CSChristopher H. Scholz

Christopher H. Scholz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Christopher H. Scholz has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Shift and Increase in Tidal Modulation of Seismicity in the Ridgecrest Fault Zone Before and After the 2019 Magnitude 7.1 Earthquake

    by Eric Beaucé, Piero Poli, Felix Waldhauser, Benjamin K. Holtzman, Chris H. Scholz

    We studied the tidal modulation of the rate of seismicity in the Ridgecrest, California area between 2008 and 2024, thus including the 2019 Mw 7.1 earthquake. We combined machine-learning-enhanced earthquake detection and location with a novel methodology to characterize tidal modulation. We identified significant modulation of seismicity in the Ridgecrest fault zone and in the neighboring regions, the Coso volcanic field and the Garlock fault, but tidal modulation in the fault zone exhibits a unique temporal evolution. Modulation in the fault zone shifts, around 2014–2015, from a stress-controlled regime where peak seismicity occurs at peak tidal stress to a stress-rate-controlled regime where peak seismicity occurs at peak tidal stress rate. In contrast, peak seismicity in Coso and along the Garlock fault consistently occurs at peak tidal stress throughout time. Moreover, the strength of tidal modulation in the fault zone increases before the 2019 Mw 7.1 earthquake, unlike in its surroundings. A possible interpretation based on experimental and theoretical work suggests that some characteristic frictional time scale (the nucleation time or the critical period of the fault) becomes shorter than the dominant tidal period after 2015. This change implies that the fault loading rate increases, which may be accompanied by a decrease in effective normal stress. Reduced effective stress, fault zone resonance, or increased mechanical compliance could cause the increase in modulation strength. We propose that these changes manifest a preparation phase before a large earthquake.


  • Open Access

    The Correspondence of Earthquakes and Faults

    by Christopher H. Scholz

    A compilation of many data sets indicates that the exponents α for the cumulative length distribution N(L) = CL−α, of small faults of L < T, the brittle thickness, and for large faults of L > T, are both approximately 2. The same result was found by Zou and Fialko (2024, https://doi.org/10.1029/2024ea003824), but that was fortuitous: their finding being contingent on two compensating errors. If α is 2 for both distributions, it indicates that the exponent B of the cumulative moment distribution N(Mg) = cMg−B is −2/3 for small faults and −1 for large faults, the same values as found for small and large earthquakes. The moment release rates obtained from both earthquake and fault data have also been found to correspond. This demonstrates that in continental regions the long‐assumed correspondence between earthquakes and faults is inclusive. All tectonic earthquakes must occur on faults and faults must slip predominately in earthquakes. The relative contribution of small earthquakes/faults to strain is minor for a single large fault over the recurrence time of the fault‐rupturing earthquake because that case is governed by the characteristic earthquake model. In contrast, over a larger region containing many moderate sized faults, for which the Gutenberg–Richter distribution holds, the relative contribution of small earthquakes/faults to strain may be significant. These different behaviors characterize mature smooth versus immature segmented fault systems.


  • Open Access

    The Correspondence of Earthquakes and Faults

    by Christopher H. Scholz

    A compilation of many data sets indicates that the exponents for the cumulative length distribution of small faults of L < T, the brittle thickness, and for large faults of L > T, are both approximately 2. The same result was found by Zou and Fialko (2024), but that was fortuitous: their finding being contingent on two cancelling errors. If is 2 for both distributions, it indicates that the exponent B of the cumulative moment distribution is 2/3 for small faults and 1 for large faults, the same values as found for small and large earthquakes. The moment release rates obtained from both earthquake and fault data have also been found to correspond. This demonstrates that in continental regions the long-assumed correspondence between earthquakes and faults is exclusive. All tectonic earthquakes must occur on faults and faults must slip predominately in earthquakes. The relative contribution of small earthquakes/faults to strain is minor for a single large fault over the recurrence time of the fault-rupturing earthquake because that case is governed by the characteristic earthquake model. In contrast, over a larger region containing many moderate sized faults, for which the Gutenberg-Richter distribution holds, the relative contribution of small earthquakes/faults to strain may be significant. These different behaviors characterize mature smooth vs. immature segmented fault systems.

  • Open Access

    Patience Cowie and the Inception of Modern Fault Mechanics:  A Recollection

    by Christopher H. Scholz

    Patience Cowie’s PhD thesis, conducted with me at Lamont, resulted in three papers, published in 1992, that laid the groundwork for the modern era of fault mechanics studies. In the first paper1 she reasoned that a cohesive zone model provided a plausible model of fault grown provided that the width of the cohesive zone scales linearly with fault length. In that case, the Griffith instability is avoided and faults grow self-similarly in quasistatic equilibrium. This model is consistent with the existence of faults of all sizes in which displacement scales linearly with length and the fault grows by the breakdown of a damage zone at the fault tip. In the second paper2 she showed that the then existing data for fault displacement and length were consistent with linear scaling for faults rupturing rock of similar strength. In the third paper3 she combined the earthquake slip/length scaling law with that fault scaling law to show how faults can grow by the accumulation of slip from earthquakes.In the subsequent thirty years much more work has been done to expand on these themes pioneered by Patience. Here I share some memories of working with Patience in those formative years. 1          Cowie, P. A. & Scholz, C. H. Physical explanation for the displacement-length relationship of faults using a post-yield fracture mechanics model. J.       Struct. Geol. 14, 1133-1148 (1992).2          Cowie, P. A. & Scholz, C. H. Displacement-length scaling relationship for faults: data synthesis and discussion. J. Struct. Geol. 14, 1149-1156 (1992).3          Cowie, P. A., and Scholz, C.H. Growth of faults by accumulation of seismic slip. J. Geophys. Res. 97(B7), 11085-11095 (1992b).

