Ke Gong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ke Gong has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Anne Myers Kelley
Dept. of Chemistry and Biochemistry, U C Merced
4 shared publications David F. Kelley
Chemistry and Chemical Biology, University of California, Merced, 5200 North Lake Road, Merced, California 95343, USA
4 shared publications- Chen Lin
Chemistry and Chemical Biology, University of California, Merced, 5200 North Lake Road, Merced, California 95343, United States
1 shared publication - David F. Kelley
Dept. of Chemistry and Biochemistry, University of California Merced
1 shared publication Jamie J. Grenland
Chemistry and Chemical Biology, University of California, Merced, 5200 North Lake Road, Merced, California 95343, United States
1 shared publication
Latest Publications
- 8 December 2017
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 147 (22) , 224702
Resonance Raman excitation profiles of CdS in pure CdS and CdSe/CdS core/shell quantum dots: CdS-localized excitons
Resonance Raman excitation profiles have been measured for the longitudinal optical phonon in two sizes of CdS quantum dots and in CdSe/CdS core/shell quantum dots. In pure CdS, the resonance Raman cross section for the fundamental transition is sharply peaked around the lowest-energy excitonic transition and becomes weaker with higher-energy excitation even though the absorbance continues to increase to higher energies. This effect, also observed in earlier studies of CdSe quantum dots, is attributed largely to interferences among multiple excitonic transitions contributing to the resonance Raman polarizability. No variation in exciton-phonon coupling strength with exciton energy is required to explain the decrease in the ratio of the Raman cross section to absorption cross section at shorter wavelengths. In core/shell structures, the CdSe phonons are relatively strong when exciting on resonance with the lower excitonic transitions, in which the hole is largely localized to the CdSe core, but become nearly undetectable at excitation wavelengths >0.6 eV above the lowest exciton, where both electrons and holes are largely localized in the CdS shell. The CdS phonon Raman cross section exhibits a maximum 0.6-0.7 eV above the lowest exciton and then decreases at higher energies for the same reasons as in pure CdS.
- 8 December 2017
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 147 (22) , 224702
Resonance Raman excitation profiles of CdS in pure CdS and CdSe/CdS core/shell quantum dots: CdS-localized excitons
Resonance Raman excitation profiles have been measured for the longitudinal optical phonon in two sizes of CdS quantum dots and in CdSe/CdS core/shell quantum dots. In pure CdS, the resonance Raman cross section for the fundamental transition is sharply peaked around the lowest-energy excitonic transition and becomes weaker with higher-energy excitation even though the absorbance continues to increase to higher energies. This effect, also observed in earlier studies of CdSe quantum dots, is attributed largely to interferences among multiple excitonic transitions contributing to the resonance Raman polarizability. No variation in exciton-phonon coupling strength with exciton energy is required to explain the decrease in the ratio of the Raman cross section to absorption cross section at shorter wavelengths. In core/shell structures, the CdSe phonons are relatively strong when exciting on resonance with the lower excitonic transitions, in which the hole is largely localized to the CdSe core, but become nearly undetectable at excitation wavelengths >0.6 eV above the lowest exciton, where both electrons and holes are largely localized in the CdS shell. The CdS phonon Raman cross section exhibits a maximum 0.6-0.7 eV above the lowest exciton and then decreases at higher energies for the same reasons as in pure CdS.
- 20 March 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 121 (12) , 7056-7061
Resonance Raman Investigation of the Interaction between Aromatic Dithiocarbamate Ligands and CdSe Quantum Dots
- 20 March 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 121 (12) , 7056-7061
Resonance Raman Investigation of the Interaction between Aromatic Dithiocarbamate Ligands and CdSe Quantum Dots
- 23 January 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 8 (3) , 626-630
Nonuniform Excitonic Charge Distribution Enhances Exciton–Phonon Coupling in ZnSe/CdSe Alloyed Quantum Dots
Zinc to cadmium cation exchange of ZnSe quantum dots has been used to produce a series of alloyed Zn1–xCdxSe quantum dots. As x increases and the lowest-energy exciton shifts to the red, the peak initially broadens and then sharpens as x approaches 1. Resonance Raman spectra obtained with excitation near the lowest excitonic absorption peak show a gradual shift of the longitudinal optical phonon peak from 251 cm–1 in pure ZnSe to 210 cm–1 in nearly pure CdSe with strong broadening at intermediate compositions. The LO overtone to fundamental intensity ratio, a rough gauge of exciton–phonon coupling strength, increases considerably for intermediate compositions compared with those of either pure ZnSe or pure CdSe. The results indicate that partial localization of the hole in locally Cd-rich regions of the alloyed particles increases the strengths of local internal electric fields, increasing the coupling between the exciton and polar optical phonons.
