Saifal Talpur
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Saifal Talpur has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Tek Tjing Lie
School of Engineering, Computer and Mathematical Sciences, Auckland University of Technology, Auckland 1010, New Zealand
6 shared publications - Ramon Zamora
Department of Electrical and Electronic Engineering, Auckland University of Technology, Auckland 1010, New Zealand
3 shared publications A. Kubis
PSI Software AG, Dortmund, Germany
1 shared publicationA. Singh
PSI Software AG, Dortmund, Germany
1 shared publication- Bhaba Priyo Das
University of Canterbury
1 shared publication Carl Johan Wallnerstrom
School of Electrical Engineering, KTH, Stockholm Sweden
1 shared publication
Latest Publications
- Open Access
- 9 January 2024
- Published by Elsevier in SSRN Electronic Journal
Application of Emergency- Short-Term Thermal Reserves for Congestion Management
In this paper, thermal reserve forecasting tool is developed, which evaluates short-termthermalreserve across each overhead line in the test network. The developed tool considers weatherand generator active power dispatching factors towards line’s enhanced thermal reserves.After N-1 line contingency, the minimum thermal reserve time across each line is calculatedbefore and after three generator re-dispatch scenarios, i.e., nominal generator dispatch, thermalreserve time dependent generator dispatch and the economic generator re-dispatch scenariosunder actual and worst weather conditions. The actual weather conditions under the proposedthermal reserve dependent generator re-dispatch resulted significant improvement in thermalreserve time in comparison to nominal and economic generator re-dispatching regardless ofambient conditions. The enhanced thermal reserve time is found to facilitate the systemoperator towards timely selection of appropriate curative control measures to relieve thecongestion from the network.
- 9 January 2024
- Published by Elsevier in SSRN Electronic Journal
Open AccessApplication of Emergency- Short-Term Thermal Reserves for Congestion Management
In this paper, thermal reserve forecasting tool is developed, which evaluates short-termthermalreserve across each overhead line in the test network. The developed tool considers weatherand generator active power dispatching factors towards line’s enhanced thermal reserves.After N-1 line contingency, the minimum thermal reserve time across each line is calculatedbefore and after three generator re-dispatch scenarios, i.e., nominal generator dispatch, thermalreserve time dependent generator dispatch and the economic generator re-dispatch scenariosunder actual and worst weather conditions. The actual weather conditions under the proposedthermal reserve dependent generator re-dispatch resulted significant improvement in thermalreserve time in comparison to nominal and economic generator re-dispatching regardless ofambient conditions. The enhanced thermal reserve time is found to facilitate the systemoperator towards timely selection of appropriate curative control measures to relieve thecongestion from the network.
- 2 November 2021
- Published by Institution of Engineering and Technology (IET) in IET Conference Proceedings
- Vol. 2021 (6) , 2008-2012
DEVELOPMENT OF A FLEXIBILITY SERVICE MECHANISM FOR THE DETERMINATION AND EXPLOITATION OF FLEXIBILITY IN ACTIVE DISTRIBUTION NETWORK THROUGH PARALLELIZED OPTIMAL POWER FLOW CALCULATIONS
- 2 November 2021
- Published by Institution of Engineering and Technology (IET) in IET Conference Proceedings
- Vol. 2021 (6) , 2008-2012
DEVELOPMENT OF A FLEXIBILITY SERVICE MECHANISM FOR THE DETERMINATION AND EXPLOITATION OF FLEXIBILITY IN ACTIVE DISTRIBUTION NETWORK THROUGH PARALLELIZED OPTIMAL POWER FLOW CALCULATIONS
- Open Access
Maximum Utilization of Dynamic Rating Operated Distribution Transformer (DRoDT) with Battery Energy Storage System: Analysis on Impact from Battery Electric Vehicles Charging
This paper investigates thermal overloading, voltage dips and insulation failure across a distribution transformer (DT), under residential and battery electric vehicle (BEV) loadings. The objective of this paper is to discuss the charging impact of BEVs on voltage across consumer-service points, as well as across the life of paper insulation under varying ambient temperatures (during winter and summer), with and without a centralized battery energy storage system (BESS). This study contributes in two ways. The first part of this study deals with coordinated and uncoordinated BEV charging scenarios. The second part of this study deals with maximum utilization of a test DT rated under dynamic thermal rating (DRoDT). The DRoDT integration with BESS is carried out to flatten the load spikes, to obtain maximum DT utilization, to achieve active power and voltage supports in addition to an enhanced DT lifespan. The obtained results indicate that, when test DT operates under the proposed hybrid technique (combining both dynamic transformer ratings and a centralized BESS), it attains maximum utilization, lower hot-spot temperature, enhanced lifespan, less degraded paper insulation and an improved voltage across each consumer service point. The proposed technique is furthermore found effective in maintaining the loading across the distribution transformer within the nominal limits. However, under excess loading during peak hours, the proposed technique provides relief to the DT to a certain extent. To achieve an optimal DT operation and an enhanced BESS lifespan, the BESS is operated under nominal charging and discharging cyclic limits. Under the proposed DRoDT integration with BESS, DT attains 25.9% more life when loaded with coordinated BEV charging, in comparison to no BESS integration under the same loading scenario. The worst loading due to uncoordinated BEV charging also brings 51% increase in DT life when loaded under the proposed technique.
