Dmitriy A. Buhtiyarov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dmitriy A. Buhtiyarov has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Anatoly P. Gorbachev
Novosibirsk State Technical University, Novosibirsk, Russia
3 shared publications- Victor V. Atuchin
Research and Development Department, Kemerovo State University, Kemerovo 650000, Russia
3 shared publications A.P. Gorbachev
Department of Radio Engineering and Electronics, Novosibirsk State Technical University, Novosibirsk 630073, Russia
2 shared publications- Anatolii P. Gorbachev
Department of Radio Receiving and Radio Transmitted Devices Novosibirsk State Technical University Novosibirsk Russia
1 shared publication - Anatoly Gorbachev
Novosibirsk State Technical University, Novosibirsk, Russia
1 shared publication - Natalya Tarasenko
Novosibirsk State Technical University, Novosibirsk, Russia
1 shared publication
Latest Publications
- Open Access
- 19 June 2026
- Published by al-Farabi Kazakh National University in Physical Sciences and Technology
- Vol. 13 (1-2) , 78-93
The reduced size quasi-Yagi antenna with an ends-fed dipole-like driver
A modified version of the printed quasi-Yagi antenna by using the so-called ends-fed dipole-like radiator is presented. In this radiator, the excitation nodes are placed on the far ends of the dipole metallic halves rather than on the adjacent ones. As a result, the current distribution along each of the radiator cylindrical/printed wire significantly differs from that related to the ordinary center-fed dipole. That is why the frequency behavior of the proposed radiator input impedance guarantees the nontraditional radiation properties. Additionally, this approach to the choice of the excitation nodes leads to the simplification of the printed-circuit-board (PCB) implementation. A printed prototype operating at 2.8 GHz is developed and tested. Since the area around the radiating arms is fully free from any conductors and dielectrics (except for the substrate itself), the proposed quasi-Yagi antenna is a good candidate to emit radiation of high polarization purity. The measured results revealed that such an antenna is able to reach an effective area reduction to 40% with the enhanced up to 10 dB front-to-back ratio without decreasing the bandwidth. Keywords: Printed-circuit-board radiators, induced electromotive force method, quasi-Yagi antenna, radiation pattern, telecommunication.
- 19 June 2026
- Published by al-Farabi Kazakh National University in Physical Sciences and Technology
- Vol. 13 (1-2) , 78-93
Open AccessThe reduced size quasi-Yagi antenna with an ends-fed dipole-like driver
A modified version of the printed quasi-Yagi antenna by using the so-called ends-fed dipole-like radiator is presented. In this radiator, the excitation nodes are placed on the far ends of the dipole metallic halves rather than on the adjacent ones. As a result, the current distribution along each of the radiator cylindrical/printed wire significantly differs from that related to the ordinary center-fed dipole. That is why the frequency behavior of the proposed radiator input impedance guarantees the nontraditional radiation properties. Additionally, this approach to the choice of the excitation nodes leads to the simplification of the printed-circuit-board (PCB) implementation. A printed prototype operating at 2.8 GHz is developed and tested. Since the area around the radiating arms is fully free from any conductors and dielectrics (except for the substrate itself), the proposed quasi-Yagi antenna is a good candidate to emit radiation of high polarization purity. The measured results revealed that such an antenna is able to reach an effective area reduction to 40% with the enhanced up to 10 dB front-to-back ratio without decreasing the bandwidth. Keywords: Printed-circuit-board radiators, induced electromotive force method, quasi-Yagi antenna, radiation pattern, telecommunication.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 202-204
The novel waveguide-fed dipole-like antenna
A modified dipole aerial is presented and analyzed by the integral equations. Both the wires of an aerial are positioned parallel to rectangular waveguide. Such an aerial may be used as the qualitative radiating element in wireless local-area network IEEE 802.11a (lower and middle band).
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 202-204
The novel waveguide-fed dipole-like antenna
A modified dipole aerial is presented and analyzed by the integral equations. Both the wires of an aerial are positioned parallel to rectangular waveguide. Such an aerial may be used as the qualitative radiating element in wireless local-area network IEEE 802.11a (lower and middle band).
- Open Access
- 1 November 2016
- Published by Elsevier in Pacific Science Review A: Natural Science and Engineering
- Vol. 18 (3) , 157-161
Compact printed microwave filters for wireless communication applications
- 1 November 2016
- Published by Elsevier in Pacific Science Review A: Natural Science and Engineering
- Vol. 18 (3) , 157-161
Open AccessCompact printed microwave filters for wireless communication applications
- 1 June 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 290-293
The linearly polarized ends-fed magnetic dipole antenna excited by circular waveguide
The novel waveguide-fed magnetic dipole antenna is presented. To excite the antenna arms, the two equal in magnitude and in-phase excitations are created using the standard circular waveguide. Since the area around the radiating slot is free of any balun conductors (exception for a finite ground plane and thin magnetic dipole box), the antenna radiation is of high polarization purity. The stand-alone antenna operating near 2.7 GHz was fabricated and tested to verify the design validity. Both the far-field pattern and the return loss show good agreement with the designed parameters. Such antenna is a qualitative candidate for using as a building block in the linearly polarized assemblies as well as the stand-alone radiator.
