Covadonga Astorga
Research Subjects
Covadonga Astorga has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Birgitte Romme Larsen
Department of Educational Anthropology, Danish School of Education (DPU), Aarhus University, 2400 Copenhagen NV, Denmark
2 shared publications - Giorgio Martini
Institute for Environment and Sustainability
2 shared publications A. Farfaletti
EC Joint Research Centre Ispra, Institute for Environment and Sustainability, Transport and Air Quality Unit, 21027 Ispra (VA), Italy
1 shared publicationA. Krasenbrink
EC Joint Research Centre Ispra, Institute for Environment and Sustainability, Transport and Air Quality Unit, 21027 Ispra (VA), Italy
1 shared publicationAlois Krasenbrink
Institute for Environment and Sustainability
1 shared publication- Andre Stephan Henry Prevot
Paul Scherrer Institute
1 shared publication
Latest Publications
- 1 June 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (18) , 2167-2175
Hydrocarbon emission fingerprints from contemporary vehicle/engine technologies with conventional and new fuels
- 1 June 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (18) , 2167-2175
Hydrocarbon emission fingerprints from contemporary vehicle/engine technologies with conventional and new fuels
- 23 November 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 44 (1) , 505-512
Chemical Characterization of Emissions from Modern Two-Stroke Mopeds Complying with Legislative Regulation in Europe (EURO-2)
In view of a new amendment to the European legislative regulation on emissions from two-stroke mopeds a study was carried out to comprehensively characterize exhaust gases of mopeds complying current EURO-2 emission standards. Three mopeds with different engine types (carburetor, direct injection, and electronic carburetion system ECS) where investigated by applying two different driving cycles, the legislative cycle ECE47 and the worldwide motorcycle test cycle WMTC. Thereby, particulate matter (PM), regulated compounds, carbonyls, volatile hydrocarbons (VOC), and particle-associated polyaromatic hydrocarbons (PAH) were analyzed and ozone formation potentials (OFP) as well as toxicity equivalents (TEQ) determined. The ECE47 emission factors for almost all species and moped types were much higher in the nonregulated, prior cold phase than in the hot phase, which is considered for legislation. Great differences for the mopeds could be observed for NOx, VOC, and PM, whereas discrepancies between the driving cycles ECE47 and WMTC were smaller. In addition, a positive influence on exhaust composition caused by technical modifications of the ECS engine was determined. Results indicate that regulation of total hydrocarbons (THC) alone might not be sufficient to regulate PM, especially for direct injection engines. Moreover, recommendations for a revised future test protocol are demonstrated and discussed, whereby the cold phase and the hot phase are taken into account.
- 23 November 2009
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 44 (1) , 505-512
Chemical Characterization of Emissions from Modern Two-Stroke Mopeds Complying with Legislative Regulation in Europe (EURO-2)
In view of a new amendment to the European legislative regulation on emissions from two-stroke mopeds a study was carried out to comprehensively characterize exhaust gases of mopeds complying current EURO-2 emission standards. Three mopeds with different engine types (carburetor, direct injection, and electronic carburetion system ECS) where investigated by applying two different driving cycles, the legislative cycle ECE47 and the worldwide motorcycle test cycle WMTC. Thereby, particulate matter (PM), regulated compounds, carbonyls, volatile hydrocarbons (VOC), and particle-associated polyaromatic hydrocarbons (PAH) were analyzed and ozone formation potentials (OFP) as well as toxicity equivalents (TEQ) determined. The ECE47 emission factors for almost all species and moped types were much higher in the nonregulated, prior cold phase than in the hot phase, which is considered for legislation. Great differences for the mopeds could be observed for NOx, VOC, and PM, whereas discrepancies between the driving cycles ECE47 and WMTC were smaller. In addition, a positive influence on exhaust composition caused by technical modifications of the ECS engine was determined. Results indicate that regulation of total hydrocarbons (THC) alone might not be sufficient to regulate PM, especially for direct injection engines. Moreover, recommendations for a revised future test protocol are demonstrated and discussed, whereby the cold phase and the hot phase are taken into account.
- Open Access
- 20 November 2007
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 112 (D22)
A photochemical modeling study of ozone and formaldehyde generation and budget in the Po basin
In this work, a photochemical dispersion model, CAMx (Comprehensive Air quality Model with eXtensions) was used to simulate a high ozone episode observed in the Po basin during the 2003 FORMAT (Formaldehyde as a Tracer of Oxidation in the Troposphere) campaign. The study focuses on formaldehyde and ozone, and a budget analysis was set up for interpreting the importance of different processes, namely emission, chemistry, transport and deposition, for three different areas (urban, downwind, suburban) around the Milan metropolitan region. In addition, a sensitivity study was carried out based on 11 different VOC emission scenarios. The results of the budget study show that the strongest O3 production rate (4 ppbv/hour) occurs in the downwind area of the city of Milan, and that accumulated O3 is transported back to Milan city during nighttime. More than 80% of the HCHO concentration over the Milan metropolitan region is secondary, i.e., photochemically produced from other VOCs. The sensitivity study shows that the emissions of isoprene are not, on average, a controlling factor for the peak concentrations of O3 and HCHO over the model domain because of very few oak trees in this region. Although the paraffinic (PAR) emissions are fairly large, a 20% reduction of PAR yields only 1.7% of HCHO reduction and 2.7% reduction of the O3 peak. The largest reduction of O3 levels can be obtained by reduced xylene (XYL) emissions. A 20% reduction of the total anthropogenic VOC emissions leads to 15.5% (20.3 ppbv) reduction of O3 peak levels over the Milan metropolitan region.
