MRM. Raghuram

M. Raghuram

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


M. Raghuram has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Stabilized High Voltage Gain With Reduced Common Mode Voltage Using SN-USMC for Remote Green EV Charging

    by Vulavakayala Siva, M. Raghuram, Santosh K Singh

    The main contribution of this paper is to enhance the voltage gain of an ultra sparse matrix converter (USMC) with the help of the switched impedance network (SN) and also improve the common mode voltage (CMV) profile. Moreover, it produces balanced output voltage even during disturbed wind conditions. The prime focus of this paper is to provide information about the selection of active vectors and decide the switching sequence of the space vector modulation technique to reduce the peak-peak CMV. Controlling this switched network without affecting the stable operation of USMC has remained a challenging task, which the authors are carefully handling in this paper. This paper also discusses the analysis of the proposed converter for various supply frequencies, unbalanced supply, and output power factor operating ranges. Later, the proposed converter is compared with the earlier reported similar converters. The simulation and experimental results show that the proposed converter can boost the voltage gain beyond unity with reduced passive components. This would allow a stable, enhanced operating range of wind energy based AC-AC supply systems for EV charging.

  • Analysis and Control of Impedance Network Integrated High Voltage Gain USMC for Wider Output Frequency

    by Vulavakayala Siva, M. Raghuram, Aakash Singh, Santosh K Singh

    The conventional ultra sparse matrix converter (USMC) attains a maximum voltage gain of 0.866, a crucial limitation of matrix converters. It can be overcome by integrating the impedance network with USMC. The primary focus of this article is to integrate switched boost network with USMC to improve the gain profile. This impedance network consists of semiconductor devices and energy storing elements. Controlling this impedance network without affecting the normal operation of USMC has remained a challenging task, which the authors have carefully handled in this article. This article investigates the load power factor effects on the overall voltage gain, which leads the converter to a nonzero discontinuous current mode. Further, this article deals with the total harmonic distortion dependency on the output frequency. In comparison to already reported converters, the proposed converter enhances the gain with minimum passive components. The simulation and experimental results (400 Hz load frequency) show that the proposed converter can boost the voltage gain greater than the unity with two passive elements.

  • Switching Strategy to Reduce Inductor Current Ripple and Common Mode Voltage in Quasi Z-Source Ultra Sparse Matrix Converter

    by Vulavakayala Siva, M. Raghuram, Aakash Singh, Santosh K Singh, Yam P. Siwakoti

    This paper aims to reduce the ripple current in the inductor used in a Quasi Z-source Ultra Sparse Matrix Converter (QZSUSMC). The main limitations of the conventional Ultra Sparse Matrix Converter (USMC) are limited voltage gain $(\leq 0.866)$ and high common mode voltage (CMV). By integrating a quasi Z-source network in the DC link of USMC and providing a shoot-through (ST) state in a switching cycle, a voltage gain greater than unity can be achieved. Inductors are magnetised during the ST state and demagnetized during the nonshoot-through (NST) state. Hence with a proper arrangement of the ST and NST states, ripple in the inductor current can be minimised. In the proposed modulation, the total ST time is divided into six unequal parts and arranging them to minimize the inductor ripple current. in addition to it, proposed method also offers proper switching arrangements by using active vectors to attenuate peak-peak common mode voltage (CMV). As compared to the earlier reported methods, the proposed method produces a better inductor current ripple and a reduced peak of the CMV. Simulation and developed testing circuit results show the effectiveness of the proposed method.


  • High Gain Quasi-Switched Boost Inverter With Optimal Performance Parameters

    by Motiur Reza, Avneet Kumar, Yi Wang, M. Raghuram, Naresh K. Pilli, Santosh K. Singh, Xuewei Pan, Xuewei Pan Xiaogang Xiong

    Numerous Z-source three phase inverters are developed for realizing higher voltage gain which are suitable to use in hybrid electric vehicle to drive the electric machine. However, higher voltage and current stress of the passive elements and semiconductor devices are the major limitations of the reported Z-source inverters. In this paper, a new quasi switched boost three phase inverter is proposed which has following features: 1) very low continuous input current 2) reduced voltage stress 3) reduced current stress 4) shoot through immunity 5) single stage voltage conversion from DC to AC 6) improved output voltage quality by utilizing higher modulation index. The operation, steady-state analysis and design guidelines for the proposed converter are discussed in detail. To prove the feasibility of the proposed inverter, a comparative analysis is also presented with the state of art converters. An experimental set up is designed on printed circuit board and tested for 400 W power rating.


  • Switched-LC Based High Gain Converter With Lower Component Count

    by Avneet Kumar, Yi Wang, Xuewei Pan, M. Raghuram, Santosh Kumar Singh, Xiaogang Xiong, Abhishek K. Tripathi

    In renewable application, a compact high step up DC-DC converter is a prime requirement with continuous input current and lower voltage stress across the devices. In this paper, a high gain DC-DC converter is proposed which utilizes the concept of switched inductor/capacitor and dual switch. The proposed converter has reduced conduction losses, reduced component count, low voltage stress across the devices and therefore compact in size. In addition, the proposed converter has lower inductor current ripple which is suitable for renewable integration. The operation and steady state analysis of the converter is done in continuous current mode. The proposed converter voltage and current stress along with the losses are calculated analytically. Moreover, a comparative analysis is presented to prove the effectiveness of the proposedconverter. Finally, an experimental set up is designed and tested for two distinct power ratings.


