Ankush Chaudhary
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ankush Chaudhary has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Narendra Parihar
Department of Electrical Engineering, IIT Bombay, Mumbai 400076, India
2 shared publications - Souvik Mahapatra
Department of Electrical Engineering, IIT Bombay, Mumbai, India
2 shared publications Beryl Fernandez
Department of Electrical Engineering, IIT Bombay, Mumbai, India
1 shared publication- Hiu Yung Wong
San Jose State University
1 shared publication R Anandkrishnan
Department of Electrical Engineering, IIT Bombay, Mumbai 400076, India
1 shared publicationRakesh Rao
Department of Electrical Engineering, IIT Bombay, Mumbai, India
1 shared publication
Latest Publications
- 21 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3273-3278
A Comparative Analysis of NBTI Variability and TDDS in GF HKMG Planar p-MOSFETs and RMG HKMG p-FinFETs
The time kinetics of threshold voltage shift (Δ VT) is measured for negative-bias temperature instability (NBTI) and time-dependent defect spectroscopy (TDDS) experiments by an ultra-fast (10-μs delay) method in gate-first high-k metal gate (HKMG) planar p-MOSFETs and replacement metal gate HKMG p-FinFETs. The mean NBTI stress-recovery time kinetics obtained from multiple small-area MOSFETs and few-fin FinFETs at different values of stress bias (VGSTR) and temperature (T) is modeled by uncorrelated contributions from interface (Δ VIT) and bulk (Δ VOT) trap generation and trapping of holes (Δ VHT) in pre-existing defects. The time constant associated with recovery steps and the impact of each step for multiple TDDS sweeps on a single device and after NBTI in multiple devices are compared. The NBTI-induced Δ VT distribution shape is verified using TDDS charge impact. The shift in mean and variance of NBTI-induced Δ VT and post-stress VT distributions is modeled.
- 21 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (8) , 3273-3278
A Comparative Analysis of NBTI Variability and TDDS in GF HKMG Planar p-MOSFETs and RMG HKMG p-FinFETs
The time kinetics of threshold voltage shift (Δ VT) is measured for negative-bias temperature instability (NBTI) and time-dependent defect spectroscopy (TDDS) experiments by an ultra-fast (10-μs delay) method in gate-first high-k metal gate (HKMG) planar p-MOSFETs and replacement metal gate HKMG p-FinFETs. The mean NBTI stress-recovery time kinetics obtained from multiple small-area MOSFETs and few-fin FinFETs at different values of stress bias (VGSTR) and temperature (T) is modeled by uncorrelated contributions from interface (Δ VIT) and bulk (Δ VOT) trap generation and trapping of holes (Δ VHT) in pre-existing defects. The time constant associated with recovery steps and the impact of each step for multiple TDDS sweeps on a single device and after NBTI in multiple devices are compared. The NBTI-induced Δ VT distribution shape is verified using TDDS charge impact. The shift in mean and variance of NBTI-induced Δ VT and post-stress VT distributions is modeled.
- 6 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (1) , 256-263
Consistency of the Two Component Composite Modeling Framework for NBTI in Large and Small Area p-MOSFETs
Consistency of the recently proposed deterministic composite modeling framework for Negative Bias Temperature Instability (NBTI) in large area devices is verified for stochastic NBTI in small area devices. The framework has two independent and uncoupled components, interface trap generation (ΔVIT), and hole trapping in pre-existing defects (ΔVHT). The time evolution of mean threshold voltage shift (ΔV T), from multiple ultra-fast measurements in small area devices under diverse stress and recovery conditions, is predicted by the deterministic composite framework. It is shown that although the physical mechanism of NBTI remains the same as the device area is scaled, there can be significant differences in the relative ΔVIT and Δ VHT contribution to ΔVT between large and small area devices, which can alter the overall model parameters. A stochastic simulation framework, fully consistent with the deterministic framework, is developed, which is shown to predict experimentally measured mean time evolution of ΔVT in small area devices.
- 6 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (1) , 256-263
Consistency of the Two Component Composite Modeling Framework for NBTI in Large and Small Area p-MOSFETs
Consistency of the recently proposed deterministic composite modeling framework for Negative Bias Temperature Instability (NBTI) in large area devices is verified for stochastic NBTI in small area devices. The framework has two independent and uncoupled components, interface trap generation (ΔVIT), and hole trapping in pre-existing defects (ΔVHT). The time evolution of mean threshold voltage shift (ΔV T), from multiple ultra-fast measurements in small area devices under diverse stress and recovery conditions, is predicted by the deterministic composite framework. It is shown that although the physical mechanism of NBTI remains the same as the device area is scaled, there can be significant differences in the relative ΔVIT and Δ VHT contribution to ΔVT between large and small area devices, which can alter the overall model parameters. A stochastic simulation framework, fully consistent with the deterministic framework, is developed, which is shown to predict experimentally measured mean time evolution of ΔVT in small area devices.
- 12 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 63 (12) , 4624-4631
TCAD-Based Predictive NBTI Framework for Sub-20-nm Node Device Design Considerations
The kinetics of trap generation during negative-bias temperature instability (NBTI) stress in pMOSFETs, as governed by the double interface H–H2 reaction–diffusion (RD) model, is incorporated for the first time in a commercial technology computer-aided design (TCAD) software, and used for simulating degradation in various device architectures. The calibrated TCAD framework is shown to successfully explain the measured impact of interface trap generation ($ \Delta N _{\mathrm{ IT}} $ ) in bulk silicon FinFETs for wide range of stress bias and temperature. The impact of device design on NBTI degradation is explored by comparing the simulated trap generation kinetics in bulk FinFET, silicon on insulator FinFET, and gate all around nanowire FET devices having different geometries. The simulated predictions agree well with the experimental observations reported in the literature. The proposed TCAD framework would enable performance-reliability co-optimization during device design for advanced technology nodes.- 12 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 63 (12) , 4624-4631
TCAD-Based Predictive NBTI Framework for Sub-20-nm Node Device Design Considerations
The kinetics of trap generation during negative-bias temperature instability (NBTI) stress in pMOSFETs, as governed by the double interface H–H2 reaction–diffusion (RD) model, is incorporated for the first time in a commercial technology computer-aided design (TCAD) software, and used for simulating degradation in various device architectures. The calibrated TCAD framework is shown to successfully explain the measured impact of interface trap generation ($ \Delta N _{\mathrm{ IT}} $ ) in bulk silicon FinFETs for wide range of stress bias and temperature. The impact of device design on NBTI degradation is explored by comparing the simulated trap generation kinetics in bulk FinFET, silicon on insulator FinFET, and gate all around nanowire FET devices having different geometries. The simulated predictions agree well with the experimental observations reported in the literature. The proposed TCAD framework would enable performance-reliability co-optimization during device design for advanced technology nodes.