SASourabh V. Apte

Sourabh V. Apte

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sourabh V. Apte has a total of 49 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Momentum transport and interfacial turbulence across the sediment–water interface in rough permeable beds

    by Zeeshan Q. Memon, Brian D. Wood, Sourabh V. Apte

    A unified investigation of momentum transport mechanisms is performed using both laboratory measurements and predictive numerical simulations of flow over a randomly packed, permeable bed of spherical particles representative of natural aquatic systems. High-resolution refractive-index-matched particle image velocimetry (RIM-PIV) is used to resolve the near-bed and pore-level velocity fields at low permeability Reynolds numbers (Re K ≈ 0.22–0.36). These measurements are compared with a single-domain, variable-porosity Volume-Averaged Navier–Stokes (VaNS) simulation at a matching low Re K ≈ 0.34. The VaNS model is then applied at higher permeability Reynolds numbers (Re K ≈ 2.56–5.39), with the available PR-DNS data used to assess the higher-Re K predictions. Results show that the sediment–water interface acts as a narrow adjustment zone where velocity and shear stresses change rapidly, with strong damping of fluctuations inside the bed. Streamwise fluctuations remain dominant near the interface and are significantly larger than the wall-normal components. Increasing Re K enhances slip velocity, strengthens interfacial shear, and increases turbulent kinetic energy production and dissipation near the sediment crest. The agreement at low Re K and the comparisons with the available PR-DNS data show that the continuum model captures the main volume-averaged flow trends at lower cost than a pore-resolved simulation.

  • Euler–Lagrange modeling of sediment–turbulence interactions in horizontal channel flow

    by Pedram Pakseresht, Sourabh V. Apte

    Euler–Lagrange (EL) modeling of sediment-laden, highly turbulent channel flows remains challenging particularly in the near-wall region, because sediment particles are relatively large compared with the local flow scales. The accuracy of EL simulations can deteriorate in two-way and four-way coupled simulations, especially in the presence of large particles relative to the local resolved scales. The issue arises in the inter-phase coupling where the particle force is added to the adjacent fluid-phase momentum equations that introduces disturbance in the local flow field. Using the disturbed field to compute particle forces in subsequent time steps can lead to inaccuracies that become more pronounced as the particle size increases relative to the local flow scales. This occurs because most closure models are derived based on the undisturbed background flow, which is no longer available in the two-way (and four-way) coupled simulations. In this study, a newly developed corrected EL approach coupled with large eddy simulations is employed to model sediment–turbulence interactions in a horizontal channel flow with a Reynolds number of Reτ=583.3 defined based on the bed friction velocity. Sediment particles near the bed are fully resolved in the wall-normal direction (dp+=5.77) but under-resolved in the streamwise and spanwise directions. The recently developed correction scheme by Pakseresht et al. [“A correction scheme for wall-bounded two-way coupled point-particle simulations,” J. Comput. Phys. 420, 109711 (2020)] is employed to adjust the EL approach and recover the undisturbed flow field required for accurate force estimation of large particles. The corrected EL approach successfully captures several key experimental observations of sediment-laden, wall-bounded turbulence, including (i) an increase in the bed friction velocity, (ii) damping of the mean fluid velocity in the outer layer and enhancement in the inner layer, and (iii) increases in turbulence intensities and Reynolds shear stress quadrants near the bed. The promising results and findings of this study can lead to further improvements in the EL predictions of wall-bounded, particle-laden, highly-turbulent flows.

  • Open Access

    Influence of turbulence on momentum transfer at the river-hyporheic zone interface: An approach combining experiments, high-performance computing, and upscaling theory with machine learning (Final Report)

    by Brian Wood, Corvallis Oregon State Univ., Univ. Of Oxford (United Kingdom), Sourabh Apte, James Liburdy

