Patricia Mestas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Patricia Mestas has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Maria Cristina Tavares
School of Electrical and Computer Engineering, University of Campinas, Campinas, Brazil
5 shared publications Aniruddha M. Gole
Department of Electrical and Computer Engineering, University of Manitoba, Winnipeg, Canada
1 shared publication
Latest Publications
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Effects of Arc Extinction Time Reduction during Three-Phase Reclosing
Most of transmission line faults are line to ground and most of them are transitory in nature. In this sense, high speed auto reclosing improves the system stability, but there must be certainty that the arc has been extinguished. For shunt compensated transmission lines, frequently, an additional singlephase reactor is connected between neutral and ground. This reactor contributes to coupling reduction and is important to reduce secondary arc current amplitude, which in turn will decrease the secondary arc extinction time during single pole reclosing This paper examines different aspects related to the neutral reactor optimization and its effects for arc extinction time reduction during three-phase reclosing. Additionally, the result of applying a switching method to reduce overvoltages during three-phase reclosing is presented.
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Effects of Arc Extinction Time Reduction during Three-Phase Reclosing
Most of transmission line faults are line to ground and most of them are transitory in nature. In this sense, high speed auto reclosing improves the system stability, but there must be certainty that the arc has been extinguished. For shunt compensated transmission lines, frequently, an additional singlephase reactor is connected between neutral and ground. This reactor contributes to coupling reduction and is important to reduce secondary arc current amplitude, which in turn will decrease the secondary arc extinction time during single pole reclosing This paper examines different aspects related to the neutral reactor optimization and its effects for arc extinction time reduction during three-phase reclosing. Additionally, the result of applying a switching method to reduce overvoltages during three-phase reclosing is presented.
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 29 (6) , 2605-2613
Relevant Parameters in a Statistical Analysis—Application to Transmission-Line Energization
This paper summarizes the important factors that affect statistical switching transients studies during transmission-line energization. These factors include the number of repetitions to ensure the statistical characteristic of the study, the variation range of the mean closing time of the circuit-breaker contacts, the model used for the representation of the transmission line, and the influence of transposition. In addition, a statistical analysis of mitigation methods to reduce overvoltages during transmission-line energization maneuver is presented, specifically the use of surge arresters, of controlled switching, and of a preinsertion resistor. The shunt compensation degree is considered as an independent parameter. Digital simulations were performed with PSCAD.
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 29 (6) , 2605-2613
Relevant Parameters in a Statistical Analysis—Application to Transmission-Line Energization
This paper summarizes the important factors that affect statistical switching transients studies during transmission-line energization. These factors include the number of repetitions to ensure the statistical characteristic of the study, the variation range of the mean closing time of the circuit-breaker contacts, the model used for the representation of the transmission line, and the influence of transposition. In addition, a statistical analysis of mitigation methods to reduce overvoltages during transmission-line energization maneuver is presented, specifically the use of surge arresters, of controlled switching, and of a preinsertion resistor. The shunt compensation degree is considered as an independent parameter. Digital simulations were performed with PSCAD.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 352-356
A comparison of overvoltage control methods during three-phase reclosing varying the length of shunt compensated transmission lines
The overvoltage phenomena due to three-phase reclosing of shunt compensated extra high voltage (EHV) transmission lines are analyzed and verified by PSCAD/EMTDC simulation. The study made in an actual 500 kV AC transmission system considers three alternatives in order to limit overvoltages during line reclosing: a developed synchronous switching method, the use of circuit breakers with pre-insertion resistors and the use of metal oxide surge arresters at both line ends. The developed synchronous switching method detects the first minimum region of the voltage beating across the circuit breakers after protection dead time and works independently of zero voltage crossing, reducing significantly the overvoltages and reclosure time. The study was realized taking the line length as an independent parameter.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 352-356
A comparison of overvoltage control methods during three-phase reclosing varying the length of shunt compensated transmission lines
The overvoltage phenomena due to three-phase reclosing of shunt compensated extra high voltage (EHV) transmission lines are analyzed and verified by PSCAD/EMTDC simulation. The study made in an actual 500 kV AC transmission system considers three alternatives in order to limit overvoltages during line reclosing: a developed synchronous switching method, the use of circuit breakers with pre-insertion resistors and the use of metal oxide surge arresters at both line ends. The developed synchronous switching method detects the first minimum region of the voltage beating across the circuit breakers after protection dead time and works independently of zero voltage crossing, reducing significantly the overvoltages and reclosure time. The study was realized taking the line length as an independent parameter.
- 3 December 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 26 (2) , 954-962
Implementation and Performance Evaluation of a Reclosing Method for Shunt Reactor-Compensated Transmission Lines
This paper proposes a new control method to reduce overvoltages due to three-phase reclosing for shunt compensated transmission lines (TL). The method detects the first minimum voltage region of the beating across the circuit breakers after protection dead time and works independently of voltage zero crossing, reducing significantly the reclosure time. The controller was tested on a Real Time Digital Simulator (RTDS) and its performance was compared to the traditional preinsertion resistor approach and another existing control method.
- 3 December 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 26 (2) , 954-962
Implementation and Performance Evaluation of a Reclosing Method for Shunt Reactor-Compensated Transmission Lines
This paper proposes a new control method to reduce overvoltages due to three-phase reclosing for shunt compensated transmission lines (TL). The method detects the first minimum voltage region of the beating across the circuit breakers after protection dead time and works independently of voltage zero crossing, reducing significantly the reclosure time. The controller was tested on a Real Time Digital Simulator (RTDS) and its performance was compared to the traditional preinsertion resistor approach and another existing control method.
- 1 January 2010
- Published by Elsevier in Electric Power Systems Research
- Vol. 80 (1) , 115-120
Comparative analysis of techniques for control of switching overvoltages during transmission lines energization
- 1 January 2010
- Published by Elsevier in Electric Power Systems Research
- Vol. 80 (1) , 115-120
Comparative analysis of techniques for control of switching overvoltages during transmission lines energization