  • An Ultra High Gain Quasi Z-Source Inverter Consisting Active Switched Network

    by Avneet Kumar, Yi Wang, M. Raghuram, P. Naresh, Xuewei Pan, Xiaogang Xiong

    A high voltage gain inverter is a prime requirement for high voltage power application. Z-source inverter has attracted the attention widely. A lot of efforts has been made to improve the voltage gain with better design. However, still, there is a gap to achieve higher voltage gain with the optimum number of components. In this brief, a quasi Z-source inverter is proposed to achieve higher voltage gain. The proposed inverter utilizes the active switched network along with switched inductor cell. The proposed inverter offers continuous input current and higher voltage gain. The operation and steady-state analysis are presented to derive the voltage gain. A comparative analysis is presented to describe the features of the proposed inverter. Finally, an experimental analysis is conducted to validate the feasibility of the proposed inverter.


  • A Generalized Switched Inductor Cell Modular Multilevel Inverter

    by Avneet Kumar, Yi Wang, M. Raghuram, Naresh K. Pilli, Santosh Kumar Singh, Xuewei Pan, Xiaogang Xiong

    An interesting feature of Z-source inverter is to provide buck-boost ability in a single stage. However, this concept is most popular in conventional inverters. In a few multilevel inverters, Z-source is utilized to have higher gain along with retaining the advantages of multilevel inverter such as better EMI compatibility, low harmonic distortion, etc. However, the potential of the Z-source concept is not fully exploited in multilevel inverters. To widen the feasibility of Z-source concept in the multilevel inverter, a modular multilevel inverter is considered. In this paper, a generalized switched inductor cell is selected as a Z-source network for integration, however, other Z-source networks such as quasi boost network, quasi switched boost network, two winding coupled inductor network, three winding coupled inductor network, etc. may be used in place of switched inductor cell. The quantitative and qualitative analysis is done for the proposed converter in both the continuous current mode and discontinuous current mode. The analysis shows that a higher voltage gain can be achieved in the discontinuous current mode as compared to the continuous current mode. To control the proposed converter, two new modulation techniques are proposed i.e. full shoot through and upper shoot through/lower shoot through. Finally, the proposed converter is validated experimentally in both the modes and for different modulation techniques.


  • Two Coupled Inductor Based High Gain DC-DC Converters

    by Avneet Kumar, Yi Wang, M. Raghuram, Naresh K. Pilli, Santosh K. Singh, Pan Xuewei, Xiaogang Xiong

    Renewable energy has shown tremendous growth in recent years, especially solar energy. However, solar energy strictly requires high gain DC-DC converter for the regulation purpose. To meet the requirement, two coupled inductor based DC-DC converters are proposed in this paper. These coupled inductor utilizes the two winding coupled inductor which is cost and size effective as compared to three winding coupled inductor. The first converter is a combination of a switched inductor and coupled inductor which is named as switched inductor based coupled inductor converter while other is a combination of switched inductor/capacitor and coupled inductor and hence named as switched inductor/capacitor based coupled inductor converter. The operation and steady analysis of these converters are elaborated. A comparative analysis is also presented to validate the potential of the proposed converters. Finally, these converters are simulated in PSIM 11.0 to demonstrate the suitability.


  • Extended Range of Ultra Sparse Matrix Converter Using Integrated Switched Capacitor Network

    by M. Raghuram, Avneet K. Chauhan, Santosh Kumar Singh

    Ultra sparse matrix converter (USMC) is known for ac-ac conversion with sinusoidal input currents, output voltages, and variable frequency operation. However, its operation is restricted for voltage gain up to 0.866 and load power factor angle up to 30° along with requirement of protection circuit for pulsating loads. This paper proposes switched capacitor USMC to overcome the restrictions of USMC with improved performance. Experimental results are provided to evaluate the converter capability and behavior under balanced and unbalanced input voltage conditions. Furthermore, the proposed converter is compared with the other counterparts.


  • High-Gain-Integrated Switched Capacitor Indirect Matrix Converter

    by M. Raghuram, Avneet K. Chauhan, Santosh Kumar Singh

    Ultra sparse matrix converter (USMC) is a derived form of Indirect matrix converter (IMC) having less number of switches. Though it has unidirectional power flow capability, it is appropriate candidate for specific applications such as wind energy systems, electrohydrostatic actuator, variable speed drives etc. However, gain of the converter is limited irrespective of various topological and control strategy modifications. Unlike the previous propositions, this paper is primarily focused on integration of switched capacitor boost network within USMC to enhance its gain, while preserving the advantages of USMC. For controlling the proposed converter, a modified space vector modulation technique is also presented in this paper. In order to explore the potential of the proposed converter, analytical expressions are derived. The theoretical findings are further verified using simulation and experimental results.