    The interface between a river and the groundwater has been identified as being a critical component of the ecohydrology of watersheds. The spatially and temporally fluctuating region where surface waters and groundwaters mix is termed, loosely, the hyporheic zone. The hyporheic zone has been identified as being one of the most important components controlling the exchange of nutrients (including carbons sources, electron donors, and electron acceptors such as oxygen) and other aqueous components (such as colloids and dissolved contaminants) between the surface and groundwater systems. The fluctuating motions of fluids, known as turbulence, has been identified as a major process affecting transport across the sediment-water interface. In this work, we conducted a closer examination of the influence of turbulence near the SWI at resolutions that have been previously not tractable. This exploration included the following. 1. Direct experimental observations of the flow structures that increase momentum (and mass) transport in the region of the hyporheic zone. 2. A combination of high-resolution computer simulations of the flow near the sediment-water interface. These were used both to interpret experimental observations, and to provide necessary data and analysis for the development of theory. 3. Development of new mathematical models that represent the transport of fluid and dissolved components near the sediment-water interface. The results of this work were (1) A suite of experimental data ( available to other scientists) that reports direct measurements of the influence of turbulence at the sediment-water interface, (2) numerical simulations that support and help interpret these experiments, and (3) a number of peer-reviewed journal articles that report the results to the broader scientific community.

  • Characteristics of Turbulent Transport Over Permeable and Impermeable Bed of Particles

    by Shashank K. Karra, Sourabh V. Apte, Xiaoliang He, Timothy D. Scheibe, Brian D. Wood


  • Multiscale settling dynamics of Kolmogorov-scale sediment-like particles in turbulence

    by Nathan Keane, Sourabh V. Apte

    The settling dynamics of finite size, slightly heavier-than-fluid Kolmogorov-scale particles in homogeneous, isotropic turbulence at moderate volume loadings is investigated. A thoroughly validated two-way-coupled, point-particle model based on the complete Maxey–Riley–Gatignol equation of motion is used with closure models for all forces, including the history force, together with corrections for the self-disturbance field created by the particle using a novel zonal-advection-diffusion-reaction method. Settling dynamics is investigated by varying turbulence intensities relative to the particle settling speed in quiescent flow for multiple Stokes numbers. The length scales associated with the turbulence structures that strongly interact with and influence the settling dynamics are investigated using multiscale statistical analysis of the fluid velocity and second invariant of the velocity gradient tensors sampled by the particles. The time scales are investigated using trajectory curvature angle statistics of inertial and fluid particles. Low-to-moderate Stokes number particles tend to sample strain-rate dominated regions of the flow, tend to follow the curvature of the flow paths and show enhanced settling at higher turbulence intensities due to fast tracking and preferential sampling. Higher Stokes number particles, on the other hand, have a tendency to travel in straight lines relative to the flow and result in reduced settling speeds due to loitering. For the low mass loadings considered in this work, there is minimal global effect on the turbulent flow characteristics; however, it is found that the Kolmogorov-scale particles interact with and locally modify flow structures approximately twice their size, whereas they sample flow velocities from scales up to ten times the particle size, influencing preferential sampling and settling characteristics.


  • An evaluation of two-way coupled Euler–Lagrange methodology through direct comparison with particle-resolved simulations

    by Jungyun Kim, Sourabh V. Apte, S. Balachandar

    The two-way coupled Euler–Lagrange (EL) methodology is an efficient computational tool for investigating multiphase flows, enabling simulations with tens of millions of particles without Reynolds number limitations. This method resolves the fluid motion on scales larger than a filter length scale, which typically exceeds the particle size and the inter-particle spacing. However, EL simulations require closure models to account for unresolved scales. This work compares particle-resolved (PR) and EL simulations to assess the accuracy of EL solutions. We examine how well EL simulations capture the statistical distribution of particle and fluid quantities in multiphase flows by comparing them with PR solutions. The focus is on modeling the force on particles and understanding the influence of the filter scale on EL simulation accuracy. The results show that, due to variations in feedback forces at individual particle locations, the forces computed in the EL method do not consistently correlate with those obtained from the PR simulations.