Open AccessMaximum Utilization of Dynamic Rating Operated Distribution Transformer (DRoDT) with Battery Energy Storage System: Analysis on Impact from Battery Electric Vehicles Charging
This paper investigates thermal overloading, voltage dips and insulation failure across a distribution transformer (DT), under residential and battery electric vehicle (BEV) loadings. The objective of this paper is to discuss the charging impact of BEVs on voltage across consumer-service points, as well as across the life of paper insulation under varying ambient temperatures (during winter and summer), with and without a centralized battery energy storage system (BESS). This study contributes in two ways. The first part of this study deals with coordinated and uncoordinated BEV charging scenarios. The second part of this study deals with maximum utilization of a test DT rated under dynamic thermal rating (DRoDT). The DRoDT integration with BESS is carried out to flatten the load spikes, to obtain maximum DT utilization, to achieve active power and voltage supports in addition to an enhanced DT lifespan. The obtained results indicate that, when test DT operates under the proposed hybrid technique (combining both dynamic transformer ratings and a centralized BESS), it attains maximum utilization, lower hot-spot temperature, enhanced lifespan, less degraded paper insulation and an improved voltage across each consumer service point. The proposed technique is furthermore found effective in maintaining the loading across the distribution transformer within the nominal limits. However, under excess loading during peak hours, the proposed technique provides relief to the DT to a certain extent. To achieve an optimal DT operation and an enhanced BESS lifespan, the BESS is operated under nominal charging and discharging cyclic limits. Under the proposed DRoDT integration with BESS, DT attains 25.9% more life when loaded with coordinated BEV charging, in comparison to no BESS integration under the same loading scenario. The worst loading due to uncoordinated BEV charging also brings 51% increase in DT life when loaded under the proposed technique.
- 23 December 2019
- Published by Institution of Engineering and Technology (IET) in IET Renewable Power Generation
- Vol. 14 (2) , 177-187
Progress in control and coordination of energy storage system‐based VSG: a review
Virtual synchronous generator (VSG) is an important concept toward frequency stabilisation of the modern power system. The penetration of power electronic‐based power generation in power grid reduces the total inertia, and thus increases the risk of frequency instability when disturbance occurs in the grid. VSG produces virtual inertia by injecting appropriate active power value to the grid when needed. This virtual inertia can stabilise the grid frequency in case of a power imbalance between generation and loads or any disturbances that affected frequency stability. Its intensive research can see the importance of VSG in inertia control and various intelligent controller techniques. Owing to the importance of VSG in the modern power grid, this study provides a comprehensive review on the control and coordination of VSG toward grid stabilisation in terms of frequency, voltage and oscillation damping during inertia response. A review on the type of energy storage system used for VSG and their benefits is also presented. Finally, perspective on the technical challenges and potential future research related to VSG is also discussed in this study.
