Daniela Giretti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Daniela Giretti has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- Vincenzo Fioravante
University of Ferrara
16 shared publications V. Fioravante
4 shared publications- Elena Dodaro
University of Bologna
3 shared publications K. Been
Golder Associates Ltd, Halifax, NS, Canada
3 shared publications- Roberta Ventini
Ministry of Infrastructures and Transport, Interregional Public Works Department, 50122 Firenze, Italy
3 shared publications S. Dickenson
New Albion Geotechnical Inc., Reno, NV, USA
3 shared publications
Latest Publications
- 2 August 2026
- Published by Springer Nature
- p. 145-153
Dissipation Processes of Excess Pore Water Pressure from Seismic Centrifuge Tests on Liquefiable Sand
- 2 August 2026
- Published by Springer Nature
- p. 145-153
Dissipation Processes of Excess Pore Water Pressure from Seismic Centrifuge Tests on Liquefiable Sand
- Open Access
- 19 May 2025
- Published by Elsevier in Soil Dynamics and Earthquake Engineering
- Vol. 197
Numerical simulations of seismic centrifuge tests: Validation of pore water pressure models in sand
- 19 May 2025
- Published by Elsevier in Soil Dynamics and Earthquake Engineering
- Vol. 197
Open AccessNumerical simulations of seismic centrifuge tests: Validation of pore water pressure models in sand
- Open Access
- 17 September 2024
- Published by Taylor & Francis
- p. 1136-1141
Liquefaction resistance of carbonate sands from cone penetration tests
Liquefaction assessment is normally carried out using semi-empirical approaches based on the pioneering study of Seed and Idriss (1982). The methods relate a penetration resistance measured in situ (preferably from cone penetration tests, CPTs) to observed instances of liquefaction and non-liquefaction of sandy deposits. However, the applicability of a simplified approach is questionable for materials which fall outside the range of silica sands and slightly silty sands for which it has been developed and extensively verified against field data. For such cases a more rigorous method is needed. Carbonate sands are well known and documented to behave differently from silica sands: at the same relative density, penetration resistance is generally lower than in siliceous sands, while cyclic laboratory testing indicates higher cyclic resistance. These observations cannot rationally be combined into the commonly used simplified liquefaction procedures. An experimental approach, based on the measured mechanical properties of the carbonate sands, is essential. This paper provides an example of calibration of liquefaction resistance from CPTU for a fill made of dredged carbonate sand, based on centrifuge CPTUs and cyclic laboratory tests.
- 17 September 2024
- Published by Taylor & Francis
- p. 1136-1141
Open AccessLiquefaction resistance of carbonate sands from cone penetration tests
Liquefaction assessment is normally carried out using semi-empirical approaches based on the pioneering study of Seed and Idriss (1982). The methods relate a penetration resistance measured in situ (preferably from cone penetration tests, CPTs) to observed instances of liquefaction and non-liquefaction of sandy deposits. However, the applicability of a simplified approach is questionable for materials which fall outside the range of silica sands and slightly silty sands for which it has been developed and extensively verified against field data. For such cases a more rigorous method is needed. Carbonate sands are well known and documented to behave differently from silica sands: at the same relative density, penetration resistance is generally lower than in siliceous sands, while cyclic laboratory testing indicates higher cyclic resistance. These observations cannot rationally be combined into the commonly used simplified liquefaction procedures. An experimental approach, based on the measured mechanical properties of the carbonate sands, is essential. This paper provides an example of calibration of liquefaction resistance from CPTU for a fill made of dredged carbonate sand, based on centrifuge CPTUs and cyclic laboratory tests.
- Open Access
- 9 February 2024
- Published by IntechOpen
Physical Modeling of Liquefaction in Various Granular Materials
This paper compiles numerous experiences gained from physical models, to highlight the phenomena of triggering, propagation, and mitigation of liquefaction in granular soils. Results of tests at different scales, from the element volume (cyclic triaxial tests) to small-scale models in centrifuge, performed using several granular soils, will be presented to provide behavioral tools for predicting the phenomenon. Furthermore, the efficacy of vertical and horizontal drains as liquefaction mitigation techniques will be discussed.
- 9 February 2024
- Published by IntechOpen
Open AccessPhysical Modeling of Liquefaction in Various Granular Materials
This paper compiles numerous experiences gained from physical models, to highlight the phenomena of triggering, propagation, and mitigation of liquefaction in granular soils. Results of tests at different scales, from the element volume (cyclic triaxial tests) to small-scale models in centrifuge, performed using several granular soils, will be presented to provide behavioral tools for predicting the phenomenon. Furthermore, the efficacy of vertical and horizontal drains as liquefaction mitigation techniques will be discussed.
