Bruno Charles Dias Soares
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bruno Charles Dias Soares has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- José Tarcísio Lima
Department of Forest Sciences, Federal University of Lavras, Lavras, Brazil
4 shared publications - Ana Clara Caxito de Araújo
Universidade Federal de Lavras, Brasil
2 shared publications José Tarcísio Lima
Univ Fed Lavras UFLA, Dept Engn Floresta, Lavras, MG, Brazil
2 shared publications- José Tarcísio Lima
Universidade Federal de Lavras, Brazil
2 shared publications - Maria Fernanda Vieira Rocha
Bracell Bahia Florestal , Alagoinhas , Bahia , Brazil
2 shared publications - Milene Teixeira de Souza
Universidade Federal Rural do Rio de Janeiro, Seropédica, Rio de Janeiro, Brazil
2 shared publications
Latest Publications
- 10 November 2022
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 77 (1) , 16-27
Wood quality of residual branches of Hymenaea courbaril L. from logging in the Amazon rainforest
Branches remain in the forest environment as logging activity residue. Considering the large size of many Amazonian trees, their branches have considerable dimensions and can contribute to a sustainable wood alternative for various applications. Due to the formation of reaction wood in the branches, relevant macro and ultrastructural changes can occur in its characteristics in relation to the trunk wood. However, the woods of the branches are not technologically well known. Therefore, this work aimed to evaluate the wood quality of branches of Hymenaea courbaril L., comparing it with wood of trunks. The extractives and lignin contents, basic density, shrinkage, fiber biometry, microfibril angle and mechanical resistance to compression parallel to the fibers were analyzed. The branch wood had smaller fiber dimensions and a higher microfibril angle than the trunk wood. The basic density was similar between these materials. The linear and volumetric shrinkages were smaller in the branch wood than in the trunk, while the axial shrinkage was higher in the branch. The parallel compressive strength was also lower in the branch wood than in the trunk. The branch wood has properties suitable for products with higher added value such as furniture, decorative objects, floors and utensils in general.
- 10 November 2022
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 77 (1) , 16-27
Wood quality of residual branches of Hymenaea courbaril L. from logging in the Amazon rainforest
Branches remain in the forest environment as logging activity residue. Considering the large size of many Amazonian trees, their branches have considerable dimensions and can contribute to a sustainable wood alternative for various applications. Due to the formation of reaction wood in the branches, relevant macro and ultrastructural changes can occur in its characteristics in relation to the trunk wood. However, the woods of the branches are not technologically well known. Therefore, this work aimed to evaluate the wood quality of branches of Hymenaea courbaril L., comparing it with wood of trunks. The extractives and lignin contents, basic density, shrinkage, fiber biometry, microfibril angle and mechanical resistance to compression parallel to the fibers were analyzed. The branch wood had smaller fiber dimensions and a higher microfibril angle than the trunk wood. The basic density was similar between these materials. The linear and volumetric shrinkages were smaller in the branch wood than in the trunk, while the axial shrinkage was higher in the branch. The parallel compressive strength was also lower in the branch wood than in the trunk. The branch wood has properties suitable for products with higher added value such as furniture, decorative objects, floors and utensils in general.
- 18 February 2022
- Published by Springer Nature in Trees
- Vol. 36 (4) , 1185-1192
Influence of density and lignin content on cleavage strength of Eucalyptus grandis wood
- 18 February 2022
- Published by Springer Nature in Trees
- Vol. 36 (4) , 1185-1192
Influence of density and lignin content on cleavage strength of Eucalyptus grandis wood
- 12 August 2021
- Published by Springer Nature in Trees
- Vol. 36 (1) , 191-197
Application of X-ray diffraction to assess the microfibril angle of green and dry Eucalyptus grandis wood
- 12 August 2021
- Published by Springer Nature in Trees
- Vol. 36 (1) , 191-197
Application of X-ray diffraction to assess the microfibril angle of green and dry Eucalyptus grandis wood
- Open Access
- 1 January 2020
- Published by FapUNIFESP (SciELO) in Matéria (Rio de Janeiro)
- Vol. 25 (4)
Activated carbon quality produced by Tectona grandis wastes: activation methods and adsorption capacity
Activated carbons (AC) are high porosity and adsorptive carbonaceous materials. These adsorbents can be produced using different organic materials. Precursor material properties may impact their quality. This study aimed to produce activated carbon from Tectona grandis wood wastes, besides determining efficiency in adsorption of different pollutants. Chemical activation, with ZnCl2 (AC_ZnCl2) and CuSO4 (AC_CuSO4), and physical activation, with CO2 (AC_CO2) were performed. Activated carbons were characterized by FTIR, surface functional groups (Boehm) and surface area analysis. Moreover, ACs were tested regarding adsorption capacity of methylene blue (MB), phenol and Cr+6 ions in aqueous medium. Higher total pore volume (0.62 cm³ g-¹), micropore volume (0.31 cm³ g-¹) and surface area (524.50 m² g-¹) were obtained in AC_ZnCl2, which was also the most effective in MB and phenol adsorption. AC_CuSO4 obtained high adsorption capacity for phenol and presented functional groups different from the other AC. AC_CO2 was the second with better adsorption performance for all pollutants.