  • Numerical investigation of turbulent flow over a randomly packed sediment bed using a variable porosity continuum model

    by Shashank K. Karra, Sourabh V. Apte

    A large eddy simulation (LES) is performed for a turbulent open channel flow over a porous sediment bed at permeability Reynolds number of ReK∼2.56 (Reτ = 270) representative of aquatic systems. A continuum approach based on the upscaled, volume-averaged Navier−Stokes (VaNS) equations is used by defining smoothly varying porosity across the sediment water interface (SWI) and modeling the drag force in the porous bed using a modified Ergun equation with Forchheimer corrections for inertial terms. The results from the continuum approach are compared with a pore-resolved direct numerical simulation (PR-DNS) in which turbulent flow over a randomly packed sediment bed of monodispersed particles is investigated [Karra et al.,J. Fluid Mech. 971, A23 (2023)] A spatially varying porosity profile generated from the pore-resolved DNS is used in the continuum approach. Mean flow, Reynolds stress statistics, and net momentum exchange between the freestream and the porous bed are compared between the two studies, showing reasonably good agreement. Small deviations within the transitional region between the sediment bed and the freestream as compared to the PR-DNS results are attributed to the local protrusions of particles in a randomly packed bed that are absent in the continuum approach but are present in the PR-DNS. A better representation of the effective permeability in the top transition layer that accounts for roughness effect of exposed particles is necessary. The continuum approach significantly reduces the computational cost, thereby making it suitable to study hyporheic exchange of mass and momentum in large scale aquatic domains with combined influence of bedform and bed roughness.


  • Pore-resolved investigation of turbulent open channel flow over a randomly packed permeable sediment bed

    by Shashank K. Karra, Sourabh V. Apte, Xiaoliang He, Timothy D. Scheibe

    Pore-resolved direct numerical simulations are performed to investigate the interactions between streamflow turbulence and groundwater flow through a randomly packed porous sediment bed for three permeability Reynolds numbers, $Re_K=2.56$ , 5.17 and 8.94, representative of natural stream or river systems. Time–space averaging is used to quantify the Reynolds stress, form-induced stress, mean flow and shear penetration depths, and mixing length at the sediment–water interface (SWI). The mean flow and shear penetration depths increase with $Re_K$ and are found to be nonlinear functions of non-dimensional permeability. The peaks and significant values of the Reynolds stresses, form-induced stresses, and pressure variations are shown to occur in the top layer of the bed, which is also confirmed by conducting simulations of just the top layer as roughness elements over an impermeable wall. The probability distribution functions (p.d.f.s) of normalized local bed stress are found to collapse for all Reynolds numbers, and their root-mean-square fluctuations are assumed to follow logarithmic correlations. The fluctuations in local bed stress and resultant drag and lift forces on sediment grains are mainly a result of the top layer; their p.d.f.s are symmetric with heavy tails, and can be well represented by a non-Gaussian model fit. The bed stress statistics and the pressure data at the SWI potentially can be used in providing better boundary conditions in modelling of incipient motion and reach-scale transport in the hyporheic zone.


  • Open Access

    Effect of interpolation kernels and grid refinement on two way-coupled point-particle simulations

    by Nathan A. Keane, Sourabh V. Apte, Suhas S. Jain, Makrand A. Khanwale

    The predictive capability of two way--coupled point-particle Euler-Lagrange model in accurately capturing particle-flow interactions under grid refinement, wherein the particle size can be comparable to the grid size, is systematically evaluated. Two situations are considered, (i) uniform flow over a stationary particle, and (ii) decaying isotropic turbulence laden with Kolmogorov-scale particles. Particle-fluid interactions are modeled using only the standard drag law, typical of large density-ratio systems. A zonal, advection-diffusion-reaction (Zonal-ADR) model is used to obtain the undisturbed fluid velocity needed in the drag closure. Two main types of interpolation kernels, grid-based and particle size--based, are employed. The effect of interpolation kernels on capturing the particle-fluid interactions, kinetic energy, dissipation rate, and particle acceleration statistics are evaluated in detail. It is shown that the interpolation kernels whose width scales with the particle size perform significantly better under grid refinement than kernels whose width scales with the grid size. Convergence with respect to spatial resolution is obtained with the particle size--based kernels with and without correcting for the self-disturbance effect. While the use of particle size--based interpolation kernels provide spatial convergence and perform better than kernels that scale based on grid size, small differences can still be seen in the converged results with and without correcting for the particle self-disturbance. Such differences indicate the need for self-disturbance correction to obtain the best results, especially when the particles are larger than the grid size.