- Open Access
- 29 December 2023
- Published by Elsevier in Soils and Foundations
- Vol. 64 (1)
Settlement prediction of shallow foundations for quality controls of sandy hydraulic fills
- 29 December 2023
- Published by Elsevier in Soils and Foundations
- Vol. 64 (1)
Open AccessSettlement prediction of shallow foundations for quality controls of sandy hydraulic fills
- 17 June 2023
- Published by Springer Nature
- p. 569-577
Integrated Physical and Numerical Modelling to Study the Hydro-Mechanical Response of a River Embankment
- 17 June 2023
- Published by Springer Nature
- p. 569-577
Integrated Physical and Numerical Modelling to Study the Hydro-Mechanical Response of a River Embankment
- Open Access
- 10 June 2023
- Published by MDPI AG in Geosciences
- Vol. 13 (6) , 174
Centrifuge Modelling of Vertical and Horizontal Drains to Mitigate Earthquake-Induced Liquefaction
This paper reports the results of dynamic centrifuge tests carried out on sandy models alternatively equipped with vertical or horizontal drains. The main aim of the experimentation was to investigate the use of horizontal drains to mitigate the liquefaction susceptibility of sandy deposits and to validate their applicability as a remediation technique applicable in urban and industrial areas to protect existing buildings from liquefaction. The assessment and validation were carried out by comparing the seismic behavior of models treated with horizontal drains with that of the untreated model and models equipped with vertical drains.
- 10 June 2023
- Published by MDPI AG in Geosciences
- Vol. 13 (6) , 174
Open AccessCentrifuge Modelling of Vertical and Horizontal Drains to Mitigate Earthquake-Induced Liquefaction
This paper reports the results of dynamic centrifuge tests carried out on sandy models alternatively equipped with vertical or horizontal drains. The main aim of the experimentation was to investigate the use of horizontal drains to mitigate the liquefaction susceptibility of sandy deposits and to validate their applicability as a remediation technique applicable in urban and industrial areas to protect existing buildings from liquefaction. The assessment and validation were carried out by comparing the seismic behavior of models treated with horizontal drains with that of the untreated model and models equipped with vertical drains.
- Open Access
- 1 July 2021
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 19 (10) , 3807-3833
Effects of seismic input, fine crust and existing structure on liquefaction from centrifuge model tests
The results of dynamic centrifuge tests carried out to study the effects of seismic input, fine crust and existing structure on liquefaction triggering and manifestations are presented. The basic concept of the experimentation was to analyse the seismic behaviour of level ground, saturated, 14 m deep sandy deposits, homogeneous or stratified, subjected to increasing seismic excitations up to liquefaction, with or without a one degree of freedom structure on shallow foundations. The study was performed in the framework of the European project Horizon2020 “LIQUEFACT”.
- 1 July 2021
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 19 (10) , 3807-3833
Open AccessEffects of seismic input, fine crust and existing structure on liquefaction from centrifuge model tests
The results of dynamic centrifuge tests carried out to study the effects of seismic input, fine crust and existing structure on liquefaction triggering and manifestations are presented. The basic concept of the experimentation was to analyse the seismic behaviour of level ground, saturated, 14 m deep sandy deposits, homogeneous or stratified, subjected to increasing seismic excitations up to liquefaction, with or without a one degree of freedom structure on shallow foundations. The study was performed in the framework of the European project Horizon2020 “LIQUEFACT”.
- Open Access
- 29 April 2021
- Published by MDPI AG in Geosciences
- Vol. 11 (5) , 192
Experimental and Numerical Investigations of a River Embankment Model under Transient Seepage Conditions
The evaluation of riverbank stability often represents an underrated problem in engineering practice, but is also a topical geotechnical research issue. In fact, it is certainly true that soil water content and pore water pressure distributions in the riverbank materials vary with time, due to the changeable effects of hydrometric and climatic boundary conditions, strongly influencing the bank stability conditions. Nonetheless, the assessment of hydraulic and mechanical behavior of embankments are currently performed under the simplified hypothesis of steady-state seepage, generally neglecting the unsaturated soil related issues. In this paper, a comprehensive procedure for properly defining the key aspects of the problem is presented and, in particular, the soil characterization in partially saturated conditions of a suitably compacted mixture of sand and finer material, typical of flood embankments of the main river Po tributaries (Italy), is reported. The laboratory results have then been considered for modelling the embankment performance under transient seepage and following a set of possible hydrometric peaks. The outcome of the present contribution may provide meaningful geotechnical insights, for practitioners and researchers, in the flood risk assessment of river embankments.
- 29 April 2021
- Published by MDPI AG in Geosciences
- Vol. 11 (5) , 192
Open AccessExperimental and Numerical Investigations of a River Embankment Model under Transient Seepage Conditions
The evaluation of riverbank stability often represents an underrated problem in engineering practice, but is also a topical geotechnical research issue. In fact, it is certainly true that soil water content and pore water pressure distributions in the riverbank materials vary with time, due to the changeable effects of hydrometric and climatic boundary conditions, strongly influencing the bank stability conditions. Nonetheless, the assessment of hydraulic and mechanical behavior of embankments are currently performed under the simplified hypothesis of steady-state seepage, generally neglecting the unsaturated soil related issues. In this paper, a comprehensive procedure for properly defining the key aspects of the problem is presented and, in particular, the soil characterization in partially saturated conditions of a suitably compacted mixture of sand and finer material, typical of flood embankments of the main river Po tributaries (Italy), is reported. The laboratory results have then been considered for modelling the embankment performance under transient seepage and following a set of possible hydrometric peaks. The outcome of the present contribution may provide meaningful geotechnical insights, for practitioners and researchers, in the flood risk assessment of river embankments.