  • Open Access

    The Shear Deformation Zone and the Smoothing of Faults with Displacement

    by Clement Perrin, Felix Waldhauser, Christopher H. Scholz

    We use high-resolution earthquake locations to characterize the three-dimensional structure of active faults and how it evolves with fault structural maturity. We investigate the distribution of aftershocks of several recent large earthquakes that occurred on crustal strike slip faults of various structural maturity (i.e. various cumulative fault displacement, length, initiation age and slip rate). Aftershocks define a tabular zone of shear deformation surrounding the mainshock rupture plane. Comparing this to geological observations, we conclude that this results from the re-activation of secondary faults. We observe a rapid fall off of the number of aftershocks at a distance range of 0.06-0.25 km from the main fault surface of mature faults, and 0.7-1.5 km from the fault surface of immature faults. The total width of the active shear deformation zone surrounding the main fault plane reaches ~1.5 km and 2.5-6 km for mature and immature faults, respectively. We find that the width of the shear deformation zone decreases as a power law with cumulative fault displacement. Comparing with an existing dynamic rough fault model, we show that the narrowing of the shear deformation zone agrees quantitatively with earlier estimates of the smoothing of faults with displacement, both of which are aspects of fault wear. We compare this evolution of fault structure with several attributes of earthquakes, and find that earthquake stress drop decreases with fault displacement and hence with increased smoothness.


  • Open Access

    The mechanism of tidal triggering of earthquakes at mid-ocean ridges

    by Christopher H. Scholz, Yen Joe Tan, Fabien Albino

    The strong tidal triggering of mid-ocean ridge earthquakes has remained unexplained because the earthquakes occur preferentially during low tide, when normal faulting earthquakes should be inhibited. Using Axial Volcano on the Juan de Fuca ridge as an example, we show that the axial magma chamber inflates/deflates in response to tidal stresses, producing Coulomb stresses on the faults that are opposite in sign to those produced by the tides. When the magma chamber’s bulk modulus is sufficiently low, the phase of tidal triggering is inverted. We find that the stress dependence of seismicity rate conforms to triggering theory over the entire tidal stress range. There is no triggering stress threshold and stress shadowing is just a continuous function of stress decrease. We find the viscous friction parameter A to be an order of magnitude smaller than laboratory measurements. The high tidal sensitivity at Axial Volcano results from the shallow earthquake depths.


  • Open Access

    The Brittle‐Ductile Transition Predicted by a Physics‐Based Friction Law

    by Einat Aharonov, Christopher H. Scholz

    A theory of the brittle‐ductile transition (BDT) is shown to be a direct consequence of a recently developed physics‐based constitutive law for rock friction (Aharonov & Scholz, 2018, https://doi.org/10.1002/2016JB013829), which assumes exponential creep on contacts. The theory was previously tested against experimental data for sliding at low ambient temperature and stress. Here, theoretical interpretation of experimental data at high temperature and stress shows that at some point the real area of contact reaches a maximum value beyond which it becomes fixed. The constitutive law shows that this marks the onset of the BDT, beyond which sliding changes from frictional to an exponential flow law for low‐temperature plasticity. Application to the Earth's crust shows that beyond this point, strength fall linearly with depth until it intersects the power law for bulk flow of the country rock, which marks the lower boundary of the BDT. Modeling, constrained by experimental data for granite, predicts that the BDT starts at a temperature of about 300°C, at a depth of 11–13 km in the continental crust, depending on fault slip rate and temperature gradient. The completion of the BDT is similarly calculated to occur around 475°, at 16–18 km, in agreement with laboratory and field observations. The BDT is thus found to be a region spanning about 175°C with a width of several kilometers. Within the exponential flow region, the structural outcome would be a relatively narrow mylonitized fault zone, which widens into a broader region of shear at the base of the BDT.


  • Earthquake prediction and hazard analysis

    by Christopher H. Scholz

    The Mechanics of Earthquakes and Faulting - by Christopher H. Scholz January 2019


  • Open Access

    Joseph B. Walsh (1930–2017)

    by Christopher H. Scholz, David L. Goldsby, Yves Bernabé, Brian Evans

    This world traveler and rugby enthusiast devised theories fundamental to such diverse fields as seismology, oil and gas exploration, and hydrology. He also designed the hull of the Alvin submersible.