- 23 December 2019
- Published by Institution of Engineering and Technology (IET) in IET Renewable Power Generation
- Vol. 14 (2) , 177-187
Progress in control and coordination of energy storage system‐based VSG: a review
Virtual synchronous generator (VSG) is an important concept toward frequency stabilisation of the modern power system. The penetration of power electronic‐based power generation in power grid reduces the total inertia, and thus increases the risk of frequency instability when disturbance occurs in the grid. VSG produces virtual inertia by injecting appropriate active power value to the grid when needed. This virtual inertia can stabilise the grid frequency in case of a power imbalance between generation and loads or any disturbances that affected frequency stability. Its intensive research can see the importance of VSG in inertia control and various intelligent controller techniques. Owing to the importance of VSG in the modern power grid, this study provides a comprehensive review on the control and coordination of VSG toward grid stabilisation in terms of frequency, voltage and oscillation damping during inertia response. A review on the type of energy storage system used for VSG and their benefits is also presented. Finally, perspective on the technical challenges and potential future research related to VSG is also discussed in this study.
- Open Access
- 13 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 366 (1) , 012070
Operational Analysis of Dynamic Line Ratings
Overhead line is an important asset for power industries. Rising demand in electricity, environmental concerns and cheaper electricity prices are some important factors behind operating the lines at their maximum potential. Replacing overhead lines and/or constructing new lines are not only expensive but also at the same time raise environmental concerns. However, rating overhead lines based on their natural capacity besides being cost effective is a technically feasible solution. In this project, the operational analysis of dynamic line ratings (DLR) is conducted to analyze potential of DLR when practically implemented across overhead line in a sub transmission network. It further guides system operators in fully utilizing the line capacity to its maximum potential. The project also investigates the impact of Flexible AC Transmission System (FACTS) device in the presence of DLR technique to control power flow from wind generators for stabilized and controlled transfer of electricity.
- 13 June 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 366 (1) , 012070
Open AccessOperational Analysis of Dynamic Line Ratings
Overhead line is an important asset for power industries. Rising demand in electricity, environmental concerns and cheaper electricity prices are some important factors behind operating the lines at their maximum potential. Replacing overhead lines and/or constructing new lines are not only expensive but also at the same time raise environmental concerns. However, rating overhead lines based on their natural capacity besides being cost effective is a technically feasible solution. In this project, the operational analysis of dynamic line ratings (DLR) is conducted to analyze potential of DLR when practically implemented across overhead line in a sub transmission network. It further guides system operators in fully utilizing the line capacity to its maximum potential. The project also investigates the impact of Flexible AC Transmission System (FACTS) device in the presence of DLR technique to control power flow from wind generators for stabilized and controlled transfer of electricity.
- 1 December 2017
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 80, 880-887
Testing and model validation of round rotor synchronous generator (GENROU)
- 1 December 2017
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 80, 880-887
Testing and model validation of round rotor synchronous generator (GENROU)
- Open Access
- 1 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
PMU based WAMC application in multi-modular HVDC based large scale solar system
Limited fossil fuel resources, rising electricity prices and the environmental impacts are some major concerns for system operators towards reliable and cost- effective electricity supply. Excess renewable energy in the electricity network is moreover an effective solution to these problems. However, the huge distance between renewable energy resources like solar and wind from load centers requires Wide Area Monitoring and Control (WAMC) application and is therefore investigated in this project with the help of Phasor Measurement Units (PMUs). The project also aims at investigating the role of Voltage Source Converters (VSCs) based High Voltage Direct Current (HVDC) system to make the electricity transmission reliable and efficient from the remotely located Photo-Voltaic (PV) panels to the load centers.
- 1 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Open AccessPMU based WAMC application in multi-modular HVDC based large scale solar system
Limited fossil fuel resources, rising electricity prices and the environmental impacts are some major concerns for system operators towards reliable and cost- effective electricity supply. Excess renewable energy in the electricity network is moreover an effective solution to these problems. However, the huge distance between renewable energy resources like solar and wind from load centers requires Wide Area Monitoring and Control (WAMC) application and is therefore investigated in this project with the help of Phasor Measurement Units (PMUs). The project also aims at investigating the role of Voltage Source Converters (VSCs) based High Voltage Direct Current (HVDC) system to make the electricity transmission reliable and efficient from the remotely located Photo-Voltaic (PV) panels to the load centers.