Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Phongsaphak Sittimart has a total of 51 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Capacitance Characteristics of Glass-Embedded Interdigitated Capacitors for Touch Sensing Applications

    by Apichart Kaewcharoen, Kirote Arpanutud, Prayoot Akkaraekthalin, Phongsaphak Sittimart, Suramate Chalermwisutkul

    This paper investigates the capacitance characteristics of a glass-embedded interdigitated capacitive sensor (IDCS) for touch-sensing applications. The study analyzes both baseline (no-touch) and touch-induced capacitance variations through a combination of analytical modeling and experimental validation. A multilayer analytical model is first employed to calculate the baseline capacitance of the proposed structure, followed by experimental measurements for model verification. Subsequently, an equivalent circuit model of the touched state is introduced to represent the interaction between the human fingertip, sensor electrodes, and earth-ground, explaining the observed capacitance reduction during a finger touch. Sensor prototypes with electrode finger widths of 1.4, 2.0, 2.4, and 3.0 mm were fabricated within a 40 × 40 mm2 sensing area. The baseline capacitance decreased from 28.6 pF at 1.4 mm to 12 pF at 3.0 mm electrode finger width, while the capacitance change upon touch ranged from 0.6–0.9 pF. Touch sensitivity for three test persons increased from about 1.7–4.6% at 1.4 mm to 5–7.6% at 3.0 mm electrode finger width. The results confirm that narrower-electrode designs yield higher absolute capacitance, whereas wider electrodes enhance touch sensitivity and provide greater uniformity within the defined sensing area. Overall, the findings validate the proposed IDCS configuration as a practical approach for realizing glass-integrated touch sensors and offer practical guidelines for optimizing electrode geometry in touch-based smart-glass applications.


  • Thermal annealing effects on β-Ga2O3/diamond (111) heteroepitaxial structures fabricated by radio frequency magnetron sputtering

    by Yixin Wang, Sreenath Mylo Valappil, Yuki Katamune, Itsuki Misono, Yuto Ikegami, Hiroshi Naragino, Phongsaphak Sittimart, Abdelrahman Zkria, Tsuyoshi Yoshitake


  • Harsh Environment‐Immune All‐Carbon Visible Light Photodetector: Sensitivity Improvement by Nitrogen‐Vacancy Center Density Enhancement Through Electron Irradiation

    by Sreenath Mylo Valappil, Taisuke Kageura, Shinya Ohmagari, Shinobu Onoda, Phongsaphak Sittimart, Hiroshi Naragino, Tsuyoshi Yoshitake

    A novel all‐carbon visible light detector is fabricated on a nitrogen‐doped (N‐doped) single‐crystalline diamond (SCD) with interdigitated nanocarbon ohmic contacts. It has been posited that the formation of nitrogen‐vacancy (NV) centers within the photoabsorption layer serves as an effective strategy to augment the device's detection capabilities. To illustrate the significance of this enhancement, NV density is manipulated and augmented by electron beam irradiation in a moderately N‐doped diamond. Despite the incompetent nitrogen doping, the enhancement of NV density in the diamond active layer has resulted in a substantial enhancement of nearly 1.5 orders of magnitude for several critical detection parameters. The NV‐enabled all‐carbon detector demonstrates a high degree of tolerance toward thermal and corrosive environments. The dark current is maintained at a level below 0.01 pA even when the device is operated at a temperature of 250 °C. The robust interfacial bonding between the diamond and the nanocarbon‐interdigitated electrodes ensures that the device exhibits no physical or performance deterioration when subjected to highly corrosive environments. The results of this study may provide insights that can inform the development of high‐sensitivity, harsh environment immune diamond visible light detectors benefiting from the multiple photon excitation of NV quantum centers.


  • Maximizing visible Raman resolution of nanodiamond grains fabricated by coaxial arc plasma deposition through oxygen plasma etching optimization

    by Sreenath Mylo Valappil, Abdelrahman Zkria, Phongsaphak Sittimart, Shinya Ohmagari, Tsuyoshi Yoshitake

    Among the nondestructive carbon material characterization tools, the prominence of visible Raman spectroscopy has surged remarkably for many years due to its ability to explore a diverse array of carbon bonding configurations. However, to fully unlock the distinctive features concealed within carbon composite materials, additional specimen treatments or precise spectroscope calibrations are necessary. In the same regard, the tiny diamond grain size (5–10 nm) and the pronounced amount of sp 2 carbon in the ultrananocrystalline diamond film represent major challenges in visible light excitation. In this work, we employ calibrated oxygen plasma reactive ion etching conditions to manifest the nanodiamond visible Raman signature from ultrananocrystalline diamond/amorphous carbon composite (UNCD/a‐C) films fabricated by coaxial arc plasma deposition. Upon plasma etching, the broad defect band in the visible Raman spectra converged toward the diamond characteristic Raman peak at 1332 cm −1 . A detailed explanation of band components of the Raman spectra is extracted through peak fitting procedures. The results of Raman spectroscopy are further correlated with the electrical characteristics of the nitrogen‐doped UNCD/a‐C films due to the optimized oxygen plasma etching processes.


