EZErwin Zoethout

Erwin Zoethout

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Erwin Zoethout has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High erosion and re-deposition rates of tungsten in the highly collisional plasmas of Magnum-PSI

    by Mark J.H. Cornelissen, Beata Tyburska-Pueschel, Marcin Rasinski, Serge Brons, Erwin Zoethout, Daniel Dorow-Gerspach, Sebastijan Brezinsek, Marius Wirtz, Gerald Pintsuk, Job Beckers, et al.

    Prompt re-deposition strongly reduces the migration of eroded material in current fusion devices, thus lowering core dilution and extending the lifetime of the plasma-facing components. However, under the high-density ( n e > 2 × 10 20 m−3), low-temperature ( T e < 5 eV) divertor plasma conditions anticipated for future fusion devices like ITER, Coulomb collisions become highly efficient. These collisions not only prevent the ions from completing their Larmor orbits but also strongly couple the sputtered impurities to the plasma, leading to impurity entrainment. Entrainment drags impurities with the plasma flow to the surface, leading to enhanced impurity impact energies as discussed in the companion paper (Cornelissen M.J.H. et al 2025 Nucl. Fusion 65 026009), and the re-deposition of sputtered particles. This entrained re-deposition was studied with the linear plasma generator Magnum-PSI, whose linear geometry allowed for a clear distinction between entrained and prompt re-deposition. Five W targets were exposed to high-density ( n e ≈ 5 × 10 20 m−3), low-temperature ( T e ≈ 1.2 eV) argon (Ar) plasmas. The deposition pattern of tungsten (W) on molybdenum (Mo) witness plates was determined using ion beam analysis and electron scanning microscopy. As the ion-impact energy of Ar+ increased from E i ≈ 43 eV to E i ≈ 94 eV, the local re-deposition rate decreased from R ≈ 93% to R ≈ 68%. Entrained re-deposition became evident from an up-downstream asymmetry in the re-deposition profile and was dominant over prompt re-deposition for the exposures investigated. Although the ionization length was long, high re-deposition rates were found, revealing that neutral-ion interactions were important. Thus, entrainment will be a crucial ingredient in the erosion and re-deposition studies of future fusion reactors.


  • Open Access

    Erosion enhancement by impurity entrainment in the highly collisional plasmas of Magnum-PSI

    by Mark Johannes Hendrikus Cornelissen, Jordy W.M. Vernimmen, Jesse D.E. Verstappen, Erwin Zoethout, Ivo G.J. Classen, Job Beckers, Thomas W. Morgan

    Extrinsic impurity seeding is planned for ITER to avoid high heat fluxes to the tungsten divertor targets. Nevertheless, excessive sputtering by impurities would lead to a reduction in fusion power output and divertor lifetime. Unlike today’s fusion devices, the entrainment of impurities is expected to play an increasing role in ITER’s highly collisional near-surface plasma. Impurity entrainment refers to the acceleration of impurities with the plasma flow by collisional drag, leading to elevated impact energies. To investigate impurity entrainment under ITER-like divertor plasma conditions ( n e > 2 × 10 20 m−3, T e < 5 eV), argon-seeded hydrogen plasmas were formed in the linear plasma generator Magnum-PSI. Doppler shifts in spatially-resolved emission profiles of argon (Ar II - 480.6 nm) and hydrogen (H β - 486.1 nm) reveal the entrainment of seeded argon towards the upstream hydrogen velocity (∼9 cm from the surface), corresponding to ∼0.39 of the common-system sound speed. In addition, the sputtering yield of tungsten by argon bombardment for the argon-seeded hydrogen plasma was compared to a pure argon plasma by monitoring tungsten (W I - 400.9 nm) emission. These sputtering experiments reveal further entrainment of the argon impurities to ∼0.65 of the common-system sound speed at the sheath edge, leading to a large increase in their impact energy. Extrapolation of the Magnum-PSI results to ITER, using existing SOLPS-ITER simulations to determine the divertor plasma conditions, indicates more than an order of magnitude increase in gross erosion of the divertor targets due to impurity entrainment. However, the net erosion rate could still be kept under control if high re-deposition rates are achieved, which is treated in the companion paper (Cornelissen M.J.H. et al 2025 Nucl. Fusion 65 026008). The combination of a low sputtering threshold energy and high impact energy of impurities constrains the fine balance between radiative cooling with impurity seeding and avoiding extensive divertor erosion.


  • Open Access

    Plasma‐Driven Synthesis of Self‐Supported Nickel‐Iron Nanostructures for Water Electrolysis

    by Ameya Ranade, Mengmeng Lao, Remco H.M. Timmer, Erwin Zoethout, Hans J.N. van Eck, Mihalis N. Tsampas

    Nickel‐based electrocatalysts are deemed as promising low‐cost, earth‐abundant materials in the development of the next‐generation alkaline and anion exchange membrane water electrolyzers. Herein, a plasma‐processing technique is presented for fabricating self‐supported nanostructures from planar NiFe substrates and its performance for water splitting reactions. Irradiating the samples with helium plasma results in the formation of nano‐tendrils, which are affixed to the metallic substrate. This unique design not only enhances charge and mass transport, but also increases the electrochemical surface area by 3 to4 times, as compared to the unmodified/planar surfaces. For the benchmark 10 mAcm−2geo current density, the nanostructured electrodes demonstrate overpotentials of 330 and 354 mV for oxygen evolution reaction and hydrogen evolution reaction respectively in 1 M‐ KOH. Moving forward, application of this technique can be extended for fabricating self‐supported 3D substrates (e.g., foams, felts, perforated sheets), all of which find practical applications in energy conversion and storage devices.