- 20 November 2007
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 112 (D22)
Open AccessA photochemical modeling study of ozone and formaldehyde generation and budget in the Po basin
In this work, a photochemical dispersion model, CAMx (Comprehensive Air quality Model with eXtensions) was used to simulate a high ozone episode observed in the Po basin during the 2003 FORMAT (Formaldehyde as a Tracer of Oxidation in the Troposphere) campaign. The study focuses on formaldehyde and ozone, and a budget analysis was set up for interpreting the importance of different processes, namely emission, chemistry, transport and deposition, for three different areas (urban, downwind, suburban) around the Milan metropolitan region. In addition, a sensitivity study was carried out based on 11 different VOC emission scenarios. The results of the budget study show that the strongest O3 production rate (4 ppbv/hour) occurs in the downwind area of the city of Milan, and that accumulated O3 is transported back to Milan city during nighttime. More than 80% of the HCHO concentration over the Milan metropolitan region is secondary, i.e., photochemically produced from other VOCs. The sensitivity study shows that the emissions of isoprene are not, on average, a controlling factor for the peak concentrations of O3 and HCHO over the model domain because of very few oak trees in this region. Although the paraffinic (PAR) emissions are fairly large, a 20% reduction of PAR yields only 1.7% of HCHO reduction and 2.7% reduction of the O3 peak. The largest reduction of O3 levels can be obtained by reduced xylene (XYL) emissions. A 20% reduction of the total anthropogenic VOC emissions leads to 15.5% (20.3 ppbv) reduction of O3 peak levels over the Milan metropolitan region.
- 16 April 2007
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
(Nano) Particles from 2-S Scooters: SOF / INSOF; Improvements of Aftertreatment; Toxicity
Limited and non-regulated emissions of scooters were analysed during several annual research programs of the Swiss Federal Office of Environment (BAFU) *). Small scooters, which are very much used in the congested centers of several cities, are a remarkable source of air pollution. Therefore every effort to reduce the emissions is an important contribution to improve the air quality in urban centers. In the present work detailed investigations of particle emissions of different 2-stroke scooters with direct injection and with carburettor were performed. The nanoparticulate emissions were measured by means of SMPS, (CPC) and NanoMet. Also the particle mass emission (PM) was measured with the same method as for Diesel engines. Extensive analyses of PM-residuum for SOF/INSOF, PAH and toxicity equivalence (TEQ), were carried out in an international project network. Particle mass emission (PM) of 2-S Scooters consists mostly of SOF. The standard coulometric EC/OC-analysis, as well as the analyzer MEXA 1370 PM overestimate the amount of soot due to the effect of “charring”, which provokes the heaviest VOC to stay in the sample during the thermal extraction and to be indicated as EC. A solution for this analytical problem is demonstrated. Wiremash Filter Catalyst (WFC) is en efficient measure to intensify the oxidation of the exhaust gas components and to reduce PM, PC, PAH, TEQ & VOC. The presented WFC needs a further development for durability and product integration. The amount of total PAH, as well as the toxicity equivalence factor TEQ correlate roughly with the total particle mass PM. WFC is an efficient aftertreatment measure to substancially lower the toxicity of 2-S exhaust gases.
- 16 April 2007
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
(Nano) Particles from 2-S Scooters: SOF / INSOF; Improvements of Aftertreatment; Toxicity
Limited and non-regulated emissions of scooters were analysed during several annual research programs of the Swiss Federal Office of Environment (BAFU) *). Small scooters, which are very much used in the congested centers of several cities, are a remarkable source of air pollution. Therefore every effort to reduce the emissions is an important contribution to improve the air quality in urban centers. In the present work detailed investigations of particle emissions of different 2-stroke scooters with direct injection and with carburettor were performed. The nanoparticulate emissions were measured by means of SMPS, (CPC) and NanoMet. Also the particle mass emission (PM) was measured with the same method as for Diesel engines. Extensive analyses of PM-residuum for SOF/INSOF, PAH and toxicity equivalence (TEQ), were carried out in an international project network. Particle mass emission (PM) of 2-S Scooters consists mostly of SOF. The standard coulometric EC/OC-analysis, as well as the analyzer MEXA 1370 PM overestimate the amount of soot due to the effect of “charring”, which provokes the heaviest VOC to stay in the sample during the thermal extraction and to be indicated as EC. A solution for this analytical problem is demonstrated. Wiremash Filter Catalyst (WFC) is en efficient measure to intensify the oxidation of the exhaust gas components and to reduce PM, PC, PAH, TEQ & VOC. The presented WFC needs a further development for durability and product integration. The amount of total PAH, as well as the toxicity equivalence factor TEQ correlate roughly with the total particle mass PM. WFC is an efficient aftertreatment measure to substancially lower the toxicity of 2-S exhaust gases.