Azlan Shah Hussain
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Azlan Shah Hussain has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Christopher Hardacre
Department of Chemical Engineering The University of Manchester Oxford Road Manchester M13 9PL UK
3 shared publications - Peter Goodrich
School of Chemistry and Chemical Engineering/QUILL, Queen’s University, Stranmillis Road, Belfast, Northern Ireland BT9 5AG, UK
3 shared publications - Ashraf Zin Zawawi
PETRONAS Research Sdn Bhd, Lot 3288 & 3289, Off Jalan Ayer Itam, Kawasan Institusi Bangi, Kajang 43000, Selangor, Malaysia
2 shared publications D.W. Rooney
School of Chemistry and Chemical Engineering/QUILL, Queen’s University, Stranmillis Road, Belfast, Northern Ireland BT9 5AG, UK
2 shared publications- Kris Anderson
School of Chemistry and Chemical Engineering/QUILL, Queen’s University, Stranmillis Road, Belfast, Northern Ireland BT9 5AG, UK
2 shared publications Law Poh Gaik
2 shared publications
Latest Publications
- Open Access
- 27 September 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (51) , 31972-31982
Catalytic ketonization of palmitic acid over a series of transition metal oxides supported on zirconia oxide-based catalysts
Catalyst screening and optimization of a series of ZrO2 supported metal oxides for ketonization of undiluted, neat palmitic acid.
- 27 September 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (51) , 31972-31982
Open AccessCatalytic ketonization of palmitic acid over a series of transition metal oxides supported on zirconia oxide-based catalysts
Catalyst screening and optimization of a series of ZrO2 supported metal oxides for ketonization of undiluted, neat palmitic acid.
- Open Access
Optimization Study of Biomass Hydrogenation to Ethylene Glycol Using Response Surface Methodology
Statistical-based study using response surface methodology (RSM) was conducted to study the effects of process parameters towards biomass hydrogenation. Using Malaysian oil palm empty fruit bunches (EFB) fibres as feedstock, the central composite design (CCD) technique was employed and 18 runs were generated by CCD when four parameters (mass ratio of binary catalyst, hydrogen pressure, temperature and mass ratio of catalyst to feedstock) were varied with two center points to determine the effects of process parameters and eventually to get optimum ethylene glycol (EG) yield. RSM with quadratic function was generated for biomass hydrogenation, indicating all factors except temperature, were important in determining EG yield. Analysis of variance (ANOVA) showed a high coefficient of determination (R2) value of >0.98, ensuring a satisfactory prediction of the quadratic model with experimental data. The quadratic model suggested the optimum EG yield should be >25 wt.% and the EG yield results were successfully reproduced in the laboratory.
Open AccessOptimization Study of Biomass Hydrogenation to Ethylene Glycol Using Response Surface Methodology
Statistical-based study using response surface methodology (RSM) was conducted to study the effects of process parameters towards biomass hydrogenation. Using Malaysian oil palm empty fruit bunches (EFB) fibres as feedstock, the central composite design (CCD) technique was employed and 18 runs were generated by CCD when four parameters (mass ratio of binary catalyst, hydrogen pressure, temperature and mass ratio of catalyst to feedstock) were varied with two center points to determine the effects of process parameters and eventually to get optimum ethylene glycol (EG) yield. RSM with quadratic function was generated for biomass hydrogenation, indicating all factors except temperature, were important in determining EG yield. Analysis of variance (ANOVA) showed a high coefficient of determination (R2) value of >0.98, ensuring a satisfactory prediction of the quadratic model with experimental data. The quadratic model suggested the optimum EG yield should be >25 wt.% and the EG yield results were successfully reproduced in the laboratory.
- Open Access
- 18 December 2019
- Published by IntechOpen
Fungal Pretreatment of Lignocellulosic Materials
The biomass must be converted to fermentable carbohydrates through pretreatment process to break down the complex structure to its constituents prior to fermentation. For lignocellulosic materials, lignin moiety is extremely resistant to degradation because of hydrogen bond cross-linking between the cellulose and hemicellulose. Biological pretreatment using white-rot fungi are novel method and environmental-friendly as a method of biomass deconstruction as compared to other conventional means. These fungi can excrete ligninolytic enzymes to degrade lignin although the rate of deconstruction is slow. Hence, this chapter will focus on the fungal pretreatment or delignification process using white-rot fungi as it is an important step to increase the feedstock conversion.
- 18 December 2019
- Published by IntechOpen
Open AccessFungal Pretreatment of Lignocellulosic Materials
The biomass must be converted to fermentable carbohydrates through pretreatment process to break down the complex structure to its constituents prior to fermentation. For lignocellulosic materials, lignin moiety is extremely resistant to degradation because of hydrogen bond cross-linking between the cellulose and hemicellulose. Biological pretreatment using white-rot fungi are novel method and environmental-friendly as a method of biomass deconstruction as compared to other conventional means. These fungi can excrete ligninolytic enzymes to degrade lignin although the rate of deconstruction is slow. Hence, this chapter will focus on the fungal pretreatment or delignification process using white-rot fungi as it is an important step to increase the feedstock conversion.
- Open Access
- 24 December 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 458
Structural Analysis on the Effect of Base-Catalysed Delignification Process Parameters on Palm Oil Empty Fruit Bunches Fibres using Glycome Profiling
- 24 December 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 458
Open AccessStructural Analysis on the Effect of Base-Catalysed Delignification Process Parameters on Palm Oil Empty Fruit Bunches Fibres using Glycome Profiling
- 10 February 2017
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 8 (1) , 59-68
An optimisation study on biomass delignification process using alkaline wash
- 10 February 2017
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 8 (1) , 59-68
An optimisation study on biomass delignification process using alkaline wash
- 23 February 2014
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 4 (4) , 333-340
Production of bioethanol from empty fruit bunches cellulosic biomass and Avicel PH-101 cellulose
- 23 February 2014
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 4 (4) , 333-340
Production of bioethanol from empty fruit bunches cellulosic biomass and Avicel PH-101 cellulose
- 22 December 2009
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 55 (4) , 1505-1515
Thermophysical Properties of Amino Acid-Based Ionic Liquids
- 22 December 2009
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 55 (4) , 1505-1515
Thermophysical Properties of Amino Acid-Based Ionic Liquids