Prakash S. Kulkarni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Prakash S. Kulkarni has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Nikhil J. Bodele
Electrical Engineering Department, Visvesvaraya National Institute of Technology, Nagpur, India
3 shared publications A. S. Werulkar
SVPCET
2 shared publications- Karun Kokkonda
Department of Electrical Engineering Visvesvaraya National Institute of Technology Nagpur India
2 shared publications - Manoj A. Waghmare
Department of Electrical Engineering Visvesvaraya National Institute of Technology Nagpur Maharashtra India
2 shared publications - Prachi Salodkar
Shree Ramdeobaba College of Engineering and Management
2 shared publications - Ravindra M. Moharil
Yeshwantrao Chavan College of Engineering
2 shared publications
Latest Publications
- 30 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 71 (10) , 4561-4565
A Zero-Leakage-Current Single-Stage PV-Battery Integrated Inverter With Active Power Decoupling
This brief presents a single-phase, single-stage inverter designed to mitigate solar energy fluctuations through a battery energy storage system (BESS). This inverter fulfils important requirements of the solar PV-based system, such as the elimination of leakage current and enabling voltage boost capability while reducing volume and cost. Additionally, it possesses several important benefits, including the ability to perform maximum power point tracking, simultaneous charging/discharging of the BESS, and active power decoupling, ensuring optimal performance under varying atmospheric conditions. Also, its single-stage operation and continuous input current features enhance its suitability for PV applications. Finally, the experimental results verify the performance and effectiveness of the proposed topology.
- 30 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 71 (10) , 4561-4565
A Zero-Leakage-Current Single-Stage PV-Battery Integrated Inverter With Active Power Decoupling
This brief presents a single-phase, single-stage inverter designed to mitigate solar energy fluctuations through a battery energy storage system (BESS). This inverter fulfils important requirements of the solar PV-based system, such as the elimination of leakage current and enabling voltage boost capability while reducing volume and cost. Additionally, it possesses several important benefits, including the ability to perform maximum power point tracking, simultaneous charging/discharging of the BESS, and active power decoupling, ensuring optimal performance under varying atmospheric conditions. Also, its single-stage operation and continuous input current features enhance its suitability for PV applications. Finally, the experimental results verify the performance and effectiveness of the proposed topology.
- 23 February 2024
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (4) , 5055-5067
Unlocking the floating solar photovoltaic potential on hydropower reservoirs: a case study of Srisailam dam, India
- 23 February 2024
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (4) , 5055-5067
Unlocking the floating solar photovoltaic potential on hydropower reservoirs: a case study of Srisailam dam, India
- 15 May 2023
- Published by Elsevier in Solar Energy
- Vol. 259, 1-14
Modular battery-integrated bidirectional single-stage DC–DC converter for solar PV based DC Nano-grid application
- 15 May 2023
- Published by Elsevier in Solar Energy
- Vol. 259, 1-14
Modular battery-integrated bidirectional single-stage DC–DC converter for solar PV based DC Nano-grid application
- 7 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2021, 1-5
Performance Study of 84.5 kWp Grid Linked SPV System
A rapidly growing sector of India's renewable energy sector is solar electricity. As of 1 June 2022, the country's installed solar capacity was 56.951 GW. The Indian government's early target of 20 GW capacity for 2022 was met four years earlier than expected. The performance evaluation in this article and specifications of a 84.5 kWp grid linked rooftop SPV system at one block in VNIT campus at Nagpur, India, is described. This city is located at the center of the Indian subcontinent. The location is situated in latitude 21.12°N and longitude 79.05°E. The precise measurements values of the system parameter is matched with the result gained by modelling the system using PVsyst 7.16. Auditing the system's performance is vital for identifying variations from the expected value and for maintaining the higher system efficiency. Using the outcomes of the simulation, it is discovered that the above system's design can generate 135 MWh of energy yearly. The actual Annual Performance Ratio (PR) is 73.65% against estimated PR of 80.3%, Annual Capacity Utilization Factor (CUF) of 14.89%, Final Yield (YF), Array Yield (AY), Reference Yield (YR) etc. calculated using PVsyst. Over the span of its projected 25-year operation, the 84.5 kWp would save 2641.295 tons of carbon dioxide.
- 7 April 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2021, 1-5
Performance Study of 84.5 kWp Grid Linked SPV System
A rapidly growing sector of India's renewable energy sector is solar electricity. As of 1 June 2022, the country's installed solar capacity was 56.951 GW. The Indian government's early target of 20 GW capacity for 2022 was met four years earlier than expected. The performance evaluation in this article and specifications of a 84.5 kWp grid linked rooftop SPV system at one block in VNIT campus at Nagpur, India, is described. This city is located at the center of the Indian subcontinent. The location is situated in latitude 21.12°N and longitude 79.05°E. The precise measurements values of the system parameter is matched with the result gained by modelling the system using PVsyst 7.16. Auditing the system's performance is vital for identifying variations from the expected value and for maintaining the higher system efficiency. Using the outcomes of the simulation, it is discovered that the above system's design can generate 135 MWh of energy yearly. The actual Annual Performance Ratio (PR) is 73.65% against estimated PR of 80.3%, Annual Capacity Utilization Factor (CUF) of 14.89%, Final Yield (YF), Array Yield (AY), Reference Yield (YR) etc. calculated using PVsyst. Over the span of its projected 25-year operation, the 84.5 kWp would save 2641.295 tons of carbon dioxide.
