Ivan Isailović
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ivan Isailović has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Augusto Cannone Falchetto
Department of Civil Engineering, ISBS – Pavement Engineering Centre, Technische Universität Braunschweig, Beethovenstraße 51 b, 38106 Braunschweig, Germany
4 shared publicationsMichael P. Wistuba
Technische Universität Braunschweig
3 shared publications- Michael P. Wistuba
Technische Universität Braunschweig
1 shared publication Michael Wistuba
Department of Civil Engineering, ISBS – Pavement Engineering Centre, Technische Universität Braunschweig, Beethovenstraße 51 b, 38106 Braunschweig, Germany
1 shared publication
Latest Publications
- 13 February 2018
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 20 (5) , 1131-1144
Sweep test protocol for fatigue evaluation of asphalt mixtures
This paper presents a laboratory test protocol for evaluating fatigue properties of asphalt mixtures through sweep tests at multiple amplitudes and frequencies. Conventional fatigue evaluation of asphalt mixtures typically relies on a limited number of single fatigue tests, and each test is performed at constant test temperature. Moreover, in order to reduce laboratory effort to a minimum, testing is quite often limited to a single test temperature, which means that the dependency of asphalt fatigue on temperature is ignored. Such test procedure is in best accordance with the European Standards. However, so-derived results may provoke misleading conclusions, as exemplarily shown in this study. In order to solve this shortcoming, a sweep test protocol for fatigue evaluation of asphalt mixtures at different temperatures is proposed. Frequency–amplitude sweeps are used for complex modulus evaluation and fatigue evaluation, but without significantly extending the laboratory effort compared to conventional fatigue testing. This sweep test protocol is applicable for fatigue evaluation of any asphalt mixture.
- 13 February 2018
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 20 (5) , 1131-1144
Sweep test protocol for fatigue evaluation of asphalt mixtures
This paper presents a laboratory test protocol for evaluating fatigue properties of asphalt mixtures through sweep tests at multiple amplitudes and frequencies. Conventional fatigue evaluation of asphalt mixtures typically relies on a limited number of single fatigue tests, and each test is performed at constant test temperature. Moreover, in order to reduce laboratory effort to a minimum, testing is quite often limited to a single test temperature, which means that the dependency of asphalt fatigue on temperature is ignored. Such test procedure is in best accordance with the European Standards. However, so-derived results may provoke misleading conclusions, as exemplarily shown in this study. In order to solve this shortcoming, a sweep test protocol for fatigue evaluation of asphalt mixtures at different temperatures is proposed. Frequency–amplitude sweeps are used for complex modulus evaluation and fatigue evaluation, but without significantly extending the laboratory effort compared to conventional fatigue testing. This sweep test protocol is applicable for fatigue evaluation of any asphalt mixture.
- 19 October 2017
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 18 (sup4) , 514-534
Fatigue investigation on asphalt mixture layers’ interface
In this paper, the interface shear fatigue performance is investigated based on a new fatigue test protocol, which includes both cyclic shear and normal static compressive load. Several asphalt structure types are tested at five temperatures (from −10°C to 50°C) and three normal stress levels (from 0 to 0.50 MPa). Based on fatigue tests at three different shear amplitude levels unique fatigue functions of the layers’ interface were identified. It was found that the interface shear fatigue performance is highly dependent on normal stress state and increases with increasing normal stress. This is a direct consequence of the enhanced friction, adhesion and interlock at the shear interface. Observing the fatigue lives at different test temperatures, the best resistance was observed at lowest temperature. From a practical viewpoint, it is highly recommended to perform the test without normal stress application, since this can better reflect the research and practice experience, while keeping the testing protocol to a reasonable level of complexity.
- 19 October 2017
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 18 (sup4) , 514-534
Fatigue investigation on asphalt mixture layers’ interface
In this paper, the interface shear fatigue performance is investigated based on a new fatigue test protocol, which includes both cyclic shear and normal static compressive load. Several asphalt structure types are tested at five temperatures (from −10°C to 50°C) and three normal stress levels (from 0 to 0.50 MPa). Based on fatigue tests at three different shear amplitude levels unique fatigue functions of the layers’ interface were identified. It was found that the interface shear fatigue performance is highly dependent on normal stress state and increases with increasing normal stress. This is a direct consequence of the enhanced friction, adhesion and interlock at the shear interface. Observing the fatigue lives at different test temperatures, the best resistance was observed at lowest temperature. From a practical viewpoint, it is highly recommended to perform the test without normal stress application, since this can better reflect the research and practice experience, while keeping the testing protocol to a reasonable level of complexity.
- 23 June 2017
- Published by Springer Nature in Materials and Structures
- Vol. 50 (4) , 196
Experimental study on asphalt mixture recovery
- 23 June 2017
- Published by Springer Nature in Materials and Structures
- Vol. 50 (4) , 196
Experimental study on asphalt mixture recovery
- 8 March 2017
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 19 (5) , 1230-1240
Investigation on mixture recovery properties in fatigue tests
In this paper the recovery properties of hot mix asphalt (HMA) mixture in fatigue tests are investigated based on dissipated energy approach. In order to determine the influence of material ageing, bitumen content, polymer modification and compaction energy on material ability to recover its initial characteristics, different variations of an asphalt mixture for surface course AC 11 D S were prepared. Recovery of material mechanical properties is observed during a single rest period, introduced into tension–compression cyclic fatigue tests under stress control. The analysis of the experimental results reveals that there is a significant influence of the duration of rest period on recovery capability. A plateau phase is achieved when the length of the rest period does not have any impact on asphalt recovery properties. Asphalt ageing plays an important role in reducing the effects of material recovery. The degree of compaction used in this research seems to have no influence on material ability to restore its initial properties. Mixtures prepared with additionally 0.5% of bitumen by mass show the best recovery characteristics compared to other variations.
- 8 March 2017
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 19 (5) , 1230-1240
Investigation on mixture recovery properties in fatigue tests
In this paper the recovery properties of hot mix asphalt (HMA) mixture in fatigue tests are investigated based on dissipated energy approach. In order to determine the influence of material ageing, bitumen content, polymer modification and compaction energy on material ability to recover its initial characteristics, different variations of an asphalt mixture for surface course AC 11 D S were prepared. Recovery of material mechanical properties is observed during a single rest period, introduced into tension–compression cyclic fatigue tests under stress control. The analysis of the experimental results reveals that there is a significant influence of the duration of rest period on recovery capability. A plateau phase is achieved when the length of the rest period does not have any impact on asphalt recovery properties. Asphalt ageing plays an important role in reducing the effects of material recovery. The degree of compaction used in this research seems to have no influence on material ability to restore its initial properties. Mixtures prepared with additionally 0.5% of bitumen by mass show the best recovery characteristics compared to other variations.
- 26 May 2016
- Published by Springer Nature
- p. 253-258
Assessment of Healing Properties of Asphalt Mixtures
- 26 May 2016
- Published by Springer Nature
- p. 253-258
Assessment of Healing Properties of Asphalt Mixtures