- 1 June 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 290-293
The linearly polarized ends-fed magnetic dipole antenna excited by circular waveguide
The novel waveguide-fed magnetic dipole antenna is presented. To excite the antenna arms, the two equal in magnitude and in-phase excitations are created using the standard circular waveguide. Since the area around the radiating slot is free of any balun conductors (exception for a finite ground plane and thin magnetic dipole box), the antenna radiation is of high polarization purity. The stand-alone antenna operating near 2.7 GHz was fabricated and tested to verify the design validity. Both the far-field pattern and the return loss show good agreement with the designed parameters. Such antenna is a qualitative candidate for using as a building block in the linearly polarized assemblies as well as the stand-alone radiator.
- 7 July 2015
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 29 (13) , 1720-1727
The linearly polarized waveguide-fed dipole-like antenna
The modified waveguide-fed dipole-like antenna is designed using the induced emf method. To excite the antenna arms, the two equal in magnitude and 180° and out-of-phase excitations are created using the standard rectangular waveguide. Since the area around the radiating arms is free of any conductors (exception for a finite ground plane), the antenna radiation is of high polarization purity. The stand-alone antenna operating near 1.7 GHz was fabricated and tested to verify the design validity. Both the far-field pattern and the return loss level show good agreement with the designed parameters. Such antenna is optimal for using as a building block in the linearly polarized assemblies as well as the stand-alone radiators.
- 7 July 2015
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 29 (13) , 1720-1727
The linearly polarized waveguide-fed dipole-like antenna
The modified waveguide-fed dipole-like antenna is designed using the induced emf method. To excite the antenna arms, the two equal in magnitude and 180° and out-of-phase excitations are created using the standard rectangular waveguide. Since the area around the radiating arms is free of any conductors (exception for a finite ground plane), the antenna radiation is of high polarization purity. The stand-alone antenna operating near 1.7 GHz was fabricated and tested to verify the design validity. Both the far-field pattern and the return loss level show good agreement with the designed parameters. Such antenna is optimal for using as a building block in the linearly polarized assemblies as well as the stand-alone radiators.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 304-307
Input impedances of dipole and dipole-like antennas with prescribed phase difference between excitation currents
A novel variations of the conventional dipole radiator are analyzed. By properly choosing theirs parameters and outgoing lines of the exciting power divider/balun, it is possible to create the versions of the antenna that have suitable range of input impedance and figure-eight tilted radiation patterns. The change of the lengths of the outgoing lines allows the currents on the two arms of the antenna to have prescribed phase difference, thereby making the antenna operate at various states with corresponding E-plane maximum beam direction. The corresponding expressions for complex input impedances are derived in this paper.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 304-307
Input impedances of dipole and dipole-like antennas with prescribed phase difference between excitation currents
A novel variations of the conventional dipole radiator are analyzed. By properly choosing theirs parameters and outgoing lines of the exciting power divider/balun, it is possible to create the versions of the antenna that have suitable range of input impedance and figure-eight tilted radiation patterns. The change of the lengths of the outgoing lines allows the currents on the two arms of the antenna to have prescribed phase difference, thereby making the antenna operate at various states with corresponding E-plane maximum beam direction. The corresponding expressions for complex input impedances are derived in this paper.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 297-303
Input impedance of ends-fed dipole radiator with prescribed phase difference between excitation currents
A novel excitation of the conventional ends-fed dipole radiator is analyzed. By properly choosing its parameters and outgoing lines of the exciting power divider/balun, it is possible to create the versions of the antenna that have suitable range of input impedance and figure-eight tilted radiation patterns. The change of the lengths of the outgoing lines allows the currents on the two arms of the antenna to have prescribed phase difference, thereby making the antenna operate at various states with corresponding E-plane maximum beam direction. The corresponding closed-form expression for complex input impedance is derived in this paper.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 297-303
Input impedance of ends-fed dipole radiator with prescribed phase difference between excitation currents
A novel excitation of the conventional ends-fed dipole radiator is analyzed. By properly choosing its parameters and outgoing lines of the exciting power divider/balun, it is possible to create the versions of the antenna that have suitable range of input impedance and figure-eight tilted radiation patterns. The change of the lengths of the outgoing lines allows the currents on the two arms of the antenna to have prescribed phase difference, thereby making the antenna operate at various states with corresponding E-plane maximum beam direction. The corresponding closed-form expression for complex input impedance is derived in this paper.
- 1 October 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-28
A novel ends-fed dipole radiator
A novel approach to enhance the dipole antenna performances by using so-called an ends-fed dipole radiator is presented. Since the area around the radiating arms is free of any conductors, the proposed radiator is very good candidate to create the high polarization purity of radiation. The simulated results have revealed that such a radiator is able to achieve a high polarization purity with enhanced up to 12 dB front-to-back ratio without decreasing the bandwidth.
- 1 October 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-28
A novel ends-fed dipole radiator
A novel approach to enhance the dipole antenna performances by using so-called an ends-fed dipole radiator is presented. Since the area around the radiating arms is free of any conductors, the proposed radiator is very good candidate to create the high polarization purity of radiation. The simulated results have revealed that such a radiator is able to achieve a high polarization purity with enhanced up to 12 dB front-to-back ratio without decreasing the bandwidth.