- 1 January 2020
- Published by FapUNIFESP (SciELO) in Matéria (Rio de Janeiro)
- Vol. 25 (4)
Open AccessActivated carbon quality produced by Tectona grandis wastes: activation methods and adsorption capacity
Activated carbons (AC) are high porosity and adsorptive carbonaceous materials. These adsorbents can be produced using different organic materials. Precursor material properties may impact their quality. This study aimed to produce activated carbon from Tectona grandis wood wastes, besides determining efficiency in adsorption of different pollutants. Chemical activation, with ZnCl2 (AC_ZnCl2) and CuSO4 (AC_CuSO4), and physical activation, with CO2 (AC_CO2) were performed. Activated carbons were characterized by FTIR, surface functional groups (Boehm) and surface area analysis. Moreover, ACs were tested regarding adsorption capacity of methylene blue (MB), phenol and Cr+6 ions in aqueous medium. Higher total pore volume (0.62 cm³ g-¹), micropore volume (0.31 cm³ g-¹) and surface area (524.50 m² g-¹) were obtained in AC_ZnCl2, which was also the most effective in MB and phenol adsorption. AC_CuSO4 obtained high adsorption capacity for phenol and presented functional groups different from the other AC. AC_CO2 was the second with better adsorption performance for all pollutants.
- 29 March 2019
- Published by Instituto de Pesquisa e Estudos Florestais (IPEF) in Scientia Forestalis
- Vol. 47 (121) , 125-130
Distribuição espacial da lignina na parede celular da madeira de Eucalyptus grandis
- 29 March 2019
- Published by Instituto de Pesquisa e Estudos Florestais (IPEF) in Scientia Forestalis
- Vol. 47 (121) , 125-130
Distribuição espacial da lignina na parede celular da madeira de Eucalyptus grandis
- Open Access
- 1 January 2019
- Published by FapUNIFESP (SciELO) in Floresta e Ambiente
- Vol. 26 (3)
Do the Growing Conditions of Trees Influence the Wood Properties?
Currently, there is a little and sparse information about how the growing conditions influence the spatial variation of wood along the stem. Thus, the aim of this study was to compile the knowledge from literature in a manuscript for better understanding to what extent the growing conditions influence the spatial variation of wood properties in Eucalyptus plantations. The wood characteristics may present variations in their properties and can be caused by both genetic and environmental factors. However, how genetic and environmental factor acts on wood variation along the trunk is still unclear. Another point is that even with new genetic breeding programs, the mechanical properties of wood have not been considered in these programs, since the selection of new material is always based on the growing rate, cellulose and lignin content and wood density.
- 1 January 2019
- Published by FapUNIFESP (SciELO) in Floresta e Ambiente
- Vol. 26 (3)
Open AccessDo the Growing Conditions of Trees Influence the Wood Properties?
Currently, there is a little and sparse information about how the growing conditions influence the spatial variation of wood along the stem. Thus, the aim of this study was to compile the knowledge from literature in a manuscript for better understanding to what extent the growing conditions influence the spatial variation of wood properties in Eucalyptus plantations. The wood characteristics may present variations in their properties and can be caused by both genetic and environmental factors. However, how genetic and environmental factor acts on wood variation along the trunk is still unclear. Another point is that even with new genetic breeding programs, the mechanical properties of wood have not been considered in these programs, since the selection of new material is always based on the growing rate, cellulose and lignin content and wood density.
