MAMohammad Al-Amin

Mohammad Al-Amin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mohammad Al-Amin has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Iodine–Ethanol Surface Passivation for Measurement of Millisecond Carrier Lifetimes in Silicon Wafers with Different Crystallographic Orientations

    by Mohammad Al-Amin, Nicholas E. Grant, Alex I. Pointon, John D. Murphy

    To improve silicon device fabrication processes, it is necessary to monitor bulk minority carrier lifetimes accurately, and this requires surface recombination to be well controlled and, ideally, minimized. Good surface passivation can result from thermal oxidation or by deposition of dielectrics (e.g., Al2O3, SiNx, and amorphous Si), but these forms of passivation can modify the lifetime of the material under investigation. Various schemes can passivate surfaces on a temporary basis without modifying the bulk, and, in this article, the virtues of the iodine–ethanol (I–E) temporary surface passivation scheme are explored. A procedure for preparing the wafer surfaces prior to passivation is developed. For the optimized pretreatment, a series of experiments on 3–5 Ω cm float‐zone wafers cut from the same ingot with different thicknesses is conducted. This enables the material's bulk lifetime to be measured at 1015 cm−3 injection as 46 ms, with the surface recombination velocity being 6.5 ± 0.3 cm s−1. I–E passivation is then compared to a recently developed superacid‐derived temporary passivation scheme. Although the latter is superior on (100)‐orientation substrates, I–E performs much better on (111)‐orientation substrates, making it a better choice for (111)‐orientation wafers, such as those used for power devices.


  • Open Access

    Superacid-Treated Silicon Surfaces: Extending the Limit of Carrier Lifetime for Photovoltaic Applications

    by Nicholas E. Grant, Tim Niewelt, Neil R. Wilson, Evangeline C. Wheeler-Jones, James Bullock, Mohammad Al-Amin, Martin C. Schubert, Andre C. van Veen, Ali Javey, John D. Murphy

    Minimizing carrier recombination at interfaces is of extreme importance in the development of high-efficiency photovoltaic devices and for bulk material characterization. Here, we investigate a temporary room temperature superacid-based passivation scheme, which provides surface recombination velocities below 1 cm/s, thus placing our passivation scheme amongst state-of-the-art dielectric films. Application of the technique to high-quality float-zone silicon allows the currently accepted intrinsic carrier lifetime limit to be reached and calls its current parameterization into doubt for 1 Ω·cm n-type wafers. The passivation also enables lifetimes up to 65 ms to be measured in high-resistivity Czochralski silicon, which, to our knowledge, is the highest ever measured in Czochralski-grown material. The passivation strategies developed in this work will help diagnose bulk lifetime degradation under solar cell processing conditions and also help quantify the electronic quality of new passivation schemes.


  • Open Access

    Combining Low-Temperature Gettering With Phosphorus Diffusion Gettering for Improved Multicrystalline Silicon

    by Mohammad Al-Amin, John D. Murphy

    We have investigated low-temperature (≤500 °C) gettering in combination with phosphorus diffusion gettering with a view to improving poor quality multicrystalline silicon. Low-temperature gettering applied after standard phosphorus diffusion gettering is found to provide a >40% improvement in minority carrier lifetime in samples from the top and bottom of an ingot. The best results are achieved at 300 °C with very long annealing times (>24 h). Improvements in the lifetime do not correlate with changes in interstitial iron concentration. Experiments are performed to assess whether the presence of a phosphorus-diffused emitter affects low-temperature gettering, and results from sister samples show the low-temperature gettering behavior is not affected by the existence of an emitter. Further experiments show that low-temperature gettering prior to phosphorus diffusion results in a 20% higher lifetime after phosphorus diffusion. Low-temperature gettering can, therefore, enhance lifetime even when used in conjunction with standard phosphorus diffusion gettering.


  • Open Access

    Low Temperature Internal Gettering of Bulk Defects in Silicon Photovoltaic Materials

    by Mohammad Al-Amin, J.D. Murphy

    Multicrystalline silicon (mc-Si) substrates are widely used for photovoltaic cells. The minority carrier lifetime in mc-Si is affected by recombination associated with metallic impurities in many forms, such as point-like defects, precipitates and bound to or precipitated at structural defects such as dislocations. We have studied the effect of low temperature annealing on the lifetime and bulk iron concentration in as-received mc-Si wafers from different locations within a block. Lifetime measurements are made using a temporary iodine-ethanol surface passivation technique to minimize the occurrence of bulk hydrogenation which often occurs from dielectric films. In good wafers from the middle of the block the lifetime is reduced by annealing at 400 °C and 500 °C in a way which does not correlate with changes in bulk iron concentration. Lifetime improvements occur in relatively poor samples from the top and bottom of the block annealed at 300 °C, and also in samples from the bottom annealed at 400 °C. The improvement in bottom wafers correlates with iron loss from the bulk. Our work shows that under some conditions the lifetime in relatively poor as-grown wafers can be improved by low temperature internal gettering.