  • Open Access

    Surface-limited deuterium uptake of Ru films under plasma exposure

    by S. C. Wang, E. Zoethout, M. van Kampen, T. W. Morgan

    Blister formation has been an emerging research topic for extreme ultraviolet (EUV) mirrors exposed to hydrogen plasmas. Similar to plasma-facing materials in nuclear fusion reactors, it has been reported that blister formation in EUV mirrors is initiated by hydrogen uptake due to hydrogen ion or atom bombardment. However, the research so far has focused on Mo/Si multilayers exposed to only hydrogen ions or atoms, while the EUV mirror typically has a Ru capping layer facing hydrogen plasmas. We present experimental work to measure plasma-induced hydrogen uptake of Ru films. We bombarded our designed Ru-capped target with a low-temperature deuterium plasma and measured the deuterium retention using elastic recoil detection. Contrary to ion-driven deuterium uptake, the deuterium uptake rate of the Ru film had no dependence on the deuterium ion flux or energy after a period of plasma exposure. A reaction–diffusion model has been built to calculate the time evolution of deuterium retention, which well fits the experimental data. Based on this model, we conclude that the surface composition of the Ru film is the limiting factor for the deuterium uptake, which is seriously weakened when the surface is covered by Ru oxide. After the Ru oxide is reduced by the plasma, the uptake rate is predominantly driven by the deuterium surface coverage on metallic Ru. Our model also indicates that at the deuterium-populated Ru surface, deuterium has a low absorption barrier to penetrate the surface, which is supported by previously reported computational work.


  • Open Access

    Ultrafast Photoinduced Heat Generation by Plasmonic HfN Nanoparticles

    by Devin B. O'Neill, Sean K. Frehan, Kaijian Zhu, Erwin Zoethout, Guido Mul, Erik C. Garnett, Annemarie Huijser, Sven H. C. Askes

    There is great interest in the development of alternatives to noble metals for plasmonic nanostructures. Transition metal nitrides are promising due to their robust refractory properties. However, the photophysics of these nanostructures, particularly the hot carrier dynamics and photothermal response on ultrafast timescales, are not well understood. This limits their implementation in applications such as photothermal catalysis or solar thermophotovoltaics. In this study, the light‐induced relaxation processes in water‐dispersed HfN nanoparticles are, for the first time, elucidated by fs transient absorption, Lumerical FDTD and COMSOL Multiphysics simulations, and temperature‐dependent ellipsometry. It is unequivocally demonstrated that HfN nanoparticles convert absorbed photons into heat within <100 fs; no signature of hot charge carriers is observed. Interestingly, under high photon energy or intense irradiation stimulated Raman scattering characteristic of oxynitride surface termination is observed. These findings suggest that transition metal nitrides could offer benefits over noble metals in the field of plasmonic photothermal catalysis.


  • Charge carrier dynamics and photocatalytic activity of {111} and {100} faceted Ag3PO4 particles

    by Rochan Sinha, Dennis Friedrich, Georgios Zafeiropoulos, Erwin Zoethout, Matteo Parente, Mauritius C. M. van de Sanden, Anja Bieberle-Hütter

    Silver orthophosphate is a highly promising visible light photocatalyst with high quantum yield for solar driven water oxidation. Recently, the performance of this material has been further enhanced using facet-controlled synthesis. The tetrahedral particles with {111} exposed facets demonstrate higher photocatalytic performance than the cubic particles with {100} exposed facets. However, the reason behind this large difference in photocatalytic performance is still not understood. In this work, we study the free charge carrier dynamics, such as mobility, lifetime, and diffusion lengths, for the {111}-faceted tetrahedral and the {100}-faceted cubic particles using time-resolved microwave conductivity measurements. An order of magnitude higher charge carrier mobility and diffusion length are found for the tetrahedral particles as compared to the cubic particles. The differences in crystal structure, surface composition, and optical properties are investigated in order to understand how these properties impact the charge carrier dynamics and the photocatalytic performance of differently faceted particles.


  • Tunable plasmonic HfN nanoparticles and arrays

    by Sven H. C. Askes, Nick J. Schilder, Erwin Zoethout, Albert Polman, Erik C. Garnett

    Refractory plasmonic materials offer the benefits of thermal and chemical stability for photonic applications at high temperature or photon flux. Here we demonstrate strategies to fabricate tunable plasmonic hafnium nitride (HfN) nanoparticles.


  • Open Access

    Thermally induced interface chemistry in Mo/B4C/Si/B4C multilayered films

    by S. L. Nyabero, R. W. E. van de Kruijs, A. E. Yakshin, E. Zoethout, F. Bijkerk

    B4C diffusion barrier layers are often introduced into Mo/Si multilayered films for enhancement of thermal stability. We observe that such multilayered films exhibit both period expansion and period compaction upon annealing at temperatures below 300 °C, depending on the annealing temperature and time. Using in-situ grazing incidence x-ray reflection measurements during sequential annealing, we resolved picometer periodicity changes in Mo/B4C/Si/B4C, Si/B4C, and Mo/B4C multilayer films, and show that the two opposite period-change effects are a result of interaction of Si with B4C layers, leading to expansion, and MoxSiy formation, leading to compaction. The study of Si/B and Si/C multilayer sub-systems suggests that the cause of expansion is the formation of relatively low density SixBy compounds at the Si-B4C interface. Although the Mo-B4C interface seems to be stable based on reflectometry data, other techniques such as depth profiling x-ray photoelectron spectroscopy and wide angle x-ray diffraction measurements show that Mo and B4C actually intermix.