- 23 January 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 8 (3) , 626-630
Nonuniform Excitonic Charge Distribution Enhances Exciton–Phonon Coupling in ZnSe/CdSe Alloyed Quantum Dots
Zinc to cadmium cation exchange of ZnSe quantum dots has been used to produce a series of alloyed Zn1–xCdxSe quantum dots. As x increases and the lowest-energy exciton shifts to the red, the peak initially broadens and then sharpens as x approaches 1. Resonance Raman spectra obtained with excitation near the lowest excitonic absorption peak show a gradual shift of the longitudinal optical phonon peak from 251 cm–1 in pure ZnSe to 210 cm–1 in nearly pure CdSe with strong broadening at intermediate compositions. The LO overtone to fundamental intensity ratio, a rough gauge of exciton–phonon coupling strength, increases considerably for intermediate compositions compared with those of either pure ZnSe or pure CdSe. The results indicate that partial localization of the hole in locally Cd-rich regions of the alloyed particles increases the strengths of local internal electric fields, increasing the coupling between the exciton and polar optical phonons.
- 19 December 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (51) , 29533-29539
Resonance Raman Spectroscopy and Electron–Phonon Coupling in Zinc Selenide Quantum Dots
- 19 December 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (51) , 29533-29539
Resonance Raman Spectroscopy and Electron–Phonon Coupling in Zinc Selenide Quantum Dots
- 19 November 2014
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 141 (19) , 194704
A predictive model of shell morphology in CdSe/CdS core/shell quantum dots
Lattice mismatch in core/shell nanoparticles occurs when the core and shell materials have different lattice parameters. When there is a significant lattice mismatch, a coherent core-shell interface results in substantial lattice strain energy, which can affect the shell morphology. The shell can be of uniform thickness or can be rough, having thin and thick regions. A smooth shell minimizes the surface energy at the expense of increased lattice strain energy and a rough shell does the opposite. A quantitative treatment of the lattice strain energy in determining the shell morphology of CdSe/CdS core/shell nanoparticles is presented here. We use the inhomogeneity in hole tunneling rates through the shell to adsorbed hole acceptors to quantify the extent of shell thickness inhomogeneity. The results can be understood in terms of a model based on elastic continuum calculations, which indicate that the lattice strain energy depends on both core size and shell thickness. The model assumes thermodynamic equilibrium, i.e., that the shell morphology corresponds to a minimum total (lattice strain plus surface) energy. Comparison with the experimental results indicates that CdSe/CdS nanoparticles undergo an abrupt transition from smooth to rough shells when the total lattice strain energy exceeds about 27 eV or the strain energy density exceeds 0.59 eV/nm2. We also find that the predictions of this model are not followed for CdSe/CdS nanoparticles when the shell is deposited at very low temperature and therefore equilibrium is not established.
- 19 November 2014
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 141 (19) , 194704
A predictive model of shell morphology in CdSe/CdS core/shell quantum dots
Lattice mismatch in core/shell nanoparticles occurs when the core and shell materials have different lattice parameters. When there is a significant lattice mismatch, a coherent core-shell interface results in substantial lattice strain energy, which can affect the shell morphology. The shell can be of uniform thickness or can be rough, having thin and thick regions. A smooth shell minimizes the surface energy at the expense of increased lattice strain energy and a rough shell does the opposite. A quantitative treatment of the lattice strain energy in determining the shell morphology of CdSe/CdS core/shell nanoparticles is presented here. We use the inhomogeneity in hole tunneling rates through the shell to adsorbed hole acceptors to quantify the extent of shell thickness inhomogeneity. The results can be understood in terms of a model based on elastic continuum calculations, which indicate that the lattice strain energy depends on both core size and shell thickness. The model assumes thermodynamic equilibrium, i.e., that the shell morphology corresponds to a minimum total (lattice strain plus surface) energy. Comparison with the experimental results indicates that CdSe/CdS nanoparticles undergo an abrupt transition from smooth to rough shells when the total lattice strain energy exceeds about 27 eV or the strain energy density exceeds 0.59 eV/nm2. We also find that the predictions of this model are not followed for CdSe/CdS nanoparticles when the shell is deposited at very low temperature and therefore equilibrium is not established.