Giorgio Martini
Giorgio Martini has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Birgitte Romme Larsen
Department of Educational Anthropology, Danish School of Education (DPU), Aarhus University, 2400 Copenhagen NV, Denmark
2 shared publications - Covadonga Astorga
Institute for Environment and Sustainability
2 shared publications Elena Paffumi
2 shared publicationsMichele De Gennaro
2 shared publicationsA. Farfaletti
EC Joint Research Centre Ispra, Institute for Environment and Sustainability, Transport and Air Quality Unit, 21027 Ispra (VA), Italy
1 shared publicationA. Krasenbrink
EC Joint Research Centre Ispra, Institute for Environment and Sustainability, Transport and Air Quality Unit, 21027 Ispra (VA), Italy
1 shared publication
Latest Publications
- Open Access
- 1 December 2018
- Published by Elsevier in Case Studies on Transport Policy
- Vol. 6 (4) , 785-802
European-wide study on big data for supporting road transport policy
- 1 December 2018
- Published by Elsevier in Case Studies on Transport Policy
- Vol. 6 (4) , 785-802
Open AccessEuropean-wide study on big data for supporting road transport policy
- Open Access
- 1 September 2018
- Published by Elsevier in Transport Policy
- Vol. 68, 80-97
Alternative utility factor versus the SAE J2841 standard method for PHEV and BEV applications
- 1 September 2018
- Published by Elsevier in Transport Policy
- Vol. 68, 80-97
Open AccessAlternative utility factor versus the SAE J2841 standard method for PHEV and BEV applications
- Open Access
- 1 June 2018
- Published by Elsevier in Atmospheric Environment
- Vol. 182, 200-212
Experimental investigation of tread wear and particle emission from tyres with different treadwear marking
- 1 June 2018
- Published by Elsevier in Atmospheric Environment
- Vol. 182, 200-212
Open AccessExperimental investigation of tread wear and particle emission from tyres with different treadwear marking
- 1 June 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (18) , 2167-2175
Hydrocarbon emission fingerprints from contemporary vehicle/engine technologies with conventional and new fuels
- 1 June 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (18) , 2167-2175
Hydrocarbon emission fingerprints from contemporary vehicle/engine technologies with conventional and new fuels
- 23 November 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 44 (1) , 505-512
Chemical Characterization of Emissions from Modern Two-Stroke Mopeds Complying with Legislative Regulation in Europe (EURO-2)
In view of a new amendment to the European legislative regulation on emissions from two-stroke mopeds a study was carried out to comprehensively characterize exhaust gases of mopeds complying current EURO-2 emission standards. Three mopeds with different engine types (carburetor, direct injection, and electronic carburetion system ECS) where investigated by applying two different driving cycles, the legislative cycle ECE47 and the worldwide motorcycle test cycle WMTC. Thereby, particulate matter (PM), regulated compounds, carbonyls, volatile hydrocarbons (VOC), and particle-associated polyaromatic hydrocarbons (PAH) were analyzed and ozone formation potentials (OFP) as well as toxicity equivalents (TEQ) determined. The ECE47 emission factors for almost all species and moped types were much higher in the nonregulated, prior cold phase than in the hot phase, which is considered for legislation. Great differences for the mopeds could be observed for NOx, VOC, and PM, whereas discrepancies between the driving cycles ECE47 and WMTC were smaller. In addition, a positive influence on exhaust composition caused by technical modifications of the ECS engine was determined. Results indicate that regulation of total hydrocarbons (THC) alone might not be sufficient to regulate PM, especially for direct injection engines. Moreover, recommendations for a revised future test protocol are demonstrated and discussed, whereby the cold phase and the hot phase are taken into account.
- 23 November 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 44 (1) , 505-512
Chemical Characterization of Emissions from Modern Two-Stroke Mopeds Complying with Legislative Regulation in Europe (EURO-2)
In view of a new amendment to the European legislative regulation on emissions from two-stroke mopeds a study was carried out to comprehensively characterize exhaust gases of mopeds complying current EURO-2 emission standards. Three mopeds with different engine types (carburetor, direct injection, and electronic carburetion system ECS) where investigated by applying two different driving cycles, the legislative cycle ECE47 and the worldwide motorcycle test cycle WMTC. Thereby, particulate matter (PM), regulated compounds, carbonyls, volatile hydrocarbons (VOC), and particle-associated polyaromatic hydrocarbons (PAH) were analyzed and ozone formation potentials (OFP) as well as toxicity equivalents (TEQ) determined. The ECE47 emission factors for almost all species and moped types were much higher in the nonregulated, prior cold phase than in the hot phase, which is considered for legislation. Great differences for the mopeds could be observed for NOx, VOC, and PM, whereas discrepancies between the driving cycles ECE47 and WMTC were smaller. In addition, a positive influence on exhaust composition caused by technical modifications of the ECS engine was determined. Results indicate that regulation of total hydrocarbons (THC) alone might not be sufficient to regulate PM, especially for direct injection engines. Moreover, recommendations for a revised future test protocol are demonstrated and discussed, whereby the cold phase and the hot phase are taken into account.