- 31 August 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 51 (1) , 243-264
Multi‐input battery‐integrated single‐stage DC‐DC converter for reliable operation of solar photovoltaic‐based systems
Summary: Solar photovoltaic (PV) systems are emerging progressively due to their wide compatibility range, ease of installation, and environmental friendliness. The module mismatch (MM) losses and module open circuit (MOC) fault can cause the power mismatch between different PV modules. This significantly affects the energy output from the PV module. Also, the intermittent nature of solar PV power makes the solar PV systems unreliable; to compensate for this, conventional PV systems utilize a battery storage system (BSS) with separate bidirectional converter. These bidirectional converters require two‐stage power conversion and massive battery bank connected at the DC link. This leads to the further reduction in overall efficiency. To address these issues, this paper proposed a multi‐input PV battery system (MIPBS) that uses nonisolated buck and boost converter combinations. It requires single‐stage power conversion to extract maximum power from each PV module along with BSS charging and discharging. Its modular design allows it to function across a wide range of voltage, power, and BSS choices. The proposed system is capable of mitigating the MM loss and sustaining the MOC fault. This paper discusses the operation, steady‐state analysis, and dynamic analysis of the proposed MIPBS. The performance of the proposed MIPBS is validated using a state‐of‐the‐art experimental setup with two PV modules, each having a rating of 60.53 W.
- 31 August 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 51 (1) , 243-264
Multi‐input battery‐integrated single‐stage DC‐DC converter for reliable operation of solar photovoltaic‐based systems
Summary: Solar photovoltaic (PV) systems are emerging progressively due to their wide compatibility range, ease of installation, and environmental friendliness. The module mismatch (MM) losses and module open circuit (MOC) fault can cause the power mismatch between different PV modules. This significantly affects the energy output from the PV module. Also, the intermittent nature of solar PV power makes the solar PV systems unreliable; to compensate for this, conventional PV systems utilize a battery storage system (BSS) with separate bidirectional converter. These bidirectional converters require two‐stage power conversion and massive battery bank connected at the DC link. This leads to the further reduction in overall efficiency. To address these issues, this paper proposed a multi‐input PV battery system (MIPBS) that uses nonisolated buck and boost converter combinations. It requires single‐stage power conversion to extract maximum power from each PV module along with BSS charging and discharging. Its modular design allows it to function across a wide range of voltage, power, and BSS choices. The proposed system is capable of mitigating the MM loss and sustaining the MOC fault. This paper discusses the operation, steady‐state analysis, and dynamic analysis of the proposed MIPBS. The performance of the proposed MIPBS is validated using a state‐of‐the‐art experimental setup with two PV modules, each having a rating of 60.53 W.
- 1 August 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 50 (8) , 2709-2734
A non-isolated high gain DC-DC converter with coupled-inductor and built-in transformer for grid-connected photovoltaic systems
- 1 August 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 50 (8) , 2709-2734
A non-isolated high gain DC-DC converter with coupled-inductor and built-in transformer for grid-connected photovoltaic systems
- 22 May 2022
- Published by Springer Nature
- p. 487-512
Performance Analysis of 400 kWp Grid-Connected Rooftop Solar PV System for Technical Institute
- 22 May 2022
- Published by Springer Nature
- p. 487-512
Performance Analysis of 400 kWp Grid-Connected Rooftop Solar PV System for Technical Institute
- 22 May 2022
- Published by Springer Nature
- p. 991-1009
Challenges and Issues in Solar PV Development in India
- 22 May 2022
- Published by Springer Nature
- p. 991-1009
Challenges and Issues in Solar PV Development in India
- 28 March 2021
- Published by Springer Nature in Electrical Engineering
- Vol. 103 (6) , 2783-2797
A high gain soft-switching active-clamped coupled-inductor-based converter for grid-tied photovoltaic applications
- 28 March 2021
- Published by Springer Nature in Electrical Engineering
- Vol. 103 (6) , 2783-2797
A high gain soft-switching active-clamped coupled-inductor-based converter for grid-tied photovoltaic applications
- Open Access
- 21 January 2021
- Published by Yeshwantrao Chavan College of Engineering in Journal of Research in Engineering and Applied Sciences
- Vol. 6 (1) , 32-37
EVALUATION OF GENERATION SYSTEM RELIABILITY INDICES USING RBFNN METHOD
- 21 January 2021
- Published by Yeshwantrao Chavan College of Engineering in Journal of Research in Engineering and Applied Sciences
- Vol. 6 (1) , 32-37
Open AccessEVALUATION OF GENERATION SYSTEM RELIABILITY INDICES USING RBFNN METHOD