Maria Fischer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Maria Fischer has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Hans Josef Hug
Laboratory for Nanoscale Materials Science, Empa, Swiss Federal Laboratories for Materials Science and Technology, Dübendorf, Switzerland
2 shared publicationsKerstin Thorwarth
Laboratory for Nanoscale Materials Science, Empa, Swiss Federal Laboratories for Materials Science and Technology, Dübendorf, Switzerland
2 shared publicationsJörg Patscheider
Solution Design, Evatec AG, Trübbach, Switzerland
1 shared publication- Jörg Patscheider
Evatec AG, Hauptstraße 1a, 9477 Trübbach, Switzerland
1 shared publication Mathis Trant
Laboratory for Nanoscale Materials Science, Empa, Swiss Federal Laboratories for Materials Science and Technology, Dübendorf, Switzerland
1 shared publication- Mathis Trant
Empa, Swiss Fed Labs Mat Sci & Technol, Uberlandstr 129, CH-8600 Dubendorf, Switzerland
1 shared publication
Latest Publications
- Open Access
- 5 November 2019
- Published by Taylor & Francis in Science and Technology of Advanced Materials
- Vol. 20 (1) , 1031-1042
Understanding the microstructural evolution and mechanical properties of transparent Al-O-N and Al-Si-O-N films
Optically transparent, colorless Al-O-N and Al-Si-O-N coatings with discretely varied O and Si contents were fabricated by reactive direct current magnetron sputtering (R-DCMS) from elemental Al and Si targets and O2 and N2 reactive gases. The Si/Al content was adjusted through the electrical power on the Si and Al targets, while the O/N content was controlled through the O2 flow piped to the substrate in addition to the N2 flow at the targets. The structure and morphology of the coatings were studied by X-ray diffraction (XRD) and transmission electron microscopy (TEM), while the elemental composition was obtained from Rutherford backscattering spectrometry (RBS) and heavy ion elastic recoil detection analysis (ERDA). The chemical states of the elements in the coatings were analyzed by X-ray photoelectron spectroscopy (XPS). Based on analytical results, a model describing the microstructural evolution of the Al-O-N and also previously studied Al-Si-N [ 1 , 2 , 3 , 4 ] coatings with O and Si content, respectively, is established. The universality of the microstructural evolution of these coatings with the concentration of the added element is attributed to the extra valence electron (e–) that must be incorporated into the AlN wurtzite host lattice. In the case of Al-O-N, this additional valence charge arises from the e – acceptor O replacing N in the AlN wurtzite lattice, while the e – donor Si substituting Al fulfills that role in the Al-Si-N system. In view of future applications of ternary Al-O-N and quaternary Al-Si-O-N transparent protective coatings, their mechanical properties such as residual stress (σ), hardness (HD) and Young’s modulus (E) were obtained from the curvature of films deposited onto thin substrates and by nanoindentation, respectively. Moderate compressive stress levels between −0.2 and −0.5 GPa, which suppress crack formation and film-substrate delamination, could be obtained together with HD values around 25 GPa.
- 5 November 2019
- Published by Taylor & Francis in Science and Technology of Advanced Materials
- Vol. 20 (1) , 1031-1042
Open AccessUnderstanding the microstructural evolution and mechanical properties of transparent Al-O-N and Al-Si-O-N films
Optically transparent, colorless Al-O-N and Al-Si-O-N coatings with discretely varied O and Si contents were fabricated by reactive direct current magnetron sputtering (R-DCMS) from elemental Al and Si targets and O2 and N2 reactive gases. The Si/Al content was adjusted through the electrical power on the Si and Al targets, while the O/N content was controlled through the O2 flow piped to the substrate in addition to the N2 flow at the targets. The structure and morphology of the coatings were studied by X-ray diffraction (XRD) and transmission electron microscopy (TEM), while the elemental composition was obtained from Rutherford backscattering spectrometry (RBS) and heavy ion elastic recoil detection analysis (ERDA). The chemical states of the elements in the coatings were analyzed by X-ray photoelectron spectroscopy (XPS). Based on analytical results, a model describing the microstructural evolution of the Al-O-N and also previously studied Al-Si-N [ 1 , 2 , 3 , 4 ] coatings with O and Si content, respectively, is established. The universality of the microstructural evolution of these coatings with the concentration of the added element is attributed to the extra valence electron (e–) that must be incorporated into the AlN wurtzite host lattice. In the case of Al-O-N, this additional valence charge arises from the e – acceptor O replacing N in the AlN wurtzite lattice, while the e – donor Si substituting Al fulfills that role in the Al-Si-N system. In view of future applications of ternary Al-O-N and quaternary Al-Si-O-N transparent protective coatings, their mechanical properties such as residual stress (σ), hardness (HD) and Young’s modulus (E) were obtained from the curvature of films deposited onto thin substrates and by nanoindentation, respectively. Moderate compressive stress levels between −0.2 and −0.5 GPa, which suppress crack formation and film-substrate delamination, could be obtained together with HD values around 25 GPa.
- 1 March 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 362, 220-224
A setup for arc-free reactive DC sputter deposition of Al-O-N
- 1 March 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 362, 220-224
A setup for arc-free reactive DC sputter deposition of Al-O-N