgnakke–Larsen method's requirement for satisfying detailed balance. Specifically, it is shown that the Borgnakke–Larsen method maintains detailed balance if and only if the probability of internal-energy exchange during a collision depends only on collision invariants (e.g., total energy). The consequences of this result are explored in the context of several published definitions of relaxation temperature, including translational, total, and cell-averaged temperatures. Of particular note, it is shown that cell-averaged temperatures, which have been widely discussed in the literature as a way to ensure equilibrium is reached, also fail in a similar, although less dramatic, fashion when the aforementioned relationship is not enforced. The developed theory can be used when implementing existing or new relaxation models and will ensure that detailed balance is satisfied.
- 7 November 2019
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 53 (3) , 035203
1D PIC-DSMC analysis of a high-pressure nanosecond pulse discharge breakdown in helium
Kinetic simulations of plasma phenomena during and after formation of the conductive plasma channel of a nanosecond pulse discharge are analyzed and compared to existing experimental measurements. Particle-in-cell with direct simulation Monte Carlo collisions (PIC-DSMC) modeling is used to analyze a discharge in helium at 200 Torr and 300 K over a 1 cm gap. The analysis focuses on physics that would not be reproduced by fluid models commonly used at this high number density and collisionality, specifically non-local and stochastic phenomena. Similar analysis could be used to improve the predictive capability of lower fidelity or reduced order models. First, the modeling results compare favorably with experimental measurements of electron number density, temperature, and 1D electron energy distribution function at the same conditions. Second, it is shown that the ionization wave propagates in a stochastic, stepwise manner, dependent on rare, random ionization events ahead of the ionization wave when the ionization fraction in front of the ionization wave is very low, analagous to the stochastic branching of streamers in 3D. Third, analysis shows high-energy runaway electrons accelerated in the cathode layer produce electron densities in the negative glow region over an order of magnitude above those in the positive column. Future work to develop reduced order models of these two phenomena would improve the accuracy of fluid plasma models without the cost of PIC-DSMC simulations.
- 7 November 2019
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 53 (3) , 035203
1D PIC-DSMC analysis of a high-pressure nanosecond pulse discharge breakdown in helium
Kinetic simulations of plasma phenomena during and after formation of the conductive plasma channel of a nanosecond pulse discharge are analyzed and compared to existing experimental measurements. Particle-in-cell with direct simulation Monte Carlo collisions (PIC-DSMC) modeling is used to analyze a discharge in helium at 200 Torr and 300 K over a 1 cm gap. The analysis focuses on physics that would not be reproduced by fluid models commonly used at this high number density and collisionality, specifically non-local and stochastic phenomena. Similar analysis could be used to improve the predictive capability of lower fidelity or reduced order models. First, the modeling results compare favorably with experimental measurements of electron number density, temperature, and 1D electron energy distribution function at the same conditions. Second, it is shown that the ionization wave propagates in a stochastic, stepwise manner, dependent on rare, random ionization events ahead of the ionization wave when the ionization fraction in front of the ionization wave is very low, analagous to the stochastic branching of streamers in 3D. Third, analysis shows high-energy runaway electrons accelerated in the cathode layer produce electron densities in the negative glow region over an order of magnitude above those in the positive column. Future work to develop reduced order models of these two phenomena would improve the accuracy of fluid plasma models without the cost of PIC-DSMC simulations.