- Open Access
- 1 January 2019
- Published by FapUNIFESP (SciELO) in Floresta e Ambiente
- Vol. 26 (3)
Behavior of Juvenile and Mature Eucalyptus cloeziana Wood Subjected to Drastic Drying
This study aimed to evaluate the behavior of samples of juvenile and mature Eucalyptus cloeziana wood when subjected to the drying process, and the influence of the anatomy on that behavior. In order to do this, saturated specimens from this woods measuring 10 × 5 × 1 cm were subjected to drastic drying at 100 °C, where the drying rates and the end check scores in different steps of the process were obtained. The fibers and vessels morphology, initial moisture and basic density were analyzed to help understanding the data obtained in the drying test. The juvenile wood presented 26% higher drying rate and 21% smaller drying time, also 53% higher end check score. Smaller fibers length and fibers wall thickness, higher vessels frequency and smaller vessels diameter were associated with higher total drying rate and water adsorption, as well as with the higher end check score.
- 1 January 2019
- Published by FapUNIFESP (SciELO) in Floresta e Ambiente
- Vol. 26 (3)
Open AccessBehavior of Juvenile and Mature Eucalyptus cloeziana Wood Subjected to Drastic Drying
This study aimed to evaluate the behavior of samples of juvenile and mature Eucalyptus cloeziana wood when subjected to the drying process, and the influence of the anatomy on that behavior. In order to do this, saturated specimens from this woods measuring 10 × 5 × 1 cm were subjected to drastic drying at 100 °C, where the drying rates and the end check scores in different steps of the process were obtained. The fibers and vessels morphology, initial moisture and basic density were analyzed to help understanding the data obtained in the drying test. The juvenile wood presented 26% higher drying rate and 21% smaller drying time, also 53% higher end check score. Smaller fibers length and fibers wall thickness, higher vessels frequency and smaller vessels diameter were associated with higher total drying rate and water adsorption, as well as with the higher end check score.
- 8 September 2018
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 73 (2) , 219-222
Strength and stiffness of the reaction wood in five Eucalyptus species
Tree stems deviating from the vertical position react by the formation of tension wood (TW) or compression wood (CW), which are called in general as reaction wood (RW), in which the cells are modified chemically and anatomically. The focus of the present work is the mechanical behavior of TW in five 37-year-old Eucalyptus species, which were grown on a planting area with an average slope of 28% leading to decentralized pith in the trees, which is an unequivocal indication of the presence of RW. TW and opposite wood (OW) samples were isolated and subjected to a compression-parallel-to-grain test. It was observed that TW is less resistant and less stiff than the OW.
- 8 September 2018
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 73 (2) , 219-222
Strength and stiffness of the reaction wood in five Eucalyptus species
Tree stems deviating from the vertical position react by the formation of tension wood (TW) or compression wood (CW), which are called in general as reaction wood (RW), in which the cells are modified chemically and anatomically. The focus of the present work is the mechanical behavior of TW in five 37-year-old Eucalyptus species, which were grown on a planting area with an average slope of 28% leading to decentralized pith in the trees, which is an unequivocal indication of the presence of RW. TW and opposite wood (OW) samples were isolated and subjected to a compression-parallel-to-grain test. It was observed that TW is less resistant and less stiff than the OW.
- 1 December 2017
- Published by Instituto de Pesquisa e Estudos Florestais (IPEF) in Scientia Forestalis
- Vol. 45 (116) , 611-618
Delimitação estatística dos lenhos juvenil e adulto de Eucalyptus e Corymbia
- 1 December 2017
- Published by Instituto de Pesquisa e Estudos Florestais (IPEF) in Scientia Forestalis
- Vol. 45 (116) , 611-618
Delimitação estatística dos lenhos juvenil e adulto de Eucalyptus e Corymbia
- Open Access
- 1 January 2016
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Maderas. Ciencia y Tecnología
- No. ahead
Analysing the drying behavior of juvenile and mature Eucalyptus saligna wood in drastic drying test for optimal drying schedule
- 1 January 2016
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Maderas. Ciencia y Tecnología
- No. ahead
Open AccessAnalysing the drying behavior of juvenile and mature Eucalyptus saligna wood in drastic drying test for optimal drying schedule