GGGaurav Gupta

Gaurav Gupta

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Gaurav Gupta has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Investigation of Pd/MoOx/n-Si diodes for bipolar transistor and light-emitting device applications

    by Gaurav Gupta, Shivakumar D. Thammaiah, Lis K. Nanver, Raymond J. E. Hueting

    Sub-stoichiometric molybdenum oxide (MoO x ) has recently been investigated for application in high efficiency Si solar cells as a “hole selective” contact. In this paper, we investigate the electrical and light-emitting properties of MoO x -based contacts on Si from the viewpoint of realizing functional bipolar devices such as light-emitting diodes (LEDs) and transistors without any impurity doping of the Si surface. We realized diodes on n-type Si substrates using e-beam physical vapor deposition of Pd/MoO x contacts and compared their behavior to implanted p + n-Si diodes as a reference. In contrast to majority-carrier dominated conduction that occurs in conventional Schottky diodes, Pd/MoO x /n-Si diodes show minority-carrier dominated charge transport with I–V, C–V, and light-emitting characteristics comparable to implanted counterparts. Utilizing such MoO x -based contacts, we also demonstrate a lateral bipolar transistor concept without employing any doped junctions. A detailed C–V analysis confirmed the excessive band-bending in Si corresponding to a high potential barrier ( > 0.90 V) at the MoO x /n-Si interface which, along with the observed amorphous SiO x (Mo) interlayer, plays a role in suppressing the majority-carrier current. An inversion layer at the n-Si surface was also identified comprising a sheet carrier density greater than 8.6 × 10 11 cm − 2 , and the MoO x layer was found to be conductive though with a very high resistivity in the 10 4 Ω -cm range. We refer to these diodes as metal/non-insulator/semiconductor diodes and show with our device simulations that they can be mimicked as high-barrier Schottky diodes with an induced inversion layer at the interface.


  • E-Nose: Multichannel Analog Signal Conditioning Circuit With Pattern Recognition for Explosive Sensing

    by Vijay S. Palaparthy, Shambhulingayya N. Doddapujar, Gaurav Gupta, Pallabi Das, Saurabh Arun Chandorkar, Soumyo Mukherji, Maryam Shojaei Baghini, V. Ramgopal Rao

    This paper presents E-Nose, a novel cost-effective, field-deployable portable system that constitutes a 4-channel signal conditioning circuit and multi-coated piezo-resistive micro-cantilever sensors for explosive sensing. E-Nose also features an embedded PCA and K-means based pattern recognition (PR) algorithm for the classification of explosives from non-explosives. The 4-channel configuration is a stack of two 2-channel circuits that are capable of measuring the change in the sensor resistance or capacitance in four optional modes of DR-DR, DR-DC, DC-DR, and DC-DC by using time multiplexing. The circuit uses a bidirectional AC current excitation method to drive the sensor bridge for significant reduction of DC offset errors, 1/f noise, line noise, and DC drifts. The proposed signal conditioning circuit uses the phase-sensitive synchronous rectification (PSSR) method for AC-to-DC conversion by using balanced demodulation. The circuit can measure a wide range of resistors that range from 100Y to 4MY, with a sensitivity of 0.4mV/ppm and the worst relative error of 2.6%. The capacitive measurement range is from 100pF to 100lF with the worst relative error of 3.3%. The entire data processing and the PR algorithms run on Raspberry Pi (R-Pi), which is integrated into the E-Nose system. The system performance is tested with MEMS cantilevers for the detection of explosive compounds, such as TNT and its derivatives, RDX and PETN in a controlled environment at a concentration that was as low as 16ppb TNT, 56ppb RDX and 134ppb of PETN. Measurements show that the E-Nose can detect explosives with 77% as true positive results without considering the environmental and mixed vapor effects.


  • Charge carrier transport and electroluminescence in atomic layer deposited poly-GaN/c-Si heterojunction diodes

    by Gaurav Gupta, Sourish Banerjee, Satadal Dutta, Antonius A. I. Aarnink, Jurriaan Schmitz, Alexey Y. Kovalgin, Raymond J. E. Hueting

    In this work, we study the charge carrier transport and electroluminescence (EL) in thin-film polycrystalline (poly-) GaN/c-Si heterojunction diodes realized using a plasma enhanced atomic layer deposition process. The fabricated poly-GaN/p-Si diode with a native oxide at the interface showed a rectifying behavior (Ion/Ioff ratio ∼ 103 at ±3 V) with current-voltage characteristics reaching an ideality factor n of ∼5.17. The areal (Ja) and peripheral (Jp) components of the current density were extracted, and their temperature dependencies were studied. The space charge limited current (SCLC) in the presence of traps is identified as the dominant carrier transport mechanism for Ja in forward bias. An effective trap density of 4.6 × 1017/cm3 at a trap energy level of 0.13 eV below the GaN conduction band minimum was estimated by analyzing Ja. Other basic electrical properties of the material such as the free carrier concentration, effective density of states in the conduction band, electron mobility, and dielectric relaxation time were also determined from the current-voltage analysis in the SCLC regime. Further, infrared EL corresponding to the Si bandgap was observed from the fabricated diodes. The observed EL intensity from the GaN/p-Si heterojunction diode is ∼3 orders of magnitude higher as compared to the conventional Si only counterpart. The enhanced infrared light emission is attributed to the improved injector efficiency of the GaN/Si diode because of the wide bandgap of the poly-GaN layer and the resulting band discontinuity at the GaN/Si interface.


  • Top Cited Papers

    Electrostatic Doping in Semiconductor Devices

    by Gaurav Gupta, Bijoy Rajasekharan, Raymond J. E. Hueting

    To overcome the limitations of chemical doping in nanometer-scale semiconductor devices, electrostatic doping (ED) is emerging as a broadly investigated alternative to provide regions with a high electron or hole density in a semiconductor device. In this paper, we review various reported ED approaches and related device architectures in different material systems. We highlight the role of metal and semiconductor workfunctions, energy bandgap, and applied electric field and the interplay between them for the induced ED. The effect of interface traps on the induced charge is also addressed. In addition, we discuss the performance benefits of ED devices and the major roadblocks of these approaches for potential future CMOS technology.