  • Open Access

    Wetting state and mechanical property alteration for the Fe3Si films using rapid thermal annealing under various temperatures

    by Nattakorn Borwornpornmetee, Thawichai Traiprom, Takafumi Kusaba, Phongsaphak Sittimart, Hiroshi Naragino, Boonchoat Paosawatyanyong, Tsuyoshi Yoshitake, Nathaporn Promros


  • Open Access

    Heteroepitaxial growth of β-Ga2O3 thin films on single crystalline diamond (111) substrates by radio frequency magnetron sputtering

    by Takafumi Kusaba, Phongsaphak Sittimart, Yuki Katamune, Taisuke Kageura, Hiroshi Naragino, Shinya Ohmagari, Sreenath Mylo Valappil, Satoki Nagano, Abdelrahman Zkria, Tsuyoshi Yoshitake

    In this work, we demonstrate the first achievement in heteroepitaxial growth of β-Ga2O3 thin films on single crystalline diamond (111) wafers using RF magnetron sputtering. A single monoclinic (β-phase) structure with a monofamily { 2 ¯ 01} plane was obtained. XRD pole figure shows ( 2 ̅ 02) and (002) textures of the ( 2 ̅ 01) β-Ga2O3 plane parallel to (111) diamond with six distinct rotational domains, confirming successful epitaxial growth. Collectively, this research provides valuable insights into the epitaxial growth of β-Ga2O3 on diamond via sputtering, paving the way for scalable β-Ga2O3/diamond heterostructures for future electronic and optoelectronic applications with not only high performance but also effective self-thermal management.


  • Thermally Stable and Radiation‐Proof Visible‐Light Photodetectors Made from N‐Doped Diamond

    by Phongsaphak Sittimart, Shinya Ohmagari, Hitoshi Umezawa, Hiromitsu Kato, Kotaro Ishiji, Tsuyoshi Yoshitake

    Due to the limits of the physical properties of conventional semiconductors against harsh environments, seeking a suitable material for next‐generation photoconversion devices with high‐temperature stability and strong radiation hardness has become a hot issue. Here, visible‐light photodetectors are fabricated on an N‐doped diamond. Their visible‐light detection via charge‐neutralized impurity levels including multi‐complex mid‐gap states induced crystal defects shows photosensitivity of at least four orders (104), the visible responsivity of 0.08 A W−1, and the detectivity of 3.9 × 1012 Jones. No significant deterioration of such figures of merit of photodetectors is observed even at an environmental temperature of 250 °C and after absorption to 10 MGy in the dose of white X‐ray. N‐doped diamond shows excellent potential to be applicable to visible‐light photodetectors for harsh‐environmental implementations, which conventional visible‐light photodetectors are not capable of so far.


  • Open Access

    The Role of Zn Substitution in Improving the Electrical Properties of CuI Thin Films and Optoelectronic Performance of CuI MSM Photodetectors

    by Chien-Yie Tsay, Yun-Chi Chen, Hsuan-Meng Tsai, Phongsaphak Sittimart, Tsuyoshi Yoshitake

    Pure CuI and Zn-substituted CuI (CuI:Zn) semiconductor thin films, and metal-semiconductor-metal (MSM) photodetectors were fabricated on glass substrates by a low-temperature solution process. The influence of Zn substitution concentration (0–12 at%) on the microstructural, optical, and electrical characteristics of CuI thin films and its role in improving the optoelectronic performance of CuI MSM photodetectors were investigated in this study. Incorporation of Zn cation dopant into CuI thin films improved the crystallinity and increased the average crystalline size. XPS analysis revealed that the oxidation state of Cu ions in all the CuI-based thin films was +1, and the estimated values of [Cu]/[I] for the CuI:Zn thin films were lower than 0.9. It was found that the native p-type conductivity of polycrystalline CuI thin film was converted to n-type conductivity after the incorporation of Zn ions into CuI nanocrystals, and the electrical resistivity decreased with increases in Zn concentration. A time-resolved photocurrent study indicated that the improvements in the optoelectronic performance of CuI MSM photodetectors were obtained through the substitution of Zn ions, which provided operational stability to the two-terminal optoelectronic device. The 8 at% Zn-substituted CuI photodetectors exhibited the highest response current, responsivity, and EQE, as well as moderate specific detectivity.


  • Impact of Laser‐Induced Graphitization on Diamond Schottky Barrier Diodes

    by Tomoki Iwao, Phongsaphak Sittimart, Tsuyoshi Yoshitake, Hitoshi Umezawa, Shinya Ohmagari

  • Open Access

    Nanocarbon ohmic electrodes fabricated by coaxial arc plasma deposition for phosphorus-doped diamond electronics application

    by Sreenath Mylo Valappil, Shinya Ohmagari, Abdelrahman Zkria, Phongsaphak Sittimart, Eslam Abubakr, Hiromitsu Kato, Tsuyoshi Yoshitake

    N-Type (phosphorus-doped) diamond is a promising material for diamond-based electronic devices. However, realizing good ohmic contacts for phosphorus-doped diamonds limits their applications. Thus, the search for non-conventional ohmic contacts has become a hot topic for many researchers. In this work, nanocarbon ohmic electrodes with enhanced carrier collection efficiency were deposited by coaxial arc plasma deposition. The fabricated nanocarbon ohmic electrodes were extensively examined in terms of specific contact resistance and corrosion resistance. The circular transmission line model theory was used to estimate the charge collection efficiency of the nanocarbon ohmic electrodes in terms of specific contact resistance at a specific voltage range (5–10 V); they exhibited a specific contact resistance of 1 × 10−3 Ωcm2. The result revealed one order reduction in the specific contact resistance and, consequently, a potential drop at the diamond/electrode interface compared to the conventional Ti electrodes. Moreover, the fabricated nanocarbon electrodes exhibited high mechanical adhesion and chemical inertness over repeated acid treatments. In device applications, the nanocarbon electrodes were evaluated for Ni/n-type diamond Schottky diodes, and they exhibited nearly one order enhancement in the rectification ratio and a fast charge